Bench-scale composting of source-separated human faeces for sanitation

In urine-diverting toilets, urine and faeces are collected separately so that nutrient content can be recycled unmixed. Faeces should be sanitized before use in agriculture fields due to the presence of possible enteric pathogens. Composting of human faeces with food waste was evaluated as a possible method for this treatment. Temperatures were monitored in three 78-L wooden compost reactors fed with faeces-to-food waste substrates (F:FW) in wet weight ratios of 1:0, 3:1 and 1:1, which were observed for approximately 20 days. To achieve temperatures higher than 15 degrees C above ambient, insulation was required for the reactors. Use of 25-mm thick styrofoam insulation around the entire exterior of the compost reactors and turning of the compost twice a week resulted in sanitizing temperatures (>or=50 degrees C) to be maintained for 8 days in the F:FW=1:1 compost and for 4 days in the F:FW=3:1 compost. In these composts, a reduction of >3 log(10) for E. coli and >4 log(10) for Enterococcus spp. was achieved. The F:FW=1:0 compost, which did not maintain >or=50 degrees C for a sufficiently long period, was not sanitized, as the counts of E. coli and Enterococcus spp. increased between days 11 and 15. This research provides useful information on the design and operation of family-size compost units for the treatment of source-separated faeces and starchy food residues, most likely available amongst the less affluent rural/urban society in Uganda.     

Aging and compressibility of municipal solid wastes

The expansion of a municipal solid waste (MSW) landfill requires the ability to predict settlement behavior of the existing landfill. The practice of using a single compressibility value when performing a settlement analysis may lead to inaccurate predictions. This paper gives consideration to changes in the mechanical compressibility of MSW as a function of the fill age of MSW as well as the embedding depth of MSW. Borehole samples representative of various fill ages were obtained from five boreholes drilled to the bottom of the Qizhishan landfill in Suzhou, China. Thirty-one borehole samples were used to perform confined compression tests. Waste composition and volume-mass properties (i.e., unit weight, void ratio, and water content) were measured on all the samples. The test results showed that the compressible components of the MSW (i.e., organics, plastics, paper, wood and textiles) decreased with an increase in the fill age. The in situ void ratio of the MSW was shown to decrease with depth into the landfill. The compression index, Cc, was observed to decrease from 1.0 to 0.3 with depth into the landfill. Settlement analyses were performed on the existing landfill, demonstrating that the variation of MSW compressibility with fill age or depth should be taken into account in the settlement prediction.     

Waste polyvinylchloride derived pitch as a precursor to develop carbon fibers and activated carbon fibers

Polyvinylchloride (PVC) was successfully recycled through the solvent extraction from waste pipe with an extraction yield of ca. 86%. The extracted PVC was pyrolyzed by a two-stage process (260 and 410 degrees C) to obtain free-chlorine PVC based pitch through an effective removal of chlorine from PVC during the heat-treatment. As-prepared pitch (softening point: 220 degrees C) was spun, stabilized, carbonized into carbon fibers (CFs), and further activated into activated carbon fibers (ACFs) in a flow of CO2. As-prepared CFs show comparable mechanical properties to commercial CFs, whose maximum tensile strength and modulus are 862 MPa and 62 GPa, respectively. The resultant ACFs exhibit a high surface area of 1200 m2/g, narrow pore size distribution and a low oxygen content of 3%. The study provides an effective insight to recycle PVC from waste PVC and develop a carbon precursor for high performance carbon materials such as CFs and ACFs.     

The impact of UV-B and sulphur- or copper-containing solutions in acidic conditions on chlorophyll fluorescence in selected Ramalina species

Ramalina maciformis and Ramalina lacera were exposed to different solutions and UV-B to seek for alterations in the PSII photosynthetic quantum yield (F(v)/F(m)), in response to chemicals and radiation. For R. maciformis, significant alterations of the F(v)/F(m) ratio occurred only in response to different bisulphite solutions. The F(v)/F(m) ratio decreased most in R. maciformis and R. lacera following exposure to 5 and 1 mM bisulphite, respectively. Significant differences in F(v)/F(m) ratios were observed for R. lacera in response to different solutions and light at different wavelengths, this being synergistic. The PSII system was unaffected by simulated acid rain in both lichens. R. maciformis, in particular, may survive limited acid rain exposure owing to high Ca oxalate accumulation. The F(v)/F(m) ratio decreased most in R. lacera following short-term exposures to CuSO(4), suggesting that this species is more sensitive to Cu ions under acidic conditions.     

Combustion characteristics of Malaysian municipal solid waste and predictions of air flow in a rotary kiln incinerator

Malaysia is in dire need of alternatives to landfilling for solid waste management. Recently, landfills have faced the problems of overfilling, overflowing of leachates leading to pollution of water resources, and uncontrolled dust emissions adversely affecting the local environment. With the rising cost of urbanization coupled with the high rate of waste generation, one possible method of waste treatment that is receiving particular attention by the government is incineration. Incineration of solid waste is rather new in Malaysia, with limited usage in handling small sources of waste generation such as the municipal solid waste (MSW) of resort islands; however, its potential in ameliorating the problems associated with solid waste treatment may make it an attractive alternative to landfill. This article presents the results of test runs conducted to investigate the performance of a locally designed and manufactured rotary kiln incinerator (RKI). The test runs were conducted using MSW collected from the Shah Alam municipality. The combustion efficiency was analyzed by looking at the temperature profiles and chemical species concentrations. To complement the combustion characteristics measurements, predictions of the air flow in the incinerator during the process were also investigated. The overall performance of the RKI suggests that it is suitable for treating MSW.     

Mechanical Property Characterization of Plasticized Sugar Beet Pulp and Poly(Lactic Acid) Green Composites Using Acoustic Emission and Confocal Microscopy

Sorbitol and glycerol were used to plasticize sugar beet pulp-poly(lactic acid) green composites. The plasticizer was incorporated into sugar beet pulp (SBP) at 0%, 10%, 20%, 30% and 40% w/w at low temperature and shear and then compounded with poly(lactic acid) (PLA) using twin-screw extrusion and injection molding. The SBP:PLA ratio was maintained at 30:70. As expected, tensile strength decreased by 25% and the elongation increased. Acoustic emission (AE) showed correlated debonding and fracture mechanisms for up to 20% w/w plasticizer and uncorrelated debonding and fracture for 30–40% sorbitol and 30% glycerol content in SBP–PLA composites. All samples had a well dispersed SBP phase with some aggregation in the PLA matrix. However, at 40% glycerol plasticized SBP–PLA composites exhibited unique AE behavior and confocal microscopy revealed the plasticized SBP and PLA formed a co-continuous two phase system.

Experimental Study of the Criteria of Flow Laminarization in Two-Dimensional Dense Gas Plumes

Laminarization of flow in a two-dimensional dense gas plume was experimentally investigated in this study. The plume was created by releasing CO₂ through a ground-level line source into a simulated turbulent boundary layer over an aerodynamically rough surface in a meteorological wind tunnel. The bulk Richardson number (Ri_*), based on negative plume buoyancy, plume thickness, and friction velocity, was varied over a wide range so that the effects of stable stratification on plume laminarization could be observed. A variety of ambient wind speeds as well as three different sizes of roughness arrays were used so that possible effects of roughness Reynolds number (Re_*) on plume laminarization could also be identified. Both flow visualization methods and quantitative measurements of velocity and intermittency of turbulence were used to provide quantitative assessments of plume laminarization.Flow visualization provided an overall picture of how the plume was affected by the negative buoyancy. With increasing Ri_*, both the plume depth and the vertical mixing were significantly suppressed, while upstream propagation of the plume from the source was enhanced. The most important feature of the flow revealed by visualization was the laminarization of flow in the lower part of the plume, which appeared to be closely related to both Ri_* and Re_*.Measurements within the simulated dense gas plumes revealed the influence of the stable stratification on mean velocity and turbulence intensity profiles. Both the mean velocity and turbulence intensity were significantly reduced near the surface; and these reductions systematically depended on Ri_*. The roughness Reynolds number also had considerable influence on the mean flow and turbulence structure of the dense gas plumes.An intermittency analysis technique was developed and applied to the digitized instantaneous velocity signals. It not only confirmed the general flow picture within the dense plume indicated by the flow visualization, but also clearly demonstrated the changes of flow regime with variations in Ri_* and Re_*. Most importantly, based on this intermittency analysis, simple criteria for characterizing different flow regimes are formulated; these may be useful in predicting when plume laminarization might occur.     

The Bias of Complementarity Hotspots toward Marginal Populations

Abstract: It has been suggested that using complementarity to identify networks of important areas for conserving biodiversity may preferentially select areas within the margins of species ranges. We tested this idea by examining the location of complementarity hotspots in relation to two measures of range core-periphery. The first measures patterns of aggregation among records within each species' range to identify areas within the core (i.e., areas with aggregated distributions) and periphery (i.e., areas with scattered distributions) of the range. The second measures spatial turnover among species to identify areas with a high density of range edges. For three selected groups of terrestrial vertebrates in Europe—mammals, birds, and herptiles—areas chosen based on complementarity were located within the margins of species' ranges more often than expected by chance. This pattern was consistent for the two measures of core-periphery we used. The bias of complementarity hotspots toward marginal populations is especially important for species with restricted range sizes. If extinctions are determined mainly by demographic factors, then selecting areas at the peripheries of species' ranges might be a poor option. But if extinctions are determined mainly by extrinsic factors, then peripheral populations might be important to ensure the long-term persistence of species.     

Hepatopancreatic endosymbionts in coastal isopods (Crustacea: Isopoda), and their contribution to digestion

Three isopod species (Crustacea: Isopoda), commonly found in the intertidal and supratidal zones of the North American Pacific coast, were studied with respect to symbiotic microbiota in their midgut glands (hepatopancreas). Ligia pallasii (Oniscidea: Ligiidae) contained high numbers of microbial symbionts in its hepatopancreatic caeca. Numbers of endosymbionts were strongly reduced by ingestion of antibiotics. By contrast, the hepatopancreas of Idotea wosnesenskii (Valvifera: Idoteidae) and Gnorimosphaeroma oregonense (Sphaeromatidea: Sphaeromatidae) did not contain any microbiota. Results of feeding experiments suggest that microbial endosymbionts contribute to digestive processes in L. pallasii, the most terrestrial of the three isopods that we studied. The acquisition of digestion-enhancing endosymbionts may have been an important evolutionary step allowing isopods to colonize terrestrial habitats where relatively indigestible leaf litter is the primary food source. By contrast, the ability to digest phenolic compounds was most developed in one of the more marine species, suggesting that this trait may have evolved independently in isopod species that consume a phenolic-rich diet, whether in marine habitats or on land. Received: 28 August 2000 / Accepted: 8 December 2000     

Genetic, morphological, and chemical divergence in the sponge genus Latrunculia (Porifera: Demospongiae) from New Zealand

We undertook a comprehensive study of Latrunculia in New Zealand to determine the relationship between taxonomic, environmental, and chemical variation within the genus. Sponges were collected from five locations around New Zealand: Three Kings Islands, Tutukaka, Wellington, Kaikoura, and Doubtful Sound. Allozyme electrophoresis at nine polymorphic loci indicated that sponges from each geographic location were genetically distinct, and that they displayed genetic differences of the magnitude usually associated with reproductively isolated species (Nei's D between locations =0.375-2.476). Additionally, the comparisons revealed that the green and brown colour morphs of Latrunculia that are sympatric at Three Kings Islands and Kaikoura are distinct from each other, and that there are two genetic groups within the green sponges in Doubtful Sound. On the basis of genetic data we conclude that there are at least eight species of Latrunculia in New Zealand waters, not one to four as had been previously thought. Morphological comparisons of the eight genetic species based on skeletal characters (i.e. skeletal organisation of the choanosome, spicule composition, size, and geometry) indicated that the eight Latrunculia species fell into only two morphological groups that could be easily diagnosed on the basis of discorhabd type. Within these two primary morphological groups, skeletal characteristics among the eight species largely overlap and are not diagnostic. These findings emphasise the limitations of traditional taxonomic methods based solely on skeletal characters for distinguishing species of Latrunculia. However, multivariate analysis (MANOVA and CDA) based on six measured skeletal variables did reveal significant morphological variation among the species (Pillai's Trace=3.28, F=6.90, P<0.0001), supporting the division of the genus into eight species. Comparisons of chemical extracts from Latrunculia also showed that the amounts of five different bioactive compounds (discorhabdins A, B, C, D, and J) varied predictably among the eight species. This finding suggests that discorhabdin variation within Latrunculia, previously thought to be associated with intra-specific environmental variability, is more likely to reflect differences among species rather than phenotypic plasticity. Our results also highlight the importance of thorough taxonomic studies associated with marine natural products research to understand fully the variation in bioactive properties among individuals. The potential processes underlying the unusually high speciation rates in New Zealand Latrunculia that are indicated in our study are discussed.