Solidification and recycling of incinerator bottom ash through the addition of colloidal silica (SiO2) solution

The possibility of using incinerator bottom ash as a substitute for natural aggregates was investigated. Rough, porous surface of bottom ash, which diminishes the strength of solidified products, was improved by colloidal silica solution. As a result, a significant increase of mechanical strength was accomplished by a slight amount of silica (<1 wt% to total). Moreover, pozzolanic reaction was induced in initial cement hydration due to the nano-particle size of about 20 nm in colloidal silica solution. Cylindrical specimens and bricks were prepared from bottom ash added to a colloidal silica (SiO2) solution and cement, and then their compressive strengths were evaluated. Cylindrical specimens showed an increase of approximately 60% in compressive strength when colloidal solution containing 4 wt% silica particles was sprayed onto the bottom ash. The strength of bricks containing colloidal silica was in excess of 20 MPa, which meets the requirement of construction materials. Results of leaching tests based on Toxicity Characteristic Leaching Procedure (TCLP) proved that the solidified bottom ash possessed good chemical stability.     

Halide salts accelerate degradation of high explosives by zerovalent iron

Zerovalent iron (Fe(0), ZVI) has drawn great interest as an inexpensive and effective material to promote the degradation of environmental contaminants. A focus of ZVI research is to increase degradation kinetics and overcome passivation for long-term remediation. Halide ions promote corrosion, which can increase and sustain ZVI reactivity. Adding chloride or bromide salts with Fe(0) (1% w/v) greatly enhanced TNT, RDX, and HMX degradation rates in aqueous solution. Adding Cl or Br salts after 24h also restored ZVI reactivity, resulting in complete degradation within 8h. These observations may be attributed to removal of the passivating oxide layer and pitting corrosion of the iron. While the relative increase in degradation rate by Cl(-) and Br(-) was similar, TNT degraded faster than RDX and HMX. HMX was most difficult to remove using ZVI alone but ZVI remained effective after five HMX reseeding cycles when Br(-) was present in solution.     

Parvovirus B19 infection in pregnancy: new insights and management

In this article, we review the virology, pathology, epidemiology and clinical spectrum of intrauterine human parvovirus B19 (B19V) infection, including intrauterine fetal death, non-immune hydrops fetalis, thrombocytopenia and neurological manifestations such as pediatric stroke and perivascular calcifications. In addition, we discuss the new insights into the neurodevelopmental outcome of intrauterine B19V infection. Current diagnosis and management of B19V infection is summarized, including a diagnostic and follow-up flowchart for practical clinical use. Copyright © 2011 John Wiley & Sons, Ltd.     

A simulation model for the effects of burning on the phosphorus and nitrogen cycle of a heathland ecosystem

In this paper, a simulation model is presented for nutrient cycling in heathland ecosystems. The results of simulations are compared with field data of phosphorus and nitrogen accumulation in different compartments of the system in the years after burning, given in the literature on this subject (Chapman, 1967; 1970). It is shown that for the cycling of P the system returns slowly to equilibrium after an initial disturbance. The time span of about 30 years that is required to reach equilibrium is in agreement with the field data. However, P accumulation in living above-ground biomass and litter is overestimated by the model in the first years after burning. Nitrogen accumulation in biomass and litter is systematically underestimated by the model.The results are discussed with reference to the processes in nutrient cycling that are insufficiently understood, and with reference to the management of heathlands.     

Potential Impacts of Climate Change on the Reliability of Water and Hydropower Supply from a Multipurpose Dam in South Korea

Future climate change is a source of growing concerns for the supply of energy and resources, and it may have significant impacts on industry and the economy. Major effects are likely to arise from changes to the freshwater resources system, due to the connection of energy generation to these water systems. Using future climate data downscaled by a stochastic weather generator, this study investigates the potential impacts of climate change on long‐term reservoir operations at the Chungju multipurpose dam in South Korea, specifically considering the reliability of the supply of water and hydropower. A reservoir model, Hydrologic Engineering Center‐Reservoir System Simulation (HEC‐ResSim), was used to simulate the ability of the dam to supply water and hydropower under different conditions. The hydrologic model Soil and Water Assessment Tool was used to determine the HEC‐ResSim boundary conditions, including daily dam inflow from the 6,642 km² watershed into the 2.75 Gm³ capacity reservoir. Projections of the future climate indicate that temperature and precipitation during 2070‐2099 (2080s) show an increase of +4.1°C and 19.4%, respectively, based on the baseline (1990‐2009). The results from the models suggest that, in the 2080s, the average annual water supply and hydropower production would change by +19.8 to +56.5% and by +33.9 to 92.3%, respectively. Model simulations suggest that under the new climatic conditions, the reliability of water and hydropower supply would be generally improved, as a consequence of increased dam inflow.     

Exposure assessment of particulate matter and blood chromium levels in people living near a cement plant

This study evaluates the effect of air pollution caused by cement plants on nearby residential areas and performs an exposure assessment of particulate matter (PM) and total Cr, Cr⁶⁺, Pb, and Al. Further, the blood Cr levels of residents exposed to PM released by cement plants are also assessed. Nine buildings (eight residential and one elementary school building) close to cement plants were selected for this study, which were located in Pyeongtaek port, in west of Gyeonggi Province, South Korea. A total of 51 suspended particulate samples were collected at a flow rate of 2.0 L/min. Total Cr was more widely detected in residents’ houses and elementary schools. PM levels were higher at distances of 4.1 and 4.8 km than those at closer distances of 2.7 km. This was due to the influence of wind direction. The estimated mean blood level of Cr for the study participants was 3.80 μg/L, which is higher than levels estimated by other studies on Cr blood levels. Therefore, cement plants could cause an increase in total Cr and blood Cr levels in residential areas, and more continuous monitoring is necessary to better understand their impacts.     

PAHs in surface sediments from coastal and estuarine areas of the northern Bohai and Yellow Seas, China

Polycyclic aromatic hydrocarbon (PAH) concentrations and their risks in surface sediments (n = 35) collected from coastal and estuarine areas of the northern Bohai and Yellow Seas, China, were investigated in 2008. Total concentrations of PAHs ranged from 52.3 to 1,870.6 ng/g dry weight. The greatest concentrations were observed in the Dou River of Tangshan where waste water from small factories is discharged into the river without treatment. At other locations, municipal sewage was the primary contributor of PAHs. Regional differences in concentrations of PAHs in sediments are related to human activities. Concentrations of PAHs were significantly correlated with concentrations of organic carbon in sediments. The patterns of relative concentrations and types of PAHs observed and knowledge of the potential sources, as well as the results of a principal component analysis, are consistent with the primary sources of PAHs in sediments of the northern Bohai Sea and Yellow Sea, being derived from the high-temperature pyrolytic processes such as combustion of fossil fuel. While concentrations of PAHs at most locations did not exceed the effects range median stated by the numerical effect-based sediment quality guidelines of the United States, concentrations of PAHs at some locations were similar to or greater than the effects range low.     

Evaluation of PCDD/Fs characterization in animal feed and feed additives

Safety control of feed and feed additives is necessary to have safe food of animal origin. Based on media reports, nine incidents regarding dioxins and/or PCBs contaminations occurred worldwide during the last decade. Korea is a country which imports feed and feed additives. In this study, various kinds of feed and feed additives were analyzed to monitor the contamination level of dioxins. The level of PCDD/Fs in fish oil was the highest with a concentration of 23.33ngkg(-1), which is equivalent to a toxicological concentration of 4.68ngWHO-TEQ/kg. Feed from animals origin such as chicken meal, animal fat, fish meal, fish oil, and shell powder showed relatively higher concentrations of PCDD/Fs. Feed from plants origin, minerals, and additives ranged from non-detects for bit pulp and ethoxyquin to 8.28ngkg(-1) for dl-methionine. From a toxicological point of view, the highest concentration in vitamins was 0.08ngWHO-TEQ/kg among the feed additives. 2,3,4,7,8-PeCDF was the dominant congener in samples of fish oil, fish meal, and shell powder. Animal fat showed that the pattern of PCDD/Fs depends on the sources of contamination. A sample of animal fat showed 1,2,3,4,7,8-HxCDF and the other sample showed 1,2,3,4,7,8-HxCDD as a primary congener. Generally, low levels of PCDDs were detected in feed additives. Patterns of PCDD/Fs in choline chloride were different with that in choline chloride from an incident in Europe in 2000.