氟苯胺好氧生物降解性能的研究

利用驯化污泥研究了邻氟苯胺、对氟苯胺、2,4-二氟苯胺的好氧生物降解性能.结果表明,3种氟苯胺的好氧生物降解性能从高到低依次为对氟苯胺、邻氟苯胺和2,4-二氟苯胺.降解动力学分析表明,除2,4-二氟苯胺在实验质量浓度8.56 mg/L时为一级反应,其他为零级反应;且它们的降解规律都符合Monod方程;30 ℃、振荡速率140 r/min为氟苯胺的最佳降解条件.同时研究了共基质条件下葡萄糖和苯胺对2,4-二氟苯胺的好氧降解的影响,葡萄糖的引入有促进作用,而苯胺只在一定浓度范围内有促进作用.氟苯胺的生产废水与生活污水合并处理以及多种组分混合废水处理是可行的.     

Performance of photocatalytic reactors using immobilized TiO2 film for the degradation of phenol and methylene blue dye present in water stream

TiO2 thin film photocatalyst was successfully synthesized and immobilized on glass reactor tube using sol-gel method. The synthesized TiO2 coating was transparent, which enabled the penetration of ultra-violet (UV) light to the catalyst surface. Two photocatalytic reactors with different operating modes were tested: (a) tubular photocatalytic reactor with re-circulation mode and (b) batch photocatalytic reactor. A new proposed TiO2 synthesized film formulation of 1 titanium isopropoxide: 8 isopropanol: 3 acetyl acetone: 1.1 H2O: 0.05 acetic acid (in molar ratio) gave excellent photocatalytic activity for degradation of phenol and methylene blue dye present in the water. The half-life time, t1/2 of photocatalytic degradation of phenol was 56 min at the initial phenol concentration of 1000 microM in the batch reactor. In the tubular photocatalytic reactor, 5 re-circulation passes with residence time of 2.2 min (single pass) degraded 50% of 40-microM methylene blue dye. Initial phenol concentration, presence of hydrogen peroxide, presence of air bubbling and stirring speed as the process variables were studied in the batch reactor. Initial methylene blue concentration, pH value, light intensity and reaction temperature were studied as the process variables in the tubular reactor. The synthesized TiO2 thin film was characterized using SEM, XRD and EDX analysis. A comparative performance between the synthesized TiO2 thin film and commercial TiO2 particles (99% anatase) was evaluated under the same experimental conditions. The TiO2 film was equally active as the TiO2 powder catalyst.     

盐河淮阴段氨氮污染变化分析

在分析盐河淮阴段氨氮污染的特征后，对氨氮的来源进行了研究。结果表明，畜牧业和农业面源都是比较显著的氨氮污染源，但未经集中式污水处理厂处理的生活污水，则成为盐河淮阴段最重要的氨氮污染源。     

双氧水强化微电解法处理硝基苯废水的试验研究

以某化工厂的硝基苯生产废水为研究对象,在小试确定试验条件的基础上,采用双氧水强化微电解法对废水进行处理,探讨双氧水强化微电解法对废水处理的原理及处理工艺条件.实验结果表明：双氧水强化微电解法处理难降解有机废水,效果好,可以提高废水的生化性,为废水的后续处理提供了有利条件,是难生化有机废水处理的有效方法之一.     

Biohydrogen production in continuous-flow reactor using mixed microbial culture.

The goal of the proposed project was to develop an anaerobic fermentation process that converts negative-value organic wastes into hydrogen-rich gas in a continuous-flow reactor under different operating conditions, such as hydraulic retention time (HRT), heat treatment, pH, and substrates. A series of batch tests were also conducted in parallel to the continuous study to evaluate the hydrogen conversion efficiency of two different organic substrates, namely sucrose and starch. A heat shock (at 90 degrees C for 15 minutes) was applied to the sludge in an external heating chamber known as a sludge activation chamber, as a method to impose a selection pressure to eliminate non-spore-forming, hydrogen-consuming bacteria and to activate spore germination. The experimental results showed that the heat activation of biomass enhanced hydrogen production by selecting for hydrogen-producing, spore-forming bacteria. The batch feeding at a shorter HRT of 20 hours (or higher organic loading rate) favored hydrogen production, whereas, at a longer HRT of 30 hours, methane was detected in the gas phase. The major organic acids of hydrogen fermentation were acetate, butyrate, and propionate. Up to 23.1% of influent chemical oxygen demand was consumed in biomass synthesis. Batch tests showed that the hydrogen-production potential of starch was lower than sucrose, and better conversion efficiency from starch was obtained at a lower pH of 4.5. However, addition of sucrose to starch improved the overall hydrogen-production potential and hydrogen-production rate. This study showed that sustainable biohydrogen production from carbohydrate-rich substrates is possible through heat activation of settled sludge.     

磷钨酸光催化降解甲基橙溶液的研究

以磷钨酸为光催化剂,在紫外灯照射下,对模拟染料废水甲基橙溶液进行光催化降解,并研究了催化剂加入量、pH值、甲基橙初始浓度和外加氧化剂H2O2对光催化降解效果的影响.结果表明,磷钨酸光催化剂加入量为300 mg/100 mL,pH=2.5时,甲基橙溶液的降解率明显高于其他pH值的降解率;在较低浓度下,甲基橙溶液的光催化降解反应符合一级动力学方程;外加氧化剂H2O2可提高光催化反应速率.     

连续流分段进水生物脱氮工艺控制要点及优化

主要介绍了分段进水生物脱氮工艺的系统工作原理及工艺特性,并探讨了该工艺运行操作和设计的几个重要影响因素,如进水流量分配比、溶解氧、污泥回流比、C/N比等,并在此基础上讨论了分段进水生物脱氮工艺的优化控制对策.     

Probabilistic risk assessment of abalone Haliotis diversicolor supertexta exposed to waterborne zinc

This paper describes a risk assessment approach that integrates predicted tissue concentrations of zinc (Zn) with a concentration-response relationship and leads to predictions of survival risk for pond abalone Haliotis diversicolor supertexta as well as to the uncertainties associated with these predictions. The models implemented include a probabilistic bioaccumulation model, which linking biokinetic and consumer-resource models, accounts for Zn exposure profile and a modified Hill model for reconstructing a dose-response profile for abalone exposed to waterborne Zn. The growth risk is assessed by hazard quotients characterized by measured water level and chronic no-observed effect concentration. Our risk analyses for H. diversicolor supertexta reared near Toucheng, Kouhu, and Anping, respectively, in north, central, and south Taiwan region indicate a relatively low likelihood that survival is being affected by waterborne Zn. Expected risks of mortality for abalone were estimated as 0.46 (Toucheng), 0.36 (Kouhu), and 0.29 (Anping). The predicted 90th-percentiles of hazard quotient for potential growth risk were estimated as 1.94 (Toucheng), 0.47 (Kouhu), and 0.51 (Anping). These findings indicate that waterborne Zn exposure poses no significant risk to pond abalone in Kouhu and Anping, yet a relative high growth risk in Toucheng is alarming. Because of a scarcity of toxicity and exposure data, the probabilistic risk assessment was based on very conservative assumptions.     

固定源废气监测工作若干技术问题的探讨

从监测工况、测点位置、采样过程、结果计算等几方面出发，结合实际经验，对大气固定污染源的监测工作中存在的一些疑难问题进行探讨。     

湿式氧化技术及其应用比较

对湿式氧化技术及其影响因素进行了介绍 ,叙述了各种因素的影响作用并对各因素的影响强弱进行了比较 ,认为反应温度和处理对象的性质是影响湿式氧化技术处理效果的关键因素。阐述了湿式氧化技术在废水处理、污泥处理、活性炭再生中的一些应用研究情况 ,并进行了比较。总结了湿式氧化技术的特点及其在环境治理中的优势