The adsorptive characteristics of biochar produced from garden green waste (S-char) and a mixture of food waste and garden green waste (FS-char) were investigated. Adsorption of Cu2+, Zn2+, and Mn2+ onto the two biochars reached equilibrium within 48 hours. The metal adsorption was effectively described by the pseudo-second-order kinetic and Freundlich isotherm models which suggest heterogeneous chemisorption. The initial solution pH influenced adsorption of Zn2+ and Mn2+ but not of Cu2+. Simulation via a surface complexation model showed that the fraction of XOCu+ adsorbed onto biochar was increased with increasing pH until it reached the adsorption maximum at pH 8.5, while the endpoint for the maximum of XOMn+ was higher than pH 12. 相似文献
Metallurgical production is the largest polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/F) emission source in China. However, PCDD/F monitoring and research are rarely conducted on primary metallurgical production. In this study, a demonstration primary copper smelter in China was selected to investigate PCDD/F characteristics and control. Samples were collected from major PCDD/F release points in the smelter process (fly ashes and waste water sludge). Specific analysis of PCDD/F congeners was carried out using a high resolution gas chromatography/high resolution mass spectrometry method. The results showed that PCDD/Fs might be unintentionally produced in the primary copper smelter processes, with sample concentrations of 180–6110 pg/g dry wt; highly chlorinated PCDD/F homologues were predominant. The toxicity of all the samples was calculated to be 120 pg WHO TEQ/g, fly ashes from the refining process furnaces air pollution control device and sludge were hazardous waste with higher PCDD/F toxicity. Both precursor formation and de novo synthesis were found to contribute to PCDD/F formation in the smelter process. PCDD/F characteristics and formation were compared with reported secondary copper smelters. Life-cycle control of PCDD/F was proposed for retrofitting of this smelter and for similar plants in China's primary copper production sector, including control at the PCDD/F formation, removal and disposal stages. 相似文献
Original high hydrocarbon groundwater represents a kind of groundwater in which hydrocarbon concentration exceeds 0.05 mg/L. The original high hydrocarbon will significantly reduce the environment capacity of hydrocarbon and lead environmental problems. For the past 5 years, we have carried out for a long-term monitoring of groundwater in shallow Triassic aquifer in Northwest Guizhou, China. We found the concentration of petroleum hydrocarbon was always above 0.05 mg/L. The low-level anthropogenic contamination cannot produce high hydrocarbon groundwater in the area. By using hydrocarbon potential, geochemistry and biomarker characteristic in rocks and shallow groundwater, we carried out a comprehensive study in Dalongjing (DLJ) groundwater system to determine the hydrocarbon source. We found a simplex hydrogeology setting, high-level water–rock–hydrocarbon interaction and obviously original hydrocarbon groundwater in DLJ system. The concentration of petroleum hydrocarbon in shallow aquifer was found to increase with the strong water–rock interaction. Higher hydrocarbon potential was found in the upper of Guanling formation (T2g3) and upper of Yongningzhen formation (T1yn4). Heavily saturated carbon was observed from shallow groundwater, which presented similar distribution to those from rocks, especially from the deeper groundwater. These results indicated that the high concentrations of original hydrocarbon in groundwater could be due to the hydrocarbon release from corrosion and extraction out of strata over time.
The natural selenium poisoning due to toxic Se levels in food chain had been observed in humans and animals in Lower Cambrian outcrop areas in Southern Shaanxi, China. To find out the distribution pattern of selenium and other hazardous elements in the plant, soil and water of Lower Cambrian in Southern Shaanxi, China, and their possible potential health risk, a total of 30 elements were analyzed and the health risk assessment of 18 elements was calculated. Results showed that the soil, plant and natural water of Lower Cambrian all had relatively high Se levels. In Lower Cambrian, the soil was enriched with Se, As, Ba, Cu, Mo, Ni, Zn, Ga, Cd and Cr (1.68 < Igeo < 4.48, Igeo; geo-accumulation index). In same plants, the contents of Se, Cd and Zn (except Cd in corn and rice, Zn in potato and corn) of Lower Cambrian were higher than that of the other strata. Ba and Ga in natural water were higher than that of the other strata, while K and Cs were opposite. The health risk assessment results showed that the people living in outcrop areas of Lower Cambrian had both high total non-carcinogenic risk of 18 elements (HI = 16.12, acceptable range: < 1) and carcinogenic risk of As (3.98E−04, acceptable range: 10−6–10−4). High contents of Se, As, Mo and Tl of Lower Cambrian may pose a health risk to local people, and food intake was the major pathway. For minimizing potential health risk, the local inhabitants should use the mix-imported food with local growing foods.
Red mud (RM) was used to remediate heavy metal-contaminated soils. Experiments with two different dosages of RM added to soils were carried out in this study. It was found that soil pH increased 0.3 and 0.5 unit with the dosage of 3 and 5% (wt%), respectively. At the dosage of 5%, the highest stabilization efficiencies for Cd, Pb, Cu and Zn reached 67.95, 64.21, 43.73 and 63.73%, respectively. The addition of RM obviously transferred Cd from the exchangeable fraction to the residual fraction. Meanwhile, in comparison with the control (no RM added), it reduced 24.38, 49.20, 19.42 and 8.89% of Cd, Pb, Cu and Zn in wheat grains at the RM addition dosage of 5%, respectively. At the same time, the yield of wheat grains increased 17.81 and 24.66% at the RM addition dosage of 3 and 5%, respectively. Finally, the addition of RM did not change the soil bacterial community. These results indicate that RM has a great potential in stabilizing heavy metals in calcareous agricultural soils.
Green source Ep was extracted from marine alga waste.The molecule model structure of Ep was studied and constructed.PAC-Ep coagulation system improves the efficiency of removal efficiency.Synergistic effects between NPs and HA make a big difference to enhance efficiency.Mechanism is charge neutralization, hydrogen bonding and adsorbing-complexing Enteromorpha polysaccharide (Ep) extracted from alga a novel green coagulant aid for nanoparticles (NPs) and heavy metal ions removal and the structure of EP was intensively studied in this study. The integration of Ep with polyaluminum chloride (PAC-Ep) coagulants exhibited higher coagulation performance than that of the polyaluminum chloride (PAC) because of the negatively charged NPs suspension and humic aid (HA) solution. Significant high removal efficiencies of dissolved organic matter (94.1%), turbidity (99.3%) and Zn ions (69.3%) were achieved by the PAC-Ep coagulants. The dual-coagulation properties of PAC-Ep for different pollutants was based on multiple mechanisms, including (i) Al3+ charge neutralization; (ii) hydroxy aluminum hydroxyl bridging formed polynuclearhydroxy complexes bridge and sweep colloidal particles; (iii) adsorption and bridging of Ep chain for the NPs and heavy metal ions. Results indicated that the destabilization of colloid was induced by the coexisting HA and higher removal was achieved as ions adsorption was enhance in the presence of HA complexation. On the basis of that, the extraction of polysaccharide is a promising candidate for its high coagulation performance in water treatment. 相似文献
The purpose of this study was to develop the multiple regression models to evaluate the formation of trihalomethanes (THMs) and haloacetonitriles (HANs) during chlorination of source water with low specific ultraviolet absorbance (SUVA) in Yangtze River Delta, China. The results showed that the regression models of THMs exhibited good accuracy and precision, and 86–97 % of the calculated values fell within ±25 % of the measured values. While the HANs models showed relatively weak evaluation ability, as only 75–83 % of the calculated values were within ±25 % of the measured values. The organic matter [dissolved organic carbon (DOC) or UV absorbance at 254 nm] and bromide exerted the most important influence on the formation of HANs. While for THMs, besides the organic matter and bromide, reaction time was also a key factor. Comparing the models for total THMs (T-THMs) in this study with others revealed that the regression models from the low SUVA waters may have low DOC coefficients, but high bromide coefficients as compared with those from the high SUVA waters. 相似文献