Overview of strontium-89,90 deposition measurements in Finland 1963-2005

In Finland the deposition of strontium-89 (⁹⁰Sr) and strontium-90 (⁹⁰Sr) has been monitored since the early 1960s. The measured cumulative ⁹⁰Sr deposition in 1963-2005 is on average 1200 Bq m⁻², of which 150 Bq m⁻² originates from the Chernobyl accident. Adding to this the deposition in 1945-1962 produces a value of 2040 Bq m⁻² for the cumulative deposition in Finland. The nuclear explosion-derived deposition up to 1985 obtained in this study, 1850 Bq m⁻², is in good agreement with the zonal ⁹⁰Sr deposition of 1740 Bq m⁻² in the 60°N-70°N latitude band estimated by UNSCEAR. The regional deposition patterns of ⁸⁹Sr and ⁹⁰Sr following the Chernobyl accident resemble those of the refractory nuclides such as ^239,240Pu and ⁹⁵Zr. The total deposition of Chernobyl-derived ⁹⁰Sr in Finland was about 5.3 × 10¹³ Bq. This activity corresponds to 0.027% of the reactor core inventory and 0.66% of the atmospheric emissions from the accident. The corresponding figures for ⁸⁹Sr are 4.5 × 10¹⁴ Bq, 0.023% and 0.56%, respectively.     

Modeling linkages between sediment resuspension and water quality in a shallow,eutrophic, wind-exposed lake

The interactions between bed sediments and the water column in shallow, eutrophic lakes have tremendous implications for the fate and transport of nutrients in those water bodies. This has resulted in the development of water quality models for lakes incorporating the processes of sediment resuspension. Reliable resuspension models are thus needed to accurately represent this phenomenon. In this paper, three different sediment-resuspension models are combined with a hydrodynamic and water quality model, dynamic lake model-water quality (DLM-WQ), and the resulting models are used to simulate nutrient distributions in the highly eutrophic Salton Sea, California, USA. One of the resuspension formulas is based upon sediment characteristics as well as the bed shear stress exerted by wind-induced waves and currents, while the other two are standard, power-law-type formulas for cohesive sediments with two different exponents. The outputs for water quality variables, such as temperature, chlorophyll a, dissolved oxygen and nutrients, obtained from the three resulting models and from an earlier DLM-WQ run with a simple empirical sediment-resuspension model are compared with measured data. The level of agreement between the simulations and the measured data is assessed by using both statistical and graphical model evaluation methods, including measures of residual errors, sample autocorrelations, t-tests, and box plots. Based on these assessments, DLM-WQ with an extended version of the García and Parker [García, M.H., Parker, G., 1993. Experiments on the entrainment of sediment into suspension by a dense bottom current. J. Geophys. Res.-Oceans 98, 4793–4807] relationship gave the best results for water quality in the Salton Sea, confirming that the use of formulas with more information on the sediment characteristics yields more accurate results. To the best of our knowledge, this is the first effort to combine water quality models for lakes and reservoirs with a sediment-resuspension model which was originally intended for open-channel flows. The simulations confirm that sediment resuspension is the most dominant process in the Salton Sea's nutrient cycling. The effect of proposed physical changes to the Salton Sea on water quality characteristics is also addressed.     

Theoretic model for the computer analysis of vehicle collisions

The complexity of the study and reconstruction of traffic accidents justifies the creation of tools which make easier the research in this area. That is the reason why the GIVET has developed a program called SINRAT III that lets, by means of dynamic simulation, reproduce the evolution of two vehicles in an accident in which a collision takes place, letting analyze the precollision and postcollision movements, as well as studying what happens during the contact and deformation of the vehicles in the collision stage. The simulation model is integrated by bodies developed using the bond-graph technique, that allows the simulation of the dynamic behaviour of the vehicles in any circumstance. At the end of this paper, an application example is presented, corresponding to an accident with collision between car and coach.     

Alteration in rhizosphere soil properties of afforested Rhamnus lycioides seedlings in short-term response to mycorrhizal inoculation with Glomus intraradices and organic amendment

The reestablishment of autochthonous plant species is an essential strategy for recovering degraded areas under semiarid conditions. A field experiment was carried out to assess the short-term effect of two reafforestation methods involving mycorrhizal inoculation and compost addition on soil quality parameters and Rhamnus lycioides seedling growth. The nutrient content (NPK) and enzymatic activities (dehydrogenase, urease, protease-BAA, acid phosphatase and beta-glucosidase) increased and bulk density decreased in the rhizosphere soil with the organic amendment. Biomass C of rhizosphere soil increased by at least 240% with respect to the control soil after mycorrhizal inoculation and the combination of compost addition + mycorrhizal inoculation. Both mycorrhizal inoculation and composted organic residue addition increased R. lycioides seedling growth in the same proportion. In the short term, we conclude that the application of both reafforestation methods not only enhances the establishment of R. lycioides seedlings, but also improves soil quality.     

Sorption of polycyclic aromatic compounds to humic and fulvic acid HPLC column materials

Two different humic acids (HA) and a fulvic acid (FA) were chemically immobilized to a high performance liquid chromatography (HPLC) silica column material. The immobilization was performed by binding amino groups in HA/FA to the free aldehyde group in glutardialdehyde attached to the silica gel. The HPLC column materials were compared with a blank column material made by applying the same procedure but without immobilizing HA or FA. Also, a column was made by binding carbonyl groups in HA to amino groups attached to the silica gel. The humic substances were selected to secure appropriate variation of their structural features. The retention factors of 45 polycyclic aromatic compounds (PAC) to the four columns were determined by HPLC. The advantage of the technique is a large number of compounds can easily be studied. The binding procedure does not appear to cause a drastic selection between the HA molecules. The k' values obtained for the two Aldrich HA columns agree in general reasonably. The retention or sorption of the compounds increased with the size of the PAC and the number of lipophilic substituents, but decreased when polar substituents were present. The PAC retention was much stronger to the two HA columns than to the FA and blank column, both for hydrophobic polycyclic aromatic hydrocarbons (PAH) and the polar PAC. Other factors impacting the PAC binding may be specific interactions with HA and the ionic strength of the aqueous phase. The technique has been applied to do direct determinations of Koc.     

Pilot‐scale evaluation using bioaugmentation to enhance PCE dissolution at dover AFB national test site

An Interstate Technology and Regulatory Council (ITRC) forum was recently held that focused on six case studies in which bioremediation of dense nonaqueous‐phase liquids (DNAPLs) was performed; the objective was to demonstrate that there is credible evidence for bioremediation as a viable environmental remediation technology. The first two case studies from the forum have been previously published; this third case study involves a pilot‐scale demonstration that investigated the effects of biological activity on enhancing dissolution of an emplaced tetrachloroethene (PCE) DNAPL source. It used a controlled‐release test cell with PCE as the primary DNAPL in a porous media groundwater system. Both laboratory tests and a field‐scale pilot test demonstrated that bioaugmentation can stimulate complete dechlorination to a nontoxic end product and that the mass flux from a source zone increases when biological dehalorespiration activity is enhanced through nutrient (electron donor) addition and bioaugmentation. All project goals were met. Important achievements include demonstrating the ability to degrade a PCE DNAPL source to ethene and obtaining significant information on the impacts to the microbial populations and corresponding isotope enrichments during biodegradation of a source area. © 2007 Wiley Periodicals, Inc.     

Shifts in Microbial Communities, Microbial Biomass and Organic Matter Mineralization for Three Mediterranean Soils Contaminated By Metals

Microbial communities (phospholipid fatty acid pattern, bacterial growing strategies, eco-physiological index (EPI) and total bacteria counts, as a number of heterotrophic cuhurable bacteria), substrate-induced respiration (SIR), and nitrogen mineralization were studied in three Mediterranean soils at three different depth levels (A, B and C). Soils were experimentally treated with a final concentration of 1000 ppm of trace metals (Cu²⁺, Zn²⁺, Al³⁺, Fe²⁺, Pb²⁺, Ni²⁺, Mn²⁺, Cr³⁺ and Cd²⁺). Soils were stored in 571 plastic containers for one year, and watered with 1001 during this period. Leachate was recovered through a bottom tap. Samples of the three depths were studied. Soil microbial communities showed different effects to other studies presented in the literature, but carried out on non-Mediterranean soils. Dramatic differences were found between treated soils and untreated ones, but not between soils or horizons. the treated soil displayed a decrease in CFUs, SIR N-mineralization and EPI together with a dominance of r-growing strategists. the relative moles percent of several PLFAs, especially 15:0, 16: 1ω7, cy17: 0, br18:0 and 18: 1ω7 decreased because of the pollution of soils, whereas 10Me16, 18:2ω6, cy19:0, i16:0 and br17:0 showed higher values than in untreated soils.     

Use of microbial activity measurements for monitoring RBC biofilms

Fixed biomass technologies, such as rotating biological contactors or biodiscs, have been applied for wastewater depuration both in large and medium–small-sized agglomerations. Biofilm’s composition and microorganism activity are essential parameters for the successful operation and control of these systems. Biofilm’s thickness and total dry weight have been widely used for biofilm’s characterization but, actually, are not sufficient to describe biofilm activity. In fact, biofilm’s activity is not proportional to the quantity of fixed biomass, but increases with the thickness of biofilm up to a determined level called the “active thickness”. Above this level, the diffusion of nutrients through the film becomes a limiting factor. A stable, thin, and active biofilm thus offers numerous advantages in water and wastewater treatment. Different parameters have been used to evaluate biofilm’s activity. The specific oxygen uptake rate, INT-dehydrogenase activity, and the ratio active/total cells have been applied for that purpose. These methods are not only simple and rapid but also sensitive, precise, and representative. The results obtained confirm the potential of the microbial activity measurements studied for an accurate biofilm’s characterization and biomass activity estimation in fundamental research and for the practical operation and control of fixed biomass depuration systems.     

Improvement of solar photo-Fenton by extracts of amazonian fruits for the degradation of pharmaceuticals in municipal wastewater

Extracts of copoazu (Theobroma gramdiflorum), canangucha (Maurita Flexuosa), and coffee (Coffea arabica) were explored as enhancers of the solar photo-Fenton process to eliminate acetaminophen, sulfamethoxazole, carbamazepine, and diclofenac in raw municipal wastewater. The process, at pH 6.2 and 5 mg L^?1 of iron without the presence of extracts, had a very limited action (~35% of the pollutants degradation at 90 min of treatment) due to the iron precipitation. Interestingly, the extract addition increased the soluble iron forms, but only copoazu extract improved the pollutant degradation (~95% of elimination at 20 min of the process action). The copoazu extract components acted as natural complexing agents, maintaining the soluble iron up to 2 mg L^?1 even after 90 min and, consequently, enhancing the pollutant degradation. The effect of copoazu extract dose on the process performance was also assessed, finding that an iron:polyphenols (from the copoazu extract) at a molar ratio equal to 1:0.16 was the most favorable condition. Then, the process improved by copoazu extract was applied to raw municipal wastewater. Remarkably, the process led to ~90% of total pharmaceuticals degradation at 20 min of treatment. This work evidenced the feasibility of amazonian fruit extracts to improve the solar photo-Fenton process to degrade pharmaceuticals in aqueous matrices at near-neutral pH.