Copper ultrastructural localization, subcellular distribution, and phytotoxicity in Hydrilla verticillata (L.f.) Royle

Laboratory experiments were conducted to investigate copper (Cu) subcellular distribution and toxicity in Hydrilla verticillata. Fronds were subjected to different concentrations (15, 75, and 150 μM) of Cu for 7 days. Cu grains were found in cell walls, plasmodesmata, and within the nuclei and chloroplasts using the autometallographic technique. Subcellular fractionation of Cu-containing tissues indicated that in leaves subjected to high Cu concentrations, 59–65 % of the element was located in the cell wall fraction, followed by cell organelles (21–30 %) and the soluble fraction (10–14 %). The levels of K, P, Zn, and Mg declined under all Cu concentrations, but Ca, Mn, and Fe contents reached their peak at 15 μM Cu and decreased thereafter. F _v/F _m, F ₀, and F _m fell significantly in line with the decrease in pigment content. Cu exposure also caused significant damage to the chloroplasts, mitochondria, and nuclei, including disintegration of the chloroplasts and vacuolization of the mitochondria and nuclei, all of which suggested that Cu hastened plant senescence. The Cu maximum permissible concentration for H. verticillata was 10 μM, which was less than the existing general water quality standard. This suggested that H. verticillata could be used to assess Cu phytotoxicity.     

Occurrence, possible sources, and temporal trends of polychlorinated dibenzo-p-dioxins and dibenzofurans in water and sediment from the lower Yangtze River basin, Jiangsu and Shanghai areas of Eastern China

The concentrations, compositional profiles, and possible sources of polychlorinated dibenzo-p-dioxins and polychlorinated dibenzofurans (PCDD/PCDF) in water column and surface sediment samples from the lower reaches of the Yangtze River were investigated, and the potential risks posed by these chemicals were evaluated. Concentrations of the 17 2,3,7,8-substituted PCDD/PCDF in the water and sediment samples ranged from 0.45 to 10.0 pg TEQ/L (mean 2.34 pg TEQ/L) and from 0.31 to 51 pg TEQ/g dw (mean 5.25 pg TEQ/g dw), respectively. Water and sediments from the Nanjing–Nantong sections of the Yangtze River were found to have elevated PCDD/PCDF levels, and the PCDD/PCDF TEQ concentrations in 13 sediment samples exceeded the probable effect levels (PEL), above which adverse biological effects are likely. Multivariate statistical analysis indicated that the principal PCDD/PCDF contamination source for the water and sediment was the production and use of pentachlorophenol (PCP) or sodium pentachlorophenate (PCP-Na). PCDD/PCDF concentrations were stable over time near the Yangtze River Estuary but had increased sharply in recent decades in the Nanjing–Nantong section, which will have been related to the growth in industrial activities and other anthropogenic PCDD/PCDF sources. Total organic carbon (TOC) and PCDD/PCDF concentrations correlated significantly (R?=?0.474, P?<?0.01), suggesting that TOC plays an important role in the transport and re-distribution of PCDD/PCDF in the Yangtze River basin.     

Factors influencing on the bioaccessibility of polybrominated diphenyl ethers in size-specific dust from air conditioner filters

Size-specific concentrations and bioaccessibility of polybrominated diphenyl ethers (PBDEs) in dust from air conditioner filters were measured, and the factors influencing the PBDE bioaccessibility were determined. Generally, the PBDE concentrations increased with decreasing dust particle size, and BDE209 (deca-BDE) was generally the predominant congener. The bioaccessibility ranged from 20.3% to 50.8% for tri- to hepta-BDEs, and from 5.1% to 13.9% for BDE209 in dust fractions of varied particle size. The bioaccessibility of most PBDE congeners decreased with increasing dust particle size. The way of being of PBDE (adsorbed to dust surface or incorporated into polymers) in dust significantly influenced the bioaccessibility. There was a significant negative correlation between the tri- to hepta-BDE bioaccessibility and organic matter (OM) contents in dust. Furthermore, tri- to hepta-BDE bioaccessibility increased with increasing polarity of OMs, while with decreasing aromaticity of OMs. The tri- to hepta-BDE bioaccessibility significantly positively correlated with the surface areas and pore volumes of dust. Using multiple linear regression analysis, it was found that the OM contents and pore volumes of dust were the most important factors to influence the tri- to hepta-BDE bioaccessibility and they could be used to estimate the bioaccessibility of tri- to hepta-BDEs according to the following equation: bioaccessibility (%) = 45.05 − 0.49 × OM% + 1.79 × pore volume. However, BDE209 bioaccessibility did not correlate to any of these factors.     

3种载体固定化菌藻共生系统脱氮除磷效果的对比

采用3种不同载体（海藻酸钠、聚乙烯醇、复合载体）,分别将小球藻和栅藻与活性污泥固定成菌藻共生系统,制成菌藻凝胶小球,单独菌、单独藻的凝胶小球,用于处理人工污水。结果表明,（1）复合载体固定的菌藻共生系统氮磷去除效果最好,PVA载体的脱氮除磷效果次于复合载体优于海藻酸钠;（2）固定化菌藻共生系统的脱氮除磷效果明显优于单独固定菌和单独固定藻,固定菌的效果较差;（3）3种载体包埋下的固定化小球藻的脱氮除磷效果均较相同载体固定化的栅藻效果好。     

超滤膜深度处理染整废水的膜污染机理

实验采用不同规格和材料的超滤膜进行染整二级尾水分离实验,对超滤膜污染机理及影响因素进行了分析。实验采用红外光谱分析了聚醚(PES)膜、聚砜(PSF)膜和聚醚酰亚胺(PEI)膜3种超滤膜材料,对比了污染前后膜面的接触角以及不同切割分子量对膜通量及出水水质的影响,并利用线性化的Herman堵塞模型拟合了不同分子量超滤膜的堵塞模型,初步探讨了超滤膜的污染机理。实验结果表明,膜材料表面亲水性基团的多少与初始膜通量大小成正比,出水COD值随超滤膜切割分子量减小而减小。切割分子量同为2 000 Da的3种超滤膜中,PES膜的处理效果最佳,出水COD平均值为47.81 mg/L;PEI膜通量最高,平衡通量可达50 L/(m2.h);切割分子量为1 000、10 000的超滤膜堵塞机理符合滤饼过滤模型,100 000的超滤膜堵塞机理更接近于完全堵塞模型;1 000的聚醚砜材质膜(PES)更适合此类废水的深度处理。     

氧化物催化剂对非热等离子体催化降解甲苯的影响

考察了在干燥气氛下不同氧化物催化剂对非热等离子体催化降解甲苯的影响。从甲苯降解率、碳平衡、CO2选择性和O3去除4个方面,对比了氧化物催化剂的介电性能、表面供氧能力和比表面积与多孔结构对反应产生影响的强弱。结果表明,催化剂的介电性能有利于甲苯降解率、碳平衡和O3产量的提高,但对CO2选择性和O3去除的影响极小;一定能量密度下,催化剂比表面积与多孔结构对CO2选择性和O3去除所产生的影响要强于介电性能;催化剂表面供氧能力可明显促进反应的进行,其对反应所产生的影响要强于比表面积与多孔结构。     

臭氧-BAF组合工艺对石化行业废水深度处理的中试研究

采用臭氧-曝气生物滤池（BAF）组合工艺对中石化九江分公司二级生化出水进行深度处理中试实验。探讨了臭氧投加量、进水水质冲击负荷等因素对该组合工艺出水COD、NH₄⁺-N的影响。中试结果表明,在该水质条件下,臭氧最佳投加量为20~25 mg/L;组合工艺处理后出水COD低于40 mg/L,NH₄⁺-N低于5 mg/L,达到中水回用设计标准;该组合工艺能够经受一定冲击负荷。     

Spatial distribution of polychlorinated biphenyls (PCBs) and polybrominated biphenyl ethers (PBDEs) in an e-waste dismantling region in Southeast China: Use of apple snail (Ampullariidae) as a bioindicator

Fengjiang is a large e-waste dismantling site located in southeast China. In this paper, apple snail and soil samples were collected from this e-waste dismantling site and 25 vicinal towns to investigate the contamination status, spatial distributions and congener patterns of polychlorinated biphenyls (PCBs) and polybrominated biphenyl ethers (PBDEs). Total PCB concentrations in apple snails (3.78-1812 ng g⁻¹ dry weight (dw)) were significant higher than that in soil samples (0.48-90.1 ng g⁻¹ dw). PBDE (excluding BDE 209) concentrations in apple snail and soil samples ranged from 0.09 to 27.7 ng g⁻¹ dw and 0.06 to 31.2 ng g⁻¹ dw, respectively. Concentrations of PCBs and PBDEs in snails and soils correlated negatively with the distance from Fengjiang. Both the concentrations and profiles of the pollutants were significantly correlated (p < 0.05) between the snail and soil samples, indicating the suitability of apple snail as a reliable bioindicator for PCBs and PBDEs contamination in this region. Relatively high concentrations of PCBs and PBDEs at locations far from e-waste dismantling sites implied that these pollutants have been transported to surrounding regions.     

硫酸盐还原菌污泥固定化特性

采用玉米芯为碳源,聚乙烯醇(PVA)为包埋载体,饱和硼酸(H3BO3)为交联剂,研究了硫酸盐还原菌污泥(SRBS)、铁屑、麦饭石共固处理合成煤矿酸性废水的最优配比与机理,并分析了固定化过程中小球稳定性及活性的变化规律。实验结果表明,SRBS投加量是影响处理效果的最显著因子,当投加30%SRBS、2%铁屑、3%麦饭石时SO2-4、Mn2+去除率分别为94.13%和84.39%,溶液p H为7.03,未检测出Fe2+;随着交联时间的延长,小球膨胀率及SO2-4还原率分别呈线性与指数下降,从保持小球稳定性与活性角度考虑,可将交联时间设定为4~8 h;该法可为市政污泥的处置以及生物法处理煤矿酸性废水的工程应用提供技术参考。     

Flotability and flotation separation of polymer materials modulated by wetting agents

The surface free energy, surface tension and contact angles were performed to investigate the properties of wetting agents. Adsorption of wetting agents changes wetting behavior of polymer resins. Flotability of polymer materials modulated by wetting agents was studied, and wetting agents change significantly flotability of polymer materials. The flotability decreases with increasing the concentration of wetting agents, and the wetting ability is lignin sulfonate (LS) > tannic acid (TA) > methylcellulose (MC) > triton X-100 (TX-100) (from strong to weak). There is significant difference in the flotability between polymer resins and plastics due to the presence of additives in the plastics. Flotation separation of two-component and multicomponent plastics was conducted based on the flotability modulated by wetting agents. The two-component mixtures can be efficiently separated using proper wetting agent through simple flotation flowsheet. The multicomponent plastic mixtures can be separated efficiently through multi-stage flotation using TA and LS as wetting agents, and the purity of separated component was above 94%, and the recovery was more than 93%.