Atmospheric deposition of phthalate esters in a subtropical city

In Chinese cities, air pollution has become a serious and aggravating environmental problem undermining the sustainability of urban ecosystems and the quality of urban life. Bulk atmospheric deposition samples were collected two-weekly, from February 2007 to January 2008, at three representative areas, one suburban and two urbanized, in the subtropical city, Guangzhou, China, to assess the deposition fluxes and seasonal variations of phthalate esters (PAEs). Sixteen PAE congeners in bulk deposition samples were measured and the depositional fluxes of ∑₁₆PAEs ranged from 3.41 to 190 μg m^?2 day^?1, and were highly affected by local anthropogenic activities. The significant relationship between PAEs and particulate depositional fluxes (correlation coefficient R² = 0.72, P < 0.001) showed PAEs are associated primarily with particles. Temporal flux variations of PAEs were influenced by seasonal changes in meteorological parameters, and the deposition fluxes of PAEs were obviously higher in wet season than in dry season. Diisobutyl phthalate (DiBP), Di-n-butyl phthalate (DnBP), and Di(2-ethylhexyl) phthalate (DEHP) dominated the PAE pattern in bulk depositions, which is consistent with a high consumption of the plasticizer market in China. PAE profiles in bulk deposition showed similarities exhibited in both time and space, and a weak increase of high molecular weight PAE (HMW PAE) contribution in the wet season compared to those in the dry season. Average atmospheric deposition fluxes of PAEs in the present study were significantly higher than those from other studies, reflecting strong anthropogenic inputs as a consequence of rapid industrial and urban development in the region.     

Hawaiian Residents’ Preferences for Miconia Control Program Attributes Using Conjoint Choice Experiment and Latent Class Analysis

Invasive species control or eradication is an important issue. On the islands of Hawaii, this problem is exceedingly evident when it comes to Miconia calvescens (Miconia). Adequate funding is needed to control or eradicate this invasive plant, but with the limited amount of funding available for the fight against Miconia, it is important to make sure that the fund is being spent in a way that addresses the needs or preferences of the Hawaiian residents. Using the conjoint choice experiment method, we designed a survey that would measure the Hawaiian residents’ willingness to support Miconia control program attributes. The attributes focused on were cost, biodiversity loss, extent of spread and soil erosion. Latent class approach was used to assess the surveyed population to see the different preferences by individual classes. The results show three different classes or groups of individuals with varying preferences for a control program of which cost and erosion were the top preferred attributes among the classes. These groups were defined by their socio-demographics of income, the length of residency and exposure to farming/gardening activities. Even with a preference for lower cost, a group showed willingness to pay more ($2.40) for a program that reduces erosion from high to low. Finally, the biodiversity attribute had very low consideration from a majority of the respondents showing the need for educating the public regarding its importance in preserving the unique environment in Hawaii.     

城市总体规划环评指标体系的建立及其应用

本研究首先介绍了DPSIR模型构建的原理,接着以合肥市为对象,从驱动力、压力、状态、影响、响应5个方面来构建的共36个指标,并采用层次分析法对指标权重的确定和多级灰色关联分析对指标进行综合评价,得出评价结果。合肥市在2004~2005年处于较低可持续发展水平(0.3398、0.3876)、在2010年处于中等可持续发展水平(0.5369)、在2015年处于较高可持续发展水平(0.6016)、在2020年处于较高可持续发展水平(0.7847),该预测评价结果与合肥市城市可持续发展趋势相符。最后采用改进熵值法验证多级灰色关联综合分析结论,计算得出的结果表明,该两种方法评价结论基本相同。因此,本研究对城市总体规划环境影响评价的评价方法的建立与完善,有着较强的实践意义和参考价值。     

丹江口库区坡耕地柑桔园不同覆盖方式下地表径流氮磷流失特征

以坡耕地柑桔园为研究对象,地表覆盖方式采用对照、秸秆覆盖和地膜覆盖3个处理,实验采用完全方案。结果表明,在本实验条件下,坡地地膜覆盖处理一定程度增加了径流量,而秸秆覆盖处理与对照每次降雨径流量基本相当;各处理土壤氮磷养分均有一定程度的流失,以氮素流失量较高,磷素流失量相对较低;在地膜覆盖条件下,柑桔园地表径流中N、P流失量较高,其总氮和总磷流失系数分别达0054%和0064%,而秸秆覆盖总氮和总磷流失系数最低;对不同地表覆盖方式柑桔园地表径流水体氮素形态特征分析表明,可溶性氮素占总氮的比例较高,可溶性氮素中又以NO-3 N为主,而NH+4 N所占的比重较低。以上结果说明,在丹江口库区,氮素污染风险要高于磷,防控的主要矛盾是氮,而秸秆覆盖是减少坡耕地养分流失较好的管理措施     

CuO/γ-Al2O3类Fenton试剂降解丁基黄药

CuO/γ-Al2O3类Fenton试剂是降解丁基黄药的优良试剂。该试剂与传统的Fenton试剂相比,提高了反应的pH值,可在较高pH(4~5)条件下反应,而传统的Fenton试剂的适宜pH值一般在3以下。采用单因素实验和正交实验相结合的方法研究了pH、催化剂投加量、过氧化氢投加量以及反应时间对丁基黄药降解效果的影响,并对催化剂的使用寿命进行了探讨。研究结果表明,反应的最佳条件为:pH为4~5,催化剂投加量为6 g/L,过氧化氢用量为30 mg/L,反应30min。在此反应条件下,丁基黄药的降解率达98%以上;影响丁基黄药降解效果的因素大小顺序为:pH>反应时间>H2O2用量>催化剂投加量,其中pH对CuO/γ-Al2O3类Fenton试剂降解丁基黄药的影响最为显著。     

基于白碳黑的水化硅酸钙制备及其磷回收特性简

以白碳黑、硅灰、硅藻土和硅胶筛选硅质原料,并与钙质原料电石渣制备了水化硅酸钙。借助XRF、BET、FTIR等表征手段,通过多次重复除磷实验,研究了硅质原料特性对水化硅酸钙回收磷性能的影响。结果表明,白碳黑具有极高的反应活性,因此可作为制备具有磷回收特性的水化硅酸钙的硅质原料。结合XRD等表征发现,白碳黑的有效利用率是影响水化硅酸钙回收磷性能的关键,该利用率取决于白碳黑与电石渣的摩尔配比以及水热反应温度。当电石渣与白碳黑的摩尔比为1.6：1,反应温度为170℃时,白碳黑具有最佳的利用效率。该条件制备的水化硅酸钙可作为晶种,在其表面结晶形成羟基磷灰石,从而达到磷回收的目的,磷回收后固体物质中的磷含量为19.05%。     

负载型Mn-Ce/TiO2催化剂的制备及其低温脱硝活性简

以成型TiO₂作为载体,通过浸渍法制备了Mn-Ce/TiO₂低温SCR催化剂,并系统研究了制备方法、煅烧条件、活性组分担载量、Mn含量等参数对催化剂催化还原NO性能的影响。结果表明,煅烧温度的升高会促使活性组分结晶度的提高,从而引起催化活性的降低,在500℃和600℃下所得Mn-Ce/TiO₂催化剂活性组分为无定型态,表现出较高的脱硝活性。活性组分担载量的增加有利于催化活性的提高。Mn含量对Mn-Ce/TiO₂催化剂的活性有较大影响,当Mn/（Mn+Ce）摩尔比为40%和85%时,催化剂活性最高。     

DO浓度对间歇曝气单级自养脱氮系统N2O排放的影响

以单级自养脱氮系统为研究对象,采用有效容积为15 L的SBBR反应器,系统进水NH+4-N浓度约为360 mg/L,控制温度为(30±2)℃,采用间歇曝气方式运行,曝气段DO浓度从2.4~2.6 mg/L逐渐下降到0.9~1.1 mg/L,研究了单级自养脱氮系统的脱氮性能与N2O排放情况。结果表明,反应器曝气段DO浓度从2.4~2.6 mg/L下降到0.9~1.1mg/L,系统TN去除率均达到80%,但在相同运行时间内的TN去除率依次降低,NH+4-N平均反应速率从0.19 mg/(L·min)降低至0.05 mg/(L·min),NO-3-N累计产生量稳定于14.9~16.5 mg/L,NO-2-N浓度在反应器内未产生明显的积累。随着曝气段DO浓度的下降,最大N2O释放速率逐渐降低,N2O累计释放量从73.8 mg下降到61.0 mg,N2O转化率介于2.4%~2.9%。     

Concentration and health risk evaluation of heavy metals in market-sold vegetables and fishes based on questionnaires in Beijing,China

Concentrations of heavy metals (As, Cd, Pb, Cu, Ni, Fe, Mn, and Zn) in market vegetables and fishes in Beijing, China, are investigated, and their health risk to local consumers is evaluated by calculating the target hazard quotient (THQ). The heavy metal concentrations in vegetables and fishes ranged from not detectable (ND) to 0.21 mg/kg fresh weight (f.w.) (As), ND to 0.10 mg/kg f.w. (Cd), and n.d to 0.57 mg/kg f.w. (Pb), with average concentrations of 0.17, 0.04, and 0.24 mg/kg f.w., respectively. The measured concentrations of As, Cd, Pb, Cu, Ni, Fe, Mn, and Zn are generally lower than the safety limits given by the Chinese regulation safety and quality standards of agriculture products (GB2762-2012). As, Cd, and Pb contaminations are found in vegetables and fishes. The exceeding standard rates are 19 % for As, 3 % for Cd, and 25 % for Pb. Pb contaminations are found quite focused on the fish samples from traditional agri-product markets. The paper further analyzed the health risk of heavy metals in vegetables and fishes respectively from supermarkets and traditional agri-product markets; the results showed that the fishes of traditional agri-product markets have higher health risk, while the supermarkets have vegetables of higher heavy metal risk, and the supervision should be strengthened in the fish supply channels in traditional agri-product markets.     

废旧冰箱拆解聚氨酯泡沫塑料制备PU/PP复合材料

利用废旧冰箱拆解的聚氨酯泡沫塑料(PU)和聚丙烯(PP)、聚丙烯接枝马来酸酐(PP-g-MAH)为原料,采用物理化学回收技术制备PU/PP复合材料。用正交实验法分析PU填充量、PU粒径和PP-g-MAH 3个因素对PU/PP复合材料力学性能影响的显著性。结果表明,PU填充量对PU/PP复合材料拉伸性能有显著影响,对冲击性能和弯曲性能没有显著影响;在本文的实验范围内,PU粒径对PU/PP复合材料的力学性能影响不大;而PP-g-MAH投加量对PU/PP复合材料具有一定的影响。确定的优化工艺配方为:PU 40%;PU粒径选择2.00 mm;PP-g-MAH投加量10%。采用优化工艺制备的PU/PP复合材料的密度为1 042.88 kg/m3;冲击强度为2.9 kJ/m2;拉伸强度为10.30 MPa;拉伸模量为1 100 MPa;弯曲强度为18.5 MPa;弯曲模量为733 MPa。