Enhanced degradation of azo dye alizarin yellow R in a combined process of iron–carbon microelectrolysis and aerobic bio-contact oxidation

Purpose

With the aim of enhanced degradation of azo dye alizarin yellow R (AY) and further removal of the low-strength recalcitrant matter (LsRM) of the secondary effluent as much as possible, our research focused on the combination of aerobic bio-contact oxidation (ABO) with iron/carbon microelectrolysis (ICME) process.

Materials and methods

The combined ABO (with effective volume of 2.4?l) and ICME (with effectively volume of 0.4?l) process were studied with relatively short hydraulic retention time (HRT) of 4 or 6?h.

Results

At the HRT of 6?h with the reflux ratio of 1 and 2, the AY degradation efficiency in the final effluent was >96.5%, and the total organic carbon (TOC) removal efficiency were 69.86% and 79.44%, respectively. At the HRT of 4?h and the reflux ratio of 2, TOC removal efficiency and AY degradation efficiency were 73.94% and 94.89%, respectively. The ICME process obviously enhanced the total AY removal and the generated micromolecule acids and aldehydes then that wastewater backflow to the ABO where they were further biodegraded.

Conclusion

The present research might provide the potential options for the advanced treatment azo dyes wastewater with short HRT and acceptable running costs.     

Mobility of radium and trace metals in sediments of the Winterbeek: Application of sequential extraction and DGT techniques

For several decades, phosphate ores containing ²²⁶Ra as well as several trace metals have been processed in Belgium to produce calcium phosphate for use in cattle food. The waste water is discharged in two small rivers, the Laak and the Winterbeek.In this study, the levels of ²²⁶Ra and trace metals in surface water and sediments of the Winterbeek were investigated and the mobility of these compounds was assessed using DGT (Diffusive Gradient in Thin Films) and sequential extraction techniques.The concentrations of ²²⁶Ra and trace metals in water and sediment indicate a decreasing trend in inputs to the Winterbeek.The mobility of ²²⁶Ra, assessed by DGT, is related to the reductive mobilization of Fe. The sequential extraction technique shows that at some stations an important fraction of ²²⁶Ra is found to labile sediment phases.Diffusive ²²⁶Ra sediment fluxes, are however, relatively small and have only a minor contribution to the water column concentration of ²²⁶Ra.     

Turning calcium carbonate into a cost-effective wastewater-sorbing material by occluding waste dye

Background, aim, and scope  

Over the years, organic pollution in the environment has aroused people’s concern worldwide, especially persistent organic pollutants (POPs). Particularly in developing countries, plenty of concentrated organic wastewaters treated noneffectively are discharged into aquatic environments from chemical, textile, paper-making, and other industries to seriously threaten the surface and drinking water. The conventional wastewater treatment techniques are often helpless due to high cost with multilevel processing. Adsorption as an efficient method is often applied to the treatment of wastewater. The aim of this work is to develop an eco-friendly and cost-effective wastewater-sorbing material with weak acidic pink red B (APRB) and calcium carbonate (CaCO₃) by reusing highly concentrated dye wastewater.     

珠江三角洲潮土和水稻土酸缓冲特性试验研究

珠江三角洲潮土和水稻土对不同种类的酸具有一定的缓冲性,不同种类的酸对不同类型土壤的酸化趋势不同。大旺水稻土对酸的敏感性强于龙山潮土,龙山潮土属于稍易受害的稍敏感土壤,大旺水稻土属于易受害的敏感土壤;同一土壤对酸的缓冲能力比对碱的缓冲能力强;不同种类的酸对土壤的敏感性不同,土壤对硝酸的敏感性强于对硫酸的敏感性;土壤加酸后酸缓冲曲线和土壤中铝释放曲线的交点可以作为衡量土壤对酸敏感性的指标,交点越低,敏感性越强;加酸后土壤中铝的释放可以用模型y=nx+k来预测。     

Removal of sulfamethoxazole and sulfapyridine by carbon nanotubes in fixed-bed columns

Sulfamethoxazole (SMX) and sulfapyridine (SPY), two representative sulfonamide antibiotics, have gained increasing attention because of the ecological risks these substances pose to plants, animals, and humans. This work systematically investigated the removal of SMX and SPY by carbon nanotubes (CNTs) in fixed-bed columns under a broad range of conditions including: CNT incorporation method, solution pH, bed depth, adsorbent dosage, adsorbate initial concentration, and flow rate. Fixed-bed experiments showed that pH is a key factor that affects the adsorption capacity of antibiotics to CNTs. The Bed Depth Service Time model describes well the relationship between service time and bed depth and can be used to design appropriate column parameters. During fixed-bed regeneration, small amounts of SMX (3%) and SPY (9%) were irreversibly bonded to the CNT/sand porous media, thus reducing the column capacity for subsequent reuse from 67.9 to 50.4 mg g^?1 for SMX and from 91.9 to 72.9 mg g^?1 for SPY. The reduced column capacity resulted from the decrease in available adsorption sites and resulting repulsion (i.e., blocking) of incoming antibiotics from those previously adsorbed. Findings from this study demonstrate that fixed-bed columns packed with CNTs can be efficiently used and regenerated to remove antibiotics from water.     

3种载体固定化菌藻共生系统脱氮除磷效果的对比

采用3种不同载体（海藻酸钠、聚乙烯醇、复合载体）,分别将小球藻和栅藻与活性污泥固定成菌藻共生系统,制成菌藻凝胶小球,单独菌、单独藻的凝胶小球,用于处理人工污水。结果表明,（1）复合载体固定的菌藻共生系统氮磷去除效果最好,PVA载体的脱氮除磷效果次于复合载体优于海藻酸钠;（2）固定化菌藻共生系统的脱氮除磷效果明显优于单独固定菌和单独固定藻,固定菌的效果较差;（3）3种载体包埋下的固定化小球藻的脱氮除磷效果均较相同载体固定化的栅藻效果好。     

Effects of pH and ionic strength on sulfamethoxazole and ciprofloxacin transport in saturated porous media

Many antibiotics regarded as emerging contaminants have been frequently detected in soils and groundwater; however, their transport behaviors in soils remain largely unknown. This study examined the transport of two antibiotics, sulfamethoxazole (SMZ) and ciprofloxacin (CIP), in saturated porous media. Laboratory columns packed with quartz sand was used to test the effects of solution pH and ionic strength (IS) on their retention and transport. The results showed that these two antibiotics behaved differently in the saturated sand columns. In general, SMZ manifested a much higher mobility than CIP for all experimental conditions tested. Almost all SMZ transported through the columns within one pore volume in deionized water (i.e., pH=5.6, IS=0), but no CIP was detected in the effluents under the same condition after extended column flushing. Perturbations in solution pH (5.6 and 9.5) and IS (0 and 0.1M) showed no effect on SMZ transport in the saturated columns. When pH increased to 9.5, however, ~93% of CIP was eluted from the sand columns. Increase of IS from 0 to 0.1M also slightly changed the distribution of adsorbed CIP within the sand column at pH 5.6, but still no CIP was detected in the effluents. A mathematical model based on advection-dispersion equation coupled with equilibrium and kinetic reactions successfully simulated the transport of the antibiotics in water-saturated porous media with R(2)=0.99.     

Investigation of PM2.5 pollution during COVID-19 pandemic in Guangzhou, China

The COVID-19 pandemic has raised awareness about various environmental issues,including PM_2.5 pollution.Here,PM_2.5 pollution during the COVID-19 lockdown was traced and analyzed to clarify the sources and factors influencing PM_2.5 in Guangzhou,with an emphasis on heavy pollution.The lockdown led to large reductions in industrial and traffic emissions,which significantly reduced PM_2.5 concentrations in Guangzhou.Interestingly,the trend of PM_2.5     

A statistic comparison of multi-element analysis of low atmospheric fine particles (PM2.5) using different spectroscopy techniques

Over the past few decades, the metal elements(MEs) in atmospheric particles have aroused great attention. Some well-established techniques have been used to measure particlebound MEs. However, each method has its own advantages and disadvantages in terms of complexity, accuracy, and specific elements of interest. In this study, the performances of inductively coupled plasma–optical emission spectrometry(ICP-OES) and total reflection X-ray fluorescence spectroscopy(TXRF) were evaluated for qualit...     

Determination of 27 pharmaceuticals and personal care products (PPCPs) in water: The benefit of isotope dilution

• Isotope dilution method was developed for the determination of 27 PPCPs in water. • The established method was successfully applied to different types of water samples. • The correction effect of corresponding 27 ILSs over 70 d was investigated. • Benefit of isotopic dilution method was illustrated for three examples. Pharmaceuticals and personal care products (PPCPs) are a unique group of emerging and non-persistent contaminants. In this study, 27 PPCPs in various water samples were extracted by solid phase extraction (SPE), and determined by isotope dilution method using liquid chromatography coupled to tandem triple quadruple mass spectrometer (LC-MS/MS). A total of 27 isotopically labeled standards (ILSs) were applied to correct the concentration of PPCPs in spiked ultrapure water, drinking water, river, effluent and influent sewage. The corrected recoveries were 73%–122% with the relative standard deviation (RSD)<16%, except for acetaminophen. The matrix effect for all kinds of water samples was<22% and the method quantitation limits (MQLs) were 0.45–8.6 ng/L. The developed method was successfully applied on environmental water samples. The SPE extracts of spiked ultrapure water, drinking water, river and wastewater effluent were stored for 70 days, and the ILSs-corrected recoveries of 27 PPCPs were obtained to evaluate the correction ability of ILSs in the presence of variety interferences. The recoveries of 27 PPCPs over 70 days were within the scope of 72%–140% with the recovery variation<37% in all cases. The isotope dilution method seems to be of benefit when the extract has to be stored for long time before the instrument analysis.