全文获取类型
收费全文 | 5352篇 |
免费 | 690篇 |
国内免费 | 1819篇 |
专业分类
安全科学 | 515篇 |
废物处理 | 169篇 |
环保管理 | 465篇 |
综合类 | 4031篇 |
基础理论 | 985篇 |
污染及防治 | 691篇 |
评价与监测 | 407篇 |
社会与环境 | 382篇 |
灾害及防治 | 216篇 |
出版年
2024年 | 43篇 |
2023年 | 130篇 |
2022年 | 371篇 |
2021年 | 357篇 |
2020年 | 399篇 |
2019年 | 299篇 |
2018年 | 271篇 |
2017年 | 308篇 |
2016年 | 309篇 |
2015年 | 358篇 |
2014年 | 404篇 |
2013年 | 484篇 |
2012年 | 503篇 |
2011年 | 528篇 |
2010年 | 489篇 |
2009年 | 456篇 |
2008年 | 377篇 |
2007年 | 363篇 |
2006年 | 331篇 |
2005年 | 233篇 |
2004年 | 148篇 |
2003年 | 138篇 |
2002年 | 131篇 |
2001年 | 102篇 |
2000年 | 106篇 |
1999年 | 59篇 |
1998年 | 31篇 |
1997年 | 24篇 |
1996年 | 28篇 |
1995年 | 17篇 |
1994年 | 21篇 |
1993年 | 18篇 |
1992年 | 12篇 |
1991年 | 2篇 |
1990年 | 5篇 |
1988年 | 2篇 |
1987年 | 1篇 |
1986年 | 2篇 |
1984年 | 1篇 |
排序方式: 共有7861条查询结果,搜索用时 34 毫秒
351.
垃圾填埋场微生物气溶胶粒径分布研究 总被引:4,自引:0,他引:4
为了了解垃圾填埋场微生物气溶胶粒径分布规律,在北京市某垃圾卫生填埋场填埋区、渗滤液处理区、生活区分别选定监测点,利用安德森六级微生物采样器,对填埋场空气微生物进行了系统的定点取样、测定和分析。研究结果表明,空气细菌粒径分布均为第Ⅰ级(>8.2 μm)最高,填埋区空气细菌粒径呈偏态分布,渗滤液处理区、生活区分别在第Ⅳ级和第Ⅲ级出现第2个峰值。携带细菌的可吸入微粒在渗滤液处理区比例最大。空气真菌与放线菌均在第Ⅳ级分布最高,携带真菌和放线菌的可吸入粒子的比例显著大于细菌(P<0.05)。填埋区不同作业时段空气微生物粒径在各级分布比例基本一致。填埋区细菌气溶胶中值直径为5.7 μm,渗滤液处理区为3.7 μm,生活区为5.3 μm,显著大于真菌气溶胶和放线菌气溶胶的中值直径(P<0.05)。 相似文献
352.
353.
354.
微电解-催化氧化法处理高浓度甲醇废水 总被引:6,自引:2,他引:4
采用微电解一催化氧化法处理某化工厂的高浓度甲醇生产废水。实验结果表明:在进水pH为2.0、铁炭质量比为2、微电解时间为14h、空气流量为500mL/min的条件下,废水经微电解处理后,出水COD由原来的约7000mg/L降至约1000mg/L,COD去除率达85%以上;在过滤后微电解出水COD约为950mg/L、微电解出水pH为6.5、空气流量为300mL/min、催化氧化时间为3h时的条件下,经催化氧化处理后,出水COD降至100mg/L以下,出水水质达到GB8978--1996《污水综合排放标准》的二级标准。 相似文献
355.
硫酸渣制备高纯度硫酸亚铁 总被引:1,自引:0,他引:1
以高铁硫酸渣为原料,采用酸浸一还原-除杂-结晶-重结晶-干燥工艺,合成高纯度硫酸亚铁.通过反应温度、反应时闻对硫酸渣中铁的浸出率的影响,以及结晶温度、干燥温度,干燥时间、于燥时间对硫酸亚铁产品纯度的影响做分析实验,得出最佳酸浸条件:硫酸渣与硫酸的固液比为1:3,硫酸质量分数为20%-25%,反应温度为80℃,反应时间为6 h,搅拌强度为200 r/min;最佳结晶精制条件:结晶溶液pH值1:3,温度为60℃,温度海60℃;除杂最佳条件:pH值约为4.5;冷却结晶温度控制在20℃,结晶秣过程为30℃于燥6 h. 相似文献
356.
设计并介绍分户报警与短信群发结合的报警方式,包括系统采用的布局方法、方案总体设计、整体结构、信息传输网络设计;提出分户报警的新报警策略,并给出分户报警的区域划分方法以及划分的理由和依据。在硬件方面,重点介绍分户警铃的方案,其中包括的两个重要组成部分:无线应急广播发射中心和无线应急广播接收设备;提出采用可寻址智能无线广播的新的技术方法,同时给出建议的设备,总结并分析分户报警系统的功能和特点。通过该警报系统的采用,能大大提高警报通知效率,节省疏散所需的时间。 相似文献
357.
过氯乙烯滤膜采样-酸消解-钼蓝光度法测定磷酸雾 总被引:1,自引:0,他引:1
建立了过氯乙烯滤膜采样 -酸消解 -钼蓝分光光度法测定磷化车间磷酸雾的监测方法。实验室模拟采样的捕集效率为 95 7%~ 99 1 %。单个实验室对含 5μg和 1 5μg样品进行多次测定 ,其相对标准差小于 5% ,样品加标回收率为 98 2 %~ 1 0 0 5% ,方法检测限为 0 0 0 7mg/m3。对标样测定 ,结果均在给定值范围内。用该法与等离子发射光谱法(ICP)对 5个样品进行比对测定 ,结果均令人满意。 相似文献
358.
359.
360.
Identification of sources of elevated concentrations of polycyclic aromatic hydrocarbons in an industrial area in Tianjin, China 总被引:2,自引:0,他引:2
Wentao Jiao Yonglong Lu Jing Li Jingyi Han Tieyu Wang Wei Luo Yajuan Shi Guang Wang 《Environmental monitoring and assessment》2009,158(1-4):581-592
The concentrations of 16 polycyclic aromatic hydrocarbons (PAHs) were determined by gas chromatography equipped with a mass spectrometry detector in 105 topsoil samples from an industrial area around Bohai Bay, Tianjin in the North of China. Results demonstrated that concentrations of PAHs in 104 soil samples from this area ranged from 68.7 to 5,590 ng g???1 dry weight with a mean of ∑16PAHs 814 ± 813 ng g???1, which suggests that there exists mid to high levels of PAH contamination. The concentration of ∑16PAHs in one soil sample from Tianjin Port was exceptionally high (48,700 ng g???1). Ninety-three of the 105 soil samples were considered to be contaminated with PAHs (>200 ng g???1), and 25 were heavily polluted (>1,000 ng g???1). The sites with high PAHs concentration are mainly distributed around chemical industry parks and near highways. Two low molecular weight PAHs, naphthalene and phenanthrene, were the dominant components in the soil samples, which accounted for 22.1% and 10.7% of the ∑16PAHs concentration, respectively. According to the observed molecular indices, house heating in winter, straw stalk combustion in open areas after harvest, and petroleum input were common sources of PAHs in this area, while factory discharge and vehicle exhaust were the major sources around chemical industrial parks and near highways. Biological processes were probably another main source of low molecular weight PAHs. 相似文献