SGA对垃圾焚烧飞灰中重金属的固化性能研究

根据EPA1311、HJ／T299—2007、HJ／T300—2007和HJ557—2009等国内外不同标准,研究了深圳某垃圾焚烧发电厂垃圾焚烧飞灰的浸出毒性,探讨了六硫代胍基甲酸（sixthioguanidineacid,SGA）、二甲基二硫代氨基甲酸盐（sodiumdimethyldithiocarbamate,SDD）和Ca（OH）2浓度对垃圾焚烧飞灰中重金属的固定性能的影响。研究结果表明,随着浸提液pH的降低,该厂焚烧飞灰中大部分金属元素的浸出量增大,焚烧飞灰浸出液中的cd、Ni、Ph和zn浓度分别超过国家危险废物鉴别标准（GB5085．3—2007）规定值的4．75倍、1．47倍、6．72倍和2．20倍,属于危险废弃物,必须进行稳定化处理。当固化剂SGA加入量为0．1mol／kg时,稳定化后的重金属浸出浓度已经低于危险废物鉴别标准,且对Cd、Cr、Cu和Pb的固化性能优于SDD和Ca（OH）2;当固化剂SGA、SDD和Ca（OH）2加入量为0．5mol／kg时,稳定化后的焚烧飞灰重金属浸出浓度均低于国家危险废物鉴别标准（GB5085．3-2007）中的规定值。与SDD和Ca（OH）：相比,SGA对垃圾焚烧飞灰中重金属的固化处理更具有优势。     

HZ-16型大孔树脂吸附处理含RDT-8废水

采用HZ-16型大孔树脂对含三（三溴苯氧基）三嗪（RDT-8）废水进行吸附及脱附处理。实验结果表明：在废水流量为4.0 BV/h的条件下,树脂最佳吸附工艺条件为出水体积88.0 BV,此条件下出水COD小于291 mg/L,挥发酚质量浓度小于0.08 mg/L;在脱附液流量为0.5 BV/h的条件下,树脂最佳脱附工艺条件为脱附液体积3.0 BV,此条件下脱附液中挥发酚质量浓度为30.6 mg/L,挥发酚脱附率高达76.4%。在最佳吸附-脱附工艺条件下,连续进行10次动态吸附-脱附实验,吸附出水中COD为137~294 mg/L,COD去除率为72.5%~89.1%,挥发酚质量浓度稳定在0.05 mg/L以下,挥发酚去除率为99.8%~100%,说明HZ-16型大孔树脂的吸附-脱附性能稳定。     

粉煤灰的改性及对刚果红的吸附

分别采用沸水浸泡、酸浸、碱浸和加热的方法对粉煤灰进行改性处理,利用FTIR仪和XRD仪对改性粉煤灰的成分和官能团进行了分析,并利用改性粉煤灰对模拟刚果红废水进行脱色。实验结果表明：碱改性粉煤灰中含有大量官能团,以及NaPl型沸石类物质,能够明显提高粉煤灰对刚果红的吸附性能;与活性炭相比,碱改性粉煤灰具有更高的性价比;在初始刚果红质量浓度为20mg/L、碱改性粉煤灰加入量为50g/L的条件下,废水的脱色率可达87.52%;碱改性粉煤灰对刚果红的吸附过程遵循二级反应动力学,较好地符合Langmuir等温式和Freundlich等温式。     

Factors controlling phosphate interaction with iron oxides

Factors such as pH, solution ion composition, and the presence of natural organic matter (NOM) play a crucial role in the effectiveness of phosphorous adsorption by iron oxides. The interplay between these factors shows a complicated pattern and can sometimes lead to controversial results. With the help of mechanistic modeling and adsorption experiments, the net macroscopic effect of single and combined factors can be better understood and predicted. In the present work, the relative importance of the above-mentioned factors in the adsorption of phosphate was analyzed using modeling and comparison between the model prediction and experimental data. The results show that, under normal soil conditions, pH, concentration of Ca, and the presence of NOM are the most important factors that control adsorption of phosphate to iron oxides. The presence of Ca not only enhances the amount of phosphate adsorbed but also changes the pH dependency of the adsorption. An increase of dissolved organic carbon from 0.5 to 50 mg L can lead to a >50% decrease in the amount of phosphate adsorbed. Silicic acid may decrease phosphate adsorption, but this effect is only important at a very low phosphate concentration, in particular at high pH.     

无污泥持留序批式预处理反应器渗滤液预处理的正交试验研究

以黑石子垃圾填埋场渗滤液强化预处理-生物接触氧化为依托,针对其处理效果的局限性,研究无污泥持留序批式预处理(WSIP)反应器正交试验,旨在优化运行参数,提高低温期间渗滤液处理效果.实验表明,COD、NH 4-N、TN去除率较高,出水可生化性较好;优化碳氮质量比,为后续好氧微生物降解创造条件;曝气时间、HRT、进水磷浓度、序批周期对NH 4-N、TN去除效果影响显著;低温期间,获得较好出水水质的最佳运行参数为曝气时间9h、HRT4d、进水磷质量浓度50mg/L、序批周期6h.     

Co3O4/介孔分子筛催化剂对苯催化完全氧化的研究

分别以介孔分子筛MCM-41、MCM-48、SBA-15为载体,采用等体积浸渍法制备了氧化钴/介孔分子筛催化剂,利用N₂吸附、X射线衍射、程序升温还原等技术对催化剂进行了表征,考察了Co₃O₄的负载量及载体的孔结构对催化剂完全催化氧化苯的性能的影响。结果表明,Co₃O₄的负载量为20%时,催化剂的催化活性最好;载体的孔径和催化剂的可还原性能是影响催化活性的主要因素,催化剂活性顺序为Co₃O₄ /SBA-15> Co₃O₄ /MCM41> Co₃O₄ /MCM-48。     

生物接触氧化处理渗滤液有机物的动力学模型研究

以重庆黑石子垃圾填埋场渗滤液生物接触氧化工艺为依托,针对其处理效果的局限性,设计了强化预处理-生物接触氧化反应器,并进行生物接触氧化反应器试验及其有机物降解动力学模型研究,旨在优化运行参数,提高渗滤液处理效果.结果表明,改进后系统比原工艺处理效果好,COD、NH4 -N、TN平均去除率分别达到95.83%、97.60%、85.60%;出水水质得到大幅度提高,出水COD、NH4 -N、TN平均质量浓度分别为235、35、199 mg/L.对生物接触氧化反应器内垃圾渗滤液有机物降解生化反应过程进行量化研究,得到微生物生长动力学模型为1/θc=0.918 7q-0.002 5;根据生物接触氧化反应器内基质消耗过程的物料平衡,得到生物接触氧化反应器处理垃圾渗滤液有机物生物降解的动力学模型为q=1.09S/(10 230 S).试验结果为生物接触氧化反应器的优化控制、设计与放大提供了参考依据.     

Seasonal variation on size distribution and concentration of PAHs in Guangzhou city, China

Size distribution aerosol samples were collected at an urban location of Guangzhou in four seasons of 2003-2004 by a MOUDI (Micro-orifice Uniform Deposit Impactor). The particle loading (PM10: 80-397 microg m(-3)) was comparable with some other Asia cities; however, much higher than that of Western Europe and North America. Polycyclic aromatic hydrocarbons (PAHs) were measured by gas chromatography with mass selective detector (GC-MS). Seasonal effects on the size distribution of PAHs are presented. Bimode (accumulation and coarse mode) and unimode (accumulation mode) distributions were observed for low-molecule-weight and high-molecule-weight PAHs. A slight shift to larger particles was found for the accumulation mode in autumn and winter, compared with that of spring and summer. One explanation is that the longer aging process of PAHs in autumn and winter would result in volatilization from finer particles followed by condensation onto coarser particles. Another is there was mixing process of local emission with long-range transported aerosol in autumn and winter. The relative higher value of IcdP/(BghiP+IcdP) and lower value of BghiP/BeP in winter also give evidences to the mixing process. The level of PAHs concentration has been much elevated in recent years. This can be attributed to the fast growth of motor vehicle and energy consumption.     

The ageing effect on the bioaccessibility and fractionation of arsenic in soils from China

Ingestion of contaminated soil has been recognized as an important exposure pathway of arsenic for humans, especially for children through outdoor hand-to-mouth activities. An improved sequential extraction procedure was employed in an attempt to reveal the relationship between bioaccessibility and fractionation of As in five soils from China. Arsenic bioaccessibility in acidic ( approximately pH 4.5) soils reached approximately stable levels after a sharp decline within one week of ageing. In contrast, As bioaccessibility in higher pH (>6.0) soils was found to be significantly higher and took two weeks of ageing to reach stable levels. The artificially added As was more labile than indigenous As. The main proportions of added As were found in the specifically sorbed and amorphous and poorly-crystalline hydrous Fe/Al oxide-bound fractions. Correlation analysis shows that the non-specifically and specifically sorbed As are likely to constitute the main proportion of bioaccessible soil As. The soil content of amorphous and crystalline Fe/Al oxides and soil pH appear to be the key factors controlling, not only the time needed to reach a steady state, but also the magnitude of the bioaccessibility of As added to the soils.     

Source apportionment of polycyclic aromatic hydrocarbons in surface soil in Tianjin, China

Principal component analysis and multiple linear regression were applied to apportion sources of polycyclic aromatic hydrocarbons (PAHs) in surface soils of Tianjin, China based on the measured PAH concentrations of 188 surface soil samples. Four principal components were identified representing coal combustion, petroleum, coke oven plus biomass burning, and chemical industry discharge, respectively. The contributions of major sources were quantified as 41% from coal, 20% from petroleum, and 39% from coking and biomass, which are compatible with PAH emissions estimated based on fuel consumption and emission factors. When the study area was divided into three zones with distinctive differences in soil PAH concentration and profile, different source features were unveiled. For the industrialized Tanggu-Hangu zone, the major contributors were cooking (43%), coal (37%) and vehicle exhaust (20%). In rural area, however, in addition to the three main sources, biomass burning was also important (13%). In urban-suburban zone, incineration accounted for one fourth of the total.