Effects of pH on the water solubility and 1-octanol-water partition coefficient of 2,4,6-tribromophenol

2,4,6-Tribromophenol (TBP) is expected to exist in both ionic and non-ionic forms in the environment due to ionisation of the phenolic group at near neutral pH. In this study, the water solubility (Sw) and 1-octanol-water partition coefficient (Kow) of aqueous solutions of TBP at various pH values were measured using the shake flask method. The ionisation resulted in increasing Sw and decreasing Kow by two to three orders of magnitude. From the experimental results, the environmental partitioning characteristics of TBP and the effect of pH on partitioning were discussed through a comparison with the properties of tetrabromobisphenol A (TBBP-A), which has two phenolic groups. Furthermore, the pH dependence of Sw and Kow was represented using a Henderson-Hasselbalch type model and the validity of the model was evaluated. The model was found to be highly useful for predicting the pH dependence within the range of pH 3 to 9.     

Effects of wavelength and water quality on photodegradation of N-Nitrosodimethylamine (NDMA)

N-Nitrosodimethylamine (NDMA) is a potent carcinogen that yields a cancer risk of 10⁻⁶ at concentrations as low as 0.7 ng L⁻¹. Tentative guideline values are set at 3 ng L⁻¹ in California, USA; 9 ng L⁻¹ in Ontario, Canada; 40 ng L⁻¹ nationwide in Canada; and 100 ng L⁻¹ by the World Health Organization. NDMA is a great concern in treating reclaimed water as well as drinking water. UV degradation can be considered effective degradation method. A 1-log reduction of NDMA is achieved by 1000 mJ cm⁻² of a 254-nm low pressure (LP) mercury UV lamp. However, a higher degradation efficiency than that provided by LP lamps is desired in practical treatment. In this study, the effects of wavelength and water quality were investigated to achieve higher degradation efficiency. The effects of wavelength were examined by comparing three UV lamps: a 222-nm Kr Cl Excimer UV lamp, a 254-nm LP mercury UV lamp, and a 230- to 270-nm filtered medium pressure (FMP) mercury UV lamp. The 222-nm lamp and FMP lamp achieved 4 times and 2.8 times higher degradation efficiency, respectively, than the conventional 254-nm LP lamp. Effects on water quality were also simulated by using absorption spectrum data of nitrate solutions and process water from a drinking-water treatment plant. In the simulation, the 222-nm lamp was affected by UV-absorbing compounds in the water, whereas the FMP lamp showed more stable degradation efficiency. Appropriate use of these three types of lamps could enhance the efficiency of degradation of NDMA.     

Woody biomass and RPF gasification using reforming catalyst and calcium oxide

This study focused on steam gasification and reforming of waste biomass using a reforming catalyst. The purpose of the study was to evaluate the durability of a commercial Ni reforming catalyst and the effect of CaO on the reforming behavior, and to clarify detailed factors of catalytic performance, as well as the effect of operating parameters on the characteristics of produced gas composition. Moreover, catalyst regeneration was carried out and the behavior of catalytic activity based on gas composition was investigated. Using a fluidized bed gasifier and a fixed bed reformer, gasification and reforming of waste biomass were carried out. Commercial Ni-based catalyst and calcined limestone (CaO) were applied to the reforming reaction. Temperature of the gasifier and reformer was almost 1023 K. Ratio of steam to carbon in the feedstock [mol mol⁻¹] and equivalence ratio (i.e., ratio of actual to theoretical amount of oxygen) [-] were set at about 2 and 0.3, respectively. The feed rate of the feedstock into the bench-scale gasifier was almost 15 kg h⁻¹. The results of waste biomass gasification confirmed the improvement in H₂ composition by the CO₂ absorption reaction using the reforming catalyst and CaO. In addition, CaO proved to be especially effective in decreasing the tar concentration in the case of woody biomass gasification. Catalytic activity was maintained by means of catalyst regeneration processing by hydrogen reduction after air oxidation when woody biomass was used as feedstock.     

Surrogate study for dioxins from municipal waste incinerator in startup condition: applicability as a dioxin control indicator and an organohalogen emission warning

Dioxins and their surrogates were continuously monitored during the startup of two municipal waste in cinerators (MWIs). The surrogates studied included low-volatility organohalogen compounds (LVOH) sampled by online systems, as well as chlorobenzenes (CBs) and chlorophenols (CPs). The changes in levels of LVOH, CBs, and CPs corresponded well with the trend of the toxicity equivalent quantity (TEQ). The correlation of LVOH with TEQ was fairly good, whereas that of CBs and CPs with TEQ was not consistent. The correlation of LVOH with TEQ involved a memory effect related to the delayed emission of less volatile compounds. The isomer analysis of the dioxins present under startup conditions showed evidence of the memory effect, i.e., highly chlorinated isomers were emitted slowly, whereas low-chlorinated isomers and LVOH decreased rapidly as the temperature rose. LVOH cannot act as a perfect dioxin surrogate, but it can give a versatile, quick, and comprehensive warning of the presence of organohalogen compounds because it is free from the memory effect and covers many kinds of organohalogen compounds, including dioxins.     

Separation and recovery of carbon dioxide by a membrane flash process

A novel process for carbon dioxide (CO₂) separation, which was named a membrane flash process, was developed to realize an energy-saving technology and to substitute it for a conventional regenerator. The electric energy for CO₂ recovery in a membrane flash process using aluminum oxide and diethanolamine was lower than the thermal energy of the conventional chemical absorption process. Flashing at elevated temperature by the low temperature energy significantly reduced the electric energy and required much less membrane area. This process has potentiality of low cost capture of CO₂ when the low temperature energy, which is not available for other purposes, can be utilized to elevate flashing temperature.     

Fluoranthene fumigation and exogenous scavenging of reactive oxygen intermediates (ROI) in evergreen Japanese red pine seedlings (Pinus densiflora Sieb. et. Zucc.)

Generation of reactive oxygen intermediates (ROI) such as O(2)(-), H(2)O(2), and *OH is known to be a major mechanism of damage in biological systems. This study investigated and compared effectiveness of scavenging ROI generated in fluoranthene (FLU) pre-fumigated Japanese red pine seedlings. Three kinds of eco-physiological assessments were used to express the impact of the different fumigants used inside the green house. Gas exchange measurements showed negative changes induced by 10 microM FLU on Japanese pine seedlings during a 10 d exposure period whilst no negative change was found during a 5 d exposure period. Moreover, during a 14 d FLU exposure incorporating ROI scavengers, results revealed that chlorophyll fluorescence, needle chemical contents and needle dry mass per unit area of the seedlings were affected. The negative effects of FLU on the conifer were dependent on both the dose and period of FLU fumigation. Peroxidase (PERO), superoxide dismutase (SOD) and mannitol (MANN) were all effective scavengers of ROI. MANN scavenged *OH, the most lethal of the ROI. For practicable use, MANN is more economical, and may be the best ROI scavenger among the three considered. It can be concluded that efficient scavenging of ROI in biological systems is important to mitigate the negative effects of FLU on Japanese red pine trees.     

Degradation of a Terephthalate-containing Polyester by Thermophilic Actinomycetes and <Emphasis Type="Italic">Bacillus</Emphasis> Species Derived from Composts

We intended to find thermophilic degraders of terephthalate-containing Biomax^® films. Films in mesh bags were buried in composts (inside temperature: approximately 55–60 °C), resulting in the degradation of them in 2 weeks. Fluorescent microscopy of films recovered from composts showed that microorganisms gradually covered the surface of a film during composting. DGGE analysis of microorganisms on the composted film indicated the presence of Bacillus species as main species (approximately 80% of microbial flora) and actinomycetes (approximately 10–20%) as the second major flora. Isolation of Biomax^®-utilizing bacteria was focused on these two genera: two actinomycetes and one Bacillus species were isolated as pure best degraders from the composted polymer films, which were fragmented into small pieces. All the strains were thermophilic and identified, based on their 16S rDNA analyses. Degradation of polymer films was confirmed by (1) accelerated fragmentation of films in composts, compared with a control (no inoculum) and resultant decrease in molecular weights, (2) growth in a powdered Biomax^® medium, compared with a control without powdered Biomax^®, and (3) production of terephthalate in a powdered Biomax^® medium. In this way, we concluded that these bacteria were useful for degradation of thermostable Biomax^® products.     

Characterization of semi-volatile organic compounds emitted during heating of nitrogen-containing plastics at low temperature

Because of recent volume increases, appropriate management of plastic recycling, which generates various organic compounds, is required to ensure the chemical safety of the processes. The processing temperature and resin type are the important factors determining both the efficiency of the processes and the emission of chemicals. Therefore, we studied the thermal degradation of various plastics at various temperatures from 70 to 300 °C under oxygen-present conditions to identify the semi-volatile organic compounds (SVOCs) emitted and to understand their thermal behaviors. The plastics examined were nitrogen-containing resins, such as polyamide 6, polyurethane, melamine formaldehyde, urea formaldehyde and acrylonitrile-butadiene-styrene. Major commodity plastics were also investigated for comparison. In total, more than 500 SVOCs were detected as emissions from plastics. While various nitrogen-containing SVOCs were detected from nitrogen-containing resins, the major commodity plastics released only these, which possibly were included as additives. These results indicate that the nitrogen atoms in the SVOCs emitted originated from the resins and additives, and not from ambient air at low temperature. As a result of the detection of raw materials, degradation chemicals and by-products of the polymers in the emissions, we found that the variation in chemical species is dependent on the resins. Additives were also emitted from all the resins, meaning that these chemicals were also released to the environment at the temperature examined. In most cases, the numbers and concentrations of SVOCs increased with increasing heating temperature. The variation of thermal behaviors of SVOCs was related to the origins and chemical species of SVOCs.     

Physicochemical properties of selected polybrominated diphenyl ethers and extension of the UNIFAC model to brominated aromatic compounds

The aqueous solubilities (S(w)) at various temperatures from 283 K to 308 K and 1-octanol/water partition coefficients (K(ow)) for four polybrominated diphenyl ethers (PBDEs: 4,4'-dibromodiphenyl ether (BDE-15), 2,2',4,4'-tetrabromodiphenyl ether (BDE-47), 2,2',4,4',5-pentabromodiphenyl ether (BDE-99), and 2,2',4,4',5,5'-hexabromodiphenyl ether (BDE-153)) were measured by the generator column method. The S(w) and K(ow) data revealed the effect of bromine substitution and basic structure on S(w) and K(ow). To estimate the infinite dilution activity coefficients (gamma(i)(w,infinity)) of the PBDEs in water from the S(w) data, enthalpies of fusion and melting points for those compounds were measured with a differential scanning calorimeter. Henry's Law constants (H(w)) of the PBDEs were derived from the determined gamma(i)(w,infinity) and literature vapor pressure data. Some physicochemical characteristics of PBDEs were also suggested by comparing the present property data with that of polychlorinated dibenzo-p-dioxins, brominated phenols and brominated benzenes in past studies. Furthermore, in order to represent different phase equilibria including solubility and partition equilibrium for other brominated aromatic compounds using the UNIFAC model, a pair of UNIFAC group interaction parameters between the bromine and water group were determined from the S(w) and K(ow) data of PBDEs and brominated benzenes. The ability of the determined parameters to represent both properties of brominated aromatics was evaluated.