颗粒流冲击力研究现状及讨论∗

颗粒流包括滑坡、泥石流、碎屑流、雪崩等,通常对桥梁、公路、居民区具有较大危害。分析了颗粒流的运动过程及其侵蚀、堆积和爬高等特性;此外,对颗粒流冲击力计算模型及其野外观测结果进行阐述。结果表明:现有冲击力计算模型认为冲击力在结构全断面呈均匀分布,忽略了颗粒流的运动特性对冲击力的影响;大块石冲击力计算忽略了颗粒破碎和浆体垫层效应对冲击力的影响,造成巨大的计算误差;由于传统传感器的缺陷,现有野外观测结果也存在较大误差。对此本文提出野外观测需要通过引入或开发新式压力传感器以得到更准确的颗粒流冲击力大小及其分布形式,从而更精确的修正理论模型;理论计算模型研究工作需要考虑颗粒流浆体的垫层效应、流体与基底的相互作用及块石冲击破碎等对流体冲击力的影响,从而推导出更准确的冲击力计算模型,指导工程实际。     

钢铁企业大型低位料仓汽车卸料的粉尘控制

某钢企大型低位料仓为汽车卸料,料仓厂房内空高,跨度大,料仓上部贯通,物料落差大,卸料中产生大量粉尘,环境污染问题典型突出。通过对低位料仓汽车卸料产尘特性分析,采取加强生产管理、组织汽车有序卸料、料仓厂房有效密闭、合理设计捕尘方式和布袋除尘系统等措施,能够有效地控制粉尘污染。除尘系统具有投资及运行费用少,除尘效果明显的优点。     

江苏省2014-2016年臭氧污染区域特征分析

分析2014—2016年江苏省O₃污染状况,以及苏北、苏中和苏南3个典型区域O₃年度、季度、日变化和频度占比等分布特征。结果表明,江苏省的O₃空间分布呈现北低南高,2014—2016年的O₃超标占比由18.4%上升至34.9%;2016年苏北、苏中和苏南地区O₃-8h第90百分位数与2014年相比,上升2.7%,21.8%和3.3%;3个区域夏季O₃-8h均值最高,春、秋2季次之,冬季最低;O₃-1h日变化呈单峰状态,最低值出现在06:00—07:00,最高值出现在15:00—16:00;2016年3个地区的O₃频度占比均呈正态分布,主要集中在40~80 μg/m³,所占比例均>15%;苏中和苏南区域2016和2014年相比O₃频率占比的变化幅度较大,苏北地区变化幅度不大。指出,江苏省的O₃污染程度在逐年提高,污染范围从苏南逐渐往中部和北部城市扩大。     

WRF模式参数化方案对江西山地风电场的风模拟研究

在WRF模式中选取不同的陆面过程、边界层以及近地面层参数化方案,设计了6种不同的参数化方案组合,模拟江西省某高山风电场测风塔2016年1月和2017年1月逐时风速、风向,并与同期实测数据进行比较,选出MRF边界层参数、WSM3微物理过程参数和Noah陆面过程参数作为最优参数化组合方案。对最优参数化组合方案的模拟结果进行整一年的逐时模拟效果检验,结果表明：最优参数化组合方案对全年风速模拟效果较好,模拟结果风速日变化趋势及风速段（0~24时）分布与实测基本一致,模拟的风速峰值及概率偏大,主要是由于模式的精度不足以准确描述山地风场复杂下垫面造成的。模式最优参数化方案对风向模拟与实测主导风向分布一致且风向频率相似     

江苏省水质全要素代表性监测体系的设计

为了评价并进行城市水环境质量考核排名,介绍了江苏省组织开展涵盖地表水、饮用水、地下水、近岸海域和城市内河5种类型"全要素、代表性"水质监测断面(点位)体系建设工作的情况以及全要素断面设置的基本原则和做法。分苏南、苏北、苏中3个区域,对全省地表水监测代表性进行了量化计算,结果表明,调整后全省水质综合指数极差从41.07降至7.17,标准差从3.16降为0.49;采用德尔斐层次分析法分析,设计了水质代表性指数,含1项一级指标、5项二级指标、12项三级指标,计算表明,调整前全省水质代表性指数得分为69.1分,调整后为88.7分。将调整结果进行论证后再与各市环保主管部门交换意见,取得最终一致后正式实施。     

Studies on polycyclic aromatic hydrocarbons in two sediment cores from the huaxi reservoir,china: Assessment of levels,sources, and ecological risk

This study investigated the levels, sources and ecological risks of 16 polycyclic aromatic hydrocarbons (PAHs) in two sediment cores that were collected along the Huaxi Reservoir. The spatial distributions and residue levels of the 16 priority PAHs in the sediments from the Huaxi Reservoir were analyzed for their potential ecological risk, source apportionment and contribution to the total PAH residue. The concentration level of the total PAHs (TPAHs) was in the range 1805 ng·g^?1 to 20023 ng·g^?1 based on dry weight, and the content of PAHs in the Huaxi Reservoir exhibited a gradual upward trend. The PAH congener ratios fluoranthene/(fluoranthene + pyrene) and indeno[1, 2, 3-cd]pyrene/(indeno[1, 2, 3-cd]pyrene + benzo[g, h, i]perylene) were used to identify the source. The main source of the low molecular weight PAHs was wood and coal combustion, whereas the high molecular weight PAHs were primarily from petroleum combustion sources. The results of an ecological risk assessment demonstrated that ACE poses a potential ecological risk, while FLU, NAP, ANT, BaP, DBA, PHEN and PYR can have serious ecological risks.     

Effect of ventilation rate on air cleanliness and energy consumption in operation rooms at rest

The interrelationships between ventilation rate, indoor air quality, and energy consumption in operation rooms at rest are yet to be understood. We investigate the effect of ventilation rate on indoor air quality indices and energy consumption in ORs at rest. The study investigates the air temperature, relative humidity, concentrations of carbon dioxide, particulate matter (PM), and airborne bacteria at different ventilation rates in operation rooms at rest of a medical center. The energy consumption and cost analysis of the heating, ventilating, and air conditioning (HVAC) system in the operation rooms at rest were also evaluated for all ventilation rates. No air-conditioned operation rooms had very highest PM and airborne bacterial concentrations in the operation areas. The bacterial concentration in the operation areas with 6–30 air changes per hour (ACH) was below the suggested level set by the United Kingdom (UK) for an empty operation room. A 70% of reduction in annual energy cost by reducing the ventilation rate from 30 to 6 ACH was found in the operation rooms at rest. Maintenance of operation rooms at ventilation rate of 6 ACH could save considerable amounts of energy and achieve the goal of air cleanliness.     

生物难降解有机污染物的治理对策

针对废水中难降解化学合成有机污染物的种类和数量不断增加，生物处理出水达标困难的现状，总结了国内外的经验和研究成果，对现有处理装置改造提出了若干建议，并介绍了几种国外废水处理新技术。     

Chemical speciation,transport and contribution of biomass burning smoke to ambient aerosol in Guangzhou,a mega city of China

Intensive measurements of aerosol (PM₁₀) and associated water-soluble ionic and carbonaceous species were conducted in Guangzhou, a mega city of China, during summer 2006. Elevated levels of most chemical species were observed especially at nighttime during two episodes, characterized by dramatic build-up of the biomass burning tracers levoglucosan and non-sea-salt potassium, when the prevailing wind direction had changed due to two approaching tropical cyclones. High-resolution air mass back trajectories based on the MM5 model revealed that air masses with high concentrations of levoglucosan (43–473 ng m^?3) and non-sea-salt potassium (0.83–3.2 μg m^?3) had passed over rural regions of the Pearl River Delta and Guangdong Province, where agricultural activities and field burning of crop residues are common practices. The relative contributions of biomass burning smoke to organic carbon in PM₁₀ were estimated from levoglucosan data to be on average 7.0 and 14% at daytime and nighttime, respectively, with maxima of 9.7 and 32% during the episodic transport events, indicating that biomass and biofuel burning activities in the rural parts of the Pearl River Delta and neighboring regions could have a significant impact on ambient urban aerosol levels.     

Measurement of the surface charge of ultrafine particles from laser printers and analysis of their electrostatic force

Ultrafine particles (UFPs) released from laser printers are electrostatically charged during the working processes of the devices, and the electrostatic force can obviously influence the dynamics of the particles. Due to the measurement difficulty and scarcity of relevant research, this issue was not reported. This study tried to address this issue through experimental measurement of the surface charge of UFPs and numerical investigation on the influence of electrostatic force on the dynamics of UFPs. A test chamber was set up to collect the UFPs, and the Scanning Electron Microscope was used to observe the morphologies of the UFPs. Based on the particle diameter and surface zeta potential, the surface charge of UFPs was calculated. The measurement results gave that particle emitted from laser printers are negatively charged and the average surface charge of particle emissions for four laser printers is in a range of about ?4.16 × 10^?17 to ?6.07 × 10^?17 C (～?260 to ?379 e). This paper also discussed the influence of electrostatic force on the dynamics of UFPs. According to the numerical investigation, it was found that, in the absence of electric field, the electrostatic force has to be considered when the surface charge is larger than 1 × 10^?16 C and when the UFP is very close to the wall with a distance of less than 0.01 m. These findings will guide constructively in predicting the dispersion and deposition of particles emitted from laser printers.