patterns and trends in levels of suspended particulate matter

The National Air Surveillance Network (NASN) has collected samples of suspended particulate matter since 1957. These data values are graphically summarized by the application of Whittaker-Henderson Type A curve-smoothing formulas to 10 years of data. Fifty-eight urban sites and 20 nonurban sites are studied by this technique, which permits an intuitive grasp of the underlying cyclical patterns as well as long-term trends in nationwide levels of suspended particulate matter. Seasonal patterns are evident for many urban and nonurban sites, although sharp contrasts in seasonal characteristics exist between the two types of sites. Long-term levels tend slightly downward at many urban locations, but the opposite effect is observed at many nonurban sites.     

Short Term Air Quality Standards for Suspended Particulate Matter in New York State

The Clean Air Act of 1970 requires each state to submit plans for implementation, maintenance, and enforcement of national ambient air quality standards subsequent to promulgation. Such plans have been geared to meet annual averages and maximum values. Based on experience in implementing the abatement plan it was found that air quality standards for averaging times shorter than one year are needed to shorten the time required to show contravention and to provide a basis for early corrective measures to regulate specific sources. This paper reports on the need and procedures used by New York State to develop such standards for suspended particulates. Daily suspended particulate data were analyzed by the Kolmogorov-Smirnov method goodness of fit technique to determine that the form of the distribution was log normal. A method developed by Larsen for predicting short term maximum concentrations for log normally distributed data was used to determine numerical values for one, two, and three month standards. Monthly, bi-monthly, and tri-monthly suspended particulate standards of 130, 110, and 100 µg/m³, respectively are proposed for the most extensively developed areas of New York State and correspondingly lower values for other areas. The methods used in this development are generally applicable to other air contaminants.     

Fine Particle Collection Efficiency Related to Pressure Drop,Scrubbant and Particle Properties,and Contact Mechanism

Collection efficiencies are shown for control of fine particles in venturi scrubbers (1) as a function of pressure drop, and (2) as a function of throat area and liquid to gas ratio. A relationship of pressure drop to throat area, gas density, throat velocity, and liquid to gas ratio is given and is used to provide a method for estimating efficiency knowing only these scrubber design parameters. The effect of charged particles and of surface active agents on collection efficiency are discussed briefly.     

Specifying Venturi Scrubber Throat Length for Effective Particle Capture at Minimum Pressure Loss Penalty

A simplified equation for specifying the optimum minimum length for commercial venturi scrubber throats is presented in this paper. This theoretical correlation is derived using an optimum velocity ratio (velocity of collector droplet at end of venturi throat to velocity of gas in throat) and is a function of throat gas velocity and liquid to gas ratio. This velocity ratio establishes the minimum throat length and is based on available literature data. Predicted venturi scrubber particle collection for throats specified by this procedure compare favorably with reported commercial venturi collection efficiencies and with modeled venturi efficiencies over the practical range of venturi scrubber operation.     

Industrial Pollution Prevention

The 1992 A&WMA Critical Review was authored by Harry Freeman and members of his staff at the Pollution Prevention Research Branch, Risk Reduction Engineering Laboratory, U.S. Environmental Protection Agency in Cincinnati, Ohio. Mr. Freeman presented the paper "Industrial Pollution Prevention," at the Critical Review session held during the 85th Air & Waste Management Association Annual Meeting in Kansas City, Missouri. Prepared discussions and invited comments presented during the session are published here, as well as closing remarks by Mr. Freeman.     

Measurement of Hydrocarbon Emissions Fluxes from Refinery Wastewater Impoundments Using Atmospheric Tracer Techniques

Sulfur hexafluoride (SF6) tracer was used in a series of the experiments to simulate emissions of benzene, toluene, ethyl-benzene, and xylenes (BTEX) from a refinery wastewater basin. The ratio of the measured tracer release to the ambient tracer concentration established a dilution factor which was then used to calculate the mass flux of BTEX from the wastewater basin using the ambient BTEX concentration data. Measured fluxes of BTEX varied from 7 g/min to 70 g/min.

The CHEMDAT7 air emissions model was then used to predict emissions for comparison with the emissions measured using the tracer flux simulation. CHEMDAT7 typically overpredicted total measured BTEX emissions by factors of twelve to seventeen. The degree of overprediction varied both by the individual compound and the module of CHEMDAT7 used to predict emission fluxes.     

Determination of organochlorine and organophosphorus pesticide residues in low moisture,nonfatty products using a solid phase extraction cleanup and gas chromatography

Abstract

A multiresidue solid‐phase extraction (SPE) method for the isolation and subsequent gas Chromatographie determination of organochlorine and organophosphorus pesticide residues in low‐moisture, nonfatty products is described. Residues are extracted from samples with an acetonitrile/water mixture. Cleanup of the extract is performed using graphitized carbon black and anion exchange SPE columns, and analysis is performed by gas chromatography with Hall electrolytic conductivity and flame photometric detection. Recovery data was obtained by fortifying corn, oats and wheat with pesticides. The average recoveries were 79–123% for eight organochlorine and 51–122% for 28 organophosphorus pesticide residues. The limit of quantitation for chlorpyriphos was 0.05 ppm using the Hall electrolytic conductivity detector and <0.005 ppm using the flame photometric detector.     

Chronic and episodic acidification of Adirondack streams from acid rain in 2003-2005

Limited information is available on streams in the Adirondack region of New York, although streams are more prone to acidification than the more studied Adirondack lakes. A stream assessment was therefore undertaken in the Oswegatchie and Black River drainages; an area of 4585 km(2) in the western part of the Adirondack region. Acidification was evaluated with the newly developed base-cation surplus (BCS) and the conventional acid-neutralizing capacity by Gran titration (ANC(G)). During the survey when stream water was most acidic (March 2004), 105 of 188 streams (56%) were acidified based on the criterion of BCS < 0 microeq L(-1), whereas 29% were acidified based on an ANC(G) value < 0 microeq L(-1). During the survey when stream water was least acidic (August 2003), 15 of 129 streams (12%) were acidified based on the criterion of BCS < 0 microeq L(-1), whereas 5% were acidified based on ANC(G) value < 0 microeq L(-1). The contribution of acidic deposition to stream acidification was greater than that of strongly acidic organic acids in each of the surveys by factors ranging from approximately 2 to 5, but was greatest during spring snowmelt and least during elevated base flow in August. During snowmelt, the percentage attributable to acidic deposition was 81%, whereas during the October 2003 survey, when dissolved organic carbon (DOC) concentrations were highest, this percentage was 66%. The total length of stream reaches estimated to be prone to acidification was 718 km out of a total of 1237 km of stream reaches that were assessed.