A batch study on the bio-fixation of carbon dioxide in the absorbed solution from a chemical wet scrubber by hot spring and marine algae

Carbon dioxide mass transfer is a key factor in cultivating micro-algae except for the light limitation of photosynthesis. It is a novel idea to enhance mass transfer with the cyclic procedure of absorbing CO(2) with a high performance alkaline abosorber such as a packed tower and regenerating the alkaline solution with algal photosynthesis. Hence, the algae with high affinity for alkaline condition must be purified. In this study, a hot spring alga (HSA) was purified from an alkaline hot spring (pH 9.3, 62 degrees C) in Taiwan and grows well over pH 11.5 and 50 degrees C. For performance of HSA, CO(2) removal efficiencies in the packed tower increase about 5-fold in a suitable growth condition compared to that without adding any potassium hydroxide. But ammonia solution was not a good choice for this system with regard to carbon dioxide removal efficiency because of its toxicity on HSA. In addition, HSA also exhibits a high growth rate under the controlled pHs from 7 to 11. Besides, a well mass balance of carbon and nitrogen made sure that less other byproducts formed in the procedure of carboxylation. For analysis of some metals in HSA, such as Mg, Mn, Fe, Zn, related to the photosynthesis increased by a rising cultivated pH and revealed that those metals might be accumulated under alkaline conditions but the growth rate was still limited by the ratio of bicarbonate (useful carbon source) and carbonate. Meanwhile, Nannochlopsis oculta (NAO) was also tested under different additional carbon sources. The results revealed that solutions of sodium/potassium carbonate are better carbon sources than ammonia carbonate/bicarbonate for the growth of NAO. However, pH 9.6 of growth limitation based on sodium was lower than one of HSA. The integrated system is, therefore, more feasible to treat CO(2) in the flue gases using the algae with higher alkaline affinity such as HSA in small volume bioreactors.     

A field trial for an ex-situ bioremediation of a drilling mud-polluted site

The remediation of drilling mud-polluted sites in the Southeast of Mexico is a top priority for Mexican oil industry. The objective of this work was to find a technology to remediate these sites. A field trial was performed by composting in biopiles, where four 1ton soil-biopiles were established, one treatment in triplicate and one unamended biopile. Amended biopiles were added with nutrients to get a C/N/P ratio of 100/3/0.5 plus a bulking agent (straw) at a soil/straw ratio of 97/3. Moisture content was maintained around 30-35%. Results showed that, after 180 d, total petroleum hydrocarbon (TPH) concentrations decreased from 99300+/-23000mgTPHkg(-1) soil to 5500+/-770mgTPHkg(-1) for amended biopiles and to 22900+/-7800mgTPHkg(-1) for unamended biopile. An undisturbed soil control showed no change in TPH concentrations. Gas chromatographic analysis showed residual alkyl dibenzothiophene type compounds. Highest bacterial counts were observed during the first 30 d which correlated with highest TPH removal, whereas fungal count increased at the end of the experimentation period. Results suggested an important role of the straw, nutrient addition and water content in stimulating aerobic microbial activity and thus hydrocarbon removal. This finding opens an opportunity to remediate old polluted sites with recalcitrant and high TPH concentration.     

Investigation of a new approach to decompose two potent greenhouse gases: photoreduction of SF(6) and SF(5)CF(3) in the presence of acetone

In this paper, we addressed the utilization of photochemical method as an innovative technology for the destruction and removal of two potent greenhouse gases, SF(6) and SF(5)CF(3). The destruction and removal efficiency (DRE) of the process was determined as a function of excitation wavelength, irradiation time, initial ratio of acetone to SF(5)X (X represented F or CF(3)), initial SF(5)X concentration, additive oxygen and water vapor concentration. A complete removal was achieved by a radiation period of 55min and 120min for SF(6)-CH(3)COCH(3) system and SF(5)CF(3)-CH(3)COCH(3) system respectively under 184.9nm irradiation. Extra addition of water vapor can enhance DRE by approximately 6% points in both systems. Further studies with GC/MS and FT-IR proved that no hazardous products such as S(2)F(10), SO(2)F(2), SOF(2), SOF(4) were generated in this process.     

Oxidation of trichloroethene over metal oxide catalysts: kinetic studies and correlation with adsorption properties

The performance of bulk chromium oxide is compared with that of a Mn commercial catalyst for the deep oxidation of trichloroethene (1000-2500ppmv, 55h(-1) space velocity) in air, in dry and wet (20000ppm of H(2)O) conditions, in terms of activity, selectivity and stability. Chromium oxide was found to be more active (on a catalyst weight basis), however its activity decreases continuously with time on stream. The presence of water increases its stability, the Mn catalyst showing the opposite behaviour. The effect of water on the Cr catalyst can be explained according to the Deacon equilibrium, as the presence of water tends to decrease the Cl(2) concentration, assumed to be responsible of the catalyst deactivation. Regarding to the selectivity, the Mn catalyst yields C(2)Cl(4), CCl(4) and CHCl(3) as organochlorinated by-products, whereas chromium oxide produces only trace amounts of CCl(4). Simple power-law kinetics expressions (first-order for Mn and zero-order for Cr) provide fairly good fits for the evolution of the conversion with the temperature. Furthermore, the kinetic behaviour of chromium oxide can be represented with a Langmuir-Hinshelwood model taking into account the chlorine inhibitory effect.     

Effect of amorphous silica and silica sand on removal of chromium(VI) by zero-valent iron

The effect of two surfaces (amorphous silica and silica sand) on the reduction of chromium(VI) by zero-valent iron (Fe(0)) was investigated using batch reactors. The amendment of both surfaces significantly increased the rate and extent of Cr(VI) removal. The rate enhancement by amended surfaces is presumed to result from scavenging of Fe(0)-Cr(VI) reaction products by the provided surfaces, which minimized surface deactivation of Fe(0). The rate enhancing effect was greater for silica compared to sand, and the difference is attributed to silica's higher surface area, greater affinity for reaction products and pH buffering effect. For a given mass of Fe(0), the reactivity and longevity of Fe(0) to treat Cr(VI) increased with increasing dose of silica. Elemental analyses of the reacted iron and silica revealed that chromium removed from the solution was associated with both surfaces, with its mass distribution being approximately 1:1 per mass of iron and silica. The overall result suggests reductive precipitation was a predominant Cr(VI) removal pathway, which involves initial reduction of Cr(VI) to Cr(III), followed by formation of Cr(III)/Fe(III) hydroxides precipitates.     

Comparison of calculated and measured foliar O3 flux in crop and forest species

We designed a new gas exchange system that concurrently measures foliar H2O, O3, and CO2 flux (HOC flux system) while delivering known O3 concentrations. Stomatal responses of three species were tested: snapbean, and seedlings of California black oak (deciduous broadleaf) and blue oak (evergreen broadleaf). Acute O3 exposure (120-250 ppb over an hour) was applied under moderate light and low vapor pressure deficits during near steady state conditions. The rate of stomatal closure was measured when the whole plant was placed in the dark. An adjacent leaf on each plant was also concurrently measured in an O3-free cuvette. Under some conditions, direct measurements and calculated foliar O3 flux were within the same order of magnitude; however, endogenously low gs or O3 exposure-induced depression of gs resulted in an overestimation of calculated O3 fluxes compared with measured O3 fluxes. Sluggish stomata in response to light extinction with concurrent O3 exposure, and incomplete stomatal closure likewise underestimated measured O3 flux.     

Toxic fluoride and arsenic contaminated groundwater in the Lahore and Kasur districts, Punjab, Pakistan and possible contaminant sources

The present study is the first attempt to put forward possible sources of As, F- and SO4(2-) contaminated groundwater in the Kalalanwala area, Punjab, Pakistan. Five rainwater and 24 groundwater samples from three different depths were analyzed. Shallow groundwater from 24 to 27 m depth contained high F- (2.47-21.1mg/L), while the groundwater samples from the deeper depth were free from fluoride contamination. All groundwater samples contained high As (32-1900 microg/L), in excess of WHO drinking water standards. The SO4(2-) ranges from 110 to 1550 mg/L. Delta34S data indicate three sources for SO4(2-) air pollutants (5.5-5.7 per thousand), fertilizers (4.8 per thousand), and household waste (7.0 per thousand). Our important finding is the presence of SO4(2-), As and F- in rainwater, indicating the contribution of these elements from air pollution. We propose that pollutants originate, in part, from coal combusted at brick factories and were mobilized promotionally by the alkaline nature of the local groundwater.     

Gravitational infusion of ethylenediurea (EDU) into trunks protected adult European ash trees (Fraxinus excelsior L.) from foliar ozone injury

Adult ash trees (Fraxinus excelsior L.), known to be sensitive or insensitive to ozone, determined by presence or absence of foliar symptoms in previous years, were treated with ethylenediurea (EDU) at 450 ppm by gravitational trunk infusion on six occasions at 21-day intervals in summer 2005 at Turin, Italy. At the end of the season, foliar ozone injury on EDU-treated trees was not complete, but was greatly and significantly reduced when compared to results from trees infused with water. Significant symptom reduction occurred at any crown level in the treated trees suggesting that EDU protected whole crowns. Gravitational infusion of EDU resulted in protection from ozone injury for ozone-sensitive ash trees. The amount of EDU needed to provide protection is assumed to be in the range 13-26 mg m(-2) leaf.     

The impact of UV-B and sulphur- or copper-containing solutions in acidic conditions on chlorophyll fluorescence in selected Ramalina species

Ramalina maciformis and Ramalina lacera were exposed to different solutions and UV-B to seek for alterations in the PSII photosynthetic quantum yield (F(v)/F(m)), in response to chemicals and radiation. For R. maciformis, significant alterations of the F(v)/F(m) ratio occurred only in response to different bisulphite solutions. The F(v)/F(m) ratio decreased most in R. maciformis and R. lacera following exposure to 5 and 1 mM bisulphite, respectively. Significant differences in F(v)/F(m) ratios were observed for R. lacera in response to different solutions and light at different wavelengths, this being synergistic. The PSII system was unaffected by simulated acid rain in both lichens. R. maciformis, in particular, may survive limited acid rain exposure owing to high Ca oxalate accumulation. The F(v)/F(m) ratio decreased most in R. lacera following short-term exposures to CuSO(4), suggesting that this species is more sensitive to Cu ions under acidic conditions.