Cardiac flow after fetal blood sampling in normally grown and growth-retarded fetuses

The objective of this study was to evaluate the effect of fetal blood sampling on cardiac flow velocity waveforms. Flow velocity waveforms were measured from the ascending aorta and pulmonary artery immediately before and after fetal blood sampling in 29 normally grown and 12 growth-retarded fetuses. The latter group was characterized by abnormal Doppler indices in the umbilical artery and middle cerebral artery suggestive of uteroplacental insufficiency as the causative factor of the impaired growth. The flow velocity parameters studied were the peak velocity, the time to peak velocity, and the left and right cardiac output and their ratio. In normally grown fetuses, the peak velocity and right and left cardiac output values increased significantly after fetal blood sampling, while no significant changes were observed in the other indices considered. The gestational age at the time of the procedure was positively related to the amplitude of these changes. In growth-retarded fetuses, fetal blood sampling did not induce any significant increase in cardiac output or peak velocities, while in more than 50 per cent of the fetuses these Doppler indices decreased. The amplitude of the decrease was significantly related to the severity of acidosis in the umbilical vein. In conclusion, the cardiac haemodynamic response to fetal blood sampling differs between normally grown and growth-retarded fetuses. This difference may explain the higher rate of complications occurring in the latter group of fetuses after blood sampling.     

First-trimester genetic diagnosis in multiple pregnancy: Principles and potential pitfalls

Both the principles of first-trimester genetic diagnosis in multiple pregnancy and the special considerations required to avoid potential diagnostic pitfalls are presented. The experience consisted of 65 cases of twins and one case of quadruplets. Dichorionic twins were recognized by sonography in 54 cases. Transabdominal aspiration was generally preferred to trans-cervical for obtaining chorionic tissue, although in two cases both approaches were used. Diagnostic error following erroneous sampling was reported in 3 out of 54 sets of dichorionic twins (5.5 per cent). When like-sex dichorionic twins cannot be differentiated by cytogenetic or DNA polymorphism studies, amniocentesis should be recommended to confirm the reliability of the result on chorionic tissue.     

Defining the photochemical contribution to particulate matter in urban areas using time-series analysis

The objective of this project is to demonstrate how the ambient air measurement record can be used to define the relationship between O3 (as a surrogate for photochemistry) and secondary particulate matter (PM) in urban air. The approach used is to develop a time-series transfer-function model describing the daily PM10 (PM with less than 10 microm aerodynamic diameter) concentration as a function of lagged PM and current and lagged O3, NO or NO2, CO, and SO2. Approximately 3 years of daily average PM10, daily maximum 8-hr average O3 and CO, daily 24-hr average SO2 and NO2, and daily 6:00 a.m.-9:00 a.m. average NO from the Aerometric Information Retrieval System (AIRS) air quality subsystem are used for this analysis. Urban areas modeled are Chicago, IL; Los Angeles, CA; Phoenix, AZ; Philadelphia, PA; Sacramento, CA; and Detroit, MI. Time-series analysis identified significant autocorrelation in the O3, PM10, NO, NO2, CO, and SO2 series. Cross correlations between PM10 (dependent variable) and gaseous pollutants (independent variables) show that all of the gases are significantly correlated with PM10 and that O3 is also significantly correlated lagged up to two previous days. Once a transfer-function model of current PM10 is defined for an urban location, the effect of an O3-control strategy on PM concentrations is estimated by calculating daily PM10 concentrations with reduced O3 concentrations. Forecasted summertime PM10 reductions resulting from a 5 percent decrease in ambient O3 range from 1.2 microg/m3 (3.03%) in Chicago to 3.9 microg/m3 (7.65%) in Phoenix.     

Preliminary investigation on the environmental occurrence and effects of antibiotics used in aquaculture in Italy

A preliminary investigation has been carried out on the occurrence and effects of antibiotics used in Italian aquaculture with the objective of identifying priorities for monitoring programmes. According to the information available on the most pertinent and diffuse fish diseases and their related therapies, the presence of flumequine and oxytetracycline in sediments sampled from two trout farms and three sea-bass farms and in their surrounding environments was selected for an analytical investigation. The concentrations of oxytetracycline and flumequine varied up to a maximum of 246.3 and 578.8 microg/kg d.w., respectively. Flumequine was seen to have the highest toxicity in a bioluminescence assay with EC50 values varying within the range of 12-15 mg/l, while the EC50 values for oxytetracycline were within the range of 121-139 mg/l. The results of the present study indicate flumequine and oxytetracycline as priority chemicals to be monitored for possible environmental side effects of aquaculture in Italy. Apart from peak concentrations the chronic presence of flumequine and oxytetracycline in sediments both inside and outside farms should also be considered. In spite of the potential risks related to the use of antibiotics, the concentrations found in the sediments of the studied fish farms are significantly lower than those found in other areas.     

Fractal and multifractal approach to environmental pollution

A few case studies will be presented involving both radioactive and chemical pollution at small, medium, and large space-time scales. Reported are recent advances in the field of environmental pollution involving the use of fractals and multifractals. The mathematical tools proposed here may offer new perspectives for investigating many of the problems of nonlinear variability which commonly arise when dealing with pollutants, such as the presence of outliers and the sparseness of the sampling networks. They may also lead to a simplification of the models adopted for studying natural phenomena, thanks to a scaling approach. Finally, they may provide parameters whose values are directly related to the nonlinear dynamics involved in the pollutant distribution in the environment which, in turn, may be relevant for computer simulation and epidemiological or risk assessment purposes.     

Efficiency in hydrocarbon degradation and biosurfactant production by Joostella sp. A8 when grown in pure culture and consortia

Joostella strains are emerging candidates for biosurfactant production. Here such ability was analyzed for Joostella strain A8 in comparison with Alcanivorax strain A53 and Pseudomonas strain A6, all previously isolated from hydrocarbon enrichment cultures made of polychaete homogenates. In pure cultures Joostella sp. A8 showed the highest stable emulsion percentage(78.33%), hydrophobicity rate(62.67%), and an optimal surface tension reduction during growth in mineral medium supplemented with diesel oil(reduction of about 12 mN/m), thus proving to be highly competitive with Alcanivorax and Pseudomonas strains. During growth in pure culture different level of biodegradation were detected for Alcanivorax strain A53(52.7%),Pseudomonas strain A6(38.2%) and Joostella strain A8(26.8%). When growing in consortia,isolates achieved similar abundance values, with the best efficiency that was observed for the Joostella-Pseudomonas co-culture. Gas-chromatographic analysis revealed an increase in the biodegradation efficiency in co-cultures(about 90%), suggesting that the contemporary action of different bacterial species could improve the process. Results were useful to compare the efficiencies of well-known biosurfactant producers(i.e. Pseudomonas and Alcanivorax representatives) with a still unknown biosurfactant producer, i.e. Joostella, and to confirm them as optimal biosurfactant-producing candidates.     

Feeding over the 24-h cycle: dietary flexibility of cathemeral collared lemurs (<Emphasis Type="Italic">Eulemur collaris</Emphasis>)

Animals show specific morphological, physiological and behavioural adaptations to diurnal or nocturnal activity. Cathemeral species, i.e. animals with activities distributed over the 24-h period, have to compromise between these specific adaptations. The driving evolutionary forces and the proximate costs and benefits of cathemerality are still poorly understood. Our goal was to evaluate the role of predator avoidance, food availability and diet quality in shaping cathemeral activity of arboreal mammals using a lemur species as an example. For this, two groups of collared lemurs, Eulemur collaris, were studied for 14 months in the littoral forest of southeastern Madagascar. Data on feeding behaviour were collected during all-day and all-night follows by direct observation. A phenological transect containing 78 plant species was established and monitored every 2 weeks to evaluate food availability during the study period. Characteristics of food items and animal nutritional intake were determined via biochemical analyses. The ratio of diurnal to nocturnal feeding was used as response variable in the analyses. The effects of abiotic environmental variables were removed statistically before the analyses of the biotic variables. We found that diurnal feeding lasted longer during the hot–wet season (December–February), whereas nocturnal feeding peaked during the hot–dry and cool–wet seasons (March–August). Although the lemurs foraged mostly in lower forest strata during daylight and used emergent trees preferably at night, the variables which measured animal exposure to birds of prey failed to predict the variation of the ratio of diurnal/nocturnal feeding. Ripe fruit availability and fiber intake are the two variables which best predicted the annual variation of the lemur diurnality. The data indicate that feeding over the whole 24-h cycle is advantageous during lean periods when animals have a fibre-rich, low-quality diet.     

Toxicity attenuation of olive mill wastewater in soil slurries

Olive mill wastewaters are toxic for plants and microbes due to their high polyphenol content. We studied the effect of agricultural soil as a natural catalyst to promote polyphenol oxidation and polymerization, and in turn detoxify olive mill wastewaters. We show that model polyphenols are fully converted in soil slurries. Their products show no toxicity to the growth of a typical soil bacterium, Bacillus cereus, and reduced phytotoxicity in germination tests with English cress seeds. Those findings are promising for the sustainable treatment of olive wastewater in aerated soil slurries.     

Temperature activated degradation (mineralization) of 4-chloro-3-methyl phenol by Fenton's reagent

With the aim to evaluate the effect of temperature, 4-chloro-3-methyl phenol (CMP) degradation by Fenton's reagent was investigated at 25 and 70 degrees C under the following initial conditions: [CMP]0 = 10 mM, [Fe2+]0 = 0.5 mM; ([H2O2]0/[CMP]0) = 80, pH0 = 3. The results indicated that CMP degradation was strongly influenced by temperature. In fact, the maximum TOC removal, achieved after ca. 24h, was by far greater at 70 degrees C (85%) than at 25 degrees C (36%). The same happened for organic chlorine (TOX) conversion into inorganic chloride, i.e. 100%, after 3 h at 70 degrees C, and 87%, after 27 h at 25 degrees C. As the recorded trends of CMP removal and chloride formation were basically the same, hydroxy substitution (ipso-substitution) was hypothesised as one likely mechanism of CMP degradation. The higher level of mineralization recorded at 70 degrees C was ascribed to: (i) a greater *OH concentration; (ii) a consequently greater extent of CMP oxidation to organic acids; (iii) a higher decarboxylation rate of such acids. An interesting consequence of such extended organic acids decarboxylation was a pH increase up to 8 that, in turn, caused, in the treated mixture, the decomposition of excess H2O2 as well as the precipitation of iron ions. These two latter outcomes are technologically important considering that usually, before discharging Fenton treated wastewater, specific polishing steps are required just to remove iron ions, decompose excess hydrogen peroxide and neutralise the pH.