Removal of sulfamethoxazole and sulfapyridine by carbon nanotubes in fixed-bed columns

Sulfamethoxazole (SMX) and sulfapyridine (SPY), two representative sulfonamide antibiotics, have gained increasing attention because of the ecological risks these substances pose to plants, animals, and humans. This work systematically investigated the removal of SMX and SPY by carbon nanotubes (CNTs) in fixed-bed columns under a broad range of conditions including: CNT incorporation method, solution pH, bed depth, adsorbent dosage, adsorbate initial concentration, and flow rate. Fixed-bed experiments showed that pH is a key factor that affects the adsorption capacity of antibiotics to CNTs. The Bed Depth Service Time model describes well the relationship between service time and bed depth and can be used to design appropriate column parameters. During fixed-bed regeneration, small amounts of SMX (3%) and SPY (9%) were irreversibly bonded to the CNT/sand porous media, thus reducing the column capacity for subsequent reuse from 67.9 to 50.4 mg g^?1 for SMX and from 91.9 to 72.9 mg g^?1 for SPY. The reduced column capacity resulted from the decrease in available adsorption sites and resulting repulsion (i.e., blocking) of incoming antibiotics from those previously adsorbed. Findings from this study demonstrate that fixed-bed columns packed with CNTs can be efficiently used and regenerated to remove antibiotics from water.     

Remediation of DDTs contaminated soil in a novel Fenton-like system with zero-valent iron

Application of a novel Fenton-like system with zero-valent iron, EDTA and Air (ZVI/EDTA/Air) was investigated to degrade dichlorodiphenyltrichloroethane (DDT), dichlorodiphenyldichloroethane, and dichlorodiphenyldichloroethylene (DDE) in the actual contaminated soil from an organochlorine pesticide site. It was found DDTs in the soil were effectively degraded by the system at room temperature, ambient atmosphere pressure and near neutral pH. The dosages of EDTA and ZVI were the dominant factors influencing the removal of contaminants. An increase of EDTA from 0.05 to 0.2 mM and ZVI from 1 to 5 g L^?1 improved the removal of the contaminants significantly. However, excessive amount of EDTA led to a negative effect on the degradation process. Meanwhile, EDTA was simultaneously degraded so as to avoid the secondary pollution risk on soil remediation. Only a small amount of 4,4′-DDE and 2,2-bis(4-chlorophenyl)-1-chloroethylene (4,4′-DDMU) generated as the intermediates of DDT degradation during the process. Our investigation suggests that the Fenton-like system is a promising alternative for remediation of organochlorine pesticides contaminated soils.     

天然和CPB改性沸石对Hg^2＋的吸附特征

通过静态实验研究溴代十六烷基吡啶（CPB）改性沸石和天然沸石对废水中Hg^2＋的吸附特性,探讨了吸附动力学、吸附平衡和吸附热力学机制。研究表明：Langmuir方程能较好地描述2种沸石对Hg^2＋的吸附,CPB改性沸石对Hg^2＋的吸附率得到显著提高。实验条件下,改性沸石对Hg^2＋的吸附率从67．5％提高到98．9％,吸附容量从0．521mg／g提高到3．07mg／g。利用准一级动力学方程、假二级动力学方程、颗粒内扩散模型和Elovich方程分别对动力学过程进行拟合,发现2种沸石对Hg^2＋的吸附均满足假二级动力学方程,且离子的颗粒内扩散对整个吸附过程有影响。动力学拟合、D-R方程拟合和热力学研究综合表明：2种沸石对Hg^2＋的吸附既存在化学吸附又存在物理吸附,吸附吉布斯自由能变（△G^0）、焓变（△H^0）、熵变（△S^0）均小于0,反应为自发的放热反应,低温有利于吸附的进行。     

离子交换法选择性回收污泥厌氧消化液中的磷

为探讨高效选择性回收污泥厌氧消化液中磷的离子交换方法,采用静态实验和动态实验研究了4种阴离子交换树脂（D213、D202、D301和DSQ）的磷回收性能,筛选了适合富磷污泥厌氧消化液选择性磷回收的高交换容量树脂。实验结果表明,D213、D202、D301和DSQ 4种树脂对正磷浓度为70 mg/L的厌氧消化液进行动态处理时,其最大穿透体积分别为3、7、17和90 BV;DSQ树脂磷交换容量远高于其他3种树脂,达到6 860 mg P/L湿树脂,是目前报道的高磷交换容量树脂的3~4倍;DSQ树脂能有效地抵抗厌氧消化液中有机质和硫酸根等阴离子的干扰;用NaOH溶液再生DSQ树脂并回收磷,磷洗脱率超过96%,洗脱液是高浓度含磷液,可作为磷矿石的优质替代品。研究表明,DSQ树脂是一种高效选择性分离磷的树脂,适用于污泥厌氧消化液的磷回收。     

3种载体固定化菌藻共生系统脱氮除磷效果的对比

采用3种不同载体（海藻酸钠、聚乙烯醇、复合载体）,分别将小球藻和栅藻与活性污泥固定成菌藻共生系统,制成菌藻凝胶小球,单独菌、单独藻的凝胶小球,用于处理人工污水。结果表明,（1）复合载体固定的菌藻共生系统氮磷去除效果最好,PVA载体的脱氮除磷效果次于复合载体优于海藻酸钠;（2）固定化菌藻共生系统的脱氮除磷效果明显优于单独固定菌和单独固定藻,固定菌的效果较差;（3）3种载体包埋下的固定化小球藻的脱氮除磷效果均较相同载体固定化的栅藻效果好。     

金属负载型催化剂对烟气脱硫性能的影响

介绍了国内外烟气脱硫催化剂的研究现状,研究了金属氧化物负载型催化剂对烟气脱硫性能的影响。以活性炭(AC)为载体,选用8种不同的金属硝酸盐作为浸渍液,采用等体积浸渍法制备金属氧化物负载型催化剂。以脱硫效果较好的Fe2O3/AC为例,研究了不同焙烧温度、金属负载量以及焙烧时间对催化剂脱硫性能的影响。实验结果表明,Fe2O3/AC催化剂脱硫率随着金属负载量的增加呈递增趋势,最优金属负载量为10.0%(质量分数);脱硫率随着焙烧温度的增加显著提高,最优焙烧温度为350℃;脱硫率随着焙烧时间的增加而提高,最优焙烧时间为3.0h。     

畜禽沼液中抗生素和激素的微波处理

通过间歇处理和连续处理实验,探讨微波技术对沼液中四环素类抗生素和激素喹乙醇去除的效果。结果表明,沼液在微波间歇处理中,最优反应时间为40min。此条件下沼液中喹乙醇、土霉素、四环素和金霉素的去除率分别达到26％、49％、48％和70％;微波可显著提高可生化性,BOD5／COD值达到0．37。微波一好氧处理系统中COD与氨氮的去除率分别达到91％和93％,明显优于单独好氧处理。沼液微波连续处理中,最优HRT为90min,此时喹乙醇、土霉素、四环素和金霉素的去除率分别达到24％、45％、50％和74％;BOD5／COD值达到0．34。微波．好氧处理系统中COD与氨氮的去除率均为90％,优于单独好氧处理效果。     

矿化垃圾床＋三维电极／电Fenton法处理老龄垃圾渗滤液

提出以二级矿化垃圾床为预处理单元,串联三维电极／电Fenton处理老龄垃圾渗滤液的组合工艺。矿化垃圾床处理后渗滤液中COD、氨氮、总磷、色度的去除率分别为80．55％、88．47％、98．32％和87．53％。通过单因素实验和正交实验,确定了三维电极／电Fenton法最佳工艺条件。经该组合工艺后,渗滤液中COD、氨氮、总磷和色度的最高去除率分别可达97．08％、95．24％、99．55％和96．92％,其中COD、总磷、色度这3个指标低于《生活垃圾填埋场污染控制标准》（GB16889．2008）表2规定的排放标准,为该组合工艺在实际中的应用提供重要理论依据。     

膜电解法在线再生酸性蚀刻液及回收铜新技术

采用极化曲线法研究了酸性蚀刻液阴、阳极电化学行为,并构建了离子膜电解反应体系,考察了在线再生酸性蚀刻液及回收铜的效果。结果表明,阳极氧化过程发生浓差极化,存在极限电流密度,Cu＋含量越高,极限电流密度越大;阴极还原分4步反应进行,存在极限电流密度;强化溶液传质可有效提高阴、阳极极限电流密度,有利于避免电解过程中析出氯气和氢气;在线实验表明,通过监控阳极液ORP,可避免析出氯气;分步降低电流电解有利于避免析出氢气,形成致密的金属铜块;在电流为9～24A范围内分4步电解23．5h可再生酸性蚀刻液23．5L,同时电沉积回收510g铜,纯度高达99．98％。阴极电流效率达到95．2％,吨铜电耗3251kWh。电解过程中无氯气和氢气析出,无废液排放,表明膜电解法在线再生酸性蚀刻液具有良好的应用前景。     

有害物质环境测试组合舱的研制及性能评价

研制了一种新型有害物质环境测试组合舱,该测试舱由舱体系（内舱和外舱）、恒温恒湿空气处理系统、空气循环装置和信号控制与处理软件组成。该测试舱具有可分别使用内舱和外舱对样品进行测试的特点,并采用美国FLUNT公司开发的air pack软件包对内舱和外舱的气流进行模拟与计算,并划分出内舱的层流区域,同时也对舱体系的性能进行了测试与评价。结果表明,有害物质环境测试组合舱的温湿度的相对标准偏差分别为0.04℃和0.7%,混合性达到90.7%。因此,该有害物质环境测试组合舱对温湿度控制精准,气流稳定,混合性能良好,能为室内空气污染研究提供条件稳定的室内仿真环境。