Effect of arsenic species on the growth and arsenic accumulation in Cucumis sativus

The effects of arsenic (As) species, such as As(III), As(V) and dimethylarsinic acid (DMA), on the accumulation of As in cucumber (Cucumis sativus), as well as on its growth in a soil mesocosm were evaluated. When Cucumis sativus was cultivated in soils contaminated with 20 and 50 mg/kg of As(III), As(V) or DMA for 40 days, the growth was markedly inhibited by the inorganic As (As(III) and As(V)) rather than the organic As (DMA). Irrespective of the As species, the As concentrations accumulated in Cucumis sativus increased with increasing As concentration in the soil. The As bioaccumulation factors from soil into the tissue of Cucumis sativus were 17.5-35.4, 29.3-42.7 and 17.6-25.7 for As(III), As(V) and DMA, respectively. In addition, the As translocation factors from the roots to shoots were 0.025-0.031, 0.018-0.032 and 0.014-0.026 for As(III), As(V) and DMA, respectively. In conclusion, Cucumis sativus mainly accumulated As in its roots rather than its shoots and easily accumulated inorganic rather than organic As from the soil into its tissue.     

A new approach to characterize biodegradation of organics by molecular mass distribution in landfill leachate

This study provides biodegradability of organics in leachate according to their molecular mass distributions (<0.5, 0.5 to 1, 1 to 3, 10, and >10 KDa). Organics with molecular mass values lower than 0.5 KDa were the predominant species in the raw leachate filtrate, and the aerated lagoon process was very effective in treating these highly biodegradable organics; the Fenton's oxidation process was very effective in treating not-so-biodegradable organics with molecular mass values higher than 0.5 KDa, but a portion of these organics were converted into organics <0.5 KDa after Fenton's oxidation. An oxygen uptake measurement using a respirometer was more sensitive than a conventional biochemical oxygen demand measurement to evaluate bioactivities, especially when bioactivities were low.     

Inactivation of Ascaris eggs in soil by microwave treatment compared to UV and ozone treatment

This study reports on the effect of microwave radiation for inactivation of Ascaris lumbricoides eggs in 25 g of soil compared to ultraviolet irradiation and ozone expose. Microwave radiation at 700 W with 14% water content (w/w) achieved approximately 2.5 log inactivation of eggs in soil within 60 s. On the other hand, UV irradiation at 3 mW cm⁻² with and without shaking soil for 3600 s achieved approximately 0.32 and 0.01 log inactivation of eggs, respectively. In ozone treatment, 0.13 log inactivation of eggs was achieved with 5.8 ± 0.7 mg L⁻¹ of dissolved ozone dose for 30 min in a continuous diffusion reactor. In addition, the inactivation of eggs by three disinfection techniques was conducted in water in order to compare the inactivation efficiency of eggs in soil. The inactivation efficiency of microwave radiation was found to be no significant difference between in soil and water. However, the inactivation efficiency of UV irradiation was significantly increased in water while in ozone expose there was no significant difference between in soil and water. Microwave treatment thus proved to be the most efficient method in controlling A. lumbricoides eggs in soil.     

Element associations in ash from waste combustion in fluidized bed

The incineration of MSW in fluidized beds is a commonly applied waste management practice. The composition of the ashes produced in a fluidized bed boiler has important environmental implications as potentially toxic trace elements may be associated with ash particles and it is therefore essential to determine the mechanisms controlling the association of trace elements to ash particles, including the role of major element composition. The research presented here uses micro-analytical techniques to study the distribution of major and trace elements and determine the importance of affinity-based binding mechanisms in separate cyclone ash particles from MSW combustion. Particle size and the occurrence of Ca and Fe were found to be important factors for the binding of trace elements to ash particles, but the binding largely depends on random associations based on the presence of a particle when trace elements condensate in the flue gas.     

Hydrogen sulfide effects on ammonia removal by a biofilter seeded with earthworm casts

Ammonia (NH3) removal efficencies were evaluated when hydrogen sulfide (H2S) and NH3 in binary mixture gases were supplied to a ceramic biofilter seeded with earthworm (Lumbricus terrestris) casts. The effect of inlet H2S concentration and space velocity (SV) on the removal of NH3 was investigated after the acclimation of the biofilter with NH3 gas. When NH3 was singly supplied to the biofilter, NH3 removal was maintained at almost 100% until inlet NH3 concentration was increased up to 600 microL L(-1) and SV up to 330 h(-1), at which the elimination capacity of NH3 was 148 g N m(-3) h(-1). When H2S was supplied simultaneously, however, the accumulation of toxic sulfide ions showed dual effects on NH3 removal efficiencies. First, no effects were observed at inlet H2S loading below 60 g S m(-3) h(-1); however, inhibition by H2S at higher loading was observed above 60 g S m(-3) h(-1). The point at which loading achieved a maximum of more than 99% NH3 removal efficiency was 139 g N m(-3) h(-1), when inlet H2S concentration was held under 100 microL L(-1), but it dropped to 76 and 30 g N m(-3) h(-1) when the inlet H2S concentration increased to 220 and 460 microL L(-1), respectively. The critical points of inlet H2S loading that guaranteed over 99% NH3 removal were determined as 100, 100, 60, and 40 g S m(-3) h(-1) at inlet NH3 concentrations of 100, 200, 400, and 600 microL L(-1), respectively. Inlet NH3 loading had synergic effects of increasing the inhibition of inlet H2S loading on the NH3 removability of the biofilter.     

Concentrations and analysis of health risks of ambient air metallic elements at Longjing site in central Taiwan

Environmental Geochemistry and Health - The concentrations of particulates and metallic elements that were bound to total suspended particulates in ambient air at Long Cyuan Elementary School...     

ARCGIS‐SWAT: A GEODATA MODEL AND GIS INTERFACE FOR SWAT1

This paper presents ArcGIS‐SWAT, a geodata model and geographic information system (GIS) interface for the Soil and Water Assessment Tool (SWAT). The ArcGIS‐SWAT data model is a system of geodatabases that store SWAT geographic, numeric, and text input data and results in an organized fashion. Thus, it is proposed that a single and comprehensive geodatabase be used as the repository of a SWAT simulation. The ArcGIS‐SWAT interface uses programming objects that conform to the Component Object Model (COM) design standard, which facilitate the use of functionality of other Windows‐based applications within ArcGIS‐SWAT. In particular, the use of MS Excel and MATLAB functionality for data analysis and visualization of results is demonstrated. Likewise, it is proposed to conduct hydrologic model integration through the sharing of information with a not‐model‐specific hub data model where information common to different models can be stored and from which it can be retrieved. As an example, it is demonstrated how the Hydrologic Modeling System (HMS) ‐ a computer application for flood analysis ‐ can use information originally developed by ArcGIS‐SWAT for SWAT. The application of ArcGIS‐SWAT to the Seco Creek watershed in Texas is presented.     

ARE RURAL RESIDENTS WILLING TO PAY ENOUGH TO IMPROVE DRINKING WATER QUALITY?1

ABSTRACT: The concentrations of iron and sulfate in community water supplies are a concern for a number of areas in southwestern Minnesota. This study used the contingent valuation method to determine how much consumers would be willing to pay to improve their drinking water quality. On average, individuals were willing to pay US$5.25 per month (in 1995 U.S. dollars) to reduce the level of iron and US$4.33 per month to reduce the level of sulfate in their water to the USEPA's secondary standards for drinking water quality. Respondents with negative perceptions of their drinking water quality were willing to pay more to improve water quality. The aggregate annual willingness to pay (WTP) for all consumers in community water systems in southwestern Minnesota that were out of compliance with water quality standards were estimated to be US$2.4 million and US$2.0 million (in 1995 dollars) for reducing the levels of iron and sulfate, respectively. Yet the total WTP of consumers who use small community water systems may not be enough to pay the full cost of providing improved water in those systems. Economies of scale in water treatment and difficulties in financing improvements mean that technical innovation, government assistance, or institutional changes may be needed to improve water quality in these areas.     

Characterization of pore scale NAPL morphology in homogeneous sands as a function of grain size and NAPL dissolution

In this study, we investigate pore scale morphology of nonaqueous phase liquids (NAPLs) trapped in different pore sizes using tracer techniques. Specific interfacial area and saturation of NAPL trapped in homogeneous sands were measured using the interfacial and partitioning tracer techniques. The observed NAPL-water interfacial areas increased in a log-linear fashion with decreasing sand grain size, but showed no clear trend with residual NAPL saturation formed in the various grain sizes. The measured values were used to calculate the NAPL morphology index, which characterizes the spatial NAPL distribution within the pore space. The NAPL morphology indices, increased exponentially with decreasing grain size, indicating that the NAPL becomes smaller, but more blobs. For a fixed grain size, the specific interfacial area and saturation of the NAPL were measured following changes caused by dissolution using alcohol. The observed interfacial areas showed a decrease linearly as a function of the NAPL saturation.