Remediation of contaminated agricultural soils near a former Pb/Zn smelter in Austria: batch, pot and field experiments

Metal contaminated crops from contaminated soils are possible hazards for the food chain. The aim of this study was to find practical and cost-effective measures to reduce metal uptake in crops grown on metal contaminated soils near a former metal smelter in Austria. Metal-inefficient cultivars of crop plants commonly grown in the area were investigated in combination with in-situ soil amendments. A laboratory batch experiment using 15 potential amendments was used to select 5 amendments to treat contaminated soil in a pot study using two Barley (Hordeum vulgare L.) cultivars that differed in their ability to accumulate cadmium. Results from this experiment identified 3 of these amendments for use in a field trial. In the pot experiment a reduction in ammonium nitrate extractable Cd (<41%) and Pb (<49%) compared to the controls was measured, with a concurrent reduction of uptake into barley grain (Cd<62%, Pb<68%). In the field extractable fractions of Cd, Pb, and Zn were reduced by up to 96%, 99%, and 99%, respectively in amended soils.     

The occurrence of xenoestrogens in the Elbe river and the North Sea

The xenoestrogens Bisphenol A (BPA), p-alkylphenols and p-alkylphenol ethoxylates were determined in water samples of the North Sea, the Elbe river, and its tributaries Schwarze Elster, Mulde, Saale and the Weisse Elster. The sampling sites of the Elbe river reached from Schmilka at the German-Czech border to Cuxhaven at the estuary. Samples of the North Sea were taken in the German Bight. Additionally, freshly deposed sediments of the River Elbe and its tributaries were analyzed. Partitioning coefficients of these compounds for the distribution between suspended particulate matter (SPM) and the aqueous phase were calculated for samples of the River Elbe at sampling site Geesthacht. The analytical procedure consisted of liquid-liquid extractions of the acidified water samples using dichloromethane. Sediments and SPM samples were extracted by Accelerated Solvent Extraction with n-hexane/acetone. Following a clean-up by HPLC, the analytes were derivatized with heptafluorobutyric acid anhydride and quantified using GC-MSD. The concentration ranges of the compounds analyzed in water samples of the Elbe river were as follows (in ng l(-1)): BPA 9-776, alkylphenols 10-221 and alkylphenol ethoxylates 18-302. In sediment samples the concentrations were (in microg kg(-1) dry mass): BPA 66-343, alkylphenols 17-1378 and alkylphenol ethoxylates 30-1797. In samples of the North Sea the concentrations were generally about 1 order of magnitude lower. As shown by the concentration profiles following the River Elbe into the North Sea, the Elbe river must be considered as a major pollution source for the North Sea concerning the compounds analyzed. The SPM/water-partitioning coefficients calculated (mean values) amounted to: BPA 4.50, alkylphenols 5.52-5.58 and alkylphenol ethoxylates 5.60-6.38. A comparison of the results with data from other surface waters showed that concentrations of these xenoestrogens in the River Elbe and its tributaries were relatively low. The evaluation of the data based on the lowest observable effect concentration (LOEC) for alkylphenols (endpoint: vitellogenin synthesis in male trout) indicated that the concentrations were well below the effectivity threshold.     

Multivariate statistical study of heavy metal enrichment in sediments of the Pearl River Estuary

The concentrations and chemical partitioning of heavy metals in the sediment cores of the Pearl River Estuary were studied. Based on Pearson correlation coefficients and principal component analysis results, Al was selected as the concentration normalizer for Pb, while Fe was used as the normalizing element for Co, Cu, Ni and Zn. In each profile, sections with metal concentrations exceeding the upper 95% prediction interval of the linear regression model were regarded as metal enrichment layers. The heavy metal accumulation mainly occurred at sites in the western shallow water areas and east channel, which reflected the hydraulic conditions and influence from riparian anthropogenic activities. Heavy metals in the enrichment sections were evaluated by a sequential extraction method for possible chemical forms in sediments. Since the residual, Fe/Mn oxides and organic/sulfide fractions were dominant geochemical phases in the enriched sections, the bioavailability of heavy metals in sediments was generally low. The 206Pb/207Pb ratios in the metal-enriched sediment sections also revealed the influence of anthropogenic sources. The spatial distribution of cumulative heavy metals in the sediments suggested that the Zn and Cu mainly originated from point sources, while the Pb probably came from non-point sources in the estuary.     

Assessment of ambient ozone effects on vegetation using snap bean as a bioindicator species

Tropospheric ozone is an air pollutant that is toxic to plants, causing visible injury to foliage and a reduction in growth and yield. The use of plant bioindicators is one approach to assess the ozone impacts in diverse geographical areas. The objective of this study was to evaluate snap bean (Phaseolus vulgaris L.) as a potential bioindicator species. Three snap bean genotypes known to exhibit a range of ozone sensitivity were grown in pots under charcoal-filtered (CF) or nonfiltered (NF) treatments in open-top chambers, or under ambient air (AA) conditions. Treatment effects on biomass were not significant at 56 days after planting (DAP), but midseason foliar injury increased in the NF and AA treatments relative to CF controls. An increase in ozone from 25 to 30 nL L(-1) in CF controls to approximately 50 nL L(-1) in the NF and AA treatments was found to suppress final pod dry weight per plant by 40 to 60% in the most sensitive genotype S156. The same treatments suppressed final pod dry weight by 20 to 30% in a moderately sensitive genotype Oregon-91, and by 10% or less in a tolerant genotype R123. An S156 to R123 yield ratio of approximately one was observed under CF conditions. The S156 to R123 yield ratio declined to 0.6 to 0.7 in the NF treatment and declined further to 0.4 to 0.5 in the AA treatment, suggesting that ozone impact was underestimated in the open-top chambers. The results suggest that a snap bean bioindicator system has the potential to detect ambient ozone effects at present-day ozone concentrations.     

Protecting the photosynthetic performance of snap bean under free air ozone exposure

Tropospheric ozone(O_3) is a major air pollutant and causes serious injury to vegetation. To protect sensitive plants from O_3 damage, several agrochemicals have been assessed,including cytokinin(e.g., kinetin, KIN) and ethylenediurea(EDU) with cytokinin-like activity.In higher plant, leaves are primarily injured by O_3 and protective agrochemicals are often applied by leaf spraying. To our knowledge, the mitigating abilities of EDU and KIN have not been compared directly in a realistic setup. In the present research, impacts of elevated O3(2 × ambient O_3, 24 hr per day, for 8 days) on an O_3 sensitive line(S156) of snap bean(Phaseolus vulgaris), which is often used for biomonitoring O_3 pollution, were studied in a free air controlled exposure system. The day before starting the O_3 exposure, plants were sprayed with a solution of EDU(300 ppm), KIN(1 mmol/L) or distilled water, to compare their protective abilities. The results demonstrated that 2 × ambient O_3 inhibited net photosynthetic rate and stomatal conductance, increased the minimal fluorescence yield of the dark-adapted state, decreased the maximal quantum yield of PSII photochemistry, and led to visible injury. KIN and EDU alleviated the reduction of the photosynthetic performance, and visible injury under O_3 fumigation. The plants sprayed with EDU showed greater ability to mitigate the O_3 damage than those sprayed with KIN. Chlorophyll fluorescence imaging may have detected more precisely the differences in O_3 response across the leaf than the conventional fluorometer.     

Garbage in garbage out: the contribution of our industrial advancement to wastewater degeneration

Environmental Science and Pollution Research - Natural water sources are habitually marred by insidious anthropogenic practices and municipal wastewater discharges that contain either of xenobiotic...     

Compassionate versus consequentialist conservation

Ethical treatment of wildlife and consideration of animal welfare have become important themes in conservation, but ethical perspectives on how best to protect wild animals and promote their welfare are diverse. There are advantages to the consequentialist harms ethical framework applied in managing wild herbivores for conservation purposes. To minimize harms while achieving conservation goals, we argue that overabundant wild herbivores should in many cases be managed through consumptive in situ killing. Advantages of this policy are that the negative welfare states imposed on animals last only a short time; remaining animals are not deprived of positive welfare states (e.g., linked to rearing offspring); poor welfare states of animals in overabundant populations are avoided (e.g., starvation); negative welfare impacts on heterospecifics through resource depletion (i.e., competition) are prevented; harvesting meat reduces the number of (agricultural) animals raised to supply meat; and minimal costs maximize funding for other wildlife management and conservation priorities. Alternative ethical approaches to our consequentialist framework include deontology (containing animal rights) and virtue ethics, some of which underpin compassionate conservation. These alternative ethical approaches emphasize the importance of avoiding intentional killing of animals but, if no population reduction occurs, are likely to impose considerable unintentional harms on overabundant wildlife and indirectly harm heterospecifics through ineffective population reduction. If nonlethal control is used, it is likely that overabundant animals would be deprived of positive welfare states and economic costs would be prohibitive. We encourage conservation stakeholders to consider animal-welfare consequentialism as an ethical approach to minimize harms to the animals under their care as well as other animals that policies may affect while at the same time pursuing conservation goals.     

Performance of a large-scale greenhouse solar dryer integrated with phase change material thermal storage system for drying of chili

ABSTRACT

Large-scale greenhouse solar dryers have been used for drying various products and this type of dryer is usually equipped with LPG burner as auxiliary heater, which creates more operating cost. To overcome this problem, phase change material (PCM) thermal storage was proposed to substitute for the LPG burner. In this work, the performance of a large-scale greenhouse solar dryer integrated with a PCM as a latent heat storage for drying of chili was investigated. Experimental studies were conducted to compare the performance of this dryer with that of another large-scale greenhouse solar dryer without the PCM thermal storage and open sun drying. Chili with an initial moisture content of 74.7% (w.b.) was dried to a final moisture content of 10.0% (w.b.) in 2.5 days, 3.5 days, and 11 days using the solar dryer integrated with the PCM thermal storage, the solar dryer without the PCM thermal storage and the open sun drying, respectively. The performance of the solar dryer integrated with the PCM thermal storage was also evaluated using exergy analysis. The exergy efficiency of the drying room of the solar dryer integrated with the PCM thermal storage and the solar dryer without the PCM thermal storage for drying of chili was found to be 13.1% and 11.4%, respectively and the thermal storage helps to dry chili during adverse weather conditions. The results of exergy analysis implied that the exergy losses from the dryer with the PCM should be reduced.     

Determination of suitable TPH remediation approach via MANOVA and inferential statistics assessment

Soil contamination resulting from petroleum hydrocarbon contaminants poses a fairly substantial hazard to human health and the environment. Phytoremediation, land farming, and chemico–biological stabilization were used to treat total petroleum hydrocarbons (TPHs) and polycyclic aromatic hydrocarbons (PAHs) at a crude oil polluted soil site in Nigeria. A field pilot study was conducted by preparing nine cells with subcells attached to each serving as a control with an overall area of 1.53 m². A complete block design method was used for the study. The prepared soil sample cells were divided into three groups with each group having approximately 300 kg of soil and delineated as low, medium, and high test plots. The low samples were spiked with 6.1 kg of crude oil, the medium samples were spiked with 12.2 kg of crudeoil, and the high samples were spiked with 18.3 kg of crude oil. Each row containing three cells with low, medium, and high concentrations were treated separately using the three treatment methods. The ratio of the soil sample to the organic amendment for the treatments was 2:1. The results showed over 90% degradation in the initial concentration of TPH and PAHs across different contaminant levels except in the control subcells where only 30% of degradation was recorded. Multivariate analysis of variance was employed to assess the significant difference in each treatment group while inferential statistics using a mean performance plot was used to ascertain the optimum treatment method. Land farming, chemico–biological stabilization, and phytoremediation ranked 1, 2, and 3, respectively. In conclusion, the three treatment methods employed all degraded the contaminants (TPH and PAHs) with land farming emerging as the best method.