Reducing ammonia emissions from laying-hen houses through dietary manipulation

Feed additives can change the microbiological environment of the animal digestive track, nutrient composition of feces, and its gaseous emissions. This 2-yr field study involving commercial laying-hen houses in central Iowa was conducted to assess the effects of feeding diets containing EcoCal and corn-dried distillers grain with solubles (DDGS) on ammonia (NH3), hydrogen sulfide (H2S), and greenhouse gas (CO2, CH4, and N2O) emissions. Three high-rise layer houses (256,600 W-36 hens per house) received standard industry diet (Control), a diet containing 7% EcoCal (EcoCal) or a diet containing 10% DDGS (DDGS). Gaseous emissions were continuously monitored during the period of December 2007 to December 2009, covering the full production cycle. The 24-month test results revealed that mean NH3 emission rates were 0.58 +/- 0.05, 0.82 +/- 0.04, and 0.96 +/- 0.05 g/hen/day for the EcoCal, DDGS, and Control diet, respectively. Namely, compared to the Control diet, the EcoCal and DDGS diets reduced NH3 emission by an average of 39.2% and 14.3%, respectively. The concurrent H2S emission rates were 5.39 +/- 0.46, 1.91 +/- 0.13, and 1.79 +/- 0.16 mg/ hen/day for the EcoCal, DDGS, and Control diet, respectively. CO2 emission rates were similar for the three diets, 87.3 +/- 1.37, 87.4 +/- 1.26, and 89.6 +/- 1.6 g/hen/day for EcoCal, DDGS, and Control, respectively (P = 0.45). The DDGS and EcoCal houses tended to emit less CH4 than the Control house (0.16 and 0.12 vs. 0.20 g/hen/day) during the monitored summer season. The efficacy of NH3 emission reduction by the EcoCal diet decreased with increasing outside temperature, varying from 72.2% in February 2009 to -7.10% in September 2008. Manure of the EcoCal diet contained 68% higher ammonia nitrogen (NH3-N) and 4.7 times higher sulfur content than that of the Control diet. Manure pH values were 8.0, 8.9, and 9.3 for EcoCal, DDGS, and Control diets, respectively. This extensive field study verifies that dietary manipulation provides a viable means to reduce NH3 emissions from modern laying-hen houses.     

The effects of manganese precursors on Mn-based/TiO2 catalysts for catalytic reduction of NO with NH3

Manganese acetate (MnAc) and manganese nitrate (MnN) were employed as precursors for the preparation of MnAc)/TiO2, Mn (N)/TiO2, Mn(Ac)-Ce/TiO2, and Mn(N)-Ce/TiO2 by impregnation. These complexes were used as catalysts in the low-temperature selective catalytic reduction of NO with NH3. The influence of manganese precursors on catalyst characteristics, the reduction activity, and the stability of the catalysts to poisoning by H2O and SO2 were studied. Experiments showed that Mn(N) produced MnO2 with large grain sizes in Mn(N)/TiO2 catalyst. On the contrary, Mn(Ac) led to highly dispersed and amorphous Mn2O3 in Mn (Ac)/TiO2 catalyst, which had better catalytic activity and stability to SO2 at low temperatures. The doping of cerium reduced the differences in catalytic performance between the catalysts derived from different Mn precursors.     

Optimization of circular plate separators with cross flow for removal of oil droplets and solid particles

A circular gravity-phase separator using coalescing medium with cross flow was developed to remove oil and suspended solids from wastewaters. Coalescence medium in the form of inclined plates promotes rising of oil droplets through coalescence and settling of solid particles through coagulation. It exhibits 22.67% higher removal of total suspended solids (TSS) compared to separators without coalescing medium. Moreover, it removed more than 70% of oil compared to conventional American Petroleum Institute separators, which exhibit an average of 33% oil removal. The flowrate required to attain an effluent oil concentration of 10 mg/L (Q(o10)) at different influent oil concentrations (C(io)) can be represented by Q(o10) x 10(-5) = -0.0012C(io) + 0.352. The flowrate required to attain an effluent TSS concentration of 50 mg/L (Q(ss50)) at different influent TSS concentrations (C(iss)) can be represented by Q(ss50) x 10(-5) = 1.0 x 10(6) C(iss)(-2.9576). The smallest removable solid particle size was 4.87 microm.     

Development of regenerative dye impregnated mesoporous silica materials for assessing exposure to ammonia

The mesostructured materials MCM-41 and SBA-15 were studied as possible supports of bromocresol green (BG) dye impregnation for the ammonia gas detection because of their large surface area, high regenerative property, and high thermal stability. X-ray diffraction, transmission electron microscopy, scanning electron microscope, and N2 adsorption analysis were used to characterize the prepared materials. These materials could sense ammonia via visible color change from yellowish-orange to blue color. The color change process of the nanostructured materials was fully reversible during 10 cyclic tests. The results indicated that the ammonia absorption responses of the two nanostructured materials were both very sensitive, and high linear correlation and high precision were achieved. As the gaseous ammonia concentrations were 50 and 5 ppmv, the response times for the SBA-15/BG were only 1 and 5 min, respectively. Moreover the BG dye-impregnated SBA-15 was less affected by the variation in the relative humidity. It also had faster response for the detection of NH3, as well as lower manufacturing price as compared to that of the dye-impregnated MCM-41. Such feature enables SBA-15/BG to be a very promising material for the detection of ammonia gas.     

Contribution of sociodemographic characteristics, occupation, diet and lifestyle to DDT and DDE concentrations in serum and adipose tissue from a Bolivian cohort

The organochlorine pesticide p,p′-Dichlorodiphenyltrichloroethane (DDT) was widely used in the early 1960s-70s for vector control in tropical and subtropical areas of South America. Due to its persistence, DDT has a high potential to bioaccumulate in the food chain and living organisms and is a major public health concern, especially in South America.The main purpose of the present study was to investigate predictors of serum and adipose tissue concentrations of p,p′-DDT and its main metabolite, p,p′-dichlorodiphenyldichloroethylene (p,p′-DDE), in an adult cohort (n = 112) from Santa Cruz de la Sierra, Bolivia, using multiple linear regression models. These models explained 29.3-47.8% of the variability in adipose tissue concentrations of p,p′-DDT and p,p′-DDE, respectively, and 32.9-47.0% of that in serum. Main exposure predictors included age, occupational class, residence, diet, smoking habit, and accumulated breastfeeding time.This is one of the few studies to explore predictors of human exposure to these chemicals using a multivariate approach in a South American population. Results show that predictors of human exposure to p,p′-DDT and p,p′-DDE in Santa Cruz de la Sierra may diverge from those found in other populations of the world, due to particular sociodemographic and lifestyle characteristics of this region.     

Transport and retention of fullerene nanoparticles in natural soils

Commercial production and use of fullerene (C60) nanomaterials will inevitably lead to their release into the environment, where knowledge of C60 fate and transport is limited. In this study, a series of one-dimensional column experiments was conducted to assess the transport and retention of nanoscale fullerene aggregates (nC60) in water-saturated soils. Under the experimental conditions, complete retention of nC60 was observed in columns (2.5 cm inside diameter x 11 cm length) packed with Appling or Webster soil, which contain 0.75 and 3.33% organic carbon by weight, respectively. When the volume of aqueous nC60 suspension (approximately 4.5 mg L(-1)) applied to Appling soil was increased from 5 to 65 pore volumes, the travel distance increased from 3 to 8 cm, and the retention capacity approached a limiting value of 130 microg g(-1), although nC60 was not detected in the column effluent. The addition of 20 mg C L(-1) Suwannee River humic acid to the influent suspension increased the nC60 transport in Appling soil but did not resul in breakthrough. Attempts to simulate the experimental data using clean-bed filtration theory were not satisfactory, yielding retention profiles that failed to match observed data. Subsequent incorporation of a limiting retention capacity expression into the mathematical model resulted in accurate predictions of the measured nC60 retention profiles and transport behavior. The sizable retention capacities observed in this study suggest that transport of nC60 is limited in relatively fine-textured soils containing appreciable amounts of clay minerals and organic matter, with substantial accumulation of nC60 aggregates near the point of release.     

Perennial filter strips reduce nitrate levels in soil and shallow groundwater after grassland-to-cropland conversion

Many croplands planted to perennial grasses under the Conservation Reserve Program are being returned to crop production, and with potential consequences for water quality. The objective of this study was to quantify the impact of grassland-to-cropland conversion on nitrate-nitrogen (NO3-N) concentrations in soil and shallow groundwater and to assess the potential for perennial filter strips (PFS) to mitigate increases in NO3-N levels. The study, conducted at the Neal Smith National Wildlife Refuge (NSNWR) in central Iowa, consisted of a balanced incomplete block design with 12 watersheds and four watershed-scale treatments having different proportions and topographic positions of PFS planted in native prairie grasses: 100% rowcrop, 10% PFS (toeslope position), 10% PFS (distributed on toe and as contour strips), and 20 PFS (distributed on toe and as contour strips). All treatments were established in fall 2006 on watersheds that were under bromegrass (Bromus L.) cover for at least 10 yr. Nonperennial areas were maintained under a no-till 2-yr corn (Zea mays L.)--soybean [Glycine max. (L.) Merr.] rotation since spring 2007. Suction lysimeter and shallow groundwater wells located at upslope and toeslope positions were sampled monthly during the growing season to determine NO3-N concentration from 2005 to 2008. The results indicated significant increases in NO3-N concentration in soil and groundwater following grassland-to-cropland conversion. Nitrate-nitrogen levels in the vadose zone and groundwater under PFS were lower compared with 100% cropland, with the most significant differences occurring at the toeslope position. During the years following conversion, PFS mitigated increases in subsurface nitrate, but long-term monitoring is needed to observe and understand the full response to land-use conversion.     

A Generic Bio-Economic Farm Model for Environmental and Economic Assessment of Agricultural Systems

Bio-economic farm models are tools to evaluate ex-post or to assess ex-ante the impact of policy and technology change on agriculture, economics and environment. Recently, various BEFMs have been developed, often for one purpose or location, but hardly any of these models are re-used later for other purposes or locations. The Farm System Simulator (FSSIM) provides a generic framework enabling the application of BEFMs under various situations and for different purposes (generating supply response functions and detailed regional or farm type assessments). FSSIM is set up as a component-based framework with components representing farmer objectives, risk, calibration, policies, current activities, alternative activities and different types of activities (e.g., annual and perennial cropping and livestock). The generic nature of FSSIM is evaluated using five criteria by examining its applications. FSSIM has been applied for different climate zones and soil types (criterion 1) and to a range of different farm types (criterion 2) with different specializations, intensities and sizes. In most applications FSSIM has been used to assess the effects of policy changes and in two applications to assess the impact of technological innovations (criterion 3). In the various applications, different data sources, level of detail (e.g., criterion 4) and model configurations have been used. FSSIM has been linked to an economic and several biophysical models (criterion 5). The model is available for applications to other conditions and research issues, and it is open to be further tested and to be extended with new components, indicators or linkages to other models.     

Transfer of pesticides to the brew during mate drinking process and their relationship with physicochemical properties

In order to evaluate the extraction of pesticide residues that are transferred to the brew during mate drinking process of P.U.1 yerba mate leaves (Ilex paraguariensis), a special device to simulate the way in which mate is drunk in Uruguay was developed. The transfer to the brew of 12 organophosphates, 5 synthethic pyrethroids and one organochlorine pesticide from spiked samples was studied. The relationship between the transfer data thus obtained and physicochemical properties like water solubility (Ws), octanol-water coefficient (Kow) and Henry's constant (H) was evaluated. The extractability of the pesticide residues from yerba mate can be correlated with log Ws and log Kow. These transfer values allowed the calculation of ARLs (acceptable residue level) for the pesticides following Food and Agriculture Organization (FAO), World Health Organizaion (WHO) guidelines. These results can help the future establishment of maximum residue levels (MRLs).     

Directions for combustion engine aerosol measurement in the 21st century

The Coordinating Research Council convened two Real-Time PM Measurement Workshops in December 2008 and March 2009 to take an intensive look at the current status and future directions of combustion aerosol measurement. The purpose was to examine the implications of parallel rapid developments over the past decade in ambient aerosol science, engine aftertreatment technology, and aerosol measurement methodology, which provide benefits and challenges to the stakeholders in air quality management. The workshops were organized into sessions targeting key issues in ambient and source combustion particulate matter (PM). These include (1) metrics to characterize and quantify PM, (2) the need to reconcile ambient and source measurements, (3) the role of atmospheric transformations on modeling emissions and exposures, (4) the impact of sampling conditions on PM measurement, and (5) the potential benefits of novel PM instrumentation. This paper distills the material presented by subject experts and the insights derived from the in-depth discussions that formed the core of each session. The paper's objectives are to identify areas of consensus that allow wider practical application of the past decade's advances in combustion aerosol measurement to improve emissions and air quality modeling, develop emissions reduction strategies, and to recommend directions for progress on issues in which uncertainties remain.