溴百里香酚蓝在壳聚糖上吸附的研究

采用壳聚糖吸附溴百里香酚蓝(BTB)溶液,分析了pH、BTB初始浓度、吸附时间及温度对吸附效果的影响.结果表明,pH是影响BTB吸附的重要因素,当pH为3.4时壳聚糖对BTB溶液的吸附效果最好,其吸附行为符合Lagergren准二级反应动力学方程;随着温度升高,壳聚糖对BTB溶液的吸附量有所减少;吸附过程的表观活化能(...     

The degradation of chlorpyrifos and diazinon in aqueous solution by ultrasonic irradiation: effect of parameters and degradation pathway

In this paper, elimination of two types of organophosphorus pesticides (OPPs), chlorpyrifos and diazinon spiked in aqueous solution by ultrasonic irradiation was investigated. Results showed that chlorpyrifos and diazinon could be effectively and rapidly degraded by ultrasonic irradiation, and the degradation of both pesticides was strongly influenced by ultrasonic power, temperature and pH value. Furthermore, two and seven products for the degradation of chlorpyrifos and diazinon formed during ultrasonic irradiation have been identified by gas chromatography-mass spectrometry, respectively. The hydrolysis, oxidation, hydroxylation, dehydration and decarboxylation were deduced to contribute to the degradation reaction and the degradation pathway for each pesticide under ultrasonic irradiation was proposed. Finally, the toxicity evaluation indicated that the toxicity decreased for diazinon solution after ultrasonic irradiation, but it increased for chlorpyrifos solution. The detoxification of OPPs by ultrasonic irradiation was discriminative.     

四川汶川8．0级地震间接经济损失评估方法

国内生产总值(GDP)是衡量该地区经济总量和经济发展水平的重要指标.灾区内各评估子区震害程度、企业服务业恢复生产营业时间以及地震对企业服务业生产营业影响时间与地震间接经济损失有直接的关系.在研究了国内外有关地震间接经济损失评估研究成果的基础上,根据现场灾害调查结果,结合灾区实际,提出利用灾区各市(县)国内生产总值GDP(第二、三产业)数据、各评估子区震害系数、企业服务业生产营业恢复时间以及地震对企业服务业生产营业影响时间,进行地震灾害间接经济损失评估方法.     

流化床飞灰固化焚烧飞灰效果及微观分析

以深圳某垃圾焚烧厂焚烧飞灰为例分析了焚烧飞灰的性质和重金属毒性.结果表明,飞灰中 Pb 和 Cr 超出TCLP 阈值,必须进行稳定化处理.以流化床飞灰为主要成分配制固化材料,按不同比例掺人焚烧l￡灰进行固化实验,结果表明,实验范围内重金属固定效果良好.微观测试显示,固化过程主要产物有水化硅酸钙凝胶、钙矾石等,通过物理包胶、物理吸附、复分解沉淀反应和同晶替代等作用抑制重金属浸出.     

N-doped SiO2/TiO2 mesoporous nanoparticles with enhanced photocatalytic activity under visible-light irradiation

Mesoporous nanocrystalline N-doped SiO2/TiO2 visible-light photocatalysts were prepared by treating SiO2/TiO2 xerogels in a flow of nitrogen gas bubbled through concentrated ammonia solution. Structural characterization and performance analysis results revealed that the addition of SiO2 remarkably altered the phase composition, specific surface area, microstructure, as well as the photocatalytic activity of N-doped TiO2. The presence of SiO2 in N-doped TiO2 particles suppressed the formation of rutile phase and the crystal growth of N-doped TiO2 particles during thermal calcinations. When weight ratio of SiO2/TiO2 was in 0.05-0.20, the N-doped SiO2/TiO2 exhibited higher photocatalytic activity than the N-doped TiO2, and optimum ratio was found to be 0.05. The enhanced photocatalytic activity could be attributed to the higher specific area, larger pore volume, and more surface hydroxyl groups in the catalyst.     

试验方法和接种物来源对苯甲酸钠快速生物降解率的影响

化学品的快速生物降解性直接影响其在环境中的迁移、转化和归宿,是鉴别其环境危害性和持久性的基本指标,是政府管理部门对化学品进行风险管理的重要科学依据,在生态毒理测试中具有非常重要的地位。为探讨试验方法、接种物来源以及两者的交互效应对苯甲酸钠生物降解率的影响,2013~2015年间以广州地区2个主要处理生活污水的污水处理厂(DTS、LD)为接种物来源,采用OECD 301系列试验方法(301B、301D和301F)进行了苯甲酸钠的快速生物降解性试验,共获得89个标准化测试数据。统计分析结果显示,接种物来源、试验方法与接种物来源的交互效应对苯甲酸钠生物降解率影响不显著,但试验方法单一因素的影响显著。本研究表明,当受试物为易生物降解时,接种物来源、试验方法和接种物来源的交互效应对该受试物的生物降解率无显著的影响,但在同一条件下,选择不同的试验方法往往会导致最终生物降解率出现明显差异。     

膜分离—变压吸附耦合工艺处理催化剂载体生产废气

采用膜分离—变压吸附耦合工艺处理DQ催化剂载体生产过程产生的高浓度挥发性有机物（VOCs）废气。实验结果表明：在进气正己烷和非甲烷总烃的质量浓度分别为95 000~212 000 mg/m³和100 000 ~220 000 mg/m³、渗余侧压力0.25 MPa、渗透侧真空度0.09 MPa、进气流量15 Nm³/h的条件下,膜分离单元对废气中正己烷及非甲烷总烃的平均去除率分别为97.88%和97.29%;变压吸附单元对正己烷及非甲烷总烃的平均去除率分别为99.35%和99.33%;整套装置对正己烷及非甲烷总烃的平均总去除率分别为99.99%和99.98%。平均正己烷回收率达95.56%。处理后废气中非甲烷总烃质量浓度小于70 mg/ m³,达到北京市DB 11/ 447—2007 《炼油与石油化学工业大气污染物排放标准》的一级指标。     

固体超强酸SO4^2-／TiO2-SnO2／Ce^4＋光催化降解含酚废水

采用共沉淀-浸渍法制备了固体超强酸SO4^2-／TiO2-SnO2／Ce^4＋,并用XRD、SEM等方法对其结构进行了表征。以苯酚的光催化降解为反应模型,确定了最佳的工艺条件和催化剂再生方法。结果表明：在pH值为6,苯酚初始浓度为50mg／L,催化剂投加量4g／L,光照距离12cm,光照时间为150min,降解率达67．73％,添加助催化剂H2O2后,反应60min,苯酚降解率达到86．33％,催化剂的最佳再生方法是先用1mol／L的硫酸浸渍24h后,在450℃下焙烧6h。     

Degradation of 1,4-dioxane in water with heat- and Fe2+-activated persulfate oxidation

This research investigated the 1,4-dioxane (1,4-D) degradation efficiency and rate during persulfate oxidation at different temperatures, with and without Fe²⁺ addition, also considering the effect of pH and persulfate concentration on the oxidation of 1,4-D. Degradation pathways for 1,4-D have also been proposed based on the decomposition intermediates and by-products. The results indicate that 1,4-D was completely degraded with heat-activated persulfate oxidation within 3–80 h. The kinetics of the 1,4-D degradation process fitted well to a pseudo-first-order reaction model. Temperature was identified as the most important factor influencing the 1,4-D degradation rate during the oxidation process. As the temperature increased from 40 to 60 °C, the degradation rate improved significantly. At 40 °C, the addition of Fe²⁺ also increased the 1,4-D degradation rate. Interestingly, at 50 and 60 °C, the 1,4-D degradation rate decreased slightly with the addition of Fe²⁺. This reduced degradation rate may be attributed to the rapid conversion of Fe²⁺ to Fe³⁺ and the production of an Fe(OH)₃ precipitate which limited the ultimate oxidizing capability of persulfate with Fe²⁺ under higher temperatures. Higher persulfate concentrations led to higher 1,4-D degradation rates, but pH adjustment had no significant effect on the 1,4-D degradation rate. The identification of intermediates and by-products in the aqueous and gas phases showed that acetaldehyde, acetic acid, glycolaldehyde, glycolic acid, carbon dioxide, and hydrogen ion were generated during the persulfate oxidation process. A carbon balance analysis showed that 96 and 93 % of the carbon from the 1,4-D degradation were recovered as by-products with and without Fe²⁺ addition, respectively. Overall, persulfate oxidation of 1,4-D is promising as an economical and highly efficient technology for treatment of 1,4-D-contaminated water.     

Removal of malachite green dye from wastewater by different organic acid-modified natural adsorbent: kinetics,equilibriums, mechanisms,practical application,and disposal of dye-loaded adsorbent

Natural adsorbent (Cinnamomum camphora sawdust) modified by organic acid (oxalic acid, citric acid, and tartaric acid) was investigated as a potential adsorbent for the removal of hazardous malachite green (MG) dye in aqueous media in a batch process. The extent of MG adsorption onto modified sawdust increased with increasing organic acid concentrations, pH, contact time, and temperature but decreased with increasing adsorbent dosage and ionic strength. Kinetic study indicated that the pseudo-second-order kinetic model could best describe the adsorption kinetics of MG. Equilibrium data were found to fit well with the Langmuir model, and the maximum adsorption capacity of the three kinds of organic acid-modified sawdust was 280.3, 222.8, and 157.5 mg/g, respectively. Thermodynamic parameters suggested that the sorption of MG was an endothermic process. The adsorption mechanism, the application of adsorbents in practical wastewater, the prediction of single-stage batch adsorption system, and the disposal of depleted adsorbents were also discussed.