Stability analysis of alkaline nitrobenzene-containing wastewater by a catalyzed Fe-Cu treatment process

Iron and copper bimetallic system (catalyzed Fe-Cu process) is a promising technology for alkaline nitrobenzene-containing wastewater treatment. However, little is currently known about the changes of treatment efficiency with time going. This research investigated the long-term performance of the catalyzed Fe-Cu process to reduce nitrobenzene (NB) in alkaline wastewater. In addition, the changes of the metal surfaces morphologies and matters before and after the reaction were analyzed by scanning electron microscopy (SEM) in conjunction with energy-dispersion spectroscopy (EDS) and X-ray diffraction spectroscopy (XRD). The results showed that the surface properties of copper almost remained unchanged after weeks of operation, which spelled its strong chemical stability and resistance to poisoning. Moreover, the results indicated that there were two reasons for the treatment efficiency decreasing with time. One was the gradual iron element consumption due to corrosion. The other was iron reactivity weakened due to the precipitates accumulation on the surfaces that were mainly Fe₃O₄ and FeCO. __________ Translated from Environmental Pollution & Control, 2006, 28(10): 783–785 [译自: 环境污染与防治]     

微量营养物质对有机废水厌氧消化过程的调控作用

通过向处理酸性葡萄酒蒸馏废水的厌氧移动床生物膜反应器中投加微量营养物质的试验,得出利用微量营养物质调控厌氧消化过程在技术上是可行的。Fe、Ni、Co组合不仅能加快挥发性有机酸(VFA),特别是丙酸的降解速率,进而提高厌氧反应器的溶解COD去除率,同时,还有利于厌氧反应器有机负荷的快速提升和较强pH缓冲能力的形成。B族维生素对厌氧移动床生物膜反应器运行效果影响不大。Fe对厌氧移动床生物膜反应器运行有一定影响,但效果也不十分明显。     

高压脉冲电凝聚技术处理活性染料废水试验研究

难生物降解有机废水是废水处理的难点。阐述了高压脉冲电凝聚技术处理高浓度、难生物降解有机废水的最新机理。采用高压脉冲电凝聚技术处理活性染料（活性红）生产废水．研究了影响高压脉冲电凝聚技术处理活性染料废水效果的操作条件及影响因素．结果表明，在最佳处理工艺条件下。CODCr浓度12628mg／L的生产废水经处理后CODCr去除率为65％左右。再经后续混凝沉淀，最终出水CODCr可降低到1000mg／L以下。     

工业废气污染状况与脱硫除尘技术

对工业废气污染状况进行分析讨论,综述了工业废气的多种脱硫除尘技术。并指出应选择脱硫除尘效率高,运转可靠,不产生二次污染的方法。     

水泥土桩复合地基桩土应力参数研究

本文首先通过理论分析，认为桩土应力比、桩土荷载分担比等是反映水泥土桩复合地基工作性状的重要参数。然后通过现场试验，研究桩土应力比、桩土荷载分担比随荷载变化的规律。结果认为：随着荷载增加，桩土应力比逐渐减小，当比值达到某一特征值后，不再发生明显变化；桩土应力比、桩土荷载分担比不为常数，其变化是桩土变形协调的结果。最后得出有一定参考价值的结论。     

无排泥条件下HRT对膜生物反应器硝化性能的影响及其生物群落结构分析

以无机氨氮废水(NH+4 N,500mg·L-1)为处理对象,在不排泥条件下逐渐缩短膜生物反应器的水力停留时间(HRT,30h～5h),连续运行260d.在反应器内的氨氮容积负荷和污泥负荷分别为1 2kg·(d·L)-1和2 13kg·kg-1·d-1时,氨氮去除率达98 2%以上.当HRT减少至7h时开始出现NH+4 N和NO-2 N的积累.尽管反应器内MLSS随着运行时间的延长在逐步上升,氨氧化菌(AOB)和亚硝酸氧化菌(NOB)的数量分别从HRT10h和15h起开始下降.16SrDNA聚合酶链式反应结合变性梯度凝胶电泳(PCR DGGE)的分析发现反应器内生物多样性随着运行时间的延长而增加,测序结果表明进行氨氧化作用的主要是亚硝化单胞菌属(Nitrosomonassp.),进行亚硝酸氧化的主要是硝化螺菌属(Nitrospirasp.).尽管反应器只进行无机氨氮配水,仍存在大量的异养菌,估计其生长是以胞外分泌产物和细胞裂解产物为基质.     

一种新型复合式生物流化反应器混合特性的研究

对新型蜂窝状断面复合生物流化反应器进行了液体循环速率和水力停留时间分布曲线的测定，实验表明新型反应器具有抗冲击负荷强，接近CSTR反应器的特点，反应器随气量增大、载体投加量减少和进水量减少而更近似于CSTR反应器，通过理论分析，证明了影响液体循环速率的参数主要有气体流量(气含率)、反应器沿程和局部阻力系数以及Ad/Ar，并且得出液体循环速率与反应器高度的0．5次方成正比。     

Present status and changes of the phytoplankton community after invasion of Neosalanx taihuensis since 1982 in a deep oligotrophic plateau lake, Lake Fuxian in the subtropical China

Phytoplankton assemblages in the subtrophical oligotrophic Lake Fuxian, the second deepest lake in China, were investigated monthly from September 2002 to August 2003. A total of 113 species belonging to seven phyla were identified, among them, a filamentous green alga, Mougeotia sp., dominated almost throughout the study period and comprised most of the total phytoplankton biomass.Mougeotia sp. has made a substantial development during the past decades: it was absent in 1957, only occasionally present in 1983,increased substantially in 1993, and became predominant in 2002--2003. It is likely that natural invasion of the Taihu Lake noodlefish (Neosalanx taihuensis) has led to a change of dominant herbivorous zooplankton from small to large calanoid, which has increased grazing pressure on small edible algae, and thus has indirectly favored the development of the inedible filamentous Mougeotia sp.     

室内空气中甲醛和苯系物检测与净化

通过对哈尔滨市装饰装修竣工一年内的60户室内空气污染物检测分析,结果表明:室内空气甲醛超标64.1%,苯超标54.1%,甲苯超标35.6%,二甲苯超标30.6%.采用臭氧法,光催化氧化法和药剂法三种方法对室内空气污染物甲醛和苯进行净化效果实验研究,评价其净化效果,比较了三种方法的优劣.     

甲烷高温自燃诱导过程实验与数值模拟研究

甲烷的转化在化工产业中具有举足轻重的地位与战略意义,近年来涌现的氧化偶联制烯烃等多种新型化工工艺涉及高温条件的甲烷-纯氧等体系的混合与反应过程,明确甲烷高温自燃诱导与爆炸规律是实现工艺安全设计与运行的前提,然而相关研究与基础数据仍较为欠缺。通过利用基于快速压缩装置的高温高压燃爆测试系统开展甲烷-纯氧等典型混合体系的自燃诱导过程研究,同时基于GRI-Mech 3.0机理的数值模拟方法进行了数值模拟研究。实验结果与数值模拟结果吻合较好,随着温度/压力的增加及氧气含量的下降,混合体系自燃诱导时间均缩短;燃料气中加入乙烷或氢气则会大幅缩短自燃诱导过程。对于多个工艺过程中涉及的低氧含量体系率先开展了研究,得到了不同当量比及温度条件下的典型体系自燃诱导时间,同时考察了惰性气的加入对于自燃诱导过程的延长作用。研究结果有助于深入理解甲烷自燃诱导机理,同时指导高温条件的甲烷转化工艺的本质安全化设计与爆炸防控。