Historical change of mercury pollution in remote Yongle archipelago, South China Sea

We collected three ornithogenic coral sand sedimentary profiles from Jinyin Island, Jinqing Island and Guangjin Island of Yongle archipelago, South China Sea and reconstructed the deposition flux of anthropogenic Hg over the past 700 years in the study area. On the whole, the anthropogenic Hg flux is relatively low; it remained at a low level before the Industrial Revolution with a small peak at about 1450-1550 AD, which may record the enhanced metallurgy activity in Ming Dynasty of China. During the 20th century, the deposition flux of anthropogenic Hg increased rapidly, but two troughs occurred during the periods around 1940s and 1970s, corresponding to the economic depression caused by World War II, Civil War in China (1945-1949), and the Culture Revolution (1966-1976) in China. Since the 1970s the deposition flux of anthropogenic Hg has been persistently increasing, apparently the result of fast economic development in East and Southeast Asia countries around South China Sea.     

Transformation of tetrabromobisphenol A in the presence of different solvents and metals

Solvent-based separation method is presumably an efficient and environmentally beneficial approach for elimination of brominated flame retardants (BFRs) from waste electrical and electronic equipment (WEEE). The overall goal of this study was to evaluate possible effects of organic solvent on the behavior of BFRs during solvent-based processing of WEEE. We initiated a set of batch experiments for examining the rates and possible pathways of transformation of a representative BFR (tetrabromobisphenol A, TBBPA) using acetone, toluene, and methanol as the solvents. Our results showed that toluene and methanol had no effect on the transformation of TBBPA, but approximately 20% of TBBPA (100 mg L⁻¹) was transformed by acetone within 2 h at 50 °C. Analysis of the products with GC-MS showed that two high-molecular-weight products (MW = 586) were major products of the transformation reactions. The role of acetone as a reactant in the transformation of TBBPA was further validated with dueterated acetone. In addition, the effects of co-existing metals in WEEE (i.e., Zn, Cu, and Ni) on the transformation of TBBPA in the solvent systems were investigated. These metals tested were found to greatly enhance the rates of TBBPA transformation. The metal facilitated solvent reactions with TBBPA may lower the extractability of TBBPA by formation of larger and less soluble products, hence potentially increasing the cost for separating the chemical from WEEE.     

Toxicological effect of MPA-CdSe QDs exposure on zebrafish embryo and larvae

Cadmium selenium (CdSe) quantum dots (QDs) are semiconductor nanocrystals that hold wide range of applications and substantial production volumes. Due to unique composition and nanoscale properties, their potential toxicity to aquatic organisms has increasingly gained a great amount of interest. However, the impact of CdSe QDs exposure on zebrafish embryo and larvae remains almost unknown. Therefore, the lab study was performed to determine the developmental and behavioral toxicities to zebrafish under continuous exposure to low level CdSe QDs (0.05-31.25 mg L⁻¹) coated with mercaptopropionic acid (MPA). The results showed MPA-CdSe exposure from embryo to larvae stage affected overall fitness. Our findings for the first time revealed that: (1) The 120 h LC₅₀ of MPA-CdSe for zebrafish was 1.98 mg L⁻¹; (2) embryos exposed to MPA-CdSe resulted in malformations incidence and lower hatch rate; (3) abnormal vascular of FLI-1 transgenic zebrafish larvae appeared after exposure to MPA-CdSe including vascular junction, bifurcation, crossing and particle appearance; (4) larvae behavior assessment showed during MPA-CdSe exposure a rapid transition from light-to-dark elicited a similar, brief burst and a higher basal swimming rate; (5) MPA-CdSe induced embryos cell apoptosis in the head and tail region. Results of the observations provide a basic understanding of MPA-CdSe toxicity to aquatic organisms and suggest the need for additional research to identify the toxicological mechanism.     

Effect of inoculation methods on the composting efficiency of municipal solid wastes

Four types of inoculation methods were studied during the composting of municipal solid wastes and dry grass (MSWG). The methods included a control group as well as initial-stage, two-stage, and multi-stage inoculations. Fulvic acids were extracted from the composting materials and characterized by spectroscopic techniques. The results showed that inoculation of microbes in MSWG enhanced the biodegradation of aliphatics, proteins, and polysaccharides. The inoculation also increased the molecular weight, humic- and fulvic-like compound content, as well as humification degree of the composting products. The inoculation of microbes in MSWG significantly improved composting process and efficiency. The improvement efficiency was in the order of initial-stage < two-stage < multi-stage inoculations. Inoculation of microbes based on composting organic matter composition and temperature enhanced composting efficiency.     

Identification of priority pharmaceuticals in the water environment of China

In recent years, increasing attention has been paid to the trace-level contamination of pharmaceuticals in the water environment all over the world. Considering a large number of pharmaceuticals used, it is crucial to establish a priority list of pharmaceuticals that should be monitored and/or treated first. In the present study, we developed a ranking system based on the pharmaceutical consumption, removal performance in the wastewater treatment plants (WWTPs) and potential ecological effects, and applied to the situation of China. 39 pharmaceuticals, which had available consumption data and also been reported previously in the WWTPs of China, were selected as candidate pharmaceuticals. Among them, seventeen pharmaceuticals were considered as priority pharmaceuticals, out of which, erythromycin, diclofenac acid and ibuprofen, had the high priority. Compared with other literatures, we found that some pharmaceuticals given concerns to globally should also be included in the priority list in China; while some pharmaceuticals, not mentioned in other literatures, such as cefalexin, ketoconazole, should be also given prior consideration in China. Among all the therapeutic classes, antibiotics, which were grossly abused in China, contributed the most to the priority pharmaceuticals. However, priority antibiotics accounted for only 32% of candidate antibiotics, while 71% and 100% of the candidate anti-inflammatory and antilipidemic respectively were identified as the priority pharmaceuticals, indicating that antibiotics might be overanxiously considered in the previous studies on their behaviors in the WWTPs of China.     

Cosorption of organic chemicals with different properties: their shared and different sorption sites

Complementary sorption of different chemicals was expected and investigating the relationship between the sorption inhibition of primary sorbate (ΔQ(pri)) and sorption of secondary sorbate (Q(sec)) could provide a new angle to understand coadsorption of different chemicals. This study used bisphenol A (BPA) as the primary adsorbate, sulfamethoxazole (SMX) as the competitor, and carbon nanotubes as model adsorbents to study their complementary and competitive adsorption. At low BPA concentrations, the sorption of SMX (Q(sec)) exceeded BPA sorption inhibition (ΔQ(pri)), indicating that these two chemicals complementarily adsorbed on their respectively preferred sorption sites. At high BPA concentrations, higher ΔQ(pri) was observed in comparison to Q(sec), which may be resulted from different packing efficiencies of the adsorbed SMX and BPA. This study emphasized that both competitive and complementary sorption should be discussed in binary sorption system.     

Lead tolerance and physiological adaptation mechanism in roots of accumulating and non-accumulating ecotypes of Sedum alfredii

Background, aim and scope

Lead (Pb) accumulation in soils affects plants primarily through their root systems. The aim of this study was to investigate early symptoms of the loss of membrane integrity and lipid peroxidation in root tissues and physiological adaptation mechanism to Pb in accumulating ecotypes (AE) and non-accumulating ecotypes (NAE) of Sedum alfredii under Pb stress in hydroponics.

Methods and results

Histochemical in situ analyses, fluorescence imaging, and normal physiological analysis were used in this study. Pb accumulation in roots of both AE and NAE increased linearly with increasing Pb levels (0?C200???M), and a significant difference between both ecotypes was noted. Both loss of plasma membrane integrity and lipid peroxidation in root tissues became serious with increasing Pb levels, maximum tolerable Pb level was 25 and 100???M for NAE and AE, respectively. Pb supplied at a toxic level caused a burst of reactive oxygen species (ROS) in root cells in both ecotypes. However, the root cells of AE had inherently higher activities of superoxide dismutase (SOD), guaiacol peroxidase (POD), and lipoxygenase (LOX) in control plants, and the induction response of these antioxidant enzymes occurred at lower Pb level in AE than NAE. AE plants maintained higher ascorbic acid and H₂O₂ concentrations in root cells than NAE when exposed to different Pb levels, and Pb induced more increase in dehydroascorbate (DHA), catalase (CAT), and ascorbate peroxidase (APX) in AE than NAE roots.

Discussion and conclusion

Results indicate that histochemical in situ analyses of root cell death and lipid peroxidation under Pb short-term stress was sensitive, reliable, and fast. Higher tolerance in roots of accumulating ecotype under Pb stress did depend on effective free oxygen scavenging by making complex function of both constitutively higher activities and sensitive induction of key antioxidant enzymes in root cells of S. alfredii.     

Removal of genotoxicity in chlorinated secondary effluent of a domestic wastewater treatment plant during dechlorination

Purpose  

Dechlorination with tetravalent sulfur is widely used in wastewater treatment processes after chlorination. Dechlorination can remove certain genotoxic disinfection by-products (DBPs). However, the reactions occurring during dechlorination of chlorinated secondary effluent and their genotoxic chemicals are still very complex, and the related genotoxicity changes remain unknown. Therefore, the effects of dechlorination on genotoxicity in secondary effluent and its fractions and typical genotoxic chemical after chlorination were evaluated.     

Harvesting of Chlorella sp. using hollow fiber ultrafiltration

Introduction

The suitability of the application of ultrafiltration (UF) to harvest Chlorella sp. from the culture medium was examined. We investigated the effects of two improved UF system, forward air?Cwater flushing and backwash with permeate, on the concentration process.

Materials and methods

Backwash with permeate was selected as an optimization of the improved UF system, which was more effective for permeate flux recovery. Moreover, the hollow fiber UF system by adding periodical backwash with permeate was examined for Chlorella sp. harvesting.

Results and discussion

It was found that Chlorella sp. could be concentrated with high recovery in a lab-scale experiment. An overall algal biomass recovery of above 90% was achieved when the volume concentration factor was 10. For an original biomass of 1.3?±?0.05?g/L, 1?min backwash followed by 20?min forward concentrating was more effective, which resulted in a recovery of 94% and a high average flux of 30.3?L/m²/h. In addition, the algal recovery was highly correlated to the volume concentration factor and the initial biomass. A high concentration factor or a high initial biomass resulted in a low biomass recovery.     

Carbonyl emissions from vehicular exhausts sources in Hong Kong

Vehicular emission (VE) is one of the important anthropogenic sources for airborne carbonyls in urban area. Six types of VE-dominated samples were collected at representative locations in Hong Kong where polluted by a particular fueled type of vehicles, including (i) a gas refilling taxis station (liquefied petroleum gas [LPG] emission); (ii) a light-duty passenger car park (gasoline emission); (iii) a minibus station (diesel emission); (iv) a single-deck-bus depot (diesel emission); (v) a double-deck-bus depot (diesel emission); and (vi) a whole-food market entrance for light- and heavy-duty vehicles (diesel emission). A total of 15 carbonyls in the samples were quantified. Formaldehyde was the most abundant carbonyl among the VE-dominated samples, and its contribution to the total quantified amount on a molar basis ranged from 54.8% to 60.8%. Acetaldehyde and acetone were the next two abundant carbonyls. The carbonyls were quantified at three roadside locations in Hong Kong. The highest concentrations of formaldehyde and acetaldehyde, 22.7 +/- 8.4 and 6.0 +/- 2.8 microg/m3, respectively, were determined in the samples collected at a main transportation gate for goods between Hong Kong and Mainland China. The total quantified carbonyl concentration, 37.9 +/- 9.3 microg/m3, was the highest at an entrance of a cross-harbor tunnel in downtown area. The theoretical carbonyls compositions of the three roadside locations were estimated according to the VE-dominated sample profiles and the statistics on vehicle numbers and types during the sampling period. The measured compositions of formaldehyde were much higher than the theoretical compositions in summer, demonstrating that photochemical reactions significantly contributed to the formaldehyde production in the roadsides.