Characteristics and mixing state of S-rich particles in haze episodes in Beijing

Direct individual analysis using Scanning Electron Microscopy combined with online observation was conducted to examine the S-rich particles in PM_2.5 of two typical polluted haze episodes in summer and winter from 2014 to 2015 in Beijing. Four major types of S-rich particles, including secondary CaSO₄ particles (mainly observed in summer), S-rich mineral particles (SRM), S-rich water droplets (SRW) and (C, O, S)-rich particles (COS) were identified.We found the different typical morphologies and element distributions of S-rich particles and considered that (C, O, S)-rich particles had two major mixing states in different seasons. On the basis of the S-rich particles’ relative abundances, S concentrations and their relationships with PM_2.5 as well as the seasonal comparison, we revealed that the S-participated formation degrees of SRM and SRW would enhance with increasing PM_2.5 concentration. Moreover, C-rich matter and sulfate had seasonally different but significant impacts on the formation of COS.

Open image in new window

     

上海市臭氧污染时空分布及影响因素

分析2006—2016年上海市的监测数据发现,臭氧(O_3)浓度存在逐年上升趋势,污染持续时间有所增加,但除水平风速有下降趋势外,其他相关气象因素的年际变化趋势并不显著。空间分析结果表明,上海市O_3超标主要集中在西南部郊区,但市区O_3超标潜势不容忽视。O_3污染高发季节的污染玫瑰图分析发现,上海市南部地区是影响上海市O_3污染的关键区域;对于NO_2减排的影响分析发现,尽管上海市O_3平均浓度总体处于上升趋势,但在NO_2下降幅度最为明显的内环市区和北部郊区,O_3上升幅度低于NO_2下降幅度较小的内外环区域和西部郊区,表明上海市的O_3污染控制仍需持续推进NOx的减排,并同步推进VOCs的减排。     

大气颗粒物手工比对监测体系滤膜称量质控技术探讨

健全大气颗粒物手工比对监测体系是"十三五"环境空气自动监测质量管理的一项重点任务,其中颗粒物滤膜的称量直接影响手工监测数据质量。研究调研了国内各级环保部门所属环境监测机构颗粒物滤膜称量工作情况,结合国内外方法标准、技术规范等,重点探讨了称量实验室环境、称量设备、称量影响因素等滤膜称量质控要点,并针对环境管理与监测需求对大气颗粒物手工比对监测滤膜称量质控提出建议。     

高效液相色谱法测定稻米和稻田水土中多菌灵残留

采用高效液相色谱法测定稻米和稻田水土中的多菌灵残留,用稀盐酸溶液提取,经液液分配净化,外标法定量。多菌灵的峰面积与进样质量在0．15ng-220ng范围内呈线性相关,在稻田水、土壤和稻米中的最低检出质量比分别为0．01mg／kg、0．01mg／kg和0．02mg／kg。3个质量水平的加标回收试验结果表明,多菌灵在稻田水样中的平均回收率为87．1％～93．0％,RSD为3．3％～3．8％;在土壤中的平均回收率为84．8％-91．9％,RSD为1．4％～4．1％;在稻米中的平均回收率为83．9％～89．6％,RSD为1．8％-5．5％。     

Investigation into organic phosphorus species in sediments of Baiyangdian Lake in China measured by fractionation and 31P NMR

Organic phosphorus (OP) species in sediments of the Baiyangdian Lake in China was investigated via fractionation and phosphorus-31 nuclear magnetic resonance ((31)P NMR) spectroscopy. Results of chemical fractionation showed that different OP fractions ranked in the order: humic acid-P?>?HCl-OP?>?fulvic acid-P?≈?NaHCO(3)-OP?>?residual OP. Labile OP and moderately labile OP, which can be degraded for phytoplankton uptake, contributed to 58.7-68.5% of total extracted OP, indicative of the potential P release from sediments in the lake. (31)P NMR spectroscopy results suggested the rank order of P species present in the NaOH-EDTA extractant of the sediments: orthophosphate?>?monoester-P?>?DNA-P?>?pyrophosphate-P. Phytate, polyphosphates, and phosphonates, which appeared in sediments of some deeper lakes, were not detected in the shallow lake. Significant correlations were identified between total P (TP) in water column and sediment TP, monoester-P and DNA-P, positively indicating that sediment P species, especially OP components, should probably contribute to the contents of P in water column and further to the lake eutrophication.     

Evaluation of rural wastewater treatment processes in a county of eastern China

With the rapid urbanization and industrialization in China, wastewater treatment in rural areas has become an increasing national concern. The selection of appropriate treatment processes closely based on the actual local status is crucial for the prevention of water quality deterioration in rural areas of China. This study presents a full year survey on the performances of various rural wastewater treatment processes at a county level in eastern China including seven three-chamber septic tanks (ST), five micro-power biological facilities (MP), seven constructed wetlands (CW), three stabilization ponds (SP) and five centralized activated sludge treatment plants (AS). It was found that although ST could remove a notable portion of total suspended solids (TSS) and chemical oxygen demand (COD(Cr)), it was ineffective in reducing nutrients and pathogens. Reliability and stability analyses showed that the centralized AS and decentralized CW processes outperformed the SP and MP processes. There were obvious discrepancies between the mean design concentrations, which ensure that 95% of the effluents meet the discharge standards, and the actual effluent concentrations determined for each process. The expected compliance with the tentatively adopted second-grade discharge standards (GB 18918-2002) was unsatisfactory for most of the water quality parameters examined, indicating an urgent need to design more practical discharge standards for decentralized treatment processes. Based on an overall assessment of reliability, stability and cost-effectiveness, the centralized AS was suitable for densely populated towns while the decentralized CW was suitable for sparsely populated villages.     

Composition and source apportionment of PAHs in sediments at river mouths and channel in Kaohsiung Harbor, Taiwan

Fifty-eight sediment samples were collected in 2009 from the bottom of river mouths near Kaohsiung Harbor (Taiwan) and the harbor channel for the analyses of polycyclic aromatic hydrocarbons (PAHs) using gas chromatography-mass spectrometry (GC-MS). Concentrations of total PAHs varied from 39 to 30,521 ng g(-1) (dry weight); samples collected from the mouths of Love River, Canon River, Jen-Gen River, and Salt River showed the highest PAHs concentrations. This indicates that the major sources of sediment PAHs come from those polluted urban rivers and the harbor channel. In samples collected from the Salt River mouth, approximately 43% of the PAHs are identified as PAHs with 2 or 3 rings. However, samples collected from other locations contain predominantly PAHs with 4 rings (32 to 42%) or 5 and 6 rings (36 to 44%). Emissions from traffic-related sources and waste incineration contribute to the majority of PAHs found in most channel and river mouth sediments. However, coal/oil combustion is the main cause of high concentrations of PAHs observed in the Salt River mouth sediments. Principal component analyses with multivariate linear regression (PCA/MLR) have been used to further quantify the source contributions, and the results show that the contributions of coal/oil combustion, traffic-related and waste incineration are 37%, 33% and 30%, respectively.     

环境效应系数矩阵法及其在城市能源污染最优控制策略研究中的应用

本文详细描述了能够表示能源和环境相互作用的环境效应系数矩阵的使用方法,它的定义以及矩阵的生成。通过哈尔滨市能源污染对环境影响的综合评价专题研究,说明了它在能源转换和消费导致大气污染的最优控制策略中的应用。     

浙江拔茅银矿地质特征及成因

拔茅银矿是浙东中生代火山岩带中近几年新发出的金银矿田,矿床发育于破火山口机构内,矿体主要受NW及近SN向张性硅化破碎带控制。矿床的各种特征表明,其成因属浅成低温热液型。     

Modeling cold soak evaporative vapor emissions from gasoline-powered automobiles using a newly developed method

ABSTRACT

Volatile organic compounds (VOCs) evaporate and vent from a vehicle’s fuel tank to its evaporative control system when the vehicle is both driven and parked. VOCs making it past the control system are emissions. Driving and parking activity, fuel volatility, and temperature strongly affect vapor generation and the effectiveness of control technologies, and the wide variability in these factors and the sensitivity of emissions to these factors make it difficult to estimate evaporative emissions at the macro level. Established modeling methods, such as COPERT and MOVES, estimate evaporative emissions by assuming a constant in-use canister condition and consequently contain critical uncertainty when real conditions deviate from that standard condition. In this study, we have developed a new method to model canister capacity as a representative variable, and estimated emissions for all parking events based on semi-empirical functions derived from real-world activity data and laboratory measurements. As compared to chamber measurements collected during this study, the bias of the MOVES diurnal tank venting simulation ranges from ?100% to 129%, while the bias for our method’s simulation is 1.4% to 8.5%. Our modeling method is compared to the COPERT and MOVES models by estimating evaporative emissions from a Euro-3/4/5 and a Tier 2 vehicle in conditions representative for Chicago, IL, and Guangzhou, China. Estimates using the COPERT and MOVES methods differ from our method by ?56% to 120% and ?100% to 25%, respectively. The study highlights the importance for continued modeling improvement of the anthropogenic evaporative emission inventory and for tightened regulatory standards.

Implications: The COPERT and MOVES methodologies contain large uncertainties for estimating evaporative emissions, while our modeling method is developed based on chamber measurements to estimate evaporative emissions and can properly address those uncertainties. Modeling results suggested an urgent need to complete evaporative emissions inventories and also indicated that tightening evaporative emission standards is urgently needed, especially for warm areas.