Semiconductor-assisted photocatalytic degradation of reactive dyes in aqueous solution

This work reports the semiconductor-assisted photochemical degradation of reactive dyes. In an oxygenated-UV-ZnO system almost total decolorization of Remazol Brilliant Blue R, Remazol Black B, Reactive Blue 221 and Reactive Blue 222 was observed in reaction times of about 60 min. Extending the photochemical treatment up to 120 min, mineralization higher than 80% for all the dyes was observed. During the same period, the residual acute toxicity was significantly reduced only for Remazol Black B. A systematic optimization study carried out by factorial design showed that for the reactive dyes tested, the ZnO semiconductor exhibits a better efficiency than that observed with anatase TiO2. A synergistic effect in the coupled TiO2-ZnO system was not observed.     

Decrease of PCDD/F levels in human blood from Germany over the past ten years (1989-1998)

744 whole blood samples of normal subjects from Germany collected in 1989-1998 have been analyzed for polychlorinated dibenzo-p-dioxins (PCDD) and dibenzofurans (PCDF) by capillary gas chromatography/high resolution mass spectrometry. Over the examined time period a continuous decrease of the PCDD/F concentrations in human blood was observed. The mean levels found were 43.7 pg I-TEq/g (lipid basis) in 1989 and 20.7 pg I-TEq/g (lipid basis) in 1996/98 [median: 42.2 and 19.4]. The reduction to about the half was found for most congeners. Each one-year subset of the collective and the entire collective shows a positive correlation of the PCDD/F blood levels with age for most of the congeners, the sum values and the calculated toxicity equivalents. For statistical evaluation a multiplicative model was used: Concentration = A x Age(B). The correlation is mostly pronounced for lower chlorinated PCDD and for 2,3,4,7,8-PentaCDF. The PCDD/F concentrations in human blood in relation to the year of examination and the age of the subjects can be described by a linear model: I-TEq [pg/g (lipid basis)] = 6176 - 3.097 x Year + 0.6482 x Age or by a multiplicative model: I-TEq [pg/g(lipid basis)] = 10(89.08-0.04415 x Year + 0.008468 x Age).     

Pollen germination is impeded by tap water

Pollen germination in vitro is totally inhibited in tobacco (Nicotiana tabacum) and other species if tap water is used to prepare the germination medium. This effect is already fully present if tap water accounts for only 25% of the medium. Furthermore, the pollen grains deteriorate rapidly and the culture medium turns yellowish-brown. The water toxicity is not caused by one or several compounds regularly monitored by the water authorities but can be removed by ion exchange purification. Although the factor(s) responsible for the inhibition were not identified, the study clearly shows the presence of such a contaminant in three different Orange County (Southern California) water wells. The fact that a fundamental botanical process like pollen germination is inhibited by a factor in drinking water not included in water quality control causes some general health concern. In addition, crop yield might be largely reduced if overhead spray irrigation with this water is utilized. The experiments also suggest that pollen germination in vitro could serve as a sensitive and simple bioassay for water quality.     

Comparison of microbial community between two shallow freshwater lakes in middle Yangtze basin, East China

In order to investigate the role of the microbial community in aquatic ecology and nutrient transformations in the development of eutrophication in large shallow freshwater lakes along Yangtze River, the microbial community in the depth-related sediment in Lake Chaohu and Lake Longganhu were compared. Lake Chaohu is one of the three most polluted lakes in China. However, the neighboring Lake Longganhu, a mesotrophic lake, is relatively pristine. The total phosphorous (TP) and total nitrogen (TN) concentration in water was detected at 0.193 mgl(-1) and 3.035 mgl(-1) for Lake Chaohu, 0.051 mgl(-1) and 0.774 mgl(-1) for Lake Longganhu, respectively. The population of the microorganisms with various ecological nutrient transforming functions (e.g. phosphate solubilizing, denitrifying and cellulose decomposing) and a batch of environmental parameters concerning the nutrient accumulating and transforming (e.g. total organic carbon, total nitrogen, and total phosphorous concentrations) were assayed in the depth-related sediment samples from several defined points in both lakes. The sediment samples from Lake Chaohu showed higher density of actinomycetes (P<0.05) and phosphate-solubilizing bacteria (P<0.001) and less profusion of denitrifying bacteria (P<0.05) and cellulolytic microbes (P<0.001), compared with those of Lake Longganhu. The data suggested that the current microbial community in the sediment of Lake Chaohu is in favor of sustaining or further accelerating the process of the lake eutrophication. A possible positive feedback loop which consists of sustained growth of microorganisms and gradual decline of lake eutrophic status is worth further discussing.     

The effect of diesel fuel sulfur content on particulate matter emissions for a nonroad diesel generator

The effect of sulfur content on diesel particulate matter (DPM) emissions was studied using a diesel generator (Generac Model SD080, rated at 80 kW) as the emission source to simulate nonroad diesel emissions. A load simulator was used to apply loads to the generator at 0, 25, 50, and 75 kW, respectively. Three diesel fuels containing 500, 2100, and 3700 ppm sulfur by weight were selected as generator fuels. The U.S. Environmental Protection Agency sampling Method 5 "Determination of Particulate Matter Emissions from Stationary Sources" together with Method 1A "Sample and Velocity Traverses for Stationary Sources with Small Stacks or Ducts" was adopted as a reference method for measurement of the exhaust gas flow rate and DPM mass concentration. The effects of various parameters on DPM concentration have been studied, such as fuel sulfur contents, engine loads, and fuel usage rates. The increase of average DPM concentrations from 3.9 mg/Nm3 (n cubic meter) at 0 kW to 36.8 mg/Nm3 at 75 kW is strongly correlated with the increase of applied loads and sulfur content in the diesel fuel, whereas the fuel consumption rates are only a function of applied loads. An empirical correlation for estimating DPM concentration is obtained when fuel sulfur content and engine loads are known for these types of generators: Y = Zm(alphaX + beta), where Y is the DPM concentration, mg/m3, Z is the fuel sulfur content, ppm(w) (limited to 500-3700 ppm(w)), X is the applied load, kW, m is the constant, 0.407, alpha and beta are the numerical coefficients, 0.0118 +/- 0.0028 (95% confidence interval) and 0.4535 +/- 0.1288 (95% confidence interval), respectively.     

One-year study of the elemental composition and source apportionment of PM10 aerosols in Florence, Italy

An extensive investigation was carried out for the characterisation of the air particulate composition in Florence. The aim was to determine the aerosol elemental concentrations, as well as to identify pollution sources. For our investigation, the external Particle-Induced X-Ray Emission-Particle-Induced gamma-Ray Emission beam facility of the Istituto Nazionale di Fisica Nucleare, Van de Graaff accelerator at the Physics Department of the Florence University was used. We report the results of the analysis of a long temporal series (approximately 1 yr) of PM10 particulate samples, collected on Millipore filters on a daily basis in three different sites (characterised by different urban settings). Daily concentrations of more than 20 elements were detected. The long sampling period (approximately 1 yr) allowed a comparison with the air quality recommended values and the identification of seasonal variations. Four main sources (traffic, oil-combustion, soil-dust, and wind transported sea-salt) were extracted with the help of Principal Component Analysis (PCA). An absolute PCA showed traffic to be the major source both in the high traffic site and in the urban background site.     

Development and calibration of epiphytic lichens as saltfall biomonitors--dry-deposition modelling

Blubber collected from beluga whales and ringed seals during subsistence hunts in the southern Baffin Island region of the Canadian Arctic were analysed for polychlorinated naphthalenes and eight planar PCB congeners (mono-ortho PCBs: 105, 114, 118 and 156; non-ortho PCBs: 77, 81, 126, 169). SigmaPCN (3-7 Cl) concentrations in blubber ranged from 35.9-383 pg/g (lipid weight; lw) in beluga and 35.4-71.3 pg/g (lw) in ringed seal. These represent the first measurements of PCNs in marine mammals in the Canadian Arctic, mammals which are an important part of the traditional diet of the indigenous population. SigmaCoplPCB concentrations were much higher, ranging from 15.5-317 ng/g (lw) in beluga whale blubber and 16.5-40.9 ng/g (lw) in ringed seal blubber. PCNs and coplanar PCBs both exhibit dioxin-like toxicity. Although average sigmaPCN concentrations were less than 1% of sigmaCoplPCBs, PCNs contribute up to 11% of TEQ relative to the coplanar PCBs based on TEFs determined by H4IIE enzyme assays.     

Debromination of hexabromobenzene by its co-grinding with CaO

A hexabromobenzene (HBB, C6Br6) powder was subjected to co-grinding with excess CaO powder in air using a planetary ball mill to investigate mechanochemical debromination of the HBB sample. The reaction proceeds smoothly with an increase in both grinding time and molar ratio of CaO addition. The co-grinding enables us to debrominate HBB, forming CaBr2, C and CaCO3 besides excess CaO in the product. CaBr2 in the product tends to absorb moisture from the atmosphere to form CaBr2 x nH2O. The reaction yield is quantitatively evaluated by measuring the amount of water-soluble bromide through water washing and the amount of unreacted HBB through toluene washing. It is found that almost 100% of debromination is achieved by 6 h grinding with the molar ratio kept constant at 2:1. Radicals are detected in the ground products, possibly due to rupture in the covalent bonds of C-C and C-Br in HBB.     

Environmental risk assessment of human pharmaceuticals in Denmark after normal therapeutic use

An environmental risk assessment is presented for the 25 most used pharmaceuticals in the primary health sector in Denmark. Predicted environmental concentrations (PECs) for the aquatic environment were calculated using conservative assumptions and all PECs exceeded 1 ng/l. Measured concentrations were in general within a factor of 2-5 of PECs and ranged from approximately 0.5 ng/l to 3 micrograms/l for nine of the pharmaceuticals reported in literature. The calculation of predicted no-effect concentration (PNEC) based on aquatic ecotoxicity data was possible for six of the pharmaceuticals. PEC/PNEC ratio exceeded one for ibuprofen, acetylsalicylic acid, and paracetamol. For estrogens the PEC/PNEC ratio approached one when non-standard test was used. The ratio was below one for estrogens (standard test), diazepam and digoxin. For the terrestrial compartment, toxicity data were not available, and no assessment was carried out. Comparisons of predicted concentrations of furosemide, ibuprofen, oxytetracycline and ciprofloxacin in sludge based on either preliminary experimental sludge-water partition coefficients (Kd), octanol-water coefficients (Kow) or acid-base constants (pKa) revealed large variations.     

Methodologies for estimating disaggregated anthropogenic emissions--application to a coastal Mediterranean region of Spain

Regional estimates of both anthropogenic and biogenic emissions are important inputs for models of atmospheric chemistry. A disaggregated emissions inventory of all relevant pollutants for an area of 100 x 100 km2 centered in Burriana (Castellon, Spain) has been worked out. Time and spatial resolutions were hourly and 1 x 1 km2, respectively. Estimates were made for all relevant sources of anthropogenic emissions. The pollutants considered were SO2, NOx, NMVOCs (nonmethane volatile organic compounds), CH4, CO, CO2, N2O, and NH3. Thus, the emissions inventory includes up to 18 different NMVOCs. Emissions were computed for a typical sunny workday in June when strong photochemical activity could be expected. A "top-down" methodology was applied, taking as a starting point official annual and provincial estimates based on CORINAIR emission factors. This procedure is a very useful tool, particularly for those cases where a lack of sufficient local detailed information about the main emission-generating activities, such as road traffic, makes the use of a "bottom-up" approximation inadvisable. Moreover, updating these emission inventories is easier and they could be used to evaluate the impact of possible abatement strategies.