Investigations of chemical fraction of Co and Ni in industrial fly ash and mobility of metals in environmental conditions

The quantitative evaluation of chemical fraction of Co and Ni in the industrial fly ash by methods of five step sequential extraction was carried out in order to characterize metal mobility in environmental conditions. The research involved (i) water-soluble (pH=7), (ii) acid-soluble (pH=5), (iii) oxide, (iv) sulfide and (v) residue metal fractions. It was discovered, that the total extraction of the studied metals from fly ash to solutions take place in the following quantities Co - 35.5 and Ni - 153.0mgkg(-1). The investigations of chemical fractions proved that the subject metals occur mainly in fly ash as: oxide (Co - 7.0, Ni - 28.5mgkg(-1)) and residue (Co - 11.5, Ni - 42.5mgkg(-1)) as well as sulfide (Co - 8.5, Ni - 46.5mgkg(-1)). Low concentrations of metals for water-soluble fraction (Co - 0.7, Ni - 1.2mgkg(-1)) and acid-soluble fraction (Co - 4.5, Ni - 23.5mgkg(-1)) were observed. The fractions of Co and Ni leachable from the ash in environmental conditions contain: 24.0% (Co) and 23.3% (Ni) of metal total amount in the industrial fly ash. The obtained mobility parameter of Co and Ni can be applied to estimate the concentration increase of mobile and hardly mobile forms of these metals in soil polluted with the ash.     

POPs in the Lagoon of Venice: budgets and pathways

Dioxins and furans (PCDD/Fs), polychlorobiphenyls (PCBs) and hexachlorobenzene (HCB) in the ecosystem of the Lagoon of Venice were studied, in order to provide a general picture of conditions in the lagoon in terms of contamination by persistent organic pollutants (POPs). We present here novel data on atmospheric deposition, water, sediment and clam samples collected in the lagoon during the period January 2001-December 2004. Atmospheric deposition was sampled monthly at six sites located both close and far from large industrial and urban sources. Water samples were collected monthly from fifteen stations, and twenty-five samples of sediments and clams (Tapes philippinarum) were collected in four areas where clams are farmed and harvested inside the lagoon. All samples were analysed for PCDD/Fs, PCBs and HCB by HRGC/HRMS in the same laboratory. All samples examined (atmospheric deposition and water) substantially confirmed the spatial pattern reported in previously published data on sediments and atmospheric deposition: the zone surrounding the Porto Marghera petrochemical plant always had the highest levels of POPs (i.e., PCDD/Fs: atmosphere approximately 6 pg of 2,3,7,8-TCDD equivalents (I-TE) m(-2)d(-1); water 0.37 pg I-TEl(-1); sediment: 300 ng kg(-1); clam 2.8 pg I-TE g(-1)), and the minima were found at points on the margins of the lagoon (PCDD/Fs: atmosphere approximately 1 pg I-TEm(-2)d(-1); water 0.05 pg I-TEl(-1); sediment: approximately 5 ng kg(-1); clam approximately 0.2 pg I-TE g(-1)). Intermediate values were often encountered in the historical city centre of Venice and in the central part of the lagoon. To confirm this, new data on correlation between levels of PCDD/F in sediments and clams are reported, both for absolute values and for the PCDD/F "fingerprint". There is always a clear fingerprinting signature (PCDF/PCDD>1) for samples collected near Porto Marghera, and the opposite (PCDF/PCDD<1) in the rest of the lagoon.     

Lichen and moss bags as monitoring devices in urban areas. Part II: trace element content in living and dead biomonitors and comparison with synthetic materials

Lobes of the lichen Pseudevernia furfuracea (L.) Zopf and shoots of the moss Hypnum cupressiforme Hedw. were subjected to different treatments (water washing, oven drying, HNO3 washing, NH4-oxalate extraction) to assess the influence of vitality on accumulation efficiency, during a 6-week exposure in bags in two Italian cities, Trieste and Naples. No trend emerged between treatments, in terms of accumulation ability, for major and trace elements. Only water-washed lichens showed an increased C and N content after exposure in both cities. Element concentrations generally reached higher values in mosses than in lichens, especially for Al, Fe, and Zn (both cities), and for Cu, Mg and Na (Naples). Surface development strongly influenced accumulation capacity of the biomonitors. Quartzose and cation exchange filters revealed, on a weight basis, a poor performance. In urban environments, surface interception of atmospheric particulate seems to play a major role in accumulation, irrespective of organism vitality.     

A biomimetic absorbent for removal of trace level persistent organic pollutants from water

A novel biomimetic absorbent containing the lipid triolein was developed for removing persistent organic pollutants (POPs) from water. The structural characteristics of the absorbent were obtained by SEM and a photoluminescence method. Under optimum preparation conditions, triolein was perfectly embedded in the cellulose acetate (CA) spheres, the absorbent was stable and no triolein leaked into the water. Dieldrin, endrin, aldrin and heptachlor epoxide were effectively removed by the CA--triolein absorbent in laboratory batch experiments. This suggests that CA-triolein absorbent may serve as a good absorbent for those selected POPs. Triolein in the absorbent significantly increased the absorption capacity, and lower residual concentrations of POPs were achieved when compared to the use of cellulose acetate absorbent. The absorption rate for lipophilic pollutants was very fast and exhibited some relationship with the octanol--water partition coefficient of the analyte. The absorption mechanism is discussed in detail.     

Determination of selected quaternary ammonium compounds by liquid chromatography with mass spectrometry. Part I. Application to surface, waste and indirect discharge water samples in Austria

A method for simultaneous quantitative determination of alkyl benzyl, dialkyl and trialkyl quaternary ammonium compounds (QACs) has been developed, validated and subsequently applied to real water samples in Austria. The method employs liquid-liquid extraction (LLE) followed by liquid chromatography/tandem mass spectrometry (LC-MS/MS), using electrospray ionization (ESI) in positive mode. The overall method quantification limits range from 4 to 19ng/L for the enrichment of 500mL water samples and analyte recoveries are between 80 and 99%. The method was applied to 62 of the respective water samples without filtration to avoid the loss of the analytes due to the high adsorption capacity of these compounds. Maxima in the mg/L range, especially in the wastewater of hospitals and laundries, could be detected for the selected target compounds.     

Photoelectrocatalytic degradation of pentachlorophenol in aqueous solution using a TiO2 nanotube film electrode

Titanium dioxide (TiO2) nanotube film electrodes are fabricated by the anodic oxidation method. Scanning electron microscopy (SEM) showed that these tubes were well aligned and organized into high-density uniform arrays. XRD analysis showed the TiO2 nanotubes to be in the anatase crystal form. The TiO2 nanotube film electrode exhibited increased photoelectrocatalytic (PEC) capability compared to a traditional TiO2 film electrode fabricated using the anodizing method for pentachlorophenol (PCP) degradation in aqueous solution. The bias potential, pH value, and electrolyte concentration were shown to be important factors influencing the degradation of PCP by the PEC method using the TiO2 nanotube film electrode as the working electrode.     

Generalized models for prediction of pentachlorophenol dissipation dynamics in soils

Dissipation of pentachlorophenol (PCP) in soil was investigated and the chemical relationships with soil properties were addressed. The results indicate that the dissipation of extractable PCP residues can be described using first-order kinetics equations, with a half-dissipation time (T(1/2)) ranging from 6.5 to 173.3d. The sharply different patterns of PCP dissipation in different soils were closely related to soil properties. Correlations of stepwise regression equations obtained were significant at 0.01 probability level between soil parameters and extractable PCP residues (R(2)=0.974**) as well as T(1/2) values (R(2)=0.882**). Using pH together with organic carbon content (OC) and soil particle size distribution, the dissipation dynamics of PCP in soil could be accurately predicted.     

Vegetable and synthetic tannins induce hormesis/toxicity in sea urchin early development and in algal growth

Mimosa tannin and phenol-based synthetic tannin (syntan) were tested for toxicity to sea urchin (Paracentrotus lividus and Sphaerechinus granularis) early development and to marine algal growth (Dunaliella tertiolecta). Sea urchin embryogenesis was affected by vegetable tannin and syntan water extracts (VTWE and STWE) at levels >or=1mg/L. Developmental defects were significantly decreased at VTWE and STWE levels of 0.1 and 0.3mg/L when control cultures displayed suboptimal quality, i.e. <70% "viable" (normal or retarded) larvae. Fertilization success of sea urchin sperm was increased up to 0.3 mg/L STWE or VTWE, then was inhibited by increasing tannin levels (1-30 mg/L). Offspring abnormalities, following sperm exposure to VTWE or STWE, showed the same shift from hormesis to toxicity. Cell growth bioassays in D. tertiolecta exposed to VTWE or STWE (0.1-30 mg/L) showed non-linear concentration-related toxicity. Novel criteria are suggested in defining control quality that should reveal hormetic effects.     

Prokaryotic life in a potash-polluted marsh with emphasis on N-metabolizing microorganisms

Prokaryotic life along the salt gradient of the potash marsh resulting from mining waste at Schreyahn, Northern Germany, was screened for the distribution of total prokaryote (assessed by the 16S rRNA gene) and of N2-fixing (nifH gene), denitrifying (nosZ) and nitrifying (amoA) microorganisms. Information on prokaryotes was retrieved from the different soil sites (a) by culturing in conventional media, (b) by isolating the DNA, amplifying the target genes by PCR followed by sequencing, (c) by employing the recently developed computer program (TReFID [R?sch, C., Bothe, H., 2005. Improved assessment of denitrifying, N2-fixing, and total-community bacteria by terminal restriction fragment length polymorphism analysis using multiple restriction enzymes. Applied and Environmental Microbiology 71, 2026-2035]) based on tRFLP data. New sequences were obtained as well as ones that were almost identical to those found at far distant locations. Whereas the distribution of plants strictly follows the salt gradient, this is apparently not the case with prokaryotes. Bacteria of hypersaline areas coexist with salt-non-tolerant species. The recently developed TReFID program is successfully applied to characterize a prokaryote community structure.     

Exemplifying whole-plant ozone uptake in adult forest trees of contrasting species and site conditions

Whole-tree O3 uptake was exemplified for Picea abies, Fagus sylvatica and Larix decidua in stands at high and low altitude and contrasting water availability through sap flow measurement in tree trunks, intrinsically accounting for drought and boundary layer effects on O3 flux. O3 uptake of evergreen spruce per unit foliage area was enhanced by 100% at high relative to low elevation, whereas deciduous beech and larch showed similar uptake regardless of altitude. The responsiveness of the canopy conductance to water vapor and, as a consequence, O3 uptake to soil moisture and air humidity did not differ between species. Unifying findings at the whole-tree level will promote cause-effect based O3 risk assessment and modeling.