Green energy generation by pressure retarded osmosis: State of the art and technical advancement—review

Pressure-retarded osmosis (PRO) is a method for converting salinity gradients to power by allowing water to flow through a semi-permeable membrane against an applied hydraulic pressure. PRO already has a long history, starting from the middle of the last century, and has rapidly improved in recent years. In this paper, we present a historical development of PRO since its inception: the development of this renewable energy process has gone through several stages, depending on technological developments, worldwide energy demands, and environmental concerns. The technological progress of the process is also studied, as well as its cost viability and environmental impact. Finally, some ideas to further develop the PRO process and mitigate its detrimental effects are discussed.     

Highly active photocatalytic coatings prepared by a low-temperature method

Photocatalytic properties of titanium (IV) oxide (TiO₂) in anatase form can be used for various purposes, including photocatalytic purification of water. For such an application, suspended or fixed photocatalytic reactors are used. Those with fixed phase seem to be preferred due to some advantages, one of which is the avoidance of photocatalyst filtration. To avoid leaching and exfoliation of the fixed phase, an immobilization procedure leading to a good adhesion of a catalyst to a substrate is crucial. Within this work, we present physical and photocatalytic characterization results of five commercially available TiO₂ photocatalysts (P25, P90, PC500, KRONOClean 7000, VPC-10) and one pigment (Hombitan LO-CR-S-M), which were successfully immobilized on glass slides by a “sol suspension” procedure. Different mechanical tests and characterization methods were used to evaluate the stability and morphology of the layers. Evaluation of photocatalytic activity was done by tests under UVA and UV–vis irradiation, using a method based on the detection of the fluorescent oxidation product of terephthalic acid (TPA), i.e., hydroxyterephthalic acid (HTPA). Aeroxide® P90 incorporated into the silica-titania binder was the most photocatalytically active layer and, unlike the others, showed significant increase of photocatalytic activity through the entire range of tested UVA irradiation intensities (2.3 mW/cm²–6.1 mW/cm²). The high mechanical stability of some photocatalytic layers allows using them in water photocatalytic purification reactions.     

A social–ecological analysis of ecosystem services in two different farming systems

In this exploratory study we use existing in situ qualitative and quantitative data on biophysical and social indicators to compare two contrasting Swedish farming systems (low intensity and high intensity) with regard to ecosystem service supply and demand of a broad suite of services. We show that the value (demand) placed on a service is not necessarily connected to the quantity (supply) of the service, most clearly shown for the services recreation, biodiversity, esthetic experience, identity, and cultural heritage. To better capture this complexity we argue for the need to develop portfolios of indicators for different ecosystem services and to further investigate the different aspects of supply and demand. The study indicates that available data are often ill-suited to answer questions about local delivery of services. If ecosystem services are to be included in policy, planning, and management, census data need to be formatted and scaled appropriately.     

Distribution of PCDD/Fs and dioxin-like PCBs in sediment and plants from a contaminated salt marsh (Tejo estuary,Portugal)

Concentrations and profiles of 2,3,7,8-substituted polychlorinated dibenzo-p-dioxins, polychlorinated dibenzofurans (PCDD/Fs) and dioxin-like polychlorinated biphenyls (dl-PCBs) were investigated in sediment and plants collected from a salt marsh in the Tejo estuary, Portugal. The highest PCDD/F and dl-PCB concentrations were detected in uncolonized sediments, averaging 325.25?±?57.55 pg g^?1 dry weight (dw) and 8,146.33?±?2,142.14 pg g^?1 dw, respectively. The plants Sarcocornia perennis and Halimione portulacoides growing in PCDD/F and dl-PCB contaminated sediments accumulated contaminants in roots, stems, and leaves. It was observed that PCDD/F and dl-PCB concentrations in roots were significantly lower in comparison with stems and leaves. In general, concentration of ΣPCDD/Fs and Σdl-PCBs in H. portulacoides tissues were found to be twofold higher than those in S. perennis, indicating a difference in the accumulation capability of both species. Furthermore, congener profiles changed between sediments and plant tissues, reflecting a selective accumulation of low chlorinated PCDD/Fs and non-ortho dl-PCBs in plants.     

Risk of laryngeal and nasopharyngeal cancer associated with arsenic and cadmium in the Tunisian population

Chronic exposure to heavy metals has long been recognized as being capable of increasing head and neck cancer (HNC) incidence, such as laryngeal (LC) and nasopharyngeal (NPC), among exposed human populations. The aim of the present study was to evaluate the concentrations of arsenic (As) and cadmium (Cd) in the blood of 145 patients (LC and NPC) and 351 controls in order to establish a potential relationship between these factors and the occurrence of LC and NPC. Mean blood levels of As and Cd in patients (5.67 and 3.51 μg/L, respectively) were significantly higher than those of controls (1.57 and 0.74 μg/L, respectively). The blood levels of As and Cd were mostly significantly higher than those of controls (p?<?0.05) after controlling the other risk factors of HNC including tobacco smoking and chewing, and alcohol drinking. Cd levels in blood increase significantly with the number of occupational exposure years for patients (p?<?0.05). However, seafood was not found to be contributing as an exposure source. Among these risk factors, smoking (>30 pack years) and occupational exposure (>20 years) presented the most significant association with HNC (OR?=?10.22 and 10.38, respectively, p?<?0.001). Cd level in blood sample of cases that are occupationally exposed/tobacco users (smokers and chewers) were higher than that of non-occupationally exposed/nontobacco users (p?<?0.001). The logistic regression model illustrated that HNC (LC?+?NPC) was significantly associated with blood levels of As (OR?=?2.41, p?<?0.001) and Cd (OR?=?4.95, p?<?0.001).     

Fluoride removal from aqueous solution by direct contact membrane distillation: theoretical and experimental studies

Direct contact membrane distillation (DCMD) process using polyvinylidene fluoride (PVDF) membrane was used for fluoride removal from aqueous solution. This study has been carried out on heat and mass transfer analyses in DCMD. The dusty-gas model was used to analyze the mass transfer mechanism and to calculate the permeate flux. The heat transfer is analyzed based on energy balance, and the different layers are considered as a series of thermal resistances. Mass transfer analysis showed that the transition Knudsen-molecular diffusion is the dominant mechanism to describe the transport of water vapor through the pores of the PVDF membrane. The most significant operating parameter is the feed temperature. The permeate increases sensitively with feed temperature and velocity, and it shows insignificant change with feed salts concentration. Heat transfer analysis showed the conduction through the matrix of the membrane presents the major part of available energy. The increasing feed temperature leads to increase thermal efficiency (TE) and decrease temperature polarization coefficient (TPC). The experimental results are in good agreement with theoretical values. Therefore, it is suggested to work at high feed temperature, which will benefit both the thermal efficiency and permeate flux. The experimental results proved that DCMD process is able to produce almost fluoride-free water suitable for many beneficial uses.     

Mechanical and toxicological evaluation of concrete artifacts containing waste foundry sand

The creation of metal parts via casting uses molds that are generally made from sand and phenolic resin. The waste generated after the casting process is called waste foundry sand (WFS). Depending on the mold composition and the casting process, WFS can contain substances that prevent its direct emission to the environment. In Brazil, this waste is classified according to the Standard ABNT NBR 10004:2004 as a waste Class II (Non-Inert). The recycling of this waste is limited because its characteristics change significantly after use. Although the use (or reuse) of this byproduct in civil construction is a technically feasible alternative, its effects must be evaluated, especially from mechanical and environmental points of view. Thus, the objective of this study is to investigate the effect of the use of WFS in the manufacture of cement artifacts, such as masonry blocks for walls, structural masonry blocks, and paving blocks. Blocks containing different concentrations of WFS (up to 75% by weight) were produced and evaluated using compressive strength tests (35 MPa at 28 days) and toxicity tests on Daphnia magna, Allium cepa (onion root), and Eisenia foetida (earthworm). The results showed that there was not a considerable reduction in the compressive strength, with values of 35 ± 2 MPa at 28 days. The toxicity study with the material obtained from leaching did not significantly interfere with the development of D. magna and E. foetida, but the growth of the A. cepa species was reduced. The study showed that the use of this waste in the production of concrete blocks is feasible from both mechanical and environmental points of view.     

Pesticide dissipation curves in peach,pear and tomato crops in Uruguay*

Dissipation curves of azoxystrobin and of the neonicotinoids acetamiprid and thiacloprid in peach; azinphos-methyl and carbaryl in pear and azoxystrobin, chlorfenapyr and chlorpyrifos in high-tunnel tomato crops were studied in the Southern region of Uruguay. An analytical methodology based on solid phase extraction (SPE) and detection by High Performance Liquid Chromatography with Diode Array Detector (HPLC/DAD) was used for acetamiprid and thiacloprid. Coupled SPE and detection by Gas Chromatography with Mass Selective Detector (GC/MSD) was used for the detection of azinphos-methyl, azoxystrobin, carbaryl, chlorfenapyr and chlorpyrifos residues. Curves were modeled mathematically with Solver program of Microsoft Excel®. The best fit for acetamiprid and thiacloprid in peach was achieved with the exponential model (r²=0.961 and 0.944, respectively). In the case of peach fruits there is not a Maximum Residue Limit (MRL) for acetamiprid in the Codex Alimentarius, while 0.5 mg/kg is the value rated for thiacloprid. The MRLs accepted by the European Union (EU) are 0.1 mg/kg for acetamiprid and 0.3 mg/kg for thiacloprid. According to the curves determined in these experiments, thiacloprid residues 10 to 12 days after application (daa) were below the MRLs established by both sources. In the case of acetamiprid, 25 daa would be required, according to the exponential mathematical model, to get residues levels below the MRL values established by the EU. For azinphos methyl in pear, the residues detected were mathematically fitted to an exponential model (r²=0.999). According to it, residue levels under the MRL established by the EU (0.05 mg/kg) are gotten in our conditions in 20 daa. In plastic tunnel tomato chlorfenapyr residues were not detected from 16 daa, having the dissipation curve an exponential trend. In the same condition, there was not a decay of the azoxystrobin concentration during a 24-day trial, being it around 0.40 ± 0.05 mg/kg.     

Effect of phenobarbital and polychlorinated biphenyls on the toxicity and disposition of 1,2,4,5‐tetrachlorobenzene in the rat

Soil avoidance by earthworms has been generally considered a relevant and sensitive endpoint for assessing soil contamination by xenobiotics. However, when pesticide ecotoxicological assessment is concerned, the sensitivity of the recently standardized avoidance assay has been questioned. We hypothesized that this controversy may be due to the specific pesticide mode of action of the chemicals used rather than reveal inconsistencies in the test feasibility, i.e. provided that no pesticides interfering with neuronal pathways are tested, this bioassay should keep expected high levels of sensitivity. In this study, the avoidance behaviour of the earthworm Eisenia andrei under exposure to the carbamate insecticide methomyl [S-methyl N-(methylcarbamoyloxy)thioacetimidate] was linked to the corresponding acetylcholinesterase (AChE) inhibition. Significant AChE inhibition occurred at lower concentrations (from 0.86 mg Kg^?1 onwards) than significant avoidance of spiked soil (from 5.62 mg Kg^?1 onwards). This indicates that assessments regarding pesticides that have neurotoxic activity may be biased if behavioral endpoints are selected. Despite theoretical hypothesis that have been raised, this should be the first study providing preliminary experimental evidence on such a link between avoidance behavior and neuronal impairment levels in earthworms. Further studies are ongoing that should refine conclusions of this study.     

An observational study on changes in biometry and generation time of <Emphasis Type="Italic">Odontophora villoti</Emphasis> (Nematoda,Axonolaimidae) related to petroleum pollution in Bizerte bay,Tunisia

Introduction  

We conducted a yearly polluted-reference sampling to assess the effects of petroleum pollution on life cycle characteristics of the meiobenthic nematode Odontophora villoti. Samples were taken every 15 days between 26 November 2004 and 25 November 2005 from two beaches of Bizerte bay (Tunisia), Rimel and Tunisian Refining Industries Company (TRIC). The latter site is located in front of the “Tunisian Refining Industries Company” runoff.