中国清洁生产的立法问题

清洁生产的立法需要突出针对性和循序渐进的原则。根据工艺技术的先进性和行业发展状况的不同，其法律规范分为四亿层次：禁止性规范，提倡性规范，鼓励性规范和强制性规范。灵活性和可操作性是清洁生产立法的特点。     

高温高含二氧化碳条件下五种含Cr钢适用性评价

目的 预测某高温高含二氧化碳油井中管柱的腐蚀情况,为该油井推荐安全经济的材质。方法 采用高温高压反应釜模拟现场工况进行腐蚀试验,通过失重法、扫描电子显微镜(SEM)和X射线能谱分析(EDS)对五种含Cr钢的适用性进行评价。结果 在40~160 ℃温度范围内,五种钢材随温度的升高,其均匀腐蚀速率先升高后降低,且均在80 ℃时达到最大值。3Cr钢的腐蚀速率最高,在整个温度范围内,均远高于0.076 mm/a。在温度为120 ℃时,9Cr钢开始出现局部腐蚀。在温度为160 ℃时,13Cr钢有一定的局部腐蚀倾向。S13Cr、22Cr钢在整个温度范围内的腐蚀速率都较低,试验后试样表面平整连续,耐蚀性能好。结论 建议在采出井井筒中上部40~80 ℃较低温度井段选用9Cr钢,中部80~120 ℃中高温井段选用13Cr钢,底部120~160 ℃高温井段选用S13Cr钢。     

接枝羧基壳聚糖的合成及其对重金属离子的吸附性能

以壳聚糖为基体,经环氧氯丙烷交联,制备了水不溶性交联壳聚糖,然后以Ｆｅ＾２＋－Ｈ２Ｏ２为引发剂,将丙烯腈单体接枝到ＣＣＴＳ分子骨架上,经皂化制得了水溶性接枝羧基壳聚糖聚合物。     

不锈钢-气氮板式热沉仿真研究

目的研究不锈钢-气氮板式热沉中,氮气压力、氮气入口流速以及热沉自身流道深度对热沉传热性能的影响。方法利用AnsysFluent软件,对板式热沉壁面温度分布情况以及进出口压力损失进行模拟仿真。结果提高氮气压力和氮气入口速度可以提升热沉的温度均匀性,但热沉进出口压力损失也会增大。对于气氮-板式热沉而言,流道深度的改变对热沉温度均匀性的影响不大,但流道深度较小时,进出口压力损失较大。结论建议在设计气氮-板式热沉时,流道深度选择在8~10 mm,外流程中氮气压力控制在0.3~0.4 MPa,氮气流速控制在20 m/s为宜。     

An assessment of how distance and diesel oxidation catalyst will impact thermal decomposition behaviors of particles

Decomposition mass loss and pyrolysis products analyses of particles sampled at various locations along the tailpipe of a Euro-IV diesel engine were performed using a thermogravimetry in conjunction with Fourier transformation infrared spectrometry-mass spectrum. Diesel particles were collected at the same location with and without diesel oxidation catalyst (DOC) mounted on the test engine separately. The three poles in thermal gravity-differential thermal gravity images suggested that the decomposition process of diesel particles could be divided into three stages which correspond to the decompositions of lower boiling substances, higher boiling substances and soot respectively. It is noticed that no matter whether DOC was mounted or not, the further the particles were sampled away from the engine block, the lower the peak temperatures and the heavier the mass losses within the first two stages, which indicated that the soluble organic fraction in the particle samples increased and therefore lowering the activation energy of thermal decomposition. Hydroxyl, ammonia, C_xH_y fragments, benzene, toluene, and phenol were found to be the primary products of particle decomposition, which didn't change with the location of particle sample point. The employment of DOC increased the activation energy for particle oxidation and resulted in a higher peak temperature and lower mass loss within the first-stage. Moreover, the CO stretching bands of aldehyde and ketone at 1771 cm^?1 was only detected without a DOC, while the NO₂ peak at 1634 cm^?1 was solely noticed with the presence of DOC. Compared to the first-stage pyrolysis products, more polycyclic aromatic hydrocarbons and less C_xH_y fragments were seen in the second-stage.     

Regulated emission characteristics of in-use LNG and diesel semi-trailer towing vehicles under real driving conditions using PEMS

On-road driving emissions of six liquefied natural gas(LNG) and diesel semi-trailer towing vehicles(STTVs) which met China Emission Standard IV and V were tested using Portable Emission Measurement System(PEMS) in northern China.Emission characteristics of these vehicles under real driving conditions were analyzed and proved that on-road emissions of heavy-duty vehicles(HDVs) were underestimated in the past.There were large differences among LNG and diesel vehicles, which also existed between China V vehicles and China IV vehicles.Emission factors showed the highest level under real driving conditions, which probably be caused by frequent acceleration, deceleration, and start-stop.NOx emission factors ranged from 2.855 to 20.939 g/km based on distance-traveled and 6.719–90.557 g/kg based on fuel consumption during whole tests, which were much higher than previous researches on chassis dynamometer.It was inferred from tests that the fuel consumption rate of the test vehicles had a strong correlation with NOx emission, and the exhaust temperature also affected the efficiency of Selected Catalytic Reduction(SCR) aftertreatment system, thus changing the NOx emission greatly.THC emission factors of LNG vehicles were 2.012–10.636 g/km, which were much higher than that of diesel vehicles(0.029–0.185 g/km).Unburned CH_4 may be an important reason for this phenomenon.Further on-road emission tests, especially CH_4 emission test should be carried out in subsequent research.In addition, the Particulate Number(PN) emission factors of diesel vehicles were at a very high level during whole tests, and Diesel Particulate Filter(DPF)should be installed to reduce PN emission.     

高锰酸钾强化PAC混凝处理温瑞塘河黑臭水体试验研究

以浙江省温州市温瑞塘河某河段黑臭地表水为研究对象,考察高锰酸钾强化PAC混凝工艺的除污效能,获得处理温瑞塘河黑臭水体的最佳工艺条件,为恢复河流水体生态自净功能提供基础。试验结果表明,高锰酸钾的最优投加方式为在混凝剂PAC前投加,最佳预氧化时间5 min,最佳投加量1.5 mg/L。将本实验得出的最优混凝处理条件应用于温瑞塘河实际黑臭水体的处理时发现,处理后水质明显改善,此表明高锰酸钾强化混凝应急处理温瑞塘河黑臭水体是切实可行的,可为实际的应急处理工艺提供了理论依据和技术指导。     

废旧电子电气设备的资源化与无害化技术

数量巨大的废旧电子电气设备已成为威胁我国环境的重要固体废弃物,同时也是丰富的再生资源,介绍了国内外回收处理废弃电子电气设备的现状,讨论了当前处理利用废弃电子电气设备方面存在的主要问题,并根据废旧电子电气设备的特点,就其拆卸、电子塑料的处理以及有毒有害物质的分离等技术提出了研究开发建议。     

Improved source assessment of Si, Al and related mineral components to PM10 based on a daily sampling procedure

Samples obtained from an industrialized valley in the East Alpine region were collected daily for a half year and analyzed using X-ray fluorescence to examine the elements Si,Al,Fe,Ca,Mg,Na,K,Zn,P,S and Cl.Some factors affecting the changes of these elements were considered,including time,elemental correlations,weekday,weekend and seasonal changes.Diagnostic analysis provided an insight into a decoupling behavior that occursin siliceous and carbonates minerals.A decrease in Si and Al and an increase in carbonates,Na,K,Zn and P were observed during the cold season.However,a consistently high correlation of Si and Al was observed in all seasons.It was established that such high levels originated from street surface abrasion.The increase in variability and absolute levels of carbonates during the cold season was demonstrated by adding carbonates to the street surface as gritting material to increase the grip on snowy surfaces.A marked increase in Na and Cl was observed in winter which may have been caused by thaw salt that is widely used in winter in Austria.This was associated with a significant increase in K,Zn,and P in the cold season that was the result of domestic space heating with wood.PM10 levels in December were 12 μg/m3 and were higher than levels detected in July.It was established that such high levels originated from mineral oxides,wood smoke,and inorganic ionic material(s).     

高含固污泥厌氧消化中蛋白质转化规律

采用剩余污泥在含固率(total solid,TS)为12%条件下进行中温(37℃)厌氧消化,通过分析厌氧消化前后污泥蛋白质组分的变化情况,研究了高含固污泥厌氧消化中蛋白质的转化规律,探讨了高含固条件下污泥蛋白质转化效率较低的原因.结果表明,经过45 d的厌氧消化处理,污泥蛋白质的转化率为34.26%.污泥蛋白质转化效率较低的原因主要表现在:(1)高含固条件下污泥的传质较差;同时,污泥蛋白质经水解过程形成大量的氨氮,反应结束后污泥总氨氮(total ammonia nitrogen,TAN)质量浓度达到1 201 mg·L~(-1),导致对厌氧消化过程,尤其对蛋白质的分解表现出一定的抑制作用;(2)三维荧光光谱(three-dimensional fluorescence spectroscopy,3D-EEM)分析表明,部分蛋白质向腐殖质类、富里酸类物质转化,从而更难分解;(3)通过二维电泳(two-dimensional electrophoresis,2-DE)-质谱(mass spectrometry,MS)分析发现,厌氧消化后污泥蛋白质的相对分子质量和等电点(isoelectric point,p I)降低;最终,污泥中残留的大部分蛋白质来源于微生物体内.由于微生物代谢能力随着厌氧消化过程的进行而减弱,难以继续利用这些蛋白质,或消化体系中不具备分解这些蛋白质的酶,从而限制了污泥中蛋白质的分解效率.