Using environmental stressor information to predict the ecological status of Maryland non-tidal streams as measured by biological indicators

In Maryland, U.S., an interim framework has recentlybeen developed for using biologically based thresholds, or `biocriteria', to assess the health of nontidal streams statewide at watershed scales. The evaluation of impairment is based on indices of biological integrity from the Maryland Biological Stream Survey (MBSS). We applied logistic regression to quantify how the biotic integrity of streams at a local scale is affected by cumulative effects resulting from catchment land uses, point sources, and nearby transmission line rights-of-way. Indicators for land use were developed from the remote sensing National Land Cover Data and applied at different scales. We determined that the risk of local impairment in nontidal streams rapidly increases with increased urban land use in the catchment area. The average likelihood of failing biocriteria doubled with every 10% points increment in urban land, thus an increase in urban land use from 0 to 20% quadruples the risk of impairment. For the basins evaluated in this study, catchments with more than 40–50% urban land use had greater than 80% probability of failing biocriteria, on average. Inclusion of rights-of-way and point sources in the model did not significantly improve the fit for this data set, most likely because of their low numbers. The overall results indicate that our predictive modeling approach can help pinpoint stream ecosystems experiencing or vulnerable to degradation.     

Biotreatability and kinetics of UASB reactor to mixtures of chlorophenol pollutants

In most natural ecosystems heterotrophic microorganisms encountercomplex mixtures of carbon sources, each of which is present at aconcentration of few micrograms per litre. This study examined the biotreatability and kinetics of an upflow anaerobic sludge blanket (UASB) reactor to complex mixtures of chlorophenols encountered in environmental conditions using on-line and off-line experimental studies. Results indicate that (1) steady-state concentration was quite lower (98.3 mg L^-1) with complex mixture of chlorophenols than steady-state concentration achieved when only 2.4 dichlorophenol (124 mg L^-1) was studied alone on the same reactor; (2) that toxiceffects of chlorophenols increase with increasing concentrationsof toxicant. (Onset of the inhibitory effect occurred at a lowerconcentration in multi-substrate than in single substrate utilization); (3) addition of alternative utilizable substrate can mitigate toxic effects and enhance degradation; (4) the relative concentration of substrate was critical in determiningutilization patterns. HPLC analysis of off-line experimental samples resulted in a steady-state treatment efficiency of68% for COD, 36% for 2-hlorophenol, 40.5% for 4-chlorophenol, 70.7% for 2,4-dichlorophenol, 53.2% for 2,4,6-trichlorophenol and 42% for pentachlorophenol in presence of glucose. Kinetic constant in terms of V _max and K _s were determined. K _s for the five chlorophenols ranged between 0.016 and 0.117 kg m^-3 day^-1 while V _max ranged between 0.056 and 0.244 kg m^-3 day^-1.     

24 h diffusive sampling of toxic VOCs in air onto Carbopack X solid adsorbent followed by thermal desorption/GC/MS analysis-laboratory studies

Diffusive sampling of a mixture of 42 volatile organic compounds (VOCs) in humidified, purified air onto the solid adsorbent Carbopack X was evaluated under controlled laboratory conditions. The evaluation included variations in sample air temperature, relative humidity and ozone concentration. Linearity of samples with loading was examined both for a constant concentration with time varied up to 24 h and for different concentrations over 24 h. Reverse diffusion and its increase with accumulation of sample were determined for all compounds. Tubes were examined for blank levels, change of blanks with storage time, and variability of blanks. Method detection limits were determined based on seven replicate samples. Based on this evaluation, 27 VOCs were selected for quantitative monitoring in the concentration range from approximately 0.1 to 4 ppbv. Comparison results of active and diffusive samples taken over 24 h and under the same simulated ambient conditions at a constant 2 ppbv were interpreted to estimate the effective diffusive sampling rates (ml min(-1)) and their uncertainties and to calculate the corresponding diffusive uptake rates (ng ppmv(-1) min(-1)).     

Evaluation of interference to conventional and real-time PCR for detection and quantification of fungi in dust

Advances in polymerase chain reaction (PCR) have permitted accurate, rapid and quantitative identification of microorganisms in pure cultures regardless of viability or culturability. In this study, a simple sample processing method was investigated for rapid identification and quantification of fungal spores from dust samples using both conventional and real-time PCR. The proposed method was evaluated for susceptibility to interference from environmental dust samples. Stachybotrys chartarum and Aspergillus fumigatus were used as test organisms. The sensitivity of detection in pure culture was 0.1 spore DNA equivalents per PCR reaction corresponding to 20 spores ml(-1) in the sample. However, 1 spore DNA equivalent per PCR reaction corresponding to 200 spores ml(-1) in the sample was the lowest amount of spores tested without interference in dust samples spiked with spores of either fungal species. The extent of inhibition was calculated using conventional and real-time PCR reactions containing fungal spores, specific primers, specific probes (for real-time PCR) and various amounts of dust. The results indicate that the extent of inhibition by dust on PCR varies with the type and amount of dust, and number of spores. No interference in the analysis of spiked samples was detected from 0.2 mg ml(-1) of four real-life dust samples at p-value >0.05 using 2 x 10(4) spores for conventional PCR and 2 x 10(5) spores for real-time PCR. However, samples containing >0.2 mg ml(-1) real-life dust compromised the PCR assay. These results suggest the potential usefulness of a simple sample processing method in conjunction with PCR for monitoring the fungal content of aerosols collected from indoor environments.     

Spatial contaminant heterogeneity: quantification with scale of measurement at contrasting sites

Material within the terrestrial environment is rarely homogeneously distributed, either spatially or temporally. One consequence of heterogeneity is that uncertainty is usually generated in measurements that are taken with the aim of characterising the environment. For example, a measurement of analyte concentration within soil taken from one sampling location on contaminated land can vary substantially when compared against another sample taken at effectively the same nominal location. The measurement uncertainty arising from the heterogeneity can substantially limit the reliability of the interpretations made upon environmental investigations. The sampling uncertainty usually outweighs the analytical uncertainty from the laboratory, often by a factor of 20 or more. One approach to reducing the uncertainty is to design a more suitable sampling strategy. This might be achieved by predicting the degree of heterogeneity prior to the investigation, but this is often difficult to achieve accurately. Another approach, which was investigated here, is to actually characterise the heterogeneity prior to the main investigation using rapid and inexpensive technology, such as in situ measurement techniques. In situ portable X-ray fluorescence (PXRF) and X-ray microprobe (XMP) techniques were employed to test the feasibility of this approach. Two contrasting contaminated land sites were chosen to characterise the two-dimensional spatial heterogeneity of heavy metal contamination in topsoil at a range of scales (50 m to 0.001 m). The spatial heterogeneity of contaminants, expressed as relative standard deviations, was found to differ between the two sites by a factor of two, largely due to the mode of deposition of pollution. The study also indicated that the heterogeneity did not change systematically with the scale of measurement between sampling locations at either site.     

LIDAR Measurements of the Vertical Aerosol Profile and Optical Depth during the ACE-Asia 2001 IOP, at Gosan, Jeju Island, Korea

In order to investigate the characteristic of optical properties of Asian dust particles, the atmospheric aerosol vertical profile was measured with the multi-wavelength LIDAR system, at the Gosan super site (33 degrees 17'N, 126 degrees 10'E) in Jeju Island, Korea, during the ACE-Asia intensive observation period, 11 March-4 May 2001. An air mass backward trajectory analysis, using Hysplit-4, was carried out to track the aerosol plume, with high mass loading, from the Chinese desert regions during the period of Asian dust storm events. Vertical atmospheric aerosol profiles on three major Asian dust storm event days, 22 March and 13 and 26 April 2001, have been analyzed. The LIDAR-derived aerosol optical depth values were compared with those measured by a collocated sunphotometer.     

Pool of Dust Particles over the Asian Continent: Balloon-borne Optical Particle Counter and Ground-based Lidar Measurements at Dunhuang, China

Measurements of aerosols were made in 2001 and 2002 at Dunhuang (40 degrees 00'N, 94 degrees 30'E), China to understand the nature of atmospheric particles over the desert areas in the Asian continent. Balloon-borne measurements with an optical particle counter suggested that particle size and concentration had noticeable peaks in super micron size range not only in the boundary mixing layer but also in the free troposphere. Super-micron particle concentration largely decreased in the mid tropopause (from 5 to 10 km; above sea level, a.s.l.). Lidar measurements made during August 2002 at Dunhuang suggested the possibility that mixing of dust particles occurred from near the ground to about 6 km even under calm weather conditions, and a large depolarization ratio of particulate matter was found in the aerosol layer. The top of the aerosol layer was found at heights of nearly 6 km (a.s.l.). It is strongly suggested that nonspherical dust particles (Kosa particles) frequently diffused in the free atmosphere over the Taklamakan desert through small-scale turbulences and are possible sources of dust particles of weak Kosa events that have been identified in the free troposphere not only in spring but also in summer over Japanese archipelago. Electron microscopic experiments of the particles collected in the free troposphere confirmed that coarse and nonspherical particles observed by the mineral particle were major components of coarse mode (diameter larger than 1 microm) below about 5 km over Dunhuang, China.     

Total versus inhalable sampler comparison study for the determination of asphalt fume exposures within the road paving industry

Exposure to asphalt fumes has a threshold limit value (TLV of 0.5 mg m(-3) (benzene extractable inhalable particulate) as recommended by the American Conference of Governmental Industrial Hygienists (ACGIH). This reflects a recent change (2000) whereby two variables are different from the previous recommendation. First is a 10-fold reduction in quantity from 5 mg m(-3) to 0.5 mg m(-3). Secondly, the new TLV specifies the "inhalable" fraction as compared to what is presumed to be total particulate. To assess the impact of these changes, this study compares the differences between measurements of paving asphalt fume exposure in the field using an "inhalable" instrument versus the historically used 'total' sampler. Particle size is also examined to assist in the understanding of the aerodynamic collection differences as related to asphalt fumes and confounders. Results show that when exposures are limited to asphalt fumes, a 1:1 relationship exists between samplers, showing no statistically significant differences in benzene soluble matter (BSM). This means that for the asphalt fume ACGIH TLV, the 'total' 37-mm sampler is an equivalent method to the "inhalable" method, referred to as IOM (Institute of Occupational Medicine), and should be acceptable for use against the TLV. However, the study found that when confounders (dust or old asphalt millings) are present in the workplace, there can be significant differences between the two samplers' reported exposure. The ratio of IOM/Total was 1.37 for milling asphalt sites, 1.41 for asphalt paving over granular base, and 1.02 for asphalt over asphalt pavements.     

A Metamodeling Approach for Integrated Assessment of Air Quality Policies

A method is proposed to build integrated models (also called Metamodels) aimed at quantifying the economic efficiency of air quality policies. This Metamodeling approach is based on the coupling of two complementary models, that operate at different scales in space and time, and which represent the economic and the physical and chemical processes, respectively. The joint consideration of the physico-chemical and techno-economic structure of the pollution control problems permits a comprehensive evaluation of air pollution abatement strategies. The motivating pollution control problems include urban-regional air quality management through efficient energy and traffic control policies. A pilot study, exploiting data collected in the Geneva canton (Switzerland), is used to demonstrate the potential of the approach.     

Utility of dynamics as indicators of stress in population models

The relationships between the dynamics of environmentally and chemically stressed populations and indicators of the effects of the stressor are explored in a model framework. The physiologically structured population, represented by a system of McKendrick–von Foerster hyperbolic partial differential equations, includes the dynamics of numerous individuals distinguished by ecotype. Chemical uptake of nonpolar narcotics is modeled by first order kinetics. Classical methodologies, frequency analysis and phase space reconstruction, are explored in a search for indicators of magnitude of stress. When these techniques proved generally unsuccessful for the objective of indicator selection in our model setting, summary statistics, as related to bifurcation diagrams, were constructed and appear more useful as indicators. It is concluded that physiological structures generally lead to more feasible measurable indicators of magnitude of stress than do specifics of population dynamics.