Changes in Streambed Composition in Salmonid Spawning Habitat of the Elwha River during Dam Removal

One uncertainty associated with large dam removal is the level of downstream sediment deposition and associated short‐term biological effects, particularly on salmonid spawning habitat. Recent studies report downstream sediment deposition following dam removal is influenced by proximity to the source and river transport capacity. The impacts of dam removal sediment releases are difficult to generalize due to the relatively small number of dam removals completed, the variation in release strategies, and the physical nature of systems. Changes to sediment deposition and associated streambed composition in the Elwha River, Washington State, were monitored prior to (2010‐2011) and during (2012‐2014) the simultaneous removal of two large dams (32 and 64 m). Changes in the surface layer substrate composition during dam removal varied by year and channel type. Riffles in floodplain channels downstream of the dams fined and remained sand dominated throughout the study period, and exceeded levels known to be detrimental to incubating salmonids. Mainstem riffles tended to fine to gravel, but appear to be trending toward cobble after the majority of the sediment was released and transported through system. Thus, salmonid spawning habitats in the mainstem appear to have been minimally impacted while those in floodplain channels appear to have been severely impacted during dam removal.     

Antioxidants in Capsicum chinense: Variation among countries of origin

The main objective of this investigation was to evaluate fruits of C. chinense accessions for their concentration of β -carotene, ascorbic acid, and phenols for use as parents in breeding for these phytochemicals. Mature fruits of 63 accessions of C. chinense originally acquired from Belize, Brazil, Colombia, Ecuador, Mexico, Peru, Puerto Rico, and the United States were analyzed for their chemical composition. Fruits of C. chinense accessions PI-152452 (Brazil) and PI-360726 (Ecuador) contained the greatest concentrations of ascorbic acid (1.2 and 1.1 mg g^?1 fresh fruit, respectively), while PI-438648 (Mexico) contained the greatest concentration of total phenols content (349 μ g g^?1 fresh fruit) among the other 63 accessions tested. Accession PI-355817 from Ecuador contained the greatest concentrations of β -carotene (8 mg g^?1fresh fruit). These accessions were identified as potential candidates for mass production of antioxidants with health-promoting properties.     

Wild tomato leaf extracts for spider mite and cowpea aphid control

Glandular trichomes on the leaves of wild tomato, L. hirsutum f. hirsutum Mull, also known as Solanum habrochaites (Solanaceae), synthesize and accumulate high levels of methyl ketones (MKs). L. hirsutum accession LA 407, having high concentration of MKs, was grown from seeds under greenhouse conditions. Four MKs (2-undecanone, 2-dodecanone, 2-tridecanone, and 2-pentadecanone) were screened for their toxicity to spider mites, Tetranychus urticae Koch and cowpea aphids, Aphis craccivora Koch. The objectives of this investigation were to: (1) develop a bioassay for testing MKs on spider mite and cowpea aphid mortality and (2) compare the efficacies of wild tomato leaf crude extracts and pure standard materials of MKs against spider mite and cowpea aphid mortality. Our results revealed that spider mites are most sensitive to 2-tridecanone (LC₅₀ = 0.08 μmole cm^?2 of treated leaf surface) and least sensitive to 2-undecanone (LC₅₀ = 1.5 μmole cm^?2 of treated leaf surface) 4 h after treatment. Similarly, 2-tridecanone caused greatest mortality (LC₅₀ = 0.2 μmole cm^?2 of treated leaf surface), whereas 2-undecanone caused the lowest morality (LC₅₀ = 0.48 μmole cm^?2 of treated surface) of cowpea aphid. We concluded that all MKs tested in this investigation are toxic to spider mites and aphids. 2-Tridecanone is more effective in killing mites and aphids compared to other MKs. Toxicity of crude extracts, prepared from the leaves of L. hirsutum accession LA 407, to spider mites and cowpea aphids revealed greater mortality compared to a combined mixture of MKs standard material (used at the same concentration as found on LA 407 leaves). This indicates that in addition to MKs, other unidentified compounds in LA 407 leaf extract also have pesticidal properties. Accordingly, leaf extracts of LA 407 could be explored in crop protection, and they might open a new area of MK formulations and discovery of biorational alternatives for pest control in agricultural fields.     

Spatial Variation in Acidic Sulfate and Ammonia Concentrations within Metropolitan Philadelphia

Abstract

Acidic sulfate concentrations were measured in metropolitan Philadelphia during the summers of 1992 and 1993, as part of a continuing effort to characterize particle concentrations in urban environments. Sampling was performed simultaneously at eight sites located within and around metropolitan Philadelphia. Sites were selected based on their population density and on their distance and direction from the city center. Air pollution sampling was conducted every other day during the summer of 1992 and every day during the summer of 1993. All samples were collected for 24-h periods beginning at 9 a.m. (EDT). All acidic sulfate and ammonia samples were collected using modified Harvard-EPA Annular Denuder Systems (HEADS).

In this paper, we examine the spatial variation in acidic sulfate and ammonia concentrations within the metropolitan Philadelphia area. We also identify factors that may influence their variation and develop models to predict their concentrations. Outdoor sulfate (SO₄ ^2?) concentrations were uniform within metropolitan Philadelphia; however, aerosol strong acidity (H⁺) concentrations varied spatially. This variation generally was independent of wind direction, but was related to local factors, such as the NH₃ concentration, population density, and distance from the center of the city. Physico-chemical models, which were developed using data collected during the summer of 1992, were excellent predictors of 24-h and mean summertime H⁺ concentrations measured during the summer of 1993. Models accounted for 78% of the variation in 24-h H⁺ levels. Results suggest that a single stationary ambient (SAM) monitor would be sufficient to estimate SO₄ ^2? exposures for populations living in Philadelphia. For H⁺, however, multiple monitoring sites or models should be used to determine the outdoor H+ exposures of populations living in urban environments, although a single SAM site may provide an excellent index of H⁺ variation over time.     

Solvent Extraction Processes: A Survey of Systems in the SITE Program

Solvent extraction of contaminated soils, sludges and sediments has been successfully completed at a number of Superfund sites. Each commercialized process uses a unique operating system to extract organic contaminants from solids. These operating systems may be classified by the properties of the solvents each utilizes: (1) standard solvents, (2) near-critical fluids/liquified gases, and (3) critical solution temperature solvents. Pretreatment and post-treatment requirements vary depending upon the operating systems of the solvent extraction system. Future demonstrations of these technologies by the U.S. EPA’s Superfund Innovative Technology Evaluation Program will provide additional information regarding the efficacy of these processes.     

Controlled Enrichment System for Experimental Fumigation of Plants in the Field with Sulfur Dioxide

A prototype Free-Air Controlled Enrichment (FACE) system was developed at Brookhaven National "Laboratory (BNL) for the experimental control of gas concentrations in an open field, without any form of enclosure. This FACE system consists of a toroidal plenum chamber, 15 m in diameter, with a series of 32 vertical vent pipes from which the release of a test gas can be controlled. Data on gas concentration at the center of the array and wind velocity are fed to a microprocessor where a proportional, integrative, differential (PID) algorithm is used to regulate a mass-flow controller. Data on wind direction are used to control the opening and closing of the vertical vent pipes to maintain an upwind release. In 72 hours of continuous operation during which wind velocity varied between 0.3 to 8 m sec^-1, the FACE prototype maintained 1 -min averaged concentrations within twenty percent of the 40 ppb set point 94 percent of the time.     

Receptor Model Evaluation of the Southeast Michigan Ozone Study Ambient NMOC Measurements

Abstract

Large-scale studies like the Southeast Michigan Ozone Study (SEMOS) have focused attention on quantifying and spedating inventories for volatile organic compounds (VOCs). One approach for evaluating the accuracy of a VOC emission inventory is the development of a chemical mass balance (CMB) receptor model for ambient non-methane organic compound (NMOC) measurements. CMB evaluations of ambient hydrocarbon data provide a sample-specific allocation of emissions to individual source categories. This study summarizes the results of an application of the CMB model to the NMOC data from the SEMOS study. Comparison of CMB results with emission inventory values for the Detroit area show that vehicle emissions are well represented by the inventory, as are architectural coatings and coke ovens. Estimated emissions from petroleum refineries and graphic arts industries are much lower in the inventory than determined from the receptor allocation. Under-reporting of fugitive VOC emissions from petroleum refineries is an ongoing problem. Emissions from graphic arts industries are underestimated in the inventory partly because of the broad characterization of the emission factor (i.e., mass emitted/capita), which may be less useful when specific locations and days are under consideration. This study also demonstrates the effectiveness of the CMB approach when used prospectively to track the implementation of emission control strategies. While vehicle emission concentrations were unchanged from 1988 to 1993, measurement-based CMB results suggest a decrease in evaporative emissions during this time period resulting from Reid vapor pressure (RVP) reductions (from 11.0 psi in 1988 to 8.6 psi in 1993) and fleet turnover. Changes in emissions from coke plants and petroleum refineries were also seen in the CMB allocations for these sources.     

Method Comparisons for Particulate Nitrate,Elemental Carbon,and PM2.5 Mass in Seven U.S. Cities

ABSTRACT

Methods that measure PM₂₅ mass, total particulate NO₃ ^-, and elemental carbon (EC) were evaluated in seven U.S. cities from 1997 to 1999. Sampling was performed in Bakersfield, CA; Boston, MA; Chicago, IL; Dallas, TX; Philadelphia, PA; Phoenix, AZ; and Riverside, CA. Evaluating and validating methods that measure the components of fine mass are important to the effort of establishing a speciation-monitoring network. The Harvard Impactor (HI), which measures fine particle mass, showed excellent agreement (r² = 0.99) with the PM₂₅ Federal Reference Method (FRM) for 81 24-hr samples in Riverside and Bakersfield. The HI also showed good precision (4.8%) for 243 24-hr collocated samples over eight studies.

The Aethalometer was employed in six of the sampling locations to measure black carbon (BC). These values were compared to EC as measured from a quartz filter using thermal analysis. For the six cities combined, the two methods were highly correlated (r² = 0.94; 187 24-hr samples); however, the BC values were approximately 24% less than the EC measurements consistently across all six cites. This compares well to results observed for EC/BC measurements observed in other semi-urban areas. Par-ticulate NO₃ ^- was measured using the Harvard-EPA Annular Denuder System (HEADS). This was compared to the NO₃ ^- measured from the HI Teflon (DuPont) filter to assess NO₃ ^- artifacts. Significant NO₃ ^- losses (approximately 50% of total NO₃ ^-) were found in Riverside, Philadelphia, and Boston, while minimal artifacts were observed in the other sites. Two types of HEADS configurations were employed in five cities. One system used a Na₂CO₃-coated glass fiber filter, and the other type used a nylon filter to collect volatilized NO₃ ^- from the Teflon filter. The HEADS with the Na₂CO₃-coated filter consistently underestimated the total particulate NO₃ ^- by approximately 20% compared to the nylon HEADS.     

Laboratory and Field Evaluation of Measurement Methods for One-Hour Exposures to O3, PM25, and CO

ABSTRACT

While researchers have linked acute (less than 12-hr) ambient O₃, PM₂₅, and CO concentrations to a variety of adverse health effects, few studies have characterized short-term exposures to these air pollutants, in part due to the lack of sensitive, accurate, and precise sampling technologies. In this paper, we present results from the laboratory and field evaluation of several new (or modified) samplers used in the “roll-around” system (RAS), which was developed to measure 1-hr O₃, PM₂₅, and CO exposures simultaneously. All the field evaluation data were collected during two sampling seasons: the summer of 1998 and the winter of 1999.

To measure 1-hr O₃ exposures, a new active O₃ sampler was developed that uses two nitrite-coated filters to measure O₃ concentrations. Laboratory chamber tests found that the active O₃ sampler performed extremely well, with a collection efficiency of 0.96 that did not vary with temperature or relative humidity (RH). In field collocation comparisons with a reference UV photometric monitor, the active O₃ sampler had an effective collection efficiency ranging between 0.92 and 0.96 and a precision for 1-hr measurements ranging between 4 and 6 parts per billion (ppb). The limits of detection (LOD) of this method were 9 ppb-hr for the chamber tests and ~16 ppb-hr for the field comparison tests.

PM_2.5 and CO concentrations were measured using modified continuous monitors—the DustTrak and the Langan, respectively. A size-selective inlet and a Nafion dryer were placed upstream of the DustTrak inlet to remove particles with aerodynamic diameters greater than 2.5 um and to dry particles prior to the measurements, respectively. During the field validation tests, the DustTrak consistently reported higher PM_2.5 concentrations than those obtained by the collocated 12-hr PM_{2 5} PEM samples, by approximately a factor of 2. After the DustTrak response was corrected (correction factor of 2.07 in the summer and 2.02 in the winter), measurements obtained using these methods agreed well with R² values of 0.87 in the summer and 0.81 in the winter. The results showed that the DustTrak can be used along with integrated measurements to measure the temporal and spatial variation in PM_{2 5} exposures. Finally, during the field validation tests, CO concentrations measured using the Langan were strongly correlated with those obtained using the reference method when the CO levels were above the LOD of the instrument [~1 part per million (ppm)].