Dissipation of racemic mecoprop and dichlorprop and their pure R-enantiomers in three calcareous soils with and without peat addition

Two racemic herbicides, mecoprop (R,S-MCPP) and dichlorprop (R,S-DCPP), as well as their enantiopure R-forms, were incubated in three calcareous soils at 15 degrees C and 80% of their field capacity to try to elucidate their behaviour in soil and compare the dissipation rates when racemic and enantiopure compounds are used. Quantitation of pesticides is made by HPLC and the R/S ratio by GC-MS. The inactive S-enantiomer from the racemic forms persists longer than the R-forms in silt and sandy loam soils, but for shorter time in the clay loam soil. The pure R-enantiomers, both for MCPP and DCPP, after incubation in soil, are partially converted into their S-forms. In all cases, the dissipation of racemic and pure enatiomeric forms is lower in the clay loam soil than in the silt and sandy loam soils. The R-forms' peristence, in the three soils, is approximately two times lower when they are incubated alone than when they are incubated as racemic compounds. When peat is added, the persistence of these herbicides in the silt and sandy loam soils increases, while in the clay loam soil it decreases. Besides, in the clay loam soil, the enantiomeric ratio (ER) changes from its S-preferential degradation to a preferential degradation of its R-form, so an increase in the persistence of the inactive S-form occurs.     

Acetochlor as a soil pollutant

Acetochlor is a widely used herbicide all over the world. Similarly to other organic pollutants, the environmental fate of the acetochlor is strongly related to its adsorption properties. Static adsorption equilibrium measurements were carried out at 25 degrees C on different types of Hungarian soils characterized by varying amounts of organic matter and pH values. Isotherms obtained under different conditions, as well as on various soils, exhibit a similar shape, thus indicating a two-step adsorption process. The plots cannot be interpreted according to the classes of isotherms suggested by Giles. The adsorption coefficients (K) were estimated from the initial slope of the curves. These values were determined not only by the type of the soil, but also by the composition of the aqueous media. The organic matter adsorption coefficients (Kom) were also calculated and they were approximately identical for soils of high organic matter. Due to the low value of the adsorption coefficients, the acetochlor is a rather mobile pollutant of the soil posing a potential danger to the aquatic environment. For soils with high organic content, the Kom values are similar to each other and, due to the significant coverage of the inorganic surfaces, the adsorption is controlled by the solute-organic substance interactions. The adsorption of weakly polar compounds, however, is remarkable even on those soils where the organic content is low. In this case, the binding is governed by the solute-inorganic surface interactions. This conclusion is nicely proved by the adsorption of the acetochlor on quartz. According to our hypothesis, the second part of the adsorption step is controlled by the solute-adsorbed solute interactions. The role of the organic matter in this region of the isotherm is probably negligible. As the organic matter content of the soils plays an important role in the acetochlor adsorption, humic substances must have a strong influence upon the transport of this compound. Experiments to obtain adsorption isotherms of further pesticides and the development of a quantitative model are in progress.     

Evaluation of total volatile organic compound emissions from adhesives based on chamber tests

In 1997, Homeswest in western Australia and Murdoch University developed a project to construct low-allergen houses (LAHs) in a newly developed suburb. Before the construction of LAHs, all potential volatile organic compound (VOC) emission materials used in LAHs are required to be measured to ensure that they are low total VOC (TVOC) emission materials. This program was developed based on this purpose. In recent times, the number of complaints about indoor air pollution caused by VOCs has increased. A number of surveys of indoor VOCs have indicated that many indoor materials contribute to indoor air pollution. Although some studies have been conducted on the characteristics of VOC emissions from adhesives, most of them were focused on VOC emissions from floor adhesives. Few measurements of VOC emissions from adhesives used for wood, fabrics, and leather are available. Furthermore, most research on VOC emissions from adhesives has been done in countries with cool climates, where ventilation rates in the indoor environment are lower than those in Mediterranean climates, due to energy conservation. VOCs emitted from adhesives have not been sufficiently researched to prepare an emission inventory to predict indoor air quality and to determine both exposure levels for the Australian population and the most appropriate strategies to reduce exposure. An environmental test chamber with controlled temperature, relative humidity, and airflow rate was used to evaluate emissions of TVOCs from three adhesives used frequently in Australia. The quantity of TVOC emissions was measured by a gas chromatography/flame ionization detector. The primary VOCs emitted from each adhesive were detected by gas chromatography/mass spectrometry. The temporal change of TVOC concentrations emitted from each adhesive was tested. A double-exponential equation was then developed to evaluate the characteristics of TVOC emissions from these three adhesives. With this double-exponential model, the physical processes of TVOC emissions can be explained, and a variety of emission parameters can be calculated. These emission parameters could be used to estimate real indoor TVOC concentrations in Mediterranean climates.     

Trace elements in striped dolphins (Stenella coeruleoalba) from the western Mediterranean

Tissues obtained from Stenella coeruleoalba stranded along the Spanish and Italian Mediterranean coasts from 1987 to 1994 were analysed for cadmium (Cd), copper (Cu), mercury (Hg), selenium (Se) and zinc (Zn). The age, length and weight of the dolphins were recorded. Hg levels were also assayed in skin biopsies from dolphins of the same species in the waters off northeastern Spain and in the Tyrrhenian and Ligurian Seas. Levels of all elements differed in muscle of stranded dolphins from the two areas. Hg was higher in tissues from animals stranded on the Italian coasts and in skin biopsies obtained in the Tyrrhenian and Ligurian Seas, than in the respective Spanish samples. This is probably related to Hg pollution from the natural weathering of cinnabar ores in central Italy. Se and Cd levels had similar accumulation patterns to those of Hg. Accumulation of Hg and Se is explained by the existence of a detoxification pathway involving both elements, however the reason for the similar Cd trend is unclear. Geographical differences in the accumulation pattern of these elements may reflect the existence of two different populations of Stenella coeruleoalba in the western Mediterranean.     

Leaching of glyphosate and AMPA under two soil management practices in Burgundy vineyards (Vosne-Romanée, 21-France)

Some drinking water reservoirs under the vineyards of Burgundy are contaminated with herbicides. Thus the effectiveness of alternative soil management practices, such as grass cover, for reducing the leaching of glyphosate and its metabolite, AMPA, through soils was studied. The leaching of both molecules was studied in structured soil columns under outdoor conditions for 1 year. The soil was managed under two vineyard soil practices: a chemically treated bare calcosol, and a vegetated calcosol. After 680 mm of rainfall, the vegetated calcosol leachates contained lower amounts of glyphosate and AMPA (0.02% and 0.03%, respectively) than the bare calcosol leachates (0.06% and 0.15%, respectively). No glyphosate and only low amounts of AMPA (<0.01%) were extracted from the soil. Glyphosate, and to a greater extent, AMPA, leach through the soils; thus, both molecules may be potential contaminants of groundwater. However, the alternative soil management practice of grass cover could reduce groundwater contamination by the pesticide.     

Co-occurrence patterns of some small-bodied freshwater fishes in southwestern France: implications for fish conservation and environmental management

We assessed the influence of environmental variables (elevation, stream order, distance from source, catchment area, slope, stream width, and fish species richness) on the co-occurrence patterns of the minnow, the stone loach, and the gudgeon at the stream system scale. A total of 474 sites were classified according to the seven variables using the Self-Organizing Map (neural network), and three clusters were detected (k-means algorithm). The frequency of the various fish co-occurrence patterns was calculated for each cluster, and general linear modeling was used to specify the conditions that predict the occurrence of each species. Piedmont streams were more likely to support coexisting gudgeon and minnow populations because of higher probabilities of occurrence for both species. The higher co-occurrence frequency for the three species together in headwater streams resulted from lower occurrence frequencies in gudgeon and minnow. Focusing on areas that favor the co-occurrence of species may enhance the effectiveness of conservation projects.     

Sorption of copper and nickel by spent animal bones

Animal bone is able to adsorb copper and nickel ions from their single aqueous solutions. It was noted that a decrease in the sorbent concentration with constant copper or nickel concentration, or an increase in the copper or nickel concentration with a constant sorbent concentration resulted in a higher metal loading per unit weight of the sorbent. Increase in the initial pH of the metal solution resulted in an increase in the metals uptake per unit weight of the sorbent. Freundlich isotherm model was found to be applicable for the experimental data of Cu2+ and Ni2+. The results showed that animals bones can be used for the adsorption of the Cu2+ and Ni2+ with higher affinity toward Cu2+ ions. The new sorbent was able to decrease copper concentration to a limit lower than the limit permitted by the environmental regulations.     

The importance of biological factors affecting trace metal concentration as revealed from accumulation patterns in co-occurring terrestrial invertebrates

As physicochemical properties of the soil highly influence the bioavailable fraction of a particular trace metal, measured metal body burdens in a particular species are often assumed to be more reliable estimators of the contamination of the biota. To test this we compared the Cd, Cu and Zn content of three spiders (generalist predators) and two amphipods (detritivores), co-occurring in seven tidal marshes along the river Schelde, between each other and with the total metal concentrations and the concentrations of four sequential extractions of the soils. Correlations were significant in only one case and significant site x species interactions for all metals demonstrate that factors affecting metal concentration were species and site specific and not solely determined by site specific characteristics. These results emphasize that site and species specific biological factors might be of the utmost importance in determining the contamination of the biota, at least for higher trophic levels. A hypothetical example clarifies these findings.     

Formation and emission of chloroanisoles as indoor pollutants

GOAL, SCOPE AND BACKGROUND: Complaints by residents of frame-houses about musty odour in the houses has become an increasing problem within the last years. An additional problem is that the odour is transferred to clothes and skin. The persons themselves do not recognize the smell after a while because of adaptation. Serious social problems are the result. For a long time, the smell was explained to be from mould due to construction-based humidity problems. However, in an increasing number of houses, no indications were found for elevated levels of mould growth. METHODS: Air and material samples were taken from 5 houses, which show typical musty odours, and analysed with respect to chlorophenols and chloroanisoles. Additionally, some samples were analysed for lindane and its metabolites, because lindane was commonly used together with pentachlorophenol (PCP) for wood protection. RESULTS AND DISCUSSION: Meticulous analysis resulted in the identification of chloroanisoles, mainly 2,3,4,6-tetrachloroanisole. These substances are known from corky wines and from contamination of food from pentachlorophenol (PCP) treated pallets and result from microbiological metabolic processes. Pentachlorophenol was commonly used to protect wood from fungi in Germany mainly in the later 60s and 70s. Details of these processes, as well as effective methods to identify chloroanisoles in the problem houses, are described. CONCLUSIONS: Chloroanisoles formed by metabolism of PCP have been well known to contaminate food or wine. Here, they were identified and are probably responsible for the musty odours in the frame houses. Since it is quite clear that these substances were not components of building materials used in the houses, an explanation for chloroanisole formation is proposed. Localized dampness probably favours microbial growth associated with metabolic conversion of chlorophenols to the corresponding chloroanisoles, primarily 2,3,4,6-tetrachloroanisol, which spread throughout the buildings, resulting in the observed odours. RECOMMENDATIONS AND OUTLOOK: The group of chloroanisoles has been recognized as important indoor pollutants as they possess musty odours at extremely low concentrations, e.g. for 2,4,6-trichloroanisole in a range of 5-10 ppt in air (Staples 2000). On the basis of currently available toxicological data, exposure of the occupants to the concentrations of chloroanisoles measured is not associated with a health risk. No correlation could be observed between concentrations of chloroanisoles and PCP in house dust and indoor air. However, chloroanisoles are good indicators for possible PCP-treatment of wood in frame houses and their detection should initiate investigations on PCP contamination. Research is continuing to identify the microorganisms involved and to devise a remediation procedure for affected houses.     

Adsorption of atrazine from aqueous solution on heat treated kerolites

The adsorption of 6-chloro-N(2)-ethyl-N(4)-isopropyl-1,3,5-triazine-2,4-diamine (atrazine) on heat treated kerolite samples at 110 degrees C (K-110), 200 degrees C (K-200), 400 degrees C (K-400) and 600 degrees C (K-600) from aqueous solution at 25 degrees C has been studied. The evolution of surface properties of kerolite samples such as specific surface area and porosity after heat treatment was analysed. The clays were characterised by using usual techniques: FTIR spectroscopy, XRD diffraction, TG and DTG analysis, surface analysis and Hg porosimetry. The adsorption experimental data points have been fitted to the Freundlich equation in order to calculate the adsorption capacities (K(f)) of the samples; K(f) values range from 468 mgkg(-1) for the K-110 sample up to 2291 mgkg(-1) for the K-600 sample. The values obtained for the removal efficiency (R), (percentage of pesticide removed), ranged from 48% for K-110 up to 78% for K-600. The adsorption experiments showed that the stronger heat treatment, the most effective adsorption of atrazine, so, as this type of clay is relatively plentiful, these activated samples might be used in order to remove this pesticide from water.