Soil-plant nitrogen isotope composition and nitrogen cycling after biochar applications

Environmental Science and Pollution Research - Biochar has strong potential to improve nitrogen (N) use efficiency in both agricultural and horticultural systems. Biochar is usually co-applied with...     

DNA Heat Treatment for Improving qPCR Analysis of Human Adenovirus in Wastewater

PCR inhibitory substances in complex sample matrices can cause false negatives or under-estimation of target concentration. This study assessed DNA heat treatment for reducing inhibition during qPCR analysis of human adenovirus (HAdV) in wastewater samples. Inhibition was reduced by heat treating DNA, where mean HAdV concentration was increased by 0.71 log₁₀ GC/L (and up to 3.04 log₁₀ GC/L in one case), and replicate variability and false negatives were reduced. DNA heat treatment should be further investigated for improving reliability of HAdV concentration estimates in water, which can support more accurate assessment of health risks associated with viral pathogen exposure.     

Prompting safety-belt use in the context of a belt-use law: the flash-for life revisited

PROBLEM: Safety-belt use reduces motor vehicle crash-related morbidity and mortality, yet an estimated 18% of drivers do not consistently buckle up (NHTSA, 2005). In 1985, Geller and colleagues developed an interpersonal Flash-for-Life prompt that increased belt use among 22% of 1,087 unbuckled drivers (Geller, Bruff, & Nimmer, 1985). METHOD: The Flash-for-Life intervention was re-introduced at a large university with high safety-belt use (i.e., 80%). College students stood at parking-lot entrance/exits and "flashed" signs with the message, "Please Buckle Up, I Care" to unbuckled drivers. RESULTS: Of 427 unbuckled drivers observed, 30% of these complied with the prompt. Male drivers were significantly more likely to comply with prompts delivered by females. DISCUSSION: Compliance was higher than in the 1985 study, indicating a high baseline rate of safety-belt use does not negate potential beneficial influence of a prompting intervention. This intervention is particularly effective with college-aged males, a sub-group of the driving population least likely to buckle-up. IMPACT ON INDUSTRY: A simple behavioral prompt could be used at most industrial complexes to increase safety-belt use among vehicle occupants who are not buckled-up.     

Pastoral farmland habitat diversity in south-east Ireland

In this study, habitat surveys were undertaken on 50 grass-based farms in SE Ireland and data digitised onto aerial photography. Additional data i.e. stocking rates, and participation (or otherwise) in the Irish Rural Environment Protection Scheme (REPS) were collected and analysed as possible explanatory variables for farm habitat composition.Results indicated that approximately 14.3% of the land area of sampled farms comprised of semi-natural habitat types, a proportion substantially greater than has been reported for many other European countries. The most frequently recorded semi-natural habitats included, field boundaries, scrub, and deciduous and riparian woodlands.Multivariate analysis of farm habitat configuration showed a strong dichotomy between dairy and non-dairy farming systems. Habitats such as intensively managed grassland and built ground were closely associated with dairy-based enterprises. In contrast, the incidence of other habitat types was associated with non-dairy and/or REPS participating enterprises. The ecological quality of field boundaries as assessed by the Field Boundary Evaluation and Grading System (FBEGS) Index was significantly greater on dairy, compared with dry-stock farms.This dichotomy in farm habitat composition is not reflected within current Agri-Environment (AE) policy. Integration of locally important drivers of habitat diversity into the design and implementation of AE policy, is integral to the successful performance of AE schemes.     

Point Sampling Digital Imagery with ‘Samplepoint’

Measuring percent occurrence of objects from digital images can save time and expense relative to conventional field measurements. However, the accuracy of image analysis had, until now, not reached the level of the best conventional field measurements. Additionally, most image-analysis software programs require advanced user training to successfully analyze images. Here we present a new software program, ‘SamplePoint,’ that provides the user a single-pixel sample point and the ability to view and identify the pixel context. We found SamplePoint to allow accuracy comparable with the most accurate field-methods for ground-cover measurements. Expert use of the program requires minimal training and its ease of use allows rapid measurements from image data. We recommend SamplePoint for calibrating the threshold-detection level of image-analysis software or for making direct measurements of percent occurrence from digital images.     

Dry and heat stress affects H2S production of Salmonella on selective plating media

The pH of Salmonella pre-enrichment media can become acidic (pH 4.0–5.0) when feeds/ingredients are incubated for 24?h. Salmonella in feed that have been stressed by heat and desiccation exhibit different pH tolerances than non-stressed cultures. Acidic conditions can result in cell injury/death and affect biochemical pathways. In this study, eight serotypes of Salmonella were grown in sterile meat and bone meal that was subjected to desiccation and heat stress. Cultures of non-stressed and stressed isolates were subsequently exposed to acidic pH from 4.0 to 7.0 in 0.5?pH increments (3 replicates/pH increment) in citrate buffer. At 6 and 24?h, serial dilutions were plated in duplicate on XLT-4 (xylose lysine tergitol-4) agar. Four serotypes showed an impaired ability to decarboxylate lysine on XLT-4. This inability to decarboxylate lysine was dependent on isolate, stress status, and incubation time. When the isolates’ ability to decarboxylate lysine was examined using biochemical tests, cultures were found to be able to decarboxylate lysine with the exception of S. Infantis. This suggests that XLT-4 contains a biochemical stressor(s) which affects the rate of decarboxylation by these Salmonella. These results suggest that acidic conditions may influence the detection and confirmation of Salmonella in feed.     

Innovative applications of subgrade biogeochemical reactors: Three case studies

Subgrade biogeochemical reactors (SBGRs) are an in situ remediation technology shown to be effective in treating contaminant source areas and groundwater hot spots, while being sustainable and economical. This technology has been applied for over a decade to treat chlorinated volatile organic compound source areas where groundwater is shallow (e.g., less than approximately 30 feet below ground surface [ft bgs]). However, this article provides three case studies describing innovative SBGR configurations recently developed and tested that are outside of this norm, which enable use of this technology under more challenging site conditions or for treatment of alternative contaminant classes. The first SBGR case study addresses a site with groundwater deeper than 30 ft bgs and limited space for construction, where an SBGR column configuration reduced the maximum trichloroethene (TCE) groundwater concentration from 9,900 micrograms per liter (μg/L) to <1 μg/L (nondetect) within approximately 15 months. The second SBGR is a recirculating trench configuration that is supporting remediation of a 5.7‐acre TCE plume, which has significant surface footprint constraints due to the presence of endangered species habitat. The third SBGR was constructed with a new amendment mixture and reduced groundwater contaminant concentrations in a petroleum hydrocarbon source area by over 97% within approximately 1 year. Additionally, a summary is provided for new SBGR configurations that are planned for treatment of additional classes of contaminants (e.g., hexavalent chromium, 1,4‐dioxane, dissolved explosives constituents, etc.). A discussion is also provided describing research being conducted to further understand and optimize treatment mechanisms within SBGRs, including a recently developed sampling approach called the aquifer matrix probe.     

A comparison of mesh-adaptive LES with wind tunnel data for flow past buildings: Mean flows and velocity fluctuations

In this paper we address two important aspects of micro-scale urban airflow model evaluation: (a) the identification of key flow features as dictated by the physics of the problem and as captured by the simulations, and (b) the comparison of important model output parameters (mean flows and fluctuations) with experimental data. A series of mesh-adaptive large eddy simulations (LES) was carried out for the study of air flows within two intersecting street canyons with varying building configurations. The novelty of the approach lies in the combination of LES with mesh adaptivity, which allows a variable-filter length and the implementation of an anisotropic eddy-viscosity model. Both coarse and fine-mesh simulations were carried out, using single and parallel-processor systems respectively. The simulations showed clearly that the expected flow patterns such as the street canyon recirculation and the street-mouth vortices, as well as the exchange of air flow at the street intersections, can readily be captured by the mesh-adaptive LES.In addition, the detailed comparisons of mean flows and fluctuations of the resolved velocity field with the measured data showed that the simulation results agreed well with the patterns and trends of the wind tunnel measurements. In most cases the finer-mesh simulations improved considerably the accuracy of the mean flows, especially for the symmetrical configuration. The improvement in the predicted fluctuations was less obvious, with several detector locations underpredicting the measured values, although the overall comparison was also satisfactory. The typical errors for the mean flows for all three building configurations were less than 30%, whilst for the velocity fluctuations less that 40%. Both the simulated means flows and turbulence levels were generally more accurate in the streets parallel to the wind (streamwise direction) than in the streets normal to the wind.     

Sustainability Assessment for Agriculture Scenarios in Europe’s Mountain Areas: Lessons from Six Study Areas

Sustainability assessment (SA) is a holistic and long-range strategic instrument capable of assisting policy-making in electing, and deciding upon, future development priorities. The outcomes of an SA process become more relevant and strengthened when conducted with multi-stakeholder engagement, which provides for multiple dialogues and perspectives. This was the object of research of the SA team in the context of BioScene (Scenarios for Reconciling Biodiversity Conservation with Declining Agriculture Use in Mountain Areas in Europe), a three-year project (2002–2005) funded by the European Union 5th Framework Program, which aimed to investigate the implications of agricultural restructuring and decline for biodiversity conservation in the mountain areas of Europe, using three distinct methodological streams: the ecological, the socio-economic, and the SA approaches. The SA approach drew on the previous two to assess the importance for biodiversity management of different scenarios of agri-environmental change and rural policy in six countries (France, Greece, Norway, Slovakia, Switzerland, and the United Kingdom), develop causal chains, include stakeholder views, and identify potential contributions for, or conflicts with, sustainability. This article tells how SA was used, what sustainability meant in each study area through different objectives of sustainability considered, discusses the methods used in SA, and the benefits arising. The SA was conducted by a team independent of any study area, who developed and oversaw the application of the SA methodology, assisting national teams, and developing a cross-country understanding of the sustainability of proposed scenarios in the different geographical and social contexts, and their implications for policy-making. Finally, it reflects on the persistent challenges of interdisciplinary research, compounded by multi-cultural teams, and concludes on the BioScene’s lessons for the further development and application of SA.

Efficiency of perchlorate consumption in road flares, propellants and explosives

When an explosive detonates or a propellant or flare burns, consumption of the energetic filler should be complete but rarely is, especially in the presence of large amounts of non-combustible materials. Herein we examine three types of perchlorate-containing devices to estimate their potential as sources of contamination in their normal mode of functioning. Road flares, rocket propellants and ammonium nitrate (AN) emulsion explosives are potentially significant anthropogenic sources of perchlorate contamination. This laboratory evaluated perchlorate residue from burning of flares and propellants as well as detonations of ammonium nitrate emulsion explosives. Residual perchlorate in commercial products ranged from 0.094 mg perchlorate per gram material (flares) to 0.012 mg perchlorate per gram material (AN emulsion explosives). The rocket propellant formulations, prepared in this laboratory, generated 0.014 mg of perchlorate residue per gram of material.