分子筛催化剂生产废水的生物处理

采用氨化—硝化—反硝化三段联合生物工艺处理分子筛催化剂生产过程中产生的含有机胺废水。实验结果表明：在氨化过程中,当进水COD稳定为1 200~1 600 mg/L时,出水COD低于300 mg/L,COD去除率稳定在80%左右,当进水ρ（有机氮）为100~160 mg/L时,出水ρ（有机氮）均低于30 mg/L,有机氮去除率大于80%,在整个氨化过程中,出水ρ（氨氮）较进水ρ（氨氮）提高了35~200 mg/L;硝化过程中,当进水ρ（氨氮）小于等于300 mg/L时,出水ρ（氨氮）最终稳定在15 mg/L以内,氨氮去除率大于90%;在反硝化过程中,亚硝酸盐氮去除率基本稳定在98%以上,最终出水COD低于80 mg/L,出水ρ（总氮）低于25 mg/L。     

Formation of persistent chlorinated aromatic compounds in simulated and real fly ash from iron ore sintering

Effects of carbon concentration and Cu additive in simulated fly ash (SFA) and real fly ash (RFA) on the formation of polychlorinated dibenzofurans (PCDFs), polychlorinated dibenzo-p-dioxins (PCDDs), chlorobenzenes, and polychlorinated biphenyls which were all regarded as persistent chlorinated aromatics in iron ore sintering were investigated. In the annealing process of SFA with various carbon contents, the yield of chlorinated aromatics and the I-TEQ obtained their maximum at 10 wt% carbon content. Active carbon in SFA acted as the carbon source as well as an adsorbent which led to higher production of PCDD/F in solid phase at 10 wt% carbon content. The increase of carbon content will be beneficial on the formation of 2,3,7,8-Chloro-substituted PCDF compared with 2,3,7,8-Chloro-substituted PCDD. In addition, the CuCl₂·2H₂O was a much more powerful catalyst in the formation of chlorinated aromatic compounds compared with elementary Cu, since it served as both a catalyst and a chlorine donor. However, the RFA behaved similarly with SFA with elementary Cu in the formation of chlorinated aromatic compounds. The effect of carbon content and copper additives on formation of 2,3,7,8-chloro-substituted congeners displayed similar characteristics with the tetra- to octa-PCDD/F isomers and even the total PCDD/Fs.     

Optimization of bio-drying of kitchen waste: inoculation,initial moisture content and bulking agents

Journal of Material Cycles and Waste Management - Bio-drying has been proved to be a promising method for treatment of MSW (municipal solid waste) and sewage sludge due to its high energy...     

聚四氟乙烯高压密封罐消解样品测定五氧化二钒

利用聚四氟乙烯高压密封罐消解矿石样品测定五氧化二钒,具有操作手续相对简便、轻松、快捷等优点,与传统的硫酸－磷酸混合酸消解或采用碱熔融前处理法比较,相对误差小于１．６％,样品的添加标准回收率为９２．９％～１０３．５％。     

浅谈测井事故的认识与处理

在测井过程中,由于各种不可预见的复杂原因,测井事故不可避免。文章分析了形成测井事故的影响因素,如井径、钻井液性能、全角变化率、操作过程、套管鞋等。一旦测井事故发生,根据卡电缆、卡仪器、断电缆的事故特点来判断事故类型,再根据各种处理方法的优缺点来处理事故;提出一些注意事项,使测井事故防患于未然。     

上覆水营养盐浓度对底泥氮磷释放的影响

采用校园水体底泥进行上覆水营养盐浓度对底泥释放量之间的关系研究。结果表明,在本实验条件下,上覆水水质影响底泥氮、磷的释放,尤其显著影响氮、磷的初期释放;上覆水氮、磷的浓度越小,底泥氮、磷的释放量越大;上覆水氮、磷的浓度超过一定值,会抑制底泥氮、磷的释放。     

Removal of polycyclic aromatic hydrocarbons from aqueous solution on soybean stalk-based carbon

Soybean [ (L.) Merr.] stalk-based carbons were prepared by phosphoric acid activation at different carbonization temperatures. Characteristics of the prepared carbon, including specific surface area, iodine number, and amount of methylene blue sorption, were determined. Experiments on phenanthrene, naphthalene, and acenaphthene, as representatives of polycyclic aromatic hydrocarbons (PAHs), removal from aqueous solution by the prepared carbon were conducted at different levels of carbon addition. The results indicated that the specific surface area, iodine number, and amount of methylene blue sorption increased with an increase of carbonization temperature. The maximum values were observed at 700°C and were 287.63 m g, 508.99 mg g, and 90.14 mg g, respectively. The removal efficiencies of phenanthrene, naphthalene, and acenaphthene tended to increase with increasing carbon amounts and carbonization temperature. The optimal removal performance was obtained under the experimental conditions of carbon concentrations of 0.04 g 32 mL and carbonization temperature of 700°C, and the removal efficiencies of phenanthrene, naphthalene, and acenaphthene were 99.89, 100, and 95.64%, respectively. The performance of the prepared carbon was superior to that of commercial activated carbon. Additionally, for the same carbon concentrations, the removal efficiency of PAHs on prepared carbons followed the order: phenanthrene > naphthalene > acenaphthene. Results obtained from this work provide some insight into the reuse of an agricultural residue, and also provide a new application for the treatment of PAHs in contaminated water utilizing activated carbon prepared from agricultural residues.     

重大工业危险源(罐区)监控预警系统

系统建立了管理软件和硬件监控相结合的安全生产监控预警系统，在安全管理的基 础上，把罐区诸多的危险参数给予实时监测、报警和控制。本系统实现了生产过程控制与安全监控 相结合，安全监测报警与事故预案相结合，既满足了生产控制又实现了动态的安全管理，对安全生产 具有较大意义。     

Prediction of minimum ignition energy of aerosols using flame kernel modeling combined with flame front propagation theory

Flammable aerosols have created many fire and explosion hazards in the process industry, but the flammability of aerosols has not been fully understood. The minimum ignition energy has been widely used as an indicator for flammability of combustible mixtures, but the amount of experimental data on the minimum ignition energy of aerosols is very limited. In this work, the minimum ignition energy of tetralin aerosols is predicted using an integrated model. The model applies the flame front propagation theory in aerosol systems to the growth of the flame kernel, which was created during the spark discharge in the ignition process. The aerosol minimum ignition energy was defined as the minimum level of energy in the initial flame kernel to maintain the kernel temperature above the minimum ignition temperature of 1073 K specific for tetralin aerosols during the kernel growth. The minimum ignition energy obtained in the model is influenced by the fuel-air equivalence ratio and the size of the aerosol droplets. For tetralin aerosols of 40 μm diameter, E_min decreases significantly from 0.32 mJ to 4.3 × 10 e⁻³ mJ when the equivalence ratio rises from 0.57 to 1.0. For tetralin aerosols of 0.57 equivalence ratio, E_min increases from as 0.09 mJ to 0.32 mJ when the droplet diameter rises from 10 μm to 60 μm. The trends are in agreement with previous experimental observations. The method used in current work has the potential to prediction of the minimum ignition energy of aerosol.