Distillers’ grains anaerobic digestion residue biochar used for ammonium sorption and its effect on ammonium leaching from an Ultisol

Environmental Science and Pollution Research - The aim of this work was to explore the potential application of biochar from distillers’ grains anaerobic digestion residue pyrolyzed at...     

建筑陶瓷行业SO2污染物评价及总量控制实用方法

采用高斯点源模型对建陶生产造成的SO2地面浓度增量进行计算.利用比例下降模型计算建陶业的SO2允许排放总量,并根据企业的设备生产能力进行了总量分配,在方法上具有较强的可操作性,计算结果表明,可有效降低所在地区的SO2地面浓度.     

城市危险化学品事故统计分析与对策

通过对2002-2004年发生在中国内地12个主要城市的435起非爆炸品类危险化学品事故统计分析,发现:(1)危险化学品事故总体呈进一步发展趋势;(2)处于城市生活区的化工企业发生危险化学品事故对城市的影响最大;(3)危险化学品在运输阶段,发生事故的比例最高;(4)民用燃气是造成使用阶段危险化学品事故的主要危险源,而人为失误和违规操作是民用燃气类危险化学品事故的主要原因.在统计分析基础上提出了相应的对策.     

酸雨对污染环境中重金属化学行为的影响

综述了酸雨对污染环境中重金属化学行为的影响。在酸雨作用下 ,不同环境介质中重金属活性明显增强 ,化学形态转化明显 ,迁移能力和生态危害能力亦明显加强。探讨了控制酸雨发生、重金属污染环境修复技术以及开展复合污染环境化学风险评价的必要性     

3种不同基质潜流湿地对磷的去除效果

基质是潜流式人工湿地污水处理系统的重要组成部分，直接影响到系统的处理效果。本文研究了由沸石、页岩陶粒和碎石3种不同基质构建的潜流式人工湿地对磷的去除效果。结果表明，在设计水力停留时间3d，连续进出水情况下，碎石单元对磷的去除效果最好，页岩陶粒单元次之，沸石单元效果最差，平均去除率分别为95％、60％和35％。在潜流式人工湿地污水处理系统运行初期观察到磷释放现象，沸石单元最为明显。进水磷浓度较低时，磷的去除率随浓度升高而升高，当正磷、总磷浓度分别升高到2．4—2．5和3．1～3．3mg／L时，正磷、总磷的去除率开始迅速下降。     

中国山东电网燃煤锅炉NOx排放状况和治理技术试验研究

通过对山东电网所属发电厂锅炉NOx排放状况进行调查、测试,得出锅炉NOx排放量与煤种、炉型、燃烧器型式、运行中空气过剩系数、负荷等的关系.结果表明,山东省火力发电厂50 MW及以上容量机组2003年的NOx排放总量超过40万t(按NO2计算).控制和治理NOx排放已成为刻不容缓的重要工作.     

Study of the adsorption of endocrine disruptor compounds on typical filter materials using a quartz crystal microbalance

Environmental Science and Pollution Research - Drinking water containing environmental endocrine disruptor compounds (EDCs) endangers human health, and researching the purification process of...     

锆负载型树脂用于含氟废水深度处理的研究

本文研制了一种以火力发电厂废树脂为载体的锆负载型氟离子吸附剂 ,并在评价了该树脂对氟离子的吸附性能之后探讨了该树脂用于火力发电厂含氟废水深度处理的可能性。研究结果表明 ,锆的最佳负载的最佳浓度为0 .5mol/L ,该负载树脂的最佳吸附pH为 3.0— 4 .0 ,用填充柱进行的动态实验结果表明 ,pH =3时的吸附容量显著高于 pH=4时的值。利用该树脂对火力发电厂模拟含氟废水进行了双柱串联吸附工艺处理 ,当柱流量为 35mL/min(SV10 )、第二柱穿透时 ,第一柱的吸附容量为 10 2 2 8mg/L湿树脂 ;用 0 .1mol/L的NaOH溶液进行再生 ,柱流量选择为 35mL/min(SV10 )时 ,脱附率在 95 %以上。     

Multiple copper adsorption and regeneration by zeolite 4A synthesized from bauxite tailings

Copper ions were first adsorbed by zeolite 4A synthesized from bauxite tailings, the desorption of Cu(II) using Na₂EDTA solutions was performed, and the recycling of zeolite 4A in adsorption and desorption was systematically investigated. It was observed that the Cu(II) removal efficiency was directly dependent on the initial pH value. The maximum removal efficiency of Cu(II) was 96.2% with zeolite 4A when the initial pH value was 5.0. Cu(II) was completely absorbed in the first 30 min. It was also observed that the desorption efficiency and zeolite recovery were highly dependent on the initial pH and concentration of Na₂EDTA in the solution. The desorption efficiency and percent of zeolite recovered were 73.6 and 85.9%, respectively, when the Na₂EDTA solution concentration was 0.05 mol L^?1 and the pH value was 8. The recovered zeolites were pure single phase and highly crystalline. After 3 cycles, the removal efficiency of Cu(II) was as high as 78.9%, and the zeolite recovery was 46.9%, indicating that the recovered zeolites have good adsorption capacity and can repeatedly absorb Cu(II).