Frontal zone analysis at the mouth of Saanich Inlet,British Columbia,Canada

The presence of a biological front at the mouth of an inlet (fjord) on the coast of British Columbia, Canada was established. The presence of the biological front was consistent with physical predictions based on water velocity and depth. The frontal zone was characterized by a high primary productivity and surface chlorophyll. From spectral analysis of data the zone was found to fluctuate under tidal influence so that observations made at a single point showed a 14-d cycle in chlorophyll maxima which was about 180° out of phase with maxima in tidal exchange.     

The formation and control of disinfection by-products using chlorine dioxide

In this study, chlorine dioxide (ClO2) was used as an alternative disinfectant with vanillic acid, p-hydroxybenzoic acid, and humic acid as the organic precursors in a natural aquatic environment. The primary disinfection by-products (DBPs) formed were trihalomethanes (THMs) and haloacetic acids (HAAs). Under neutral conditions (pH = 7) for vanillic acid, more total haloacetic acids (THAAs) than total trihalomethanes (TTHMs) were found, with a substantial increase during the later stages of the reaction. In the case of p-hydroxybenzoic acid, the amount of THAAs produced was minimal. Raising the concentration of ClO2 was not favorable for the control of THAAs in low concentrations of vanillic acid. ClO2 could reduce the total amount of TTHMs and THAAs for higher concentration of vanillic acid. It was found that the humic acid treatment dosage was not significant. Under alkaline conditions (pH = 9), the control of TTHMs and THAAs for the treatment of vanillic acid was better and more economical, however, an appreciable amount of inorganic by-products were observed. Under the same alkaline condition, the control of THAA for the treatment of p-hydroxybenzoic acid was not beneficial and for the treatment of humic acid was not significant.     

Prenatal diagnosis of X-linked hydrocephalus in a Chinese family with four successive affected pregnancies

We report on a woman with four successive pregnancies affected with X-linked hydrocephalus (XLH). The first child had prenatal craniocentesis and died in utero. The second child had a postnatal shunting operation, but suffers from severe growth and mental retardation at 5 years of age. In the third pregnancy, prenatal ultrasound detected hydrocephalus at the 16th and 20th weeks of gestation and the pregnancy was terminated. In the fourth pregnancy, ultrasound scanning at the 17th and 20th weeks of gestation revealed no remarkable findings, but hydrocephalus was detected at the 24th week. Autopsy confirmed the prenatal diagnosis. DNA polymorphism analysis of the Bell site of exons 17–18 of factor VIII gene of the woman and her last two fetuses seemed to be compatible with a linkage between the XLH locus and factor VIII gene. Although XLH has a variable presentation of ventriculomegaly, ultrasound scanning is still a useful tool for prenatal diagnosis at present. Earlier and more accurate prenatal diagnosis will be feasible with molecular analysis of the XLH locus or its flanking regions.     

Prenatal detection of limb defects after chorionic villus sampling

Prenatal sonographic diagnoses of two cases of severe limb defects after first-trimester chorionic villus sampling (CVS) are presented. Pathological examination after elective termination correlated well with the prenatal sonographic findings. Although the relationship between CVS and limb defects remains controversial, careful ultrasound examination for possible limb defects in cases receiving CVS is recommended.     

The pH and anion effects on the heterogeneous photocatalytic degradation of o-methylbenzoic acid in TiO2 aqueous suspension

This investigation used UV light of 365 nm and titanium dioxide in aqueous suspension to study the photocatalytic reaction of o-methylbenzoic acid under the influence of pH values, anion additives and the varieties of titanium dioxide. From experimental results, under the condition of 5 g/l TiO2, pH 3 and light intensity of 2.45 mW/cm2, 0.1 mM of o-methylbenzoic acid could be completely decomposed in 2 h. The reaction was faster with lowering pH, and was found to be apparent first-order following Langmuir-Hinshelwood model. In the presence of anion additives, the inhibitive effect of chloride ions was larger than that of sulfate ions under acidic condition for Degussa brand titanium dioxide, but without influence using Janssen brand. Both brands, however, promoted the mineralization of o-methylbenzoic acid (o-MBA).     

Molecular study of thermal immobilization of chromium(VI) with clay

Clay that contains kaolinite has been used extensively as a raw material for manufacturing of bricks and china at 900-1100 degrees C. This study used clay to stabilize the contaminant chromium(VI) [Cr(VI)] through a heating process at 500-1100 degrees C. X-ray absorption spectroscopic results indicated that the 500-900 degrees C heating process transformed hazardous Cr(VI) to nontoxic Cr(III); Cr2O3 was the species detected as most abundant. The 1100 degrees C heating process caused the formation of Cr2SiO5, which was not detected in the samples heated at 500-900 degrees C. Fourier transformed extended X-ray absorption fine structure spectra were fitted by use of WinXAS software. Phase shifts and backscatter(ing) amplitudes for specific atom pairs, based on the crystallographic data for CrO3 and Cr2O3, were theoretically calculated with the FEFF software. The processed XAS data show that the first shell coordination numbers were similar to each other as the temperature was increased from 500 to 900 degrees C and 1100 degrees C, implying that their Cr(III) crystallite size was relatively similar. The interatomic distance between the target center element and the first shell for the 500-1100 degrees C samples was 1.98 A. The Debye-Waller factor for the 1100 degrees C sample was increased compared with the 500 and 900 degrees C samples and probably indicates the formation of Cr2SiO5.     

Impact of polycyclic aromatic hydrocarbon emissions from medical waste incinerators on the urban atmosphere

In this study, polycyclic aromatic hydrocarbon (PAH) emissions from two batch-type medical waste incinerators (MWIs), one with a mechanical grate and the other with a fixed grate, both operated by a medical center, were assessed. Both MWIs shared the same air-pollution control devices (APCDs), with an electrostatic precipitator and a wet scrubber installed in series. Results show that when APCDs were used, total PAHs and total benzo[a]pyrene equivalent (total BaP(eq)) emission concentrations of both MWIs were reduced from 2220 to 1870 microg/m3 and 50 to 12.4 microg/m3, respectively. We used the Industrial Source Complex Short Term model (ISCST) to estimate the ground-level concentrations of the residential area and the traffic intersection located at the downwind side of the two MWIs. For the traffic intersection, we found both total PAHs and total BaP(eq) transported from MWIs to both studied areas were not significant. For the residential area, similar results were found when APCDs were used in MWIs. When APCDs were not included, we found that total PAHs transported from MWIs accounted for < 12%, but total BaP(eq) accounted for > 90%, of the on-site measured concentrations. These results suggest that the use of proper APCDs during incineration would significantly reduce the carcinogenic potencies associated with PAH emissions from MWIs to the residential area.     

Enzymatic Degradation and Aminolysis of Microbial Poly(3-hydroxybutyrate-co-4-hydroxybutyrate) Single Crystals

Solution-grown single crystals of poly(3-hydroxybutyrate-co-4-hydroxybutyrate) [P(3HB-co-4HB)] were hydrolyzed by polyhydroxybutyrate (PHB) depolymerase from Ralstonia pickettii T1. Enzymatic degradation proceeded from the edges of lamellar crystals, yielding serrated contour and small crystal fragments. Gel permeation chromatography analysis revealed that the molecular weights of the crystals decreased during enzymatic degradation, suggesting that the enzymatic hydrolysis of chain-folding regions at the crystal surfaces occurred in addition to the enzymatic degradation at crystal laterals or edges. After P(3HB-co-4HB) single crystals were aminolysed in 20% aqueous methylamine solution to remove the folded-chain regions and enzymatic degradation by lipase from Rhizopus oryzae to remove 4HB components at crystal surfaces of single crystal aminolyzed, it was found that a small amount (up to ca. 2 mol%) of 4HB component can be incorporated into the P(3HB) mother crystal lattice irrespective of the 4HB content.     

Impact of Polycyclic Aromatic Hydrocarbon Emissions from Medical Waste Incinerators on the Urban Atmosphere

Abstract

In this study, polycyclic aromatic hydrocarbon (PAH) emissions from two batch-type medical waste incinerators (MWIs), one with a mechanical grate and the other with a fixed grate, both operated by a medical center, were assessed. Both MWIs shared the same air-pollution control devices (APCDs), with an electrostatic precipitator and a wet scrubber installed in series. Results show that when APCDs were used, total PAHs and total benzo- [a]pyrene equivalent (total BaP_eq) emission concentrations of both MWIs were reduced from 2220 to 1870 µg/m³ and 50 to 12.4 µg/m³, respectively. We used the Industrial Source Complex Short Term model (ISCST) to estimate the ground-level concentrations of the residential area and the traffic intersection located at the down-wind side of the two MWIs. For the traffic intersection, we found both total PAHs and total BaP_eq transported from MWIs to both studied areas were not significant. For the residential area, similar results were found when APCDs were used in MWIs. When APCDs were not included, we found that total PAHs transported from MWIs accounted for <12%, but total BaP_eq accounted for >90%, of the on-site measured concentrations. These results suggest that the use of proper APCDs during incineration would significantly reduce the carcinogenic potencies associated with PAH emissions from MWIs to the residential area.     

Influence of water quality parameters on occurrence of polybrominated diphenyl ether in sediment and sediment to biota accumulation

Polybrominated diphenyl ether (PBDE) concentrations in sediment and fish from 12 principal rivers in Taiwan were investigated to determine their association with water quality parameters as well as the biota-sediment accumulation factor (BSAF) in fish with different living patterns. The highest PBDE concentration in sediment was found in the Bajhang River (261 ng g^?1 dry weight (d.w.)) and the lowest in the Beinan River and the Da-an River (0.17 ng g^?1 d.w.). The PBDE concentrations in fish samples ranged from 1.28 ng g^?1 d.w. (Oreochromis niloticus niloticus) in the Yanshuei River to 33.7 ng g^?1 d.w. (Varico rhinos barbatulus) in the Da-an River. We conclude that PBDEs contamination in sediment was significantly affected by NH₃–N, pH, and DO. The BSAF results showed a parabolic trend from low- to high-brominated BDEs. Fish easily accumulated the congeners BDE-47, -100, -119, -126, and -154 from sediment. The BSAF decreased in the following order: PeBDE > HxBDE > TeBDE > other BDEs. Principle component analysis showed that demersal fish have different PBDE sources than do pelagic fish. We conclude that living and feeding habits are critical factors affecting PBDE accumulation in fish.