污染土壤中铅的测定方法比对

采用原子吸收光谱法(AAS法)、电感耦合等离子发射光谱法(ICP-OES法)和X-荧光光谱法(XRF法)分别测定污染土壤中的铅,并对检出限、精密度、准确度等指标进行了比对。结果表明,3种方法均能满足质量控制的要求,测定结果之间无显著性差异; 3种方法中ICP-OES法和XRF法可同时测定多元素,但XRF法更快速简便。     

T酸一次洗水初步处理的研究

采用重氮化－偶合－混凝沉淀和重氮化－混凝沉淀两种方法对Ｔ酸一次洗水的初步处理进步了研究。Ｔ酸一次洗水经两种方法处理后,ＣＯＤ去除率分别为６１．３％、５０．５％,色度去除率分别为７４．６％、７１％。     

地下铀矿山留矿法采场受限空间内氡迁移的数值模拟

为研究铀矿山留矿法采场氡迁移规律,依据留矿法采场的构造和物理几何尺寸,建立了受限空间内颗粒堆积型射气介质气体流动的数学模型和氡迁移方程,以10 m和20 m高爆破矿堆为对象,采用计算流体力学(CFD)方法,研究了不同通风条件下采场中氡的迁移规律。结果表明:1)采场下行通风方式降低矿堆上部作业空间氡浓度的效果优于上行通风方式,但对采场运输巷道氡浓度的效果相反;采场排风氡浓度与采场通风风量成反比,氡析出份额与通风风量成正比;2)在相同通风风量下,10 m高爆破矿堆与20 m高爆破矿堆氡析出份额之差随通风风流量增长而逐渐缩小;3)均压通风对渗透率高(k=1×10-8m2)的采场排风氡浓度、矿堆氡析出份额有明显影响。     

The effect of moisture content within multilayer protective clothing on protection from radiation and steam

The moisture from skin sweat and atmospheric water affects the thermal protective performance provided by multilayer protective clothing. Four levels of moisture content were selected to evaluate the impact of moisture on thermal protection under dry (thermal radiation) and wet (thermal radiation and low-pressure steam) heat exposure. Also, the role of moisture and its relationship with exposure time were analyzed based on skin heat flux and Henriques integral value. The addition of moisture to a fabric system was found to result in differences in second-degree and third-degree skin burn times. When moisture is added to a fabric system, it both acts as a thermal conductor to present a negative effect and provides a positive effect owing to thermal storage of water and evaporative heat loss. The positive or negative effects of moisture are mainly dependent on the thermal exposure time, the moisture content and the presence of hot steam.     

采用支持向量机算法优化电化学处理油田污水的工艺参数

采用支持向量机(SVM)算法,将Box-Behnken设计法与支持向量回归算法(SVR)实验参数优化软件相结合,优化电化学去除油田污水COD的工艺参数。通过量子粒子群算法对SVM算法参数进行优化,从建立的回归模型中找到工艺参数的全局最佳点:电解时间60 min,电解电流3 A,三维电极填充料中石英砂质量695 g。模型得到的COD理论最优去除率为92.48%,验证实验得到的COD去除率为91.43%。     

Numerical study of heat transfer characteristics of char from waste tire pyrolysis

To investigate heat transfer of char from waste tire pyrolysis, the cooling of char was simulated by the computational fluid dynamics. To scrutinize the heat transfer characteristics, bed height, temperature of cooling wall, and mixing time were selected as calculation parameters. From the results, increasing the char bed height from 0.005 to 0.02 m, the total heat transfer is decreased as from 45.5 to 26.5 J. As the char bed height is further increased from 0.02 to 0.06 m, the total heat transfer is decreased from 26.5 to 9.1 J. The char bed height affects the total heat transfer significantly. The total heat transfer decreases from 15.9 to 14.0 J as the temperature of cooling wall increases from 273.15 to 323.15 K. The total heat transfer mildly depends on the temperature of cooling wall. The particle mixing time increases from 10 to 120 s and the total heat transfer decreases from 28.6 to 22.6 J. It is noted that the particle contact is enhanced between char particles as well as the particles and cooling wall as the particle mixing time decreases. Consequently, heat transfer is augmented.     

High CO2 adsorption on improved ZSM-5 zeolite porous structure modified with ethylenediamine and desorption characteristics with microwave

Journal of Material Cycles and Waste Management - Synthesized zeolite Socony Mobil-5 (ZSM-5) with large pore surface structures and modified with ethylenediamine were used to achieve high CO2...     

PbO_2复合电极预处理甲苯二胺废水

通过涂覆—热分解法与电沉积法制备了β-PbO_2/α-PbO_2/SnO_2-Sb2O3/Ti复合电极(PbO_2复合电极),采用X射线衍射(XRD)、扫描电子显微镜(SEM)、循环伏安法(CV)、线性极化法(LSV)和加速寿命试验对电极进行表征。将PbO_2复合电极用于处理甲苯二胺(TDA)废水,考察了电解质浓度、电流密度对TDA降解效果的影响。实验结果表明:α-PbO_2呈梭状,β-PbO_2呈花菜状,多层结构的PbO_2电极利于提高电极的稳定性和活性;PbO_2复合电极的析氧电位(1.9 V)明显高于TDA的氧化电位(1.28 V),其使用寿命长达486 d;在电流密度为60 m A/cm2、Na2SO4质量浓度为10 g/L、电解时间为240 min的条件下,对COD为4 791.74 mg/L、TDA质量浓度为486.4mg/L的废水进行处理,TDA去除率高达97.3%,COD去除率可达88.1%。     

Experimental assessment of characteristic turbulent scales in two-phase flow of hydraulic jump: from bottom to free surface

A hydraulic jump is a turbulent shear flow with a free-surface roller. The turbulent flow pattern is characterised by the development of instantaneous three-dimensional turbulent structures throughout the air–water column up to the free surface. The length and time scales of the turbulent structures are key information to describe the turbulent processes, which is of significant importance for the improvement of numerical models and physical measurement techniques. However, few physical data are available so far due to the complexity of the measurement. This paper presents an investigation of a series of characteristic turbulent scales for hydraulic jumps, covering the length and time scales of turbulent flow structures in bubbly flow, on free surface and at the impingement point. The bubbly-flow turbulent scales are obtained for Fr = 7.5 with 3.4 × 10⁴ < Re < 1.4 × 10⁵ in both longitudinal and transverse directions, and are compared with the free-surface scales. The results highlight three-dimensional flow patterns with anisotropic turbulence field. The turbulent structures are observed with different length and time scales respectively in the shear flow region and free-surface recirculation region. The bubbly structures next to the roller surface and the free-surface fluctuation structures show comparable length and time scales, both larger than the scales of vortical structures in the shear flow and smaller than the scales of impingement perimeter at the jump toe. A decomposition of physical signals indicates that the large turbulent scales are related to the unsteady motion of the flow in the upper part of the roller, while the high-frequency velocity turbulence dominates in the lower part of the roller. Scale effects cannot be ignored for Reynolds number smaller than 4 × 10⁴, mainly linked to the formation of large eddies in the shear layer. The present study provides a comprehensive assessment of turbulent scales in hydraulic jump, including the analyses of first data set of longitudinal bubbly-flow integral scales and transverse jump toe perimeter integral scales.     

重金属Cr(VI)、Pb及Cu胁迫对双齿围沙蚕体腔细胞的DNA损伤

为探讨重金属Cr(VI)、Pb以及Cu对沙蚕体腔细胞DNA的毒性效应,以双齿围沙蚕为受试动物,重金属按不同剂量水平,Cr(VI):10、100和200 mg·L~(-1),Pb:5、50和100 mg·L~(-1),Cu:1、10和20 mg·L~(-1),分别胁迫沙蚕24 h,以不加任何重金属离子的海水为对照,采用单细胞凝胶电泳技术,检测其体腔细胞DNA损伤程度。结果表明,与空白对照组相比,3种重金属离子的各浓度组都能引起沙蚕体腔细胞DNA损伤,且3种重金属胁迫浓度与细胞DNA损伤程度之间存在显著的剂量-效应关系。双齿围沙蚕可以作为单细胞凝胶电泳的实验材料用于重金属所致环境污染的生物监测指示生物。