Preservative leaching from weathered CCA-treated wood

Disposal of discarded chromated copper arsenate (CCA)-treated wood in landfills raises concerns with respect to leaching of preservative compounds. When unweathered CCA-treated wood is leached using the toxicity characteristic leaching procedure (TCLP), arsenic concentrations exceed the toxicity characteristic (TC) limit of 5mg/L in most cases. The majority of discarded CCA-treated wood, however, results from demolition activities, where the wood has typically been subjected to weathering. Since preservatives do migrate from the wood during its normal use, leaching characteristics of weathered and aged CCA-treated wood may differ from unweathered wood. To evaluate this, CCA-treated wood removed from service after various degrees of weathering was collected from multiple sources and leached with the TCLP, the synthetic precipitation leaching procedure (SPLP) and California's waste extraction test (WET). Five to seven individual pieces of wood were analyzed from each source. The average TCLP arsenic concentration for the 14 sources ranged from 3.2 to 13 mg/L. The average TCLP concentrations of the 100 wood pieces tested were 6.4, 5.9 and 3.2 mg/L for arsenic, copper and chromium, respectively. Overall, in 60 out of 100 samples tested by the TCLP, arsenic concentrations exceeded 5 mg/L (the TC regulatory value). SPLP leachate concentrations were similar to TCLP concentrations, although copper leached somewhat more with the TCLP. WET leachate concentrations were approximately a factor of 10 higher than TCLP concentrations. Discarded CCA-treated wood, even after exposure to years of weathering, often exceeds the TC limit for arsenic and without the current regulatory exemption would possibly require management as a TC hazardous waste in the US.     

Application of Dispersion Modelling for Analysis of Particle Pollution Sources in a Street Canyon

The dominating source of particles in urban air is road traffic. In terms of number concentration, its main contribution is within the range of ultrafine particles (Dp < 100 nm). The dispersion conditions, i.e. transport and dilution, of the submicrometer particles are expected to be like for gases and therefore the particle concentrations in a street canyon can be calculated using gaseous pollutants dispersion models. Such processes, like coagulation or condensation, are less important due to the short residence time within the street canyon environment.Two extensive measuring campaigns were conducted in the street Jagtvej in Copenhagen, Denmark. The particle size distributions were measured by a Differential Mobility Analyser (DMA) coupled to a particle counter, providing high time resolution data (1/2 hourly) on a continuous basis. Measurements of NO_x, CO and meteorological parameters were also available. The measured particle number concentrations, especially below 100 nm, reveal very similar dependence on the meteorological conditions as the NO_x concentrations. This underpins the conclusion that dilution properties are similar for particles and NO_x. For particle sizes over 100 nm, somewhat different behaviour is observed. This points toward existence of additional particle sources, not related to traffic emissions within the street canyon. A significant contribution is believed here to be attributed to long-range transport. The total particle emission from traffic, including daily variation and size distribution, has been calculated using the OSPM dispersion model. Results are in accordance with a previous analysis based on statistical modelling.     

Contribution of arbuscular mycorrhiza to soil quality in contrasting cropping systems

The aim of this study was to determine how the potential to rely on arbuscular mycorrhiza (AM) for plant nutrition differs between a conventional and a low-input cropping system in the long term. The roles of fertilisation rate, composting of recycled plant residues and stage of the rotations in the overall impact of the cropping systems on soil quality and AM were also identified. The conventional cropping system with a non-leguminous crop rotation (barley–barley–rye–oat–potato–oat) was fertilised at either full or half the recommended rate. In the low-input cropping system, one year with barley was replaced by clover, and oat was cultivated mixed with pea. Straw and clover were returned to the soil either with or without composting. In the low-input system, biotite and rock phosphate were used to compensate for K and P in the harvested yield, while animal manure was applied at the start only. After 15 years, crop growth and nutrition, AMF colonisation and soil quality were assessed in the field, while the AM contribution to growth and nutrient uptake were determined in a bioassay in a growth chamber. AM functioning made a higher contribution to soil quality in terms of crop performance and environmental benefits in the low-input cropping system than at either fertilisation rate in the conventional system. Halving fertilisation in the conventional system prevented some costs and enhanced some of the benefits of AM in comparison with full fertilisation. However, only the low-input system with composting conclusively favoured AM in comparison with the conventional system. It resulted in the highest percentage colonisation and, in a bioassay with flax and clover, gave a relative average contribution to growth of 27% and to P uptake of 68% in comparison with 4 and 36%, respectively, for the conventional cropping system with full fertilisation. Rye yield was in the low-input system without composting similar to that in the conventional system with full fertilisation, and with composting 87% of the latter one. Incorporation of clover green manure without composting inhibited AM functioning, leading to a temporary loss of AM contribution to crop performance. This effect draws attention to the impact of the form of recycled organic matter on supporting ecosystem services such as nutrient cycling.     

Evaluating surrogates of genetic diversity for conservation planning

Protected-area systems should conserve intraspecific genetic diversity. Because genetic data require resources to obtain, several approaches have been proposed for generating plans for protected-area systems (prioritizations) when genetic data are not available. Yet such surrogate-based approaches remain poorly tested. We evaluated the effectiveness of potential surrogate-based approaches based on microsatellite genetic data collected across the Iberian Peninsula for 7 amphibian and 3 reptilian species. Long-term environmental suitability did not effectively represent sites containing high genetic diversity (allelic richness). Prioritizations based on long-term environmental suitability had similar performance to random prioritizations. Geographic distances and resistance distances based on contemporary environmental suitability were not always effective surrogates for identification of combinations of sites that contain individuals with different genetic compositions. Our results demonstrate that population genetic data based on commonly used neutral markers can inform prioritizations, and we could not find an adequate substitute. Conservation planners need to weigh the potential benefits of genetic data against their acquisition costs.     

Watershed integrated management: A decision-support model on Sete Cidades Lake (Azores)

The Sete Cidades Lake (437 ha) is located in a volcanic crater of São Miguel Island (Azores). The watershed is 1923 ha, and 25% of it is covered with water. Extreme logging and the use of fertilizers in the cattle grazing areas have caused sedimentation and eutrophication of the main water body (Carlson Trophic State Index TSI = 40–50 mesoeutrophy). To deal with the issue, a linear programming model was created to generate efficient land-use scenarios for different amounts of phosphorus release. The model was calibrated for the present situation and then simulated to obtain 29 scenarios. It allowed us to derive parameters for each scenario. Then a multiobjective program was used to derive an acceptable weight for each indicator. The dominant solutions were discovered and discussed with different stakeholders.     

Seals at sea: modelling seal distribution in the German bight based on aerial survey data

The Wadden Sea is an important habitat for harbour seals and grey seals. They regularly haul-out on sandbanks and islands along the coast. Comparably little is known about the time seals spend at sea and how they use the remainder of the North Sea. Yet, human activity in offshore waters is increasing and information on seal distribution in the North Sea is crucial for conservation and management. Aerial line transect surveys were conducted in the German bight from 2002 to 2007 to investigate the distribution and abundance of marine mammals. Distance sampling methodology was combined with density surface modelling for a spatially explicit analysis of seal distribution in the German North Sea. Depth and distance to coast were found to be relevant predictor variables for seal density. Density surface modelling allowed for a depiction of seal distribution in the study area as well as an abundance estimate. This is the first study to use aerial survey data to develop a density surface model (DSM) for a spatially explicit distribution estimate of seals at sea.

---

Geospatial analysis of vulnerable beach-foredune systems from decadal time series of lidar data

Time series of lidar data, acquired over the past decade along the North American East Coast, provide opportunities to gain new insights into 3D evolution of barrier islands and their beach and dune systems. GIS-based per grid cell statistics and map algebra was applied to time series of Digital Surface Models representing two sections of North Carolina barrier islands to quantify elevation change trends, map dynamic and stable locations, identify new and lost buildings, measure relative volume evolution in the beach and foredune systems and analyze shoreline dynamics. Results show a relatively small stable core in both study areas, with beaches and the ocean side of the dunes exhibiting systematic high rates of elevation loss while areas landward from the dunes increase slightly in elevation. Significant number of new homes have been built at locations with very small core surface elevation, and homes built within the shoreline dynamics band have already been lost. The raster-based methodology used in this study can be applied to perform similar analyses in other coastal areas where time series of lidar data are available.     

Suicides and other fatalities from train-person collisions on Swedish railroads: a descriptive epidemiologic analysis as a basis for systems-oriented prevention

PROBLEM: Suicide is a dominating, although hidden, safety problem on Swedish railroads. The aim of this paper is to describe the epidemiology of fatal train-person collisions as a basis for systems-oriented prevention. METHOD: Data on collision circumstances were collected from narrative reports at the Swedish National Rail Administration. RESULTS: The events were evenly distributed by months and weekdays, however, most suicides occur during the day while unintentional events usually occur at night. Most train-person collisions happened in densely populated areas, and 75% of the suicide victims were waiting on the track before the collision. Significance test between types of injury event (suicide, accident, or unknown intent) showed small or no differences. CONCLUSION: Traditional approaches to accident prevention by systems modification seem largely applicable to combat railroad suicide as well. IMPACT ON INDUSTRY: Our findings show promising preventive potentials.     

Benthic foraminiferal distribution on the southeastern Brazilian shelf and upper slope

Foraminiferal data were obtained from 66 samples of box cores on the southeastern Brazilian upper margin (between 23.8°–25.9°S and 42.8°–46.13°W) to evaluate the benthic foraminiferal fauna distribution and its relation to some selected abiotic parameters. We focused on areas with different primary production regimes on the southern Brazilian margin, which is generally considered as an oligotrophic region. The total density (D), richness (R), mean diversity ([`(H^￠ )] \overline{{H^{\prime } }} ), average living depth (ALD _X ) and percentages of specimens of different microhabitats (epifauna, shallow infauna, intermediate infauna and deep infauna) were analyzed. The dominant species identified were Uvigerina spp., Globocassidulina subglobosa, Bulimina marginata, Adercotryma wrighti, Islandiella norcrossi, Rhizammina spp. and Brizalina sp.. We also established a set of mathematical functions for analyzing the vertical foraminiferal distribution patterns, providing a quantitative tool that allows correlating the microfaunal density distributions with abiotic factors. In general, the cores that fit with pure exponential decaying functions were related to the oligotrophic conditions prevalent on the Brazilian margin and to the flow of the Brazilian Current (BC). Different foraminiferal responses were identified in cores located in higher productivity zones, such as the northern and the southern region of the study area, where high percentages of infauna were encountered in these cores, and the functions used to fit these profiles differ appreciably from a pure exponential function, as a response of the significant living fauna in deeper layers of the sediment. One of the main factors supporting the different foraminiferal assemblage responses may be related to the differences in primary productivity of the water column and, consequently, in the estimated carbon flux to the sea floor. Nevertheless, also bottom water velocities, substrate type and water depth need to be considered.