氮掺杂氧化钛的简易制备及可见光催化活性的研究

为开发对可见光响应的催化剂,以尿素为氮掺杂剂,采用简易溶胶-凝胶法制备氮掺杂氧化钛,并以2,4-DCP的降解检验其光催化活性。XRD、BET、XPS和UV-Vis漫反射光谱分析表明,随着氮/钛原子比（N/Ti)的增大,各催化剂晶粒尺寸减小,比表面积增大,锐钛矿相向金红石相的转变得到抑制,除0#样品出现金红石相外,其他催化剂均只出现锐钛矿相;掺入催化剂的N位于晶格O位点和晶格间隙,替代N和间隙N掺杂使催化剂的光吸收发生明显的红移。荧光光谱分析表明,当N/Ti在0～6范围内增加时,反应体系中·OH自由基的产生速率增加,当N/Ti增大至8时,速率则下降。相似的规律也表现在氮掺杂量对光催化活性的影响。适量氮掺杂能增强氧化钛的可见光催化活性,该改性催化剂可用于有机污染物的太阳光激催化降解。     

基于超临界水氧化过程的能源环境系统设计

阐述了超临界水氧化过程的工艺路线,介绍了超临界水氧化过程的特点,提出了基于超临界水氧化过程的能源环境系统,设计了几种热量与能量回收系统程的耦合工艺,为提高超临界水氧化过程的经济性奠定了基础。     

含磁粉生物反应器处理苯酚废水

采用含磁粉生物反应器对质量浓度为120～350 mg/L的苯酚模拟废水进行强化生物处理.实验结果表明:添加适量磁粉可使废水中DO提高约10%;与不含磁粉生物反应器比较,含磁粉生物反应器工艺使填料挂膜时间缩短1～2 d,填料上附着微生物量增多;质量浓度为350 mg/L的苯酚模拟废水在20 h内的苯酚去除率可达80%,降解时间缩短了10 h.初步分析了添加磁粉提高生物反应器处理废水效率的机理.实验证实了含磁粉生物反应器工艺的合理运用是强化处理含酚废水的有效途径.     

活性艳蓝X-BR降解菌的筛选

从某印染厂废水排放出口的污泥中分离到一株活性艳蓝X-BR染料高效降解菌LPY68-14,经生理生化鉴定,该菌为埃希氏菌(Escherichia sp.).研究了影响菌株LPY68-14降解效果的因素,实验结果表明:在缺氧、质量分数为0.2%葡萄糖为外加碳源、温度37℃、接种量4 mL、pH 7的最佳条件下,质量浓度为30 mg/L的活性艳蓝X-BR经菌株LPY68-14处理24 h后的降解率可达80%;当活性艳蓝X-BR质量浓度为100～400 mg/L时,该菌处理48 h后的降解率可稳定在70%左右.     

Fe-厌氧微生物体系降解2,4,6-三氯酚

采用Fe-厌氧微生物体系降解2,4,6-三氯酚(2,4,6-TCP).在初始pH 7.0、Fe加入量10.0 g/L、以甲酸钠为碳源的条件下,2,4,6-TCP降解效果最好.采用Fe-厌氧微生物体系降解2,4,6-TCP,比单独采用Fe或厌氧微生物体系具有明显的效果,运行60h后2,4,6-TCP开始降解,108h后2,4,6-TCP降解完全.添加2-溴乙烷磺酸盐可抑制产甲烷菌的活性,能有效促进2,4,6-TCP的降解.     

干法腈纶生产废水脱氨氮研究

采用本实验室富集驯化的高效硝化细菌对生化处理后的干法腈纶生产废水进行了脱NH3-N研究,在连续运行装置中考察了DO和MLSS的变化特征,并研究了废水NH3-N负荷和COD负荷对脱NH3-N效果的影响.实验结果表明:该菌能适应干法腈纶生产废水中的难生物降解物质并有效去除废水中的NH3-N,启动期DO呈现"高-低-高"的变化,运行期污泥增长速率呈现"S"型变化;进水NH3-N负荷达到0.405 kg/(m3·d)时仍能维持出水P(NH3-N)在5 mg/L以下,进水COD负荷由0.126 kg/(m3·d)提高到0.975 kg/(m3·d)的过程中,NH3-N去除率始终高于96%.     

Biofiltration treatment of odors from municipal solid waste treatment plants

An in situ compost biofilter was established for the treatment of odors from biostabilization processing of municipal solid waste. The concentrations of total volatile organic compounds (VOCs) in odors and their components were measured. Biofilter media was characterized in terms of total carbon (TC), total nitrogen (TN), total phosphorus (TP), organic matter (OM), pH value and determination of bacterial colony structure. Gas chromatography–mass spectrometry (GC–MS) analysis showed that the main components of the produced gas were benzene, toluene, ethylbenzene and xylene (BTEX) along with other alkanes, alkenes, terpenes, and sulphur compounds. The compost biofilter had remarkable removal ability for alkylated benzenes (>80%), but poor removal for terpenes (～30%). Total VOC concentrations in odors during the biostabilization process period ranged from 0.7 to 87 ppmv, and the VOC removal efficiency of the biofilter varied from 20% to 95%. After about 140 days operation, TN, TC, TP and OM in compost were kept almost stable, but the dissolved N, NH₄–N and NO₃–N experienced an increase of 44.5%, 56.2% and 76.3%, respectively. Dissolved P decreased by 27.3%. The pH value experienced an increase in the early period and finally varied from 7.38 to 8.08. Results of bacterial colony in packing material indicated that bacteria and mold colony counts increased, but yeasts and actinomyces decreased along with biofilter operation, which were respectively, 3.7, 3.4, 0.04 and 0.07 times of their initial values.     

镰刀菌HJ01对对氯苯酚的降解特性

采用实验室分离的一株镰刀菌HJ01,以对氯苯酚(4-CP)为降解底物,以蔗糖为外加碳源,考察了蔗糖质量浓度、降解温度、初始pH对4-CP降解效果的影响,初步探讨了镰刀菌HJ01对4-CP的降解动力学和降解机理.实验结果表明:该菌株能以4-CP为惟一碳源和能源生长;在外加蔗糖为碳源,蔗糖质量浓度为3 g/L、降解温度为30℃、初始pH为8的条件下,50 mg/L4-CP能在6 d内被完全降解.以4-CP为惟一碳源和外加蔗糖下的降解动力学分别符合Haldane模型和一级动力学方程.     

混凝法深度处理印染废水中试研究

采用"高效混凝沉淀-过滤"深度处理工艺处理印染废水二级生化出水,并将混凝沉淀污泥回流.实验结果表明,混凝剂聚合氯化铝加入量为160 mg/L时,COD去除率平均可达34.6%,TP去除率平均达到87.9%,平均出水TP为0.3 mg/L.气相色谱-质谱分析和元素分析结果表明混凝沉淀工艺对有机物和TP的去除效果良好.     

废聚碳酸酯水解法制双酚A

以1,4-二氧六环为溶剂、NaOH为催化剂,采用废聚碳酸酯(PC)常压水解法制双酚A(BPA).对反应影响因素进行了研究.实验结果表明,在反应温度为100℃、反应时间为8h、m(NaOH):m(水+溶剂)=1:33、m(溶剂):m(PC)=4:1、m(水):m(PC)=1:1的最佳反应条件下,PC水解率大于98%,BPA收率大于95%.