压实黄土抗剪强度参数影响因素研究

为了进一步研究河南三门峡地区黄土抗剪强度的影响因素,采用应变控制式三轴仪对不同含水量、不同压实度下的重塑黄土进行不固结不排水三轴试验。试验结果表明:相同压实度下,随着含水量的增加,应力应变关系曲线由弱应变硬化向强应变硬化转变;粘聚力与内摩擦角均随含水量的增加而减小,粘聚力与含水量的变化呈明显负线性相关,内摩擦角与含水量无明显的相关性。相同含水量下,粘聚力与内摩擦角随压实度的增加而逐渐增大,且呈现出明显的指数相关。含水量对抗剪强度参数的影响比压实度大。对以上强度参数采用最小二乘法进行拟合,得出考虑含水率和压实度的抗剪强度相关关系式,能够较为准确的反映在某种试验条件下强度参数的变化规律,为实际工程应用和数值模拟提供依据。     

组合人工湿地对城镇污水处理厂尾水中有机物的去除特征研究

采用物理分级和三维荧光光谱法,研究了组合人工湿地对城镇污水处理厂尾水中不同形态有机物的去除特征.结果表明,组合人工湿地对污水处理厂尾水具有较好的深度处理效果,出水水质基本可以达到国家地表水环境质量标准(GB38382-2002)Ⅲ或Ⅳ类水标准.组合人工湿地处理系统对尾水中CODCr和BOD5总体去除率分别达到35.2%和44.3%,对尾水中总有机碳(TOC)、溶解性有机碳(DOC)、颗粒有机碳(POC)的平均去除率分别为46.9%、45.9%、48.3%.组合人工湿地系统不同单元对尾水中有机物的去除贡献率存在差异,其中,潜流湿地单元对尾水中CODCr和BOD5及其不同组分有机碳的去除效率较高.试验期间,由于藻类滋生,表流湿地单元出水中有机物含量波动较大,去除效果明显降低,藻类被打捞后,出水水质明显改善.三维荧光光谱分析结果显示,各个处理单元取样点的水样三维荧光光谱均出现4个明显的荧光峰.人工湿地各单元出水溶解性有机质(DOM)中,类蛋白和类腐殖酸物质含量较高,类富里酸物质含量较低.人工湿地对类蛋白和类腐殖酸物质有较强的去除作用.     

脱硫脱硫弧菌转化二氧化硫气体的研究

运用连续处理工艺研究了SO_2进气摩尔流速和去除率的关系,并对主要转化产物硫化氢和硫化物进行了测定,研究了亚硫酸盐的积累情况及其对脱硫脱硫弧菌生长的影响,同时还对碳源的消耗及转化产物进行了定量研究.实验结果表明,随着SO_2流速的提高(4·975~20·149mmol·h~(-1))菌体对二氧化硫的去除率没有发生明显的变化,始终保持在93%以上,在SO2摩尔流速低于5·034mmol·h~(-1)时产物以硫化氢为主,而随着SO_2摩尔流速的提高,液相中硫化物和亚硫酸盐开始累积;当SO_2摩尔流速增大至20·149mmol·h~(-1)时,亚硫酸盐累积浓度达到74·23mg·L~(-1),该浓度对菌体生长不会产生抑制作用;系统在SO_2摩尔流速为14·063mmol·h~(-1)下运行时较为稳定,乳酸盐全部转化为乙酸盐,每还原1mmol SO_2消耗0·4mmol CH_3CHOHCOO~-.     

水合肼生产盐渣中氮化合物的去除

将水合肼生产盐渣分离碳酸钠后,通过吹脱、氧化等工艺降低饱和盐溶液的氮含量(以氨质量浓度计),以达到电解法制备氢氧化钠工艺对原料氯化钠的使用要求。中试试验结果表明:氧化反应最佳工艺条件为以次氯酸钠为氧化剂,次氯酸钠溶液中氢氧化钠质量浓度9.2g/L,次氯酸钠与初始氨的质量比为13,溶液pH 7～8,反应温度30～35℃;在此条件下氧化处理饱和盐溶液,处理后氨质量浓度由350.0 mg/L降至2.1 mg/L。将处理后的饱和盐溶液用于电解法制备氢氧化钠的生产过程,不仅可创造一定的经济效益,而且还解决了水合肼生产中的环境污染问题。     

活性炭电极对溶液中NaCl的电吸附行为

用活性炭、酚醛树脂和乌洛托品制备了活性炭电极。利用扫描电子显微镜(SEM)、傅立叶变换红外光谱仪(FTIR)分析了电极的表面性质,发现电极表面的黏结剂可完全碳化,且活性炭上带有大量含氧官能团;利用电化学工作站采用循环伏安法对电极进行了测试,表明电吸附是一稳定而又可逆的过程,电极电流的最大值由碳化前的0.019 8A升至碳化后的0.042 7A,双电层电容提高到碳化前的2.16倍;对NaCl的电吸附实验表明碳化后电极的电吸附率是碳化前的1.59倍,活性炭的吸附容量也由1.14mg/g提高到3.29mg/g,且活性炭电极具有良好的重复利用性。     

磁絮凝处理废水工艺条件的响应曲面法优化研究

以聚硅硫酸铁(PFSS)为絮凝剂、磁流体为磁种,采用磁絮凝法处理模拟废水。在正交实验基础上,利用Matlab软件进行响应曲面分析,研究磁絮凝法处理模拟废水的各因素间具有的交互作用关系。回归拟合结果表明最佳工艺条件为:PFSS加入量36.8g/L,模拟废水pH7.4,磁种加入量14.7mg/L,搅拌转速266r/min。在最佳工艺条件下进行实验,TP去除率为97.70%。     

活性碳纤维吸附废气中的丙烯酸和甲苯

采用动态吸附法探讨了在活性碳纤维对模拟废气中丙烯酸和甲苯的吸附过程中,各因素对活性碳纤维穿透吸附量和饱和吸附量的影响。实验结果表明,在模拟废气中丙烯酸质量分数为0.2%、双柱塞泵流量为6.1mL/h、载气流量为1.60L/min的条件下,穿透时间为10min,活性碳纤维的穿透吸附量为227.5mg/g,饱和吸附时间为40min,活性碳纤维的饱和吸附量为460.0m g/g。     

Effects of productivity on biodiversity in forest ecosystems across the United States and China

In the global campaign against biodiversity loss in forest ecosystems, land managers need to know the status of forest biodiversity, but practical guidelines for conserving biodiversity in forest management are lacking. A major obstacle is the incomplete understanding of the relationship between site primary productivity and plant diversity, due to insufficient ecosystem‐wide data, especially for taxonomically and structurally diverse forest ecosystems. We investigated the effects of site productivity (the site's inherent capacity to grow timber) on tree species richness across 19 types of forest ecosystems in North America and China through 3 ground‐sourced forest inventory data sets (U.S. Forest Inventory and Analysis, Cooperative Alaska Forest Inventory, and Chinese Forest Management Planning Inventory). All forest types conformed to a consistent and highly significant (P < 0.001) hump‐shaped unimodal relationship, of which the generalized coefficients of determination averaged 20.5% over all the forest types. That is, tree species richness first increased as productivity increased at a progressively slower rate, and, after reaching a maximum, richness started to decline. Our consistent findings suggest that forests of high productivity would sustain few species because they consist mostly of flat homogeneous areas lacking an environmental gradient along which a diversity of species with different habitats can coexist. The consistency of the productivity–biodiversity relationship among the 3 data sets we examined makes it possible to quantify the expected tree species richness that a forest stand is capable of sustaining, and a comparison between the actual species richness and the sustainable values can be useful in prioritizing conservation efforts.     

The data not collected on community forestry

Conservation and development practitioners increasingly promote community forestry as a way to conserve ecosystem services, consolidate resource rights, and reduce poverty. However, outcomes of community forestry have been mixed; many initiatives failed to achieve intended objectives. There is a rich literature on institutional arrangements of community forestry, but there has been little effort to examine the role of socioeconomic, market, and biophysical factors in shaping both land‐cover change dynamics and individual and collective livelihood outcomes. We systematically reviewed the peer‐reviewed literature on community forestry to examine and quantify existing knowledge gaps in the community‐forestry literature relative to these factors. In examining 697 cases of community forest management (CFM), extracted from 267 peer‐reviewed publications, we found 3 key trends that limit understanding of community forestry. First, we found substantial data gaps linking population dynamics, market forces, and biophysical characteristics to both environmental and livelihood outcomes. Second, most studies focused on environmental outcomes, and the majority of studies that assessed socioeconomic outcomes relied on qualitative data, making comparisons across cases difficult. Finally, there was a heavy bias toward studies on South Asian forests, indicating that the literature on community forestry may not be representative of decentralization policies and CFM globally.     

Revealing the impact of water conservancy projects and urbanization on hydrological cycle based on the distribution of hydrogen and oxygen isotopes in water

Environmental Science and Pollution Research - In recent years, the development and utilization of water resources have imposed great impacts on hydrological characteristics and ecological...