The total carbohydrate: organic carbon ratio as an indicator of sewage-derived organic matter in Burbo Bight sediments, Liverpool Bay, UK

Sediments from the Burbo Bight, Liverpool Bay, were analysed for their total carbohydrate (TCH) and organic carbon (TOC) contents, and the TCH:TOC ratio (when the TCH is expressed as a percentage of the TOC) was used to give an indication of the amount of sewage-derived organic matter in the sediments. The %TCH values found ranged from 17-68 with an average of 40, indicating that sewage-derived organic matter constituted a significant fraction of the organic matter in the sediment. This appears likely to have been derived mainly from the Mersey Estuary outflow and the sewage sludge dumped in Liverpool Bay, but these two sources cannot be distinguished using this technique. It is suggested that further studies are required on the carbohydrates in sewage sludge and coastal sediments to satisfactorily establish this technique.     

Heavy metal concentrations in the liver of three duck species: influence of species and sex

To investigate interspecific and intersex differences in heavy metal levels, we analysed concentrations of cadmium, cobalt, chromium, copper, lead, mercury, manganese, nickel and zinc in the livers of male and female black duck (Anas rubripes), mallard (A. platyrhynchos) and greater scaup (Aythya marila) collected in Raritan Bay, New Jersey in December 1980 and January 1981. Certain metal levels varied significantly by species and sex. In all species, Zn and Cu had the highest concentrations, and Cd, Co, and Hg were lowest in all three species. Scaup had significantly higher levels of Cu than black ducks and mallards, and mallards had significantly higher levels of Mn and Zn than black duck and scaup. Overall, eight of nine metal levels were higher in male than female black duck. In scaup, females had significantly higher levels of Pb and Mn than males. In black ducks, males had significantly higher levels of Cu, Mn and Zn than females. The sample of mallard was too small to test intersex differences.     

The effect of pH on zinc adsorption equilibria and exchangeable zinc pools in soils

Zinc adsorption equilibria were measured in soils differing in pH but with similar textures and total zinc concentrations, using adsorption isotherm and isotopic exchange techniques. The results suggested that the equilibrium between solution and exchangeable zinc was strongly pH dependent and the active zinc species in adsorption was single charged (e.g. Zn(OH)(+)). The size of the exchangeable zinc pool was not strongly pH dependent. Similar results were obtained when zinc was added to the soils, either as Zn(NO(3))(2) or in sewage sludge.     

Boreal bog plants: nitrogen sources and uptake of recently deposited nitrogen

The main goals of this study were to determine the delta15N signature of quantitatively important boreal bog plants as basis for discussing their N sources, and to assess the effects of five different 3 year N treatments (i.e. 0, 5, 10, 20 and 40 kg N ha(-1) year(-1)) on the bog plants and surface peat at different depths (i.e. 0, 5, 10, 20 and 40 cm) by using 15N as tracer. Plants and peat were analyzed for N concentration, 15N natural abundance and 15N at.%. From the results we draw three main conclusions: First, the relative importance of different N sources is species-specific among bog plants. Second, an annual addition of 5 kg N ha(-1) year(-1) was sufficient to significantly increase the N concentration in Sphagnum mosses, liverworts and shallow rooted vascular plants, and an annual addition of 40 kg N ha(-1) year(-1) during 3 years was not sufficient to increase the N concentration in deep rooted plants, although the 15N content increased continuously, indicating a possible longer term effect. Third, an annual addition of 40 kg N ha(-1) year(-1) during 3 years increased the N content in surface peat at depths of 5 and 10 cm, but not at depths of 20 and 40 cm, indicating the capacity of the living Sphagnum mosses and the surface peat to take up deposited N, and thereby function as a filter.     

Dissolved organic matter fractions formed during composting of winery and distillery residues: evaluation of the process by fluorescence excitation-emission matrix

The aim of the present paper is to assess the maturity degree reached by different samples of several mixtures from winery and distillery residues composted using the Rutgers composting system, by means of excitation-emission matrix (EEM) fluorescence spectroscopy. The composts were sampled once a week for about 200d. EEM spectra indicate the presence of different fluorophores. The fluorescence intensities of these peaks show trends related to the maturity of the composting samples selected. The "contour density" of EEM maps is strongly modified through time. We have used the quantitative method of fluorescence regional integration (FRI). The EEMs were delineated into five excitation-emission regions. The degree of compost maturity could be correlated with the percentage of the volumetric integration under the EEM within each region. Further refinement of these techniques should provide a relatively rapid method for assessing the suitability of the compost to soil application.     

Bioremediation of tributyltin contaminated sediment: degradation enhancement and improvement of bioavailability to promote treatment processes

Bioremediation of tributyltin (TBT) contaminated sediment was studied and degradation enhancement and improvement of bioavailability were also investigated. In TBT spiked sediment, the half-life of TBT in the control sample, representing natural attenuation, was 578 d indicating its persistence. In the stimulated sample (pH 7.5, aeration and incubated at 28 °C), the half-life was significantly reduced to 11 d. Further stimulation by nutrient addition (succinate, glycerol and l-arginine) or inoculation with Enterobacter cloacae (∼10⁷ viable cells g⁻¹ of sediment) resulted in half-life reduction to 9 and 10 d, respectively. In non-spiked sediment, the indigenous microorganisms were able to degrade aged TBT, but the extended period of contamination decreased the degradation efficiency. To improve bioavailability, addition of surfactant, adjustment of salinity and sonication were studied. The highest percentage solubilisation of TBT in water was obtained by adjusting salinity to 20 psu, which increased the solubility of TBT from 13% to 33%. Half-lives after bioavailability was improved were 5, 4 and 4 d for stimulation, stimulation w/nutrient addition and stimulation w/inoculation, respectively. However, natural attenuation in the control sample was not enhanced. The results show that providing suitable conditions is important in enhancing TBT biodegradation, and bioavailability improvement additionally increased the rate and degraded amount of TBT. Unfortunately, nutrient addition and inoculation of the degrader did not enhance the degradation appreciably.     

Effects of solution conditions on the precipitation of phosphate for recovery. A thermodynamic evaluation

To understand the effects of solution conditions on the precipitation of calcium phosphates from wastewater for recovery, a computer programme PHREEQC was employed to calculate the speciation and saturation-index (SI) with respect to hydroxyapatite of a chemically defined precipitation system, which contains phosphate of 1–200 mg P/l, with Ca/P molar ratios of one to 10 times of the stoichiometric calcium to phosphorus molar ratio of hydroxyapatite, at a pH range of 7.0–11.0. The results show that the SI is respectively the logarithmic function of the phosphate concentration and the calcium concentration, increasing with the increase of either of them; the SI is a polynomial function of the solution pH value and increases with its increase, and the effect of solution pH value is due to its influence on base uptake of the precipitation reaction and the speciation of phosphate and calcium ions; the SI is also a logarithmic function of the solution ionic strength but decreases with its increase; at the temperature range of 5–30 °C the SI increases linearly with solution temperature and the effect of temperature is also due to its influence on the speciation of phosphate and calcium ions.     

PAH and soot emissions from burning components of medical waste: examination/surgical gloves and cotton pads

This is a laboratory investigation on the emissions from batch combustion of representative infectious ("red bag") medical waste components, such as medical examination latex gloves and sterile cotton pads. Plastics and cloth account for the majority of the red bag wastes by mass and, certainly, by volume. An electrically heated, horizontal muffle furnace was used for batch combustion of small quantities of shredded fuels (0.5-1.5 g) at a gas temperature of approximately 1000 degrees C. The residence time of the post-combustion gases in the furnace was approximately 1 s. At the exit of the furnace, the following emissions were measured: CO, CO2, NOx, particulates and polynuclear aromatic compounds (PACs). The first three gaseous emissions were measured with continuous gas analyzers. Soot and PAC emissions were simultaneously measured by passing the furnace effluent through a filter (to collect condensed-phase PACs) and a bed of XAD-4 adsorbent (to capture gaseous-phase PACs). Analysis involved soxhlet extraction, followed by gas chromatography-mass spectrometry (GC-MS). Results were contrasted with previously measured emissions from batch combustion of pulverized coal and tire-derived fuel (TDF) under similar conditions. Results showed that the particulate soot) and cumulative PAC emissions from batch combustion of latex gloves were more than an order of magnitude higher than those from cotton pads. The following values are indicative of the relative trends (but not necessarily absolute values) in emission yields: 26% of the mass of the latex was converted to soot, 11% of which was condensed PAC. Only 2% of the mass of cotton pads was converted to soot, and only 3% of the weight of that soot was condensed PAC. The PAC yields from latex were comparable to those from TDF. The PAC yields from cotton were higher than those from coal. A notable exception to this trend was that the three-ring gas-phase PAC yields from cotton were more significant than those from latex. Emission yields of CO and CO2 from batch combustion of cotton were, respectively, comparable and higher than those from latex, despite the fact that the carbon content of cotton was half that of latex. This is indicative of the more effective combustion of cotton. Nearly all of the mass of carbon of cotton gasified to CO and CO2 while only small fractions of the carbon in latex were converted to CO2 and CO (20% and 10%, respectively). Yields of NOx from batch combustions of latex and cotton accounted for 15% and 12%, respectively, of the mass of fuel nitrogen indicating that more fuel nitrogen was converted to NOx in the former case, possibly due to higher flame temperatures. No SO2 emissions were detected, indicating that during the fuel-rich combustion of latex, its sulfur content was converted to other compounds (such as H2S) or remained in the soot.     

Tracing sources of atmospheric sulphur using epiphytic lichens

The overall objective of this work was to measure the spatial variation of sulphur isotopic composition of lichens across the island of Newfoundland in order to assess the degree to which the atmosphere is being affected by long-range transport of anthropogenic sulphur from eastern North America, and/or local pollution sources. A contour map (based on over 80 composite samples of the lichen Alectoria sarmentosa) illustrates the spatial distribution of sulphur isotopic composition of the Newfoundland atmosphere. It shows a gradient of delta(34)S of sulphur in lichen, decreasing from the coast to the interior of the island. It also shows local anomalies corresponding to the city of St. John's, the Come-By-Chance Oil Refinery, mining areas and fossil-fuel powered pulp and paper mills in central and western Newfoundland. The study strongly suggests that the isotopic composition of sulphur in the Newfoundland atmosphere is influenced more by the ocean (sea salt sulphate) and local anthropogenic activities in the province, than by long-range transport of continental North American sulphate.