个人因素事故致因模型的探讨

从个人因素事故致因模型出发．探讨了潜在危险存在的情况下．个人因素与事故发生之间的联系;分析了不同的个人因素对于潜在危险的感知认识的作用和影响以及由此而决定的工作行为的安全程度;讨论了以控制导致事故发生的个人因素为出发点．用以预防事故发生的对策措施;提出在现代安全科学领域中,不仅要解决职工安全生产技术方面的问题．更要强调职工个人的社会性,在工作之中的成就感,被尊重的程度．这样才能达到充分激励职工、加强安全生产的目的。     

Biomechanical response targets for physical and computational models of the pediatric trunk

Objectives: This paper quantifies pediatric thoracoabdominal response to belt loading to guide the scaling of existing adult response data and to assess the validity of a juvenile porcine abdominal model for application to the development of physical and computational models of the human child. Methods: Table-top belt-loading experiments were performed on 6, 7, and 15 year-old pediatric post-mortem human subjects (PMHS). Response targets are reported for diagonal belt and distributed loading of the anterior thorax and for horizontal belt loading of the abdomen. Results: The pediatric PMHS exhibited abdominal response similar to the swine, including the degree of rate sensitivity. The thoraces of the PMHS were as stiff as, or slightly more stiff than, published adult corridors. Conclusions: An assessment of age-related changes in thoracic stiffness suggests that the effective stiffness of the chest increases through the fourth decade of life and then decreases, resulting in stiffness values similar for children and elderly adults.     

低温NH3-SCR脱硝催化剂研究进展

低温NH3-SCR脱除NOx是一种有潜力的烟气脱硝技术.综述了低温NH3-SCR脱硝催化剂的研究现状,重点介绍了锰基催化剂、钒基催化剂,以及其他金属氧化物基催化剂的研究状况,阐述了制备方法、催化剂载体,以及以不同金属改性对催化剂脱硝活性的影响.其中具备高比表面积、良好非晶态结构的低温NH3-SCR催化剂都有良好的低温脱硝活性.以CeO2改性锰(MnOx)基催化剂为例,探讨了低温NH3-SCR脱硝催化剂的脱硝机理.反应气体(NH3、NO和O2)在催化剂表面的吸附在低温NH3-SCR脱除NOx中发挥了重要作用.CeO2改性锰基催化剂催化NH3-SCR反应过程中涉及ER机理和LH机理,并且NH2与气态NO发生反应生成亚硝胺(NH2NO),进一步分解为N2和H2O是关键步骤.就燃煤烟气中水蒸气(H2O)和SO2在低温条件下对低温NH3-SCR脱硝催化剂的失活机制进行了阐述.烟气中的水蒸气与反应气体的竞争性吸附能够导致催化剂脱硝活性的降低.水蒸气(H2O)和SO2共同存在对低温NH3-SCR催化剂脱硝活性的影响表现为两者共同作用.烟气中水和SO2存在时生成的硫酸盐沉积在催化剂表面,并导致催化剂失活.     

铜与铜包铝接地线缆短路熔断特性理论计算与试验

为研究用于高压电力系统的临时接地装置抗突然短路能力及短路火灾限制措施,通过铜导体Onderdonk公式的推广算法,得到铜包铝接地线缆熔断电流的理论计算方法,以6 300 kVA大容量变压器为电流源模拟实际工作中挂接地线时可能出现的短路熔断情况,对常用的铜材料接地线缆及轻质铜包铝材料接地线缆在10 kA以上短时大电流下的熔断过程进行了试验。结果表明:绝热过程下接地线缆熔断电流的理论计算结果偏严格,通过计算公式选取接地线缆截面积具有一定的安全裕度;理论等效截面下铜包铝线缆相比铜线缆更不容易发生熔断,12. 9 kA、16. 3 kA、21. 7 kA短路电流下60 mm^2铜层体积比为10%的铜包铝裸导线熔断时间比35 mm^2铜线分别增加32. 0%、30. 1%、24. 3%;外加阻燃护层可以增加铜线缆的熔断时间而对铜包铝线缆熔断时间的影响不明显,但外加护层可以显著减少铜包铝线缆迸溅熔珠的数量,降低熔珠的引燃能力,从而对短路火灾进行有效抑制。     

Photo-assisted fenton oxidation of refractory organics in UASB-pretreated leachate

Nearly 91% of organic pollutants in Hong Kong leachate could be effectively removed by the UASB(upflow anaerobic sludge blanket)process followed by the fenton coagulation.The COD(chemical oxygen demand)of leachate was lowered from an average of 5620 mg/L to 1910 mg/L after the UASB treatment at 37℃,and was further lowered to 513 mg/L after fenton coagulation.The remaining refractory residues could be further removed by plotochemical oxidation with the addition of H2O2.The BOD/COD ratio was greatly increased from 0.062 to 0.142,indicating the biodegradability of organic residues was improved.The photochemical oxidation for the fenton-coagulation supernatant was most effective at pH3-4,with the addition of 800 mg/L of H2O2,and UV radiation time of 30 minutes.The final effluent contained only 148 mg/L of COD,21 mg/L of BOD(biochemical oxygen demand)and 56 mg/L of TOC (total organic carbon).     

沉淀法回收聚苯乙烯泡沫塑料的工艺研究

研究沉淀法回收聚苯乙烯泡沫塑料(EPS)的工艺,利用石油裂解副产物为溶剂回收废旧聚苯乙烯泡沫塑料,以废治废,回收利用。溶剂低毒,对聚苯乙烯泡沫塑料溶解速度快,溶解量大,价廉易得。采用转式间歇投料并附加溶剂挥发分回收装置的工艺,溶剂回收率高,无二次污染,可循环使用。聚苯乙烯塑料(PS)回收率可达99%。     

The degradation of endocrine disruptor di-n-butyl phthalate by UV irradiation: a photolysis and product study

The direct photolysis of an important endocrine disruptor compound, di-n-butyl phthalate (DBP), has been investigated under monochromatic UV irradiation at 254 nm over a wide pH range (3-11). The investigation was carried out under idealized conditions and has considered both reaction kinetics and the degradation mechanism. It was found that more than 90% of DBP can be degraded within an hour of irradiation in water. A simple model has been developed and used to predict the initial DBP photolysis rate constant at different pH values and initial DBP concentrations. The major decomposition mechanism of DBP is believed to involve the hydrolytic photolysis of the carbon in the alpha and/or beta-position of the ester chain with the production of aromatic carboxylic derivatives. Additionally, multi-degradation pathways are proposed for acid-catalyzed hydrolytic photolysis (pH 3-5), which was found to be useful in explaining the photo-degradation of DBP under acidic conditions. The use of 254 nm UV to photo-degrade DBP was found to be a relatively fast and clean process, especially in neutral to basic conditions.     

Characteristics of single atmospheric particles in a heavily polluted urban area of China: size distributions and mixing states

To investigate the chemical composition, size distribution, and mixing state of aerosol particles on heavy pollution days, single-particle aerosol mass spectrometry was conducted during 9–26 October 2015 in Xi’an, China. The measured particles were classified into six major categories: biomass burning (BB) particles, K-secondary particles, elemental carbon (EC)–related particles, metal-containing particles, dust, and organic carbon (OC) particles. BB and EC-related particles were the dominant types during the study period and mainly originated from biomass burning, vehicle emissions, and coal combustion. According to the ambient air quality index, two typical episodes were defined: clean days (CDs) and polluted days (PDs). Accumulation of BB particles and EC-related particles was the main reason for the pollution in Xi’an. Most types of particle size were larger on PDs than CDs. Each particle type was mixed with secondary species to different degrees on CDs and PDs, indicating that atmospheric aging occurred. The mixing state results demonstrated that the primary tracers were oxidized or vanished and that the amount of secondary species was increased on PDs. This study provides valuable information and a dataset to help control air pollution in the urban areas of Xi’an.

Graphical abstract

     

纳米刻蚀法制备氧化锰介孔材料及其降解高含盐废水中罗丹明B

为了有效去除高含盐废水中的有机染料污染物,利用有序介孔硅材料作为模板剂,通过硬模板法制备了新型锰系氧化物（MnO_x）介孔材料作为类Fenton催化剂.催化剂的结构表征结果表明,模板剂在锰前驱物溶液中浸渍和后续煅烧成型过程决定了氧化锰介孔材料的结构.浸渍-煅烧成型重复次数越多,MnO_x介孔材料中孔道结构的有序度和氧化锰的结晶度越好.浸渍-煅烧成型次数过少,MnO_x介孔材料中孔道呈现无序状态,比表面积较大但氧化锰结晶度不足;次数过多则形成更为致密的小孔径的孔道结构,从而使MnO_x介孔材料的比表面积减小.由于对罗丹明B（RhB）良好的选择性吸附能力和较多的Mn³⁺/Mn⁴⁺对,具有有序规则孔道的氧化锰介孔材料具有优异的类Fenton催化活性,对高含盐废水中RhB的5 h降解去除率最高可达90%左右.