Composting projects under the Clean Development Mechanism: sustainable contribution to mitigate climate change

The Clean Development Mechanism (CDM) of the Kyoto Protocol aims to reduce greenhouse gas emissions in developing countries and at the same time to assist these countries in sustainable development. While composting as a suitable mitigation option in the waste sector can clearly contribute to the former goal there are indications that high rents can also be achieved regarding the latter. In this article composting is compared with other CDM project types inside and outside the waste sector with regards to both project numbers and contribution to sustainable development. It is found that, despite the high number of waste projects, composting is underrepresented and a major reason for this fact is identified. Based on a multi-criteria analysis it is shown that composting has a higher potential for contribution to sustainable development than most other best in class projects. As these contributions can only be assured if certain requirements are followed, eight key obligations are presented.     

A hybrid method for quasi-three-dimensional slope stability analysis in a municipal solid waste landfill

Limited space for accommodating the ever increasing mounds of municipal solid waste (MSW) demands the capacity of MSW landfill be maximized by building landfills to greater heights with steeper slopes. This situation has raised concerns regarding the stability of high MSW landfills. A hybrid method for quasi-three-dimensional slope stability analysis based on the finite element stress analysis was applied in a case study at a MSW landfill in north-east Spain. Potential slides can be assumed to be located within the waste mass due to the lack of weak foundation soils and geosynthetic membranes at the landfill base. The only triggering factor of deep-seated slope failure is the higher leachate level and the relatively high and steep slope in the front. The valley-shaped geometry and layered construction procedure at the site make three-dimensional slope stability analyses necessary for this landfill. In the finite element stress analysis, variations of leachate level during construction and continuous settlement of the landfill were taken into account. The "equivalent" three-dimensional factor of safety (FoS) was computed from the individual result of the two-dimensional analysis for a series of evenly spaced cross sections within the potential sliding body. Results indicate that the hybrid method for quasi-three-dimensional slope stability analysis adopted in this paper is capable of locating roughly the spatial position of the potential sliding mass. This easy to manipulate method can serve as an engineering tool in the preliminary estimate of the FoS as well as the approximate position and extent of the potential sliding mass. The result that FoS obtained from three-dimensional analysis increases as much as 50% compared to that from two-dimensional analysis implies the significance of the three-dimensional effect for this study-case. Influences of shear parameters, time elapse after landfill closure, leachate level as well as unit weight of waste on FoS were also investigated in this paper. These sensitivity analyses serve as the guidelines of construction practices and operating procedures for the MSW landfill under study.     

Papermill industrial waste as a sustainable source for high efficiency absorbent production

Papermill sludge (PMS) is generated during the wastewater treatment process of paper production. Its handling and disposal techniques are of great concern for the environment. It can be landfilled as a waste, or it can be recycled and converted into useful products of high value. It has a very promising application as an absorbing agent for the cleaning of water surfaces polluted with hydrophobic substances (vegetable, synthetic and mineral oils, animal fats, fuels, organic chemicals and even coal dust). Here, we present the pretreatment procedure (hydrophobation, mechanical and thermal treatments) of PMS that produces a lightweight absorbent material (HAWSC - high efficiency absorbent for water surface cleaning), which floats on the water surface and binds hydrophobic pollutants with considerably higher efficiency than commercially available mineral and synthetic absorbents. After its application, it can be incinerated, due to its high caloric value, to produce energy. The incineration residues can then be formed into granules that can be used as an efficient absorbent for fluids spilled onto solid surfaces.     

Effects of alkyl polyglycoside (APG) on composting of agricultural wastes

Composting is the biological degradation and transformation of organic materials under controlled conditions to promote aerobic decomposition. To find effective ways to accelerate composting and improve compost quality, numerous methods including additive addition, inoculation of microorganisms, and the use of biosurfactants have been explored. Studies have shown that biosurfactant addition provides more favorable conditions for microorganism growth, thereby accelerating the composting process. However, biosurfactants have limited applications because they are expensive and their use in composting and microbial fertilizers is prohibited. Meanwhile, alkyl polyglycoside (APG) is considered a “green” surfactant. This study aims to determine whether APG addition into a compost reaction vessel during 28-day composting can enhance the organic matter degradation and composting process of dairy manure. Samples were periodically taken from different reactor depths at 0, 3, 5, 7, 14, 21, and 28 days. pH levels, electrical conductivity (EC), ammonium and nitrate nitrogen, seed germination indices, and microbial population were determined. Organic matter and total nitrogen were also measured.Compared with the untreated control, the sample with APG exhibited slightly increased microbial populations, such as bacteria, fungi, and actinomycetes. APG addition increased temperatures without substantially affecting compost pH and EC throughout the process. After 28 days, APG addition increased nitrate nitrogen concentrations, promoted matter degradation, and increased seed germination indices. The results of this study suggest that the addition of APG provides more favorable conditions for microorganism growth, slightly enhancing organic matter decomposition and accelerating the composting process, improving the compost quality to a certain extent.     

Material and energy recovery in integrated waste management systems: the potential for energy recovery

This article is part of a set of six coordinated papers reporting the main findings of a research project carried out by five Italian universities on "Material and energy recovery in Integrated Waste Management Systems (IWMS)". An overview of the project and a summary of the most relevant results can be found in the introductory article of the series. This paper describes the work related to the evaluation of mass and energy balances, which has consisted of three major efforts (i) development of a model for quantifying the energy content and the elemental compositions of the waste streams appearing in a IWMS; (ii) upgrade of an earlier model to predict the performances of Waste-to-Energy (WtE) plants; (iii) evaluation of mass and energy balances of all the scenarios and the recovery paths considered in the project. Results show that not only the amount of material available for energy recovery is significantly higher than the Unsorted Residual Waste (URW) left after Separate Collection (SC), because selection and recycling generate significant amounts of residues, but its heating value is higher than that of the original, gross waste. Therefore, the energy potential of what is left after recycling is always higher than the complement to 100% of the Source Separation Level (SSL). Also, increasing SSL has marginal effects on the potential for energy recovery: nearly doubling SSL (from 35% to 65%) reduces the energy potential only by one fourth. Consequently, even at high SSL energy recovery is a fundamental step of a sustainable waste management system. Variations of SSL do bring about variations of the composition, heating value and moisture content of the material fed to WtE plants, but these variations (i) are smaller than one can expect; (ii) have marginal effects on the performances of the WtE plant. These considerations suggest that the mere value of SSL is not a good indicator of the quality of the waste management system, nor of its energy and environmental outcome. Given the well-known dependence of the efficiency of steam power plants with their power output, the efficiency of energy recovery crucially depends on the size of the IWMS served by the WtE plant. A fivefold increase of the amount of gross waste handled in the IWMS (from 150,000 to 750,000 tons per year of gross waste) allows increasing the electric efficiencies of the WtE plant by about 6-7 percentage points (from 21-23% to 28.5% circa).     

A techno-economic comparison of fluidized bed gasification of two mixed plastic wastes

A comparison between the most promising design configurations for the industrial application of gasification based, plastics-to-energy cogenerators in the 2-6 MWe range is presented. A pilot scale bubbling fluidized bed air gasifier, having a feeding capacity of 100 kg/h, provided experimental data: the syngas complete composition, the characterization of the bed material, the entrained fines collected at the cyclone and the purge material from the scrubber. Mass and energy balances and material and substance flow analyses have been therefore drawn to assess and compare design solutions utilizing two mixed plastic wastes (MPW) obtained from separate collection of plastic packaging, after different levels of pre-treatments. The related techno-economic performances have been finally estimated on the basis of the manufacturer’s specifications. The study concludes that the MPW obtained after a very simple pre-treatment and fed to a gasifier coupled with a steam turbine is the solution that currently offers the higher reliability and provides the higher internal rate of return for the investigated range of electrical energy production.     

Phytostabilization of semiarid soils residually contaminated with trace elements using by-products: sustainability and risks

We investigated the efficiency of various by-products (sugarbeet lime, biosolid compost and leonardite), based on single or repeated applications to field plots, on the establishment of a vegetation cover compatible with a stabilization strategy on a multi-element (As, Cd, Cu, Pb and Zn) contaminated soil 4-6 years after initial amendment applications. Results indicate that the need for re-treatment is amendment- and element-dependent; in some cases, a single application may reduce trace element concentrations in above-ground biomass and enhance the establishment of a healthy vegetation cover. Amendment performance as evaluated by % cover, biomass and number of colonizing taxa differs; however, changes in plant community composition are not necessarily amendment-specific. Although the translocation of trace elements to the plant biotic compartment is greater in re-vegetated areas, overall loss of trace elements due to soil erosion and plant uptake is usually smaller compared to that in bare soil.     

Engineered nanomaterials in rivers--exposure scenarios for Switzerland at high spatial and temporal resolution

Probabilistic material flow analysis and graph theory were combined to calculate predicted environmental concentrations (PECs) of engineered nanomaterials (ENMs) in Swiss rivers: 543 river sections were used to assess the geographical variability of nano-TiO₂, nano-ZnO and nano-Ag, and flow measurements over a 20-year period at 21 locations served to evaluate temporal variation. A conservative scenario assuming no ENM removal and an optimistic scenario covering complete ENM transformation/deposition were considered. ENM concentrations varied by a factor 5 due to uncertain ENM emissions (15%-85% quantiles of ENM emissions) and up to a factor of 10 due to temporal river flow variations (15%-85% quantiles of flow). The results indicate highly variable local PECs and a location- and time-dependent risk evaluation. Nano-TiO₂ median PECs ranged from 11 to 1′623 ng L⁻¹ (conservative scenario) and from 2 to 1′618 ng L⁻¹ (optimistic scenario). The equivalent values for nano-ZnO and nano-Ag were by factors of 14 and 240 smaller.     

Functional redundancy and food web functioning in linuron-exposed ecosystems

An extensive data set describing effects of the herbicide linuron on macrophyte-dominated microcosms was analysed with a food web model to assess effects on ecosystem functioning. We showed that sensitive phytoplankton and periphyton groups in the diets of heterotrophs were gradually replaced by more tolerant phytoplankton species as linuron concentrations increased. This diet shift--showing redundancy among phytoplankton species--allowed heterotrophs to maintain their functions in the contaminated microcosms. On an ecosystem level, total gross primary production was up to hundred times lower in the treated microcosms but the uptake of dissolved organic carbon by bacteria and mixotrophs was less sensitive. Food web efficiency was not consistently lower in the treated microcosms. We conclude that linuron predominantly affected the macrophytes but did not alter the overall functioning of the surrounding planktonic food web. Therefore, a risk assessment that protects macrophyte growth also protects the functioning of macrophyte-dominated microcosms.     

Pesticide exposure and serum organochlorine residuals among testicular cancer patients and healthy controls

The incidence of testicular cancer (TC) has been increasing worldwide during the last decades. The reasons of the increase remains unknown, but recent findings suggest that organochlorine pesticides (OPs) could influence the development of TC. A hospital-based case-control study of 50 cases and 48 controls was conducted to determine whether environmental exposure to OPs is associated with the risk of TC, and by measuring serum concentrations of OPs, including p,p'-dichlorodiphenyldichloroethylene (p,p'-DDE) isomer and hexachlorobenzene (HCB) in participants. A significant association was observed between TC and household insecticide use (odds ratio [OR] = 3.01, 95 % CI: 1.11-8.14; OR(adjusted) = 3.23, 95 % CI: 1.15-9.11). Crude and adjusted ORs for TC were also significantly associated with higher serum concentrations of total OPs (OR = 3.15, 95 % CI: 1.00-9.91; OR(adjusted) = 3.34, 95 % CI: 1.09-10.17) in cases compared with controls. These findings give additional support to the results of previous research that suggest that some environmental exposures to OPs may be implicated in the pathogenesis of TC.