好氧颗粒污泥同时脱氮除磷技术研究

采用序批式活性污泥法(SBR)处理新疆油田公司准东石油基地污水,作为生物膜的一种特殊形式,介绍了该工艺的优点,在适宜的运行条件下进行实验。讨论了好氧颗粒污泥脱氮以及除磷的过程,分析了该工艺对氮、磷的去除率及好氧颗粒污泥在好氧、缺氧条件下的吸磷情况,当进水氨氮、磷和乙酸碳浓度分别为38.2 mg/L、27.7 mg/L和134.6 mg/L,MLSS和MLVSS分别为7.0 mg/L、6.4 mg/L时,氨氮、总无机氮、磷、乙酸碳的平均去除率分别达到98.8%、90.2%、98.9%、97.2%.     

Anthropogenic oligotrophication via liming: Long-term phosphorus trends in acidified,limed, and neutral reference lakes in Sweden

Restoration of acidified lakes by liming does not, in many cases, improve productivity to a pre-acidified state. We hypothesize that the poor recovery detected in many of these lakes is due to constrained in-lake phosphorous (P) cycling caused by enhanced precipitation of metals in higher pH, limed waters. Long-term (1990–2012) data for 65 limed, circum-neutral (pH 6–8), and acidified lakes in Sweden were analyzed to determine trends for P and potential drivers of these trends. Limed lakes not only had lower mean values and stronger decreasing trends for total P than non-limed lakes, but they also had the highest percentage of decreasing trends (85 %). A P release factor (Hypolimnetic P/Epilimnetic P) was developed to elucidate differences in internal P cycling between lake groups. Consistently, lower P release factors in limed lakes show limitation of internal P cycling during summer months that may be a factor limiting P bioavailability and thus productivity of these systems.     

污泥膜覆盖好氧发酵堆体流场模拟及应用研究简

运用Gambit软件建立了污泥好氧发酵堆体的多孔介质模型,通过自行设计的实验装置获得了堆体的通风粘性阻力系数和惯性阻力系数以及功能膜压差与透气量之间的关系,用Fluent软件分析了堆体不同截面形状及底部通风管数量对堆体通风均匀性的影响,为确定合理的通风管数量及截面几何形状提供理论依据。对上海奉贤区城镇污水厂污泥处理工程发酵仓进行堆体流场模拟,确定堆体采用小拱形截面形状,堆高2 m,宽8 m,底部设置4条通风管,实际运行效果良好。     

碳纳米管电极原位产生过氧化氢及其对亚甲基蓝脱色效果简

将碳纳米管固定化制成多孔疏水性导电薄膜构建电化学阴极还原体系,实现过氧化氢在阴极的原位产生。电极特性研究表明,电极在较宽的电压范围内均具有较好的活性。考察了阴极电位、电极成分、氧气流量和电解质浓度对过氧化氢原位产生的影响,在优化条件下经过120 min后过氧化氢达到66.17 mg/L,并探讨过氧化氢原位产生的机理。在此基础上考察原位过氧化氢氧化工艺下对亚甲基蓝的脱色效果,并分析其脱色机理。     

酸性洗涤塔-生物滤塔-生物曝气池组合工艺处理恶臭气体NH3和H2S

采用酸性洗涤塔、生物滤塔和生物曝气池的组合工艺处理NH3、H2S恶臭混合气体,研究表明,该组合工艺对NH3和H2S有很好的去除效果,在进气流量为35 L/min,喷淋量45 L/h时,NH3进气浓度50.15~525.4 mg/m3,H2S进气浓度10.23~110.36 mg/m3时,NH3单一进气去除率稳定在99%以上,H2S单一进气去除率90%以上。混合进气后,NH3去除率几乎为100%,H2S的去除率提高至98%以上。在一定的浓度范围内,NH3和H2S之间的相互作用对两者的去除效果没有明显的影响,而且起到了相互促进降解的作用。同时,进气流量和填料层高度都会影响NH3、H2S的去除率。系统对进气容积负荷变化的缓冲能力强,在偶尔超负荷条件下运行并不能使系统崩溃,并且微生物对高负荷逐渐表现出适应性。大部分溶于水的氨由生物曝气池去除,去除率达到96.9%。     

Heavy metal pollution in vegetables grown in the vicinity of a multi-metal mining area in Gejiu,China: total concentrations,speciation analysis,and health risk

A field survey was conducted to investigate the present situation and health risk of arsenic (As), lead (Pb), cadmium (Cd), copper (Cu), and zinc (Zn) in soils and vegetables in a multi-metal mining area, Gejiu, China. Furthermore, three vegetables (water spinach, potato, and summer squash) containing high metal concentrations were selected to further analyze metal speciation. The results showed that the average concentrations of five metals in soil exceeded the limiting values, and their bioavailable concentrations were significantly positively correlated to the total ones. Heavy metals in the edible parts of vegetables also exceeded the corresponding standards. The leaves of pakchoi, peppermint, and coriander had a strong metal-accumulative ability and they were not suitable for planting. Except the residue forms, the main forms of metals in the edible parts of three selected vegetables were ethanol-, NaCl-, and HAc-extractable fractions for As, Pb, and Cd, respectively; however, Cu was mainly presented as NaCl-extractable and Zn as HAc-extractable fractions. A high proportion of ethanol-extractable As showed that As bioactivity and toxic effects were the highest. Although the total and bioavailable Cd were high in soil, its speciation in vegetables was mainly presented as HAc-extractable fraction, which has a relatively low bioactivity. Lead and arsenic were imposing a serious threat on the local residents via vegetable consumption.     

抗铬菌株的筛选鉴定及其生物学特性和吸附特性

利用微生物分离纯化技术,在培养基中加入不同浓度的Cr3+、Cr6+,经过长时间驯化,从污染土壤中筛选出2株对Cr具有较高抗性的菌株(A和B),对其进行了形态、生理生化特性及分子生物学鉴定,并研究了其最佳生长条件及对Cr3+的生物吸附规律。结果表明,菌株A和B分别为蜡状芽孢杆菌(Bacillus cereus)和米根霉菌(Rhizopus oryzae)。菌株A和B的最适生长pH值均为7,最适生长温度均为30℃,最佳装液量为80~100 mL(250 mL摇瓶)。在培养时间一定时,随着Cr3+浓度的增加,菌株对Cr3+的吸附率减少,而生物吸附量则逐渐增大;在Cr3+浓度一定时,随着培养时间的延长,菌体对Cr3+的吸附率呈现出先增加后减少的趋势,这与生物吸附量的变化趋势基本一致。在Cr3+浓度为100 mg/L时,菌株A和B对Cr3+的吸附率达到最大,分别为51.47%和46.36%。     

纳米TiO2-石墨烯光催化剂的水热合成及其光催化性能

以钛酸四正丁酯和石墨为原料,通过水热法制备了锐钛矿型为主的纳米TiO2复合光催化剂（纳米TiO2-石墨烯）,并采用XRD,FTIR,FESEM,TEM技术对其进行了表征。通过紫外光照射降解溶液中的罗丹明B（RhB）研究了TiO2-石墨烯的光催化活性,分析了初始罗丹明B质量浓度、催化剂加入量、溶液pH和催化剂使用次数等影响降解效果的因素。实验结果表明：在初始RhB质量浓度为20 mg/L、溶液pH为7.10、催化剂加入量为1.000 g/L的条件下,紫外光照射30 min时,纳米TiO2-石墨烯对RhB的降解率高达98.69%,明显高于纳米TiO2的44.69%;纳米TiO2-石墨烯稳定性较强,可多次重复使用。     

铁氧化物复合氧化铝催化臭氧化过程中溴酸盐的生成控制

以市售活性炭、硅藻土和氧化铝小球为载体,考察了负载铁基活性组分对催化臭氧化过程中溴酸盐的控制情况,其中,铁基复合氧化铝小球体现出更好的溴酸盐还原特性和催化剂稳定性,证实催化剂中铁氧化物是溴酸盐得到有效控制的主要活性组分。进一步考察了铁基复合氧化铝小球催化臭氧化处理实际原水过程中对溴酸盐的生成控制,以及反应过程中溶解性有机碳（DOC）的去除情况。结果表明,与单独臭氧化相比,该催化剂既能有效去除水中的溶解性有机物,又能明显抑制溴酸盐的生成,反应50h,其活性并没有明显下降。催化剂失活主要归因于吸附位点数量的下降,可以通过负载铁氧化物来实现催化剂的再生。     

反应气耦合等离子体降解沙林模拟剂

采用水蒸气、氨气、过氧化氢气雾和臭氧4种气体对沙林模拟剂氟磷酸二异丙酯(DFP)进行降解研究,发现臭氧对DFP具有较好的降解作用,在流量200 L/h,DFP初始浓度50 mg/m3时,降解率最高可达56.1%。对高浓度DFP(大于80 mg/m3)进行降解研究时,等离子体单独作用最高降解率为89%,而添加臭氧后的降解率都在95%以上。计算得到臭氧作用的能量利用率为0.05 mg/(W·h),等离子体的能量利用率为0.55 mg/(W·h),而添加臭氧后的等离子体能量利用率为0.68 mg/(W·h)明显高于臭氧和等离子体能量利用率之和,因此对高浓度DFP进行处理时,臭氧与等离子体存在耦合作用。对等离子体和臭氧耦合等离子体降解DFP反应进行了产物分析,发现主要的降解产物基本一致,但是臭氧的存在能使降解更加彻底。