An automated wet deposition system to compare the effects of reduced and oxidised N on ombrotrophic bog species: Practical considerations

Critical N loads for ombrotrophic bogs, which often contain rare and N-sensitive plants (especially those in lower plant groups: lichens, mosses and liverworts), are based on very few experimental data from measured, low background N deposition areas. Additionally the relative effects of reduced versus oxidised N are largely unknown. This paper describes an automated field exposure system (30 km S. of Edinburgh, Scotland) for treating ombrotrophic bog vegetation with fine droplets of oxidised N (NaNO₃) and reduced N (NH₄Cl). Whim Moss exists in an area of low ambient N deposition (ca. 8 kg N ha^?1 y^?1), the sources and quantification of which are described. The wet N treatment system is run continuously, and is controlled/activated by wind speed and rainfall to provide a unique simulation of “real worl” treatment patterns (no rain=no treatment). Simulated precipitation is supplied at ionic concentrations below 4 mM in rainwater collected on site. Treatments provide a replicated dose response to 16, 32 and 64 kg N ha^?1 y^?1 adjusted for ambient deposition (8 kg N ha^?1 y^?1). The 16 and 64 kg N ha^?1 y^?1 are duplicated with a P+K supplement. Baseline soil chemistry and foliar nutrient status was established for all 44 plots for Calluna vulgaris, Sphagnum capillifolium, Hypnum jutlandicum and Cladonia portentosa.     

Comparative environmental analysis of waste brominated plastic thermal treatments

The aim of this research activity is to investigate the environmental impact of different thermal treatments of waste electric and electronic equipment (WEEE), applying a life cycle assessment methodology. Two scenarios were assessed, which both allow the recovery of bromine: (A) the co-combustion of WEEE and green waste in a municipal solid waste combustion plant, and (B) the staged-gasification of WEEE and combustion of produced syngas in gas turbines. Mass and energy balances on the two scenarios were set and the analysis of the life cycle inventory and the life cycle impact assessment were conducted. Two impact assessment methods (Ecoindicator 99 and Impact 2002+) were slightly modified and then used with both scenarios. The results showed that scenario B (staged-gasification) had a potentially smaller environmental impact than scenario A (co-combustion). In particular, the thermal treatment of staged-gasification was more energy efficient than co-combustion, and therefore scenario B performed better than scenario A, mainly in the impact categories of "fossil fuels" and "climate change". Moreover, the results showed that scenario B allows a higher recovery of bromine than scenario A; however, Br recovery leads to environmental benefits for both the scenarios. Finally the study demonstrates that WEEE thermal treatment for energy and matter recovery is an eco-efficient way to dispose of this kind of waste.     

纳滤膜深度处理棉针织品印染废水

采用芳香聚酰胺膜(NF-1#)、复合膜(NF-2#)和聚酰胺复合膜(NF-3#)深度处理棉针织品印染废水,考察了膜分离性能及膜污染情况的影响因素。实验结果表明,在操作压力为0.5MPa、废水温度为25~35℃、废水pH为7的条件下,NF-1#膜处理效果最佳,COD去除率最高,为76.0%~85.0%;脱盐率也最高,达90.0%。膜过滤后浓水送污水厂处理,产水回用于车间生产。操作压力增高、废水温度升高和废水pH增大均导致滤饼层阻力(Rc)和膜过滤过程中的总阻力(Rt)增加,Rc是Rt的主要组成部分,同时也是导致膜透过通量下降的主要因素。     

Laboratory scale studies on gaseous emissions generated by the incineration of an artificial automotive shredder residue presenting a critical composition

Car manufacturers must eliminate automotive shredder residues (ASR). Two ways of incineration are of interest: at 850°C in municipal waste incinerators or at higher temperatures, above 1100°C in cement plants. These processes reduce the mass and the volume of waste to be disposed of in landfills and energy recovery might be possible. Regulations govern the emission of gaseous effluents to control environmental risk. To determine gaseous effluents from a pilot sacle or an industrial incineration plant, an artificial ASR was made by mixing three representative organic polymers present in the real ASR, namely polyvinylchloride, polyurethane and rubber. This mixture was incinerated at 850 and 1100°C in laboratory experiments and the analyses of the principal gaseous effluents such as carbon oxides, nitrogen oxides, volatile organic compounds, hydrochloric and hydrocyanic acids and sulphur compounds are presented and discussed. Lastly, in order to simulate artificial ASR behaviour, the composition of the combustion gases at equilibrium was calculated using a Gibbs energy minimisation code.     

Reinforcement of Yeast Biomass Films with Bacterial Cellulose and Rice Husk Cellulose Nanofibres

Journal of Polymers and the Environment - In the last decades, cellulose nanoparticles have been widely used to reinforce polymeric materials due to their strength and their wide availability in...     

臭氧-生物活性炭深度处理黄浦江水源水中试研究

以黄浦江水源水厂的滤后水为试验对象,进行饮用水O3-BAC深度处理工艺影响因素的中试研完。针对进水水质的试验结果表明,最优臭氧投加量为3mg／L左右,空床停留时间为15min左右。试验结果可为工程设计提供有益的参考。