Aerosol particle number concentration measurements in five European cities using TSI-3022 condensation particle counter over a three-year period during health effects of air pollution on susceptible subpopulations

In this study, long-term aerosol particle total number concentration measurements in five metropolitan areas across Europe are presented. The measurements have been carried out in Augsburg, Barcelona, Helsinki, Rome, and Stockholm using the same instrument, a condensation particle counter (TSI model 3022). The results show that in all of the studied cities, the winter concentrations are higher than the summer concentrations. In Helsinki and in Stockholm, winter concentrations are higher by a factor of two and in Augsburg almost by a factor of three compared with summer months. The winter maximum of the monthly average concentrations in these cities is between 10,000 cm(-3) and 20,000 cm(-3), whereas the summer min is approximately 5000-6000 cm(-3). In Rome and in Barcelona, the winters are more polluted compared with summers by as much as a factor of 4-10. The winter maximum in both Rome and Barcelona is close to 100,000 cm(-3), whereas the summer minimum is > 10,000 cm(-3). During the weekdays the maximum of the hourly average concentrations in all of the cities is detected during the morning hours between 7 and 10 a.m. The evening maxima were present in Barcelona, Rome, and Augsburg, but these were not as pronounced as the morning ones. The daily maxima in Helsinki and Stockholm are close or even lower than the daily minima in the more polluted cities. The concentrations between these two groups of cities are different with a factor of about five during the whole day. The study pointed out the influence of the selection of the measurement site and the configuration of the sampling line on the observed concentrations.     

Release of sex pheromone and its precursors in the pine sawfly Diprion pini (Hym., Diprionidae)

Summary. The first identification of a sex pheromone of a pine sawfly (Hymenoptera, Diprionidae) dates back almost thirty years. Since then, female-produced pheromones of over twenty diprionid species have been investigated by solvent extraction followed by separation and identification. However, no study has shown what the females actually release. Collection of airborne compounds using absorbtion on charcoal filter as well as solid phase microextraction (SPME) followed by analysis employing gas chromatography combined with mass spectrometry (GC-MS), revealed an unusual system in Diprion pini, in which the pheromone precursor alcohol, 3,7-dimethyl-2-tridecanol, is released together with acetic, propionic, butyric and isobutyric acids. The corresponding acetate, propionate and butyrate esters of 3,7-dimethyl-2-tridecanol were also found in the samples. All esters were electrophysiologically active, and the propionate and isobutyrate were attractive in trapping experiments. Based on these and earlier reported results, it seems that at least in part of its range, the pheromone response of D. pini is not very specific with regard to the functional group, as long as this is an ester.     

Determination of European methane emissions,using concentration and isotope measurements

The determination of methane emissions on a regional scale is needed in order to reduce some of the uncertainties in the global methane budget. Our measurements of the concentration and the Carbon-13 isotope composition (¹³C) of atmospheric methane are, combined with trajectories, used to get insight in the type and size of the methane emissions of a large area.     

Poly(3-hydroxybutyrate-co-3-hydroxyhexanoate)/Organomodified Montmorillonite Nanocomposites for Potential Food Packaging Applications

Poly(3-hydroxybutyrate-co-3-hydroxyhexanoate) (PHBHHx) is a versatile, biobased and biodegradable copolymer from the family of polyhydroxyalkanoates. This study aims to further ameliorate its properties in order to enhance its applicability for food packaging purposes through preparation of organomodified montmorillonite clay (OMMT) nanocomposites. Nanocomposites based on pure PHBHHx as well as commercial PHBHHx granulate, after a previous dry-mixing with OMMT in concentrations of 1, 3, 5 and 10 wt%, were prepared using melt blending and compression molding. Investigation of the samples showed well dispersed nanofiller and highly intercalated nanocomposites, resulting in a continuous decrease in gas permeability, lowering O₂, CO₂ and water vapor permeability with about 5–7 % and approximately 40 % at OMMT concentration of 1 and 10 wt%, respectively. Besides gas permeability, other properties were affected as well. Thermal stability of the samples increased gradually up to 5 wt% nanofiller, but was reduced at 10 wt%. In order to investigate the effects of OMMT and molecular weights on PHBHHx crystallization, nanocomposites were also produced by solvent-casting and compared to those obtained by melt-blending. Crystallization was retarded, because of severe lowering of molecular weight due to processing-induced chain scission, catalyzed by OMMT moisture. However, this reduction was counteracted for a large part by using commercial PHBHHx granulate, which has shown better crystallization properties. The samples were rendered increasingly more brittle, displaying higher Young’s modulus and severely reduced elongation at break. From this study it appeared that, upon viewing all affected properties as a whole, the sample based on commercial PHBHHx and containing 3 wt% OMMT shows most promise for possible applications, however further research must be performed in order to exploit their fullest potential.     

Size- and food-dependent growth drives patterns of competitive dominance along productivity gradients

Patterns of coexistence among competing species exhibiting size- and food-dependent growth remain largely unexplored. Here we studied mechanisms behind coexistence and shifts in competitive dominance in a size-structured fish guild, representing sprat and herring stocks in the Baltic Sea, using a physiologically structured model of competing populations. The influence of degree of resource overlap and the possibility of undergoing ontogenetic diet shifts were studied as functions of zooplankton and zoobenthos productivity. By imposing different size-dependent mortalities, we could study the outcome of competition under contrasting environmental regimes representing poor and favorable growth conditions. We found that the identity of the dominant species shifted between low and high productivity. Adding a herring-exclusive benthos resource only provided a competitive advantage over sprat when size-dependent mortality was high enough to allow for rapid growth in the zooplankton niche. Hence, the importance of a bottom-up effect of varying productivity was dependent on a strong top-down effect. Although herring could depress shared resources to lower levels than could sprat and also could access an exclusive resource, the smaller size at maturation of sprat allowed it to coexist with herring and, in some cases, exclude it. Our model system, characterized by interactions among size cohorts, allowed for consumer coexistence even at full resource overlap at intermediate productivities when size-dependent mortality was low. Observed shifts in community patterns were crucially dependent on the explicit consideration of size- and food-dependent growth. Accordingly, we argue that accounting for food-dependent growth and size-dependent interactions is necessary to better predict changes in community structure and dynamics following changes in major ecosystem drivers such as resource productivity and mortality, which are fundamental for our ability to manage exploitation of living resources in, e.g., fisheries.     

Geographic variation in maternal investment: acidity affects egg size and fecundity in Rana arvalis

Environmental-stress-mediated geographic variation in reproductive parameters has been little studied in natural vertebrate populations outside the context of climatic variation. Based on life-history theory, an increase in the degree of environmental stress experienced by a population should lead to (1) a shift in reproductive allocation from fecundity to offspring quality, (2) stronger trade-offs between reproductive parameters, and (3) changes in the relationship between female phenotype and maternal investment. To test these predictions, we investigated geographic variation in maternal investment of moor frogs (Rana arvalis) in relation to breeding site acidity (pH 4-8). We found that mean egg size increased and clutch size and total reproductive output (TRO) decreased with increasing acidity among 19 Swedish moor frog populations. Tests for variation and co-variation in maternal investment and female size and age in 233 females from a subset of four acid origin (AO) and four neutral origin (NO) populations revealed that clutch size and TRO increased with female size in both acid and neutral environments. However, in AO populations, egg size also increased with female size, and clutch size and TRO with female age, whereas in NO populations, egg size increased with female age. The strength of the egg-size-clutch-size tradeoff tended to be stronger in AO than in NO females as expected if the former experience stronger environmental constraints. All in all, these results suggest that environmental acidification selects for investment in larger eggs at a cost to fecundity, imposes negative effects on reproductive output, and alters the relationship between female phenotype and maternal investment.     

Tales of island tails: biogeomorphic development and management of barrier islands

The Frisian islands (Southern North Sea) have extensive island tails, i.e. the entire downdrift side of an island consisting of salt marshes, dunes, beaches and beach plains, and green beaches. Currently, large parts of these tails are ageing and losing dynamics, partly due to human influence. This may mean a loss of young stages on the long term, and current management is not enough to counteract this. To aid the development of new interventions aiming at (re)introducing natural dynamics, a conceptual model of island-tail development under natural and disturbed conditions was developed, based on existing data, field visits and literature. The development of an island tail follows the general pattern of biogeomorphic succession. The first phase consists of a bare beach plain. In the second phase, embryonic dunes form. In the third phase, green beaches, dunes and salt marshes form, including drainage by creeks and washovers. In the fourth phase, vegetation succession continues and the morphology stabilises. Human interference (such as sand dikes and embankments) reduces natural dynamics and increases succession speed, leading to a reduction in the diversity in landforms and vegetation types. Both for natural and human-influenced island tails, succession is the dominant process and large-scale rejuvenation only occurs spontaneously when large-scale processes cause erosion or sedimentation. Island tails cannot be kept permanently in a young successional stage by reintroducing natural dynamics through management interventions, as biogeomorphic succession is dominant. However, such interventions may result in local and temporal rejuvenation when tailored to the specific situation.     

Aspects on the analysis of 210Po

There has been little development regarding analysis of polonium (Po) in environmental samples since the 1960ies. This is due to the straightforward spontaneous deposition of this element on silver (Ag), nickel (Ni) or copper (Cu) without any radiochemical separation. For many years, no radiochemical yield determinant was used and it was generally supposed that the yield was 100% after two depositions. Counting was often done using ZnS scintillation counter coupled to a photomultiplier tube. However, the use of the yield determinants ²⁰⁸Po and ²⁰⁹Po and the development of alpha spectrometry showed that the yield was lower. Furthermore, the tendency of Po to volatilize at low temperatures constrains the sample preparation techniques; dry-ashing cannot be used. But during the wet-ashing procedure, there are still some losses.The aim of this study was to evaluate the Po losses during wet-ashing by the use of a double-tracer technique. We have found that the losses were about 30% when open glass beakers were used and about 17% when the samples were digested in microwave oven. When long-necked bottles (Kjeldahl flasks) were used, a loss of about 20% was registered.It has also been observed that ²¹⁰Pb to some extent is plating out together with its daughter nuclide Po during the electrochemical deposition. This will result in a systematic error since an unknown amount of supported ²¹⁰Po will be produced from the ²¹⁰Pb decay depending on the fraction of ²¹⁰Pb being deposited on the disc and the waiting time between deposition and measurement of the sample. A further consequence of this is that in the assessment of the ²¹⁰Pb content in the sample, very often the remaining liquid is stored after deposition for build-up of ²¹⁰Po. Since some ²¹⁰Pb is lost on the disc, the result for ²¹⁰Pb will be too low. Both these systematic errors give rise to a too high ²¹⁰Po/²¹⁰Pb ratio. The fraction of ²¹⁰Pb which is plating out has been assessed in this study for different matrices and is about 50-90%. During the measurement by solid state Si-detectors, some Po is evaporated in the vacuum conditions contaminating the detectors. Experiments have here been done by heating the discs after deposition which indicate that less Po is evaporated from Ag than from Ni. The losses from Ag are less than that from the other metals probably due to a deeper penetration into the surface of Po. We conclude that in most aspects, Ag is better to use than the other plating metals.     

Partition of iodine (¹²⁹I and ¹²⁷I) isotopes in soils and marine sediments

Natural organic matter, such as humic and fulvic acids and humin, plays a key role in determining the fate and mobility of radioiodine in soil and sediments. The radioisotope ¹²⁹I is continuously produced and released from nuclear fuel reprocessing plants, and as a biophilic element, its environmental mobility is strongly linked to organic matter.Due to its long half-life (15.7 million years), ¹²⁹I builds up in the environment and can be traced since the beginning of the nuclear era in reservoirs such as soils and marine sediments. Nevertheless, partition of the isotope between the different types of organic matter in soil and sediment is rarely explored. Here we present a sequential extraction of ¹²⁹I and ¹²⁷I chemical forms encountered in a Danish soil, a soil reference material (IAEA-375), an anoxic marine sediment from Southern Norway and an oxic sediment from the Barents Sea. The different forms of iodine are related to water soluble, exchangeable, carbonates, oxides as well as iodine bound to humic acid, fulvic acid and to humin and minerals. This is the first study to identify ¹²⁹I in humic and fulvic acid and humin. The results show that 30-56% of the total ¹²⁷I and 42-60% of the total ¹²⁹I are associated with organic matter in soil and sediment samples. At a soil/sediment pH below 5.0-5.5, ¹²⁷I and ¹²⁹I in the organic fraction associate primarily with the humic acid while at soil/sediment pH > 6 ¹²⁹I was mostly found to be bound to fulvic acid. Anoxic conditions seem to increase the mobility and availability of iodine compared to oxic, while subaerial conditions (soils) reduces the availability of water soluble fraction compared to subaqueous (marine) conditions.     

Recent Changes in Body Size of the Eurasian Otter <Emphasis Type="Italic">Lutra lutra</Emphasis> in Sweden

We studied geographical and temporal body size trends among 169 adult museum specimens of the Eurasian otter (Lutra lutra) collected in Sweden between 1962 and 2008, whose sex, year of collection, and locality were known. Skull size and body mass increased significantly in relation to the year of collection, and skull size (but not body mass) was significantly and negatively related to latitude, contrasting Bergmann’s rule and the trend found for Norwegian otters. Latitudinal differences in body size between the two countries may be due to differences in food availability. The temporal increase in body size among Swedish otters resembled that observed for Norway otters, though Swedish otters are smaller with respect to their Norwegian counterparts. Latitude and year represent a combination of environmental factors, including ambient temperature in the year of collection as well as the number of days of ice coverage. We replaced the above factors with mean annual temperature or the number of days of ice coverage, and found that each of these factors explains a similar proportion of the variation in body size as did latitude and year. We hypothesize that this temporal increase in body size is related to a combination of factors, including reduced energy expenditure resulting from increasing ambient temperature, and increased food availability from longer ice-free periods.