Environmental hazards,neighbourhood quality,and neighbourhood environmental activism

summary This article presents a study of the association of perceived neighbourhood hazards, neighbourhood quality, and resident behavioural responses in two New Jersey, USA, communities that contain multiple technological hazards and populations that are relatively poor and racially homogeneous. The number of neighbourhood problems was highest among residents who engaged in activities to protect their neighbourhood and perceived that their neighbourhood was of poor or fair quality. These respondents perceived three to five times as many hazards as their counterparts who were passive and perceived that their neighbourhood was of excellent or good quality. Respondents' age, education, gender, type of residential unit occupied, and length of residence in the neighbourhood, were not associated with their evaluation of neighbourhood hazards. The authors argue that multiple-hazard neighbourhoods are excellent environments to learn about perception of hazards.Professor Michael Greenberg is Head of the Department of Urban Studies and Community Health where Professor Dona Schneider and Jim Parry are associates.     

Rieselfelder

Soils of the large sewage farm area south of Berlin are contaminated with heavy metals such as Cd, Cr, Cu, Hg, Ni, Pb, Zn. Based on earlier studies the total amount and the bioavailable proportions of heavy metals in soil samples were analysed. In some samples very high levels of total heavy metal concentrations were detected. For Pb, Cd, Cu and Hg the maximum values were 1360, 29.7, 817 and 40.8 mg/kg soil dry matter, respectively. The biovailable fractions of heavy metals which were found primarily in the acetate and EDTA fractions and to a lesser degree in the water extract account for about 50 % (Pb, Ni), 70 % (Cd) or 90% (Zn) of their total amount and may therefore pose a considerable environmental risk.     

Sibling species or poecilogony in the polychaete<Emphasis Type="Italic"> Scoloplos armiger</Emphasis>?

In marine invertebrates multiple modes of development, or poecilogony, may occur in a single species. However, after close examination, many of such putative cases turned out to be sibling species. A case in point may be the cosmopolitan orbiniid polychaete Scoloplos armiger, which inhabits marine shallow sediments. In addition to the well-known direct, holobenthic development from egg cocoons, pelagic larvae have also been described. Our culture experiments revealed a spatially segregated source of the two developmental modes. All females of an intertidal population produced egg cocoons and no pelagic larvae. All but 2 out of 15 females of an adjacent subtidal population produced pelagic larvae and no egg cocoons. Based on these results we performed a molecular genetic analysis (RAPD-PCR) on three intertidal and four subtidal populations in the North Sea. Selected samples from all sites were analysed also by the AFLP method. We found significantly higher genetic diversity within subtidal than within intertidal populations. This is consistent with a wider dispersal by pelagic larvae and a smaller effective population size when development is holobenthic. Total genetic divergence is not related to distance but to the intertidal/subtidal division. We suggest that S. armiger actually represents two sibling species.     

Evaluation of a gradient sampling design for environmental impact assessment

Before-After Control Impact (BACI) sampling designsare commonly used in environmental impact assessmentand are considered the most effective for detectingchanges due to anthropogenic disturbances. Thesedesigns handle local spatial variability throughrandomized placement of samples into a treatmentstratum and a control stratum. When a contaminantdisperses with distance from a point source it issuggested that a gradient design will be moresensitive to change than randomized placement ofsamples. This requires allocating samples according todistance, rather than by random placement withinrandomly placed blocks. In this paper gradient versusrandom sampling designs were compared using data froman oil field in the North Sea. The gradient samplingdesign was more powerful than a randomized CI sampling design.     

Effect of pore-water velocity on chemical nonequilibrium transport of Cd,Zn, and Pb in alluvial gravel columns

This paper investigates the effects of pore-water velocity on chemical nonequilibrium during transport of Cd, Zn, and Pb through alluvial gravel columns. Three pore-water velocities ranging from 3 to 60 m/day were applied to triplicate columns for each metal. Model results for the symmetric breakthrough curves (BTCs) of tritium (3H2O) data suggest that physical nonequilibrium components were absent in the uniformly packed columns used in these studies. As a result, values of pore-water velocity and dispersion coefficient were estimated from fitting 3H2O BTCs to an equilibrium model. The BTCs of metals display long tailing, indicating presence of chemical nonequilibrium in the system, which was further supported by the decreased metal concentrations during flow interruption. The BTCs of the metals were analysed using a two-site model, and transport parameters were derived using the CXTFIT curve-fitting program. The model results indicate that the partitioning coefficient (beta), forward rate (k1), and backward rate (k2) are positively correlated with pore-water velocity (V); while the retardation factor (R), mass transfer coefficient ((omega), and ratio of k1/k2 are inversely correlated with V. There is no apparent relationship between the fraction of exchange sites at equilibrium (f) and V. The influence of Von k2 is much greater than on R, beta, omega, and k1. A one-order-of-magnitude change in V would cause a two-order-of-magnitude change in k2 while resulting in only a one order-of-magnitude change in R, beta, omega, and k1. The forward rates for the metals are found to be two to three orders-of-magnitude greater than the corresponding backward rate. However, the difference between the two rates reduces with increasing pore-water velocity. Model results also suggest that Cd and Zn behave similarly, while Pb is much more strongly sorbed. At input concentrations of about 4 mg/l and pore-water velocities of 3-60 m/day in the groundwater within alluvial gravel, this study suggests retardation factors of 26-289 for Cd, 24-255 for Zn, and 322-6377 for Pb.     

Photodynamic action of some sensitizers by photooxidation of luminol

We report the development of a novel simple experimental method which allows the comparison of new photosensitizers based on their production of reactive oxygen species. A high-performance liquid chromatography (HPLC) assay permits the monitoring of several substances (sensitizer, reactant and oxidized end product) simultaneously on a single chromatogram. Photoreactions were monitored throughout their course by the HPLC assay surveying the sensitizers' efficiency of singlet oxygen production by the oxidative decomposition of luminol. Several photosensitizers were tested: Rose Bengal, Methylene Blue, Protoporphyrin IX, Photosan III, Photofrin, Hypericin and Pseudohypericin. Additionally, photoreactions were monitored by a standard pO₂ detection system. The measurements of the two detection methods were strongly correlated. Rose Bengal proved to be the most efficient photosensitizer, clearly decreasing the luminol concentration and causing a corresponding increase in aminophthalic acid. Our experiments show that when factors necessary for photochemical reactions are absent or are blocked (antioxidants), no reaction can be detected.     

Global Carbon Dioxide Emissions Scenarios: Sensitivity to Social and Technological Factors in Three Regions

Carbon dioxide emissions from 1990 to 2100 AD are decomposed into the product of four factors: population size, affluence (measured here as GDP per capita), energy intensity (energy use per unit GDP) and carbon intensity (carbon dioxide emissions per unit energy). These emissions factors are further subdivided into three regions: more developed countries (MDCs), China, and the remaining less developed countries (LDCs). Departures from a baseline scenario (based on IPCC, 1992a — the so-called ‘business-as-usual’ scenario) are calculated for a variety of alternative assumptions concerning the four emissions factors in the three regions. Although the IPCC scenario is called a ‘non-intervention’ scenario, it is shown, for example, that large decreases in energy intensity in China or carbon intensity in MDCs are built into the ‘business as usual’ case — and such large changes vary considerably from region to region. We show what CO₂ emissions would look like if each of these four emissions factors projected in the baseline case somehow remained constant at 1990 levels. Certain factors like energy intensity improvements and long-term population growth in LDCs, or GDP growth and carbon intensity improvements in MDCs, are shown to have a big contribution to cumulative global emissions to 2100 AD, and consequently, changes in these projected factors will lead to significant deviations from baseline emissions. None of the scenarios examined in this analysis seems to indicate that any one global factor is clearly dominant, but cultural, economic, and political costs or opportunities of altering each factor may differ greatly from country to country.