Biodegradation of high molecular weight PAHs using isolated yeast mixtures: application of meta-genomic methods for community structure analyses

Bioaugmentation for the removal of polyaromatic hydrocarbons (PAHs) from wastewater using bacteria and yeasts is considered environment-friendly and a cost-effective technique. The effectiveness of this biodegradation system depends on the stability of inoculated microorganisms and the availability of nutrients. This study is aimed to investigate the removal of high molecular weight (HMW)-PAHs from biologically treated produced water using different biological systems. Three systems, inoculated with activated sludge (AS), the mixture of five yeast strains (MY), and the mixture of AS and the five yeast strains (SY), respectively, were constructed, and their performance for the removal of HMW-PAHs was compared over 10 weeks. The effluent of the biologically treated produced water from an oilfield was used as the influent after chrysene and benzo(a)pyrene were spiked as HMW-PAHs. Polymerase chain reaction-based denaturing gradient gel electrophoresis (PCR-DGGE) and fluorescent in situ hybridization (FISH) techniques were used to examine the changes in the structures and abundances of the bacterial and yeast communities in these three systems. Only SY and MY systems were capable to remove chrysene (90.7 % and 98.5 %, respectively) and benzo(a)pyrene (80.7 % and 95.2 %, respectively). PCR-DGGE analysis confirmed that all of the five yeast strains inoculated remained in the SY and MY systems, while FISH results showed that the relative abundance of yeast in the SY and MY systems (10.6 % to 21.9 %, respectively) were significantly higher than AS system (2.3 % to 7.8 %, respectively). The relative abundances of the catechol 2,3-dioxygenase (C23O) indicated that the copy number ratios of benzene ring cleavage gene C23O in the yeast amended systems were much higher than that in the AS system. In this study, all of the three systems were effective in removing the low molecular weight (LMW)-PAHs, while HMW-PAHs including chrysene and benzo(a)pyrene were efficiently removed by MY and SY systems, not by AS system. The high HMW-PAHs removal in the MY and SY bioaugmentation systems possibly attributed to the inoculation of the mixed yeast culture. By combining the PCR-DGGE results with the FISH analyses, it was found that yeast probably consisting mainly of the five inoculated strains inhabited in the two bioaugmentation systems as a dominant population. The relatively higher performance of the SY system might be attributed to the suspended growth type which permitted a more efficient contact between microbial cells and contaminants. The bioaugmentation systems (SY and MY) were successfully established by inoculating with five nonindigenous yeast strains and demonstrated high performance in removal of HMW-PAHs.     

SRT对MBR污泥性质的影响

以浸没式膜-生物反应器(SMBR)处理模拟赖氨酸废水为研究体系,考察SRT在10、20和40 d条件下,SMBR中的胞外聚合物(EPS)组分和含量、污泥沉降性能和污泥相对疏水性等污泥性质的变化及其对膜污染的影响。结果表明,随着SRT的延长,混合液中EPS总量呈递减趋势,TBEPS中蛋白质与多糖的比值呈上升趋势,污泥的沉降性能变差,相对疏水性增强;膜通量下降速率变大,膜污染加重。污泥性质与膜污染的相关性表明,膜污染与蛋白质和多糖的比值、污泥沉降性能和相对疏水性呈正相关关系,而与EPS呈负相关关系。     

强化混凝工艺深度处理给水厂排泥废水

水厂废水的综合处理与回用是我国供水行业的新趋势和节水目标所在,采用强化混凝技术进行水厂排泥废水的深度处理。通过混凝剂筛选实验和有机物表征确定最佳混凝剂为高效聚合铝(HPAC),适宜投加量为650 mg/L。当混凝剂HPAC投加量为650 mg/L时,对COD、TOC、浊度和色度的去除率分别为82.5%、89.8%、95%和92.5%,相应的出水值分别为58 mg/L、8.46 mg/L、2.35 NTU、13度,COD满足《污水综合排放标准》(GB 8978-1996)的要求(COD≤100 mg/L),同时实验结果显示聚合氯化铝(PAC)、HPAC、三氯化铁(FeCl3)主要去除分子量处于>1 300 Da范围的有机物,对分子量处于744～1 300 Da之间的有机物去除有限。     

基于Monte-Carlo方法的静电除尘器除尘效率

针对经典除尘效率未考虑诸多随机因素影响的问题,提出了基于Monte-Carlo方法的效率分析模型,并通过实验数据验证其可靠性。通过该模型分析了粒径大小、电场气流速度、电晕电压、两极间距、粒子浓度等因素对收尘效率的影响规律,结果表明:基于Monte-Carlo方法的仿真结果精度更高,能有效预测静电除尘器的收尘效率,对于改进静电除尘器设计具有一定的理论意义和实用价值。     

高硬度富锶地下水的软化沉淀-超滤膜联用工艺

针对一种高硬度富锶地下水,分别采用石灰和石灰-碳酸钠两种方法,利用药剂软化/超滤膜工艺对其进行软化处理,同时考察了药剂投量对出水锶含量的影响。结果表明,采用石灰软化/超滤膜法,Ca(OH)2最佳投加量为270 mg/L时,出水总硬度(以CaCO3计)由287.12 mg/L降低到96.44 mg/L,硬度去除率为66.41%,出水锶含量也由原水中的0.37 mg/L下降为0.21 mg/L;而采用石灰-碳酸钠软化/超滤膜法,Ca(OH)2和Na2CO3最佳投加量分别为270 mg/L、160mg/L时,出水总硬度降低到60.34 mg/L,硬度去除率达78.98%,锶含量仅为0.02 mg/L。2种处理方法出水总硬度均达到预期目标,石灰软化/超滤膜法可使出水锶含量满足富锶水的要求,而石灰-碳酸钠软化/超滤膜法则造成了对人体有益微量元素锶的大量损失。     

基于PROMETHEEⅡ法的污染场地土壤修复技术筛选及应用

依据当前污染场地土壤修复技术特点以及场地特征,构建4层12指标21方案的污染土壤修复技术决策分析结构,运用多属性决策分析方法——PROMETHEEⅡ偏好排序法,对当前场地修复技术以及典型场地条件进行了客观分析和综合评价,实现基于具体修复目标的污染场地土壤修复技术择优筛选,并采用该方法对虚拟特定污染场地的土壤修复技术筛选进行了实例应用。这为污染场地的治理和修复提供了方法依据和理论参考。     

高效聚合氯化铝对超滤膜污染影响的中试研究

针对某水厂以超滤为核心的短流程水处理工艺,在通过聚氯乙烯(PVC)超滤膜之前选择不同投加量(5、10、15和20 mg/L)的高效聚合氯化铝(HPAC)对长江下游原水进行混凝处理。通过跨膜压差(TMP)增长趋势、CODMn的去除率以及混凝后的水质,可知HPAC的最优投加量为15 mg/L。在此投加量下,运用体积排阻色谱法分析原水、膜前水、膜后水中各相对分子质量有机物的变化,可以发现混凝去除有机物的效果要优于超滤截留的。继而将HPAC与另外4种常用混凝剂:硫酸铝(分析纯)、氯化铁(化学纯)、聚合氯化铝(PAC)、聚合硫酸铁进行对比,结果表明,在它们各自最优投加量下,HPAC能够更有效地减缓超滤膜TMP的增长率,从而降低膜污染。因此,认为HPAC是与PVC超滤合金膜契合效果最佳的混凝剂。     

有机酸土柱淋洗法修复重金属污染土壤

通过室内模拟实验,采用土柱淋洗方法,研究草酸、柠檬酸、乙酸和酒石酸溶液对某电镀厂附近土壤中重金属的去除效果。探讨了淋洗剂浓度、淋洗次数和淋洗时间等对淋洗效果的影响,研究草酸淋洗前后土壤中重金属形态的变化。结果表明,淋洗过程中铬的去除效果明显滞后于铜、锌和镍3种重金属离子。1 mol/L的草酸在土水比为1∶1,淋洗5h,淋洗4次的条件下可以达到最佳淋洗效果,Cu、Zn、Ni和Cr的去除率分别是99.6%、66.98%、88.7%和18.23%。     

人工浮床对汾江河水质净化的研究

对佛山市汾江河内布置浮床的水域的7个断面进行采样监测,分析了布置浮床侧与未布置浮床侧各水质指标的差异,以考察人工浮床对汾江河水质的净化效果。同时比较了圆币草、水罂粟、梭鱼草、狐尾草、美人蕉和鸢尾6种浮床植物的生物量和氮磷吸收量。结果表明,布置人工浮床一侧的水质TN、TP、COD和NH4＋-N含量均显著低于未布置浮床一侧的水质,表明人工浮床对水体水质的有净化效果。总面积约4 900 m2的浮床植物经过3个月的生长,从水体中共吸收了192.5 kg的氮和76.1 kg的磷。6种浮床植物中,狐尾草的净增生物量最高,达到64.2 kg/m2;圆币草次之,为62.2 kg/m2。狐尾草和圆币草对氮磷的吸收能力在6种植物中处于较高水平,每平方米狐尾草和圆币草从水体中分别吸收了51.61g氮、19.79 g磷和46.90 g氮、22.93 g磷。综合比较得出,狐尾草和圆币草在生物量和氮磷吸收量上均保持在较高水平,是较好的浮床植物。本研究为人工浮床在南方类似河流中的应用及植物选择提供了参考依据。     

清浊分流条件下的混凝-臭氧处理棉针织印染清废水

根据污染源头控制和废水回用的要求,对典型棉针织染整厂的不同生产过程废水排水水质特征进行了统计分析,提出了较实用的废水源头清浊分流方案。在此基础上重点研究了混凝-臭氧组合工艺对清废水处理效果,确定了最优的工艺条件。结果表明,清废水主要为洗水,占废水总量的25%～30%;混凝-臭氧组合工艺的最优工艺条件为：pH为6～9,PAC投加量为48 mg/L,PAM投加量为1.0 mg/L,臭氧接触时间为12 min（臭氧浓度为14.5 mg/L）,这时,清废水COD、色度去除率分别为71%和98%,实践证明,出水水质完全能够满足染整生产。