Pilot study on road traffic emissions (PAHs,heavy metals) measured by using mosses in a tunnel experiment in Vienna,Austria

BACKGROUND, AIMS AND SCOPE: Over the last few years there has been extensive research for new indicators providing information about deposition resulting from road traffic and tunnel experiments received special attention in emission research. Mosses have been used for the estimation of atmospheric heavy metal and PAH depositions for more than three decades, although they were used only a few times for estimating ambient air pollution caused by traffic. In the current study, the suitability of using a moss species for monitoring road traffic emissions inside a tunnel was evaluated. This was a first-time ever attempt to use plants (mosses) as bioindicators in a tunnel experiment. Specifically, two relevant questions were examined: 1) Do mosses accumulate toxic substances derived from road traffic emissions under the extremely adverse conditions which can be found in a tunnel, and 2) Which substances can mainly be attributed to road traffic emissions and therefore be taken as efficient and reliable indicators for motor vehicles? METHODS: For the first time a biomonitor (the moss species Hylocomium splendens (Hedwig) B.S.G.) was used in a road tunnel experiment to analyse emissions from road traffic. Moss samples were exposed for four weeks in wooden frames (size 10 cm x 10 cm), covered by a thin plastic net with a mesh size of 1 cm x 1 cm. 17 elements, mainly heavy metals, and the 16 EPA-PAHs together with coronene were analysed by ICP-AES, AAS and GC-MSD. RESULTS: Enrichment factors, calculated by comparing post-experiment concentrations to those of a background site, were high for most PAHs, especially benzo(g,h,i)perylene (150.7), coronene (134.7), benzo(a)anthracene (125.0), indeno(1,2,3-c,d)pyrene (79.8), chrysene (78.1), pyrene (69.6) and benzo(b)-fluoranthene (67.4), and among the other elements for Sb (73.1), Mo (59.6), Cr (33.9), As (24.1), Cu (19.6), and Zn (17.1). All these substances can thus be taken as indicators for road traffic pollution. Concentrations were also significantly higher in the tunnel mosses for all investigated substances than along busy roads outside tunnels. Cluster analysis revealed groups of substances which could sensibly be attributed to various sources (abrasion processes, Diesel combustion) and enrichment in the various particle size classes. DISCUSSION: The extreme high concentrations in the analysed moss samples from inside the tunnel were due to higher concentrations in the ambient tunnel air, and the fact that already deposited chemical substances are not lost by rain, as well as efficient uptake capacities even under the extremely adverse conditions in a tunnel. In accordance with previous studies our results suggest that PAHs are better indicators for emissions from the burning process than heavy metals. CONCLUSIONS: As in open fields, mosses are suitable indicators for monitoring traffic emissions in tunnels. In addition to biomonitoring in open fields, in tunnel experiments mosses are even better indicators, because the confounding effects of other sources of pollution and the 'noise' in the accumulation process (e.g. washout through wet deposition) are minimised. The results of our study demonstrate the usefulness of mosses for surveying heavy metals and PAH emissions and deposition arising from road traffic sources, even under the extremely adverse conditions of the tunnel environment. RECOMMENDATION: It can be considered that biomonitors like mosses are a suitable alternative to technical particle filters inside tunnels. They are easy to handle, low in costs and valuable information regarding traffic emissions can be obtained. PERSPECTIVE: The results of this pilot-study proved the feasibility of the method, however, should be corroborated by further investigations based on a sample set that allows for generalization of the findings and might even include other moss species. A comparison of technical measurements with the biomonitoring method could lead to a more general acceptance of the results.     

Geochemical speciation of heavy metals in semiarid soils of the central Ebro Valley (Spain)

This study describes the chemical speciation of Fe, Mn, Zn and Cr in four selected soil types representative of the more abundant agricultural soils in the central Ebro river valley in Aragón. Gypsisols, Calcisols, Solonchaks and Solonetzs represent around 20% of the total soil surface in the region. A total of 12 selected sites have been sampled and five subsamples were taken in each site to create a composite sample. The four elements have been analysed by the sequential extraction procedure of Tessier et al. [Anal. Chem. 51 (1979) 844.] by emission atomic spectrometry of solid state (ICP OES). Very little amounts of Fe and Mn were retrieved from the exchangeable phase, the ready available for biogeochemistry cycles in the ecosystems. Therefore, low quantities of Fe and Mn can be taken up by plants in these alkaline soils. Cr was not detected in the bioavailable forms as well as Zn that was only present in negligible amounts in very few samples. The absence of mobile forms of Cr in all soils eliminates the toxic risk both in the trophic chain and from its migration downwards the soil profile. The largest contents of Fe, Zn and Cr were retrieved from the residual phase where metals are strongly bound to minerals, whereas Mn from the carbonate and oxide phases amounts 80% of its total content. Gypsisols and Calcisols have the lowest metal contents while the highest are found in Solonetzs and Solonchaks.     

Untersuchungen zum ökotoxikologischen Schädigungspotenzial und Erosionsrisiko von kontaminierten Sedimenten in staugeregelten Flüssen

Particle-bound pollutants accumulate in river-bottom sediments, a process which results in a significant decrease in the ecotoxicological availability of toxicants for the majority of aquatic organisms. Under normal hydrologic conditions, the release of contaminants from bottom sediments is usually of minor importance. In contrast, flood events may remobilize highly contaminated sediments via in-stream erosion. The objective of this study was to develop a combined ecotoxicological and hydraulic approach to elucidate the ecotoxicological implications associated with the risk of erosion of contaminated sediments. This integrated strategy was applied to the lock-regulated Neckar river in Southern Germany. Both the bottom-sediment cores and suspended matter from two intensive flood events were investigated. Sediment samples below an erosional unconformity showed a sharp increase in the ecotoxicological load. Moreover, it was found that major flood events (HQ₅ and higher) could possibly erode even very old, well-consolidated and highlycontaminated sediments. The suspended matter of the high discharge events investigated (return periods of 15 to 20 years) exerted significantly higher cytotoxicity and mutagenicity than a moderate flood with a 1-year return period. These findings support the conclusion that the observed ecotoxicological effects during major floods may at least in part be due to the in-stream erosion of highly contaminated bottom sediments.     

Linkages between the energy and agricultural sectors: insights from European Union greenhouse gas mitigation scenarios

Over the past decade, the relationship between agricultural and energy markets has strengthened. Traditional energy sources have been increasingly replaced by energy from biomass, and this trend is expected to continue into the future. Consequently, an assessment of the efficiency of bioenergy policies requires a comprehensive analysis of both agricultural and energy markets. The objective of this paper is to analyze the impacts of two detailed European Union (EU) greenhouse gas (GHG) emission mitigation policies on the utilization of biomass for energy production and the implications for agricultural prices and trade. The consequences of a policy-induced shift from consumption of fossil to renewable energy are assessed under full consideration of interrelations between the energy and agricultural sectors. To this end, we combine an energy system model and an agricultural sector model by establishing a consistent interface between them. Depending on the ambition of the GHG emission reduction scenarios, the results indicate significant price increases. Furthermore, the increase in European demand for energy crops is to a substantial degree covered by additional imports. These results highlight that GHG emission mitigation policies enacted in a large economy like the EU cannot be considered without accounting for indirect effects in the rest of the world. They put the efficiency and also the effectiveness of such policies in general into question.     

A direct passive method for measuring water and contaminant fluxes in porous media

This paper introduces a new direct method for measuring water and contaminant fluxes in porous media. The method uses a passive flux meter (PFM), which is essentially a self-contained permeable unit properly sized to fit tightly in a screened well or boring. The meter is designed to accommodate a mixed medium of hydrophobic and/or hydrophilic permeable sorbents, which retain dissolved organic/inorganic contaminants present in the groundwater flowing passively through the meter. The contaminant mass intercepted and retained on the sorbent is used to quantify cumulative contaminant mass flux. The sorptive matrix is also impregnated with known amounts of one or more water soluble 'resident tracers'. These tracers are displaced from the sorbent at rates proportional to the groundwater flux; hence, in the current meter design, the resident tracers are used to quantify cumulative groundwater flux. Theory is presented and quantitative tools are developed to interpret the water flux from tracers possessing linear and nonlinear elution profiles. The same theory is extended to derive functional relationships useful for quantifying cumulative contaminant mass flux. To validate theory and demonstrate the passive flux meter, results of multiple box-aquifer experiments are presented and discussed. From these experiments, it is seen that accurate water flux measurements are obtained when the tracer used in calculations resides in the meter at levels representing 20 to 70 percent of the initial condition. 2,4-Dimethyl-3-pentanol (DMP) is used as a surrogate groundwater contaminant in the box aquifer experiments. Cumulative DMP fluxes are measured within 5% of known fluxes. The accuracy of these estimates generally increases with the total volume of water intercepted.