印染RO浓水深度处理及回用

采用Fenton-石灰苏打法耦合工艺对某印染厂印染反渗透(RO)浓水进行深度处理。通过实验研究了不同H2O2和Fe2+投加量、p H和反应时间对废水COD去除率的影响,以及不同石灰和碳酸钠投加量对废水硬度的脱除效果,出水回用于染色工段进行染色实验。结果表明,在p H=3.0,Fe2+投加量为1.5 mmol/L,H2O2投加量为3.75 mmol/L,反应时间为45 min,石灰和碳酸钠投加量分别为450 mg/L和1 000 mg/L的条件下,出水COD和硬度的去除率可分别达到73.9%和85.0%,耦合工艺出水水质符合该厂回用染色水标准,且减少了盐的使用,可实现印染RO浓水回用。     

改性活性炭对水中铬离子(Ⅵ)的吸附性能

为了研究改性前后活性炭对水中铬离子(Ⅵ)的吸附效果,以磷酸活性炭(PAC)为原料,用10%硝酸改性得到硝酸改性活性炭(N-PAC)及直接蒸发法载铁改性得到载铁活性炭(Fe-PAC)。通过静态吸附研究表明,改性后活性炭对Cr(Ⅵ)的吸附率有较大提高。在常温、自然pH条件下,0.2 g活性炭处理50 mL浓度为100 mg/L的含Cr(Ⅵ)溶液,N-PAC和Fe-PAC对Cr(Ⅵ)的吸附率分别为79.21%和90.59%,都高于原PAC对Cr(Ⅵ)的吸附率49.58%。pH从2.2升高到11.92,Fe-PAC对Cr(Ⅵ)的吸附率从99.86%降低到14.77%,N-PAC则从99.86%降低到3.23%,PAC从97.05%降低到2.53%。温度从25℃升高到70℃,3种活性炭对Cr(Ⅵ)吸附率都有较大提高,都增加到98%以上。且吸附过程较符合Langmuir等温吸附模型。     

Beryllium-7 Measurements in the Houston and Phoenix Urban Areas: An Estimation of Upper Atmospheric Ozone Contributions

Abstract

Natural radionuclides have been proposed as a means of assessing the transport of ozone (O₃) and aerosols in the troposphere. Beryllium-7 (⁷Be) is produced in the upper troposphere and lower stratosphere by the interaction of cosmogenic particles with atmospheric nitrogen and oxygen. ⁷Be has a 53.29-day half-life (478 keV γ) and is known to attach to fine particles in the atmosphere once it is formed. It has been suggested that O₃ from aloft can be transported into rural and urban regions during stratospheric–tropospheric folding events leading to increased background levels of O₃ at the surface. ⁷Be can be used as a tracer of upper atmospheric air parcels and the O₃ associated with them. Aerosol samples with a 2.5-µm cutoff were collected during 12-hr cycles (day/night) for a 30-day period at Deer Park, TX, near Houston, in August– September of 2000, and at Waddell, AZ, near Phoenix, in June–July of 2001. A comparison of ⁷Be levels with 12-hr O₃ averages and maxima shows little correlation. Comparison of nighttime and daytime O₃ levels indicate that during the day, when mixing is anticipated to be higher, the correlation of ⁷Be with O₃ in Houston is approximately twice that observed at night. This is consistent with mixing and with the anticipated loss of O₃ by reaction with nitric oxide (NO) and dry deposition. At best, 30% of the O₃ variance can be explained by the correlation with ⁷Be for Houston, less than that for Phoenix where no significant correlation was seen. This result is consistent with the intercept values obtained for ⁷Be correlations with either O₃ 24-hr averages or O₃ 12-hr maxima and is also in the range of the low O₃ levels (25 ppb) observed at Deer Park during a tropical storm event where the O₃ is attributable primarily to background air masses. That is, maximum background O₃ level contributions from stratospheric sources aloft are estimated to be in the range of 15–30 ppb in the Houston, TX, and Phoenix, AZ, area, and levels above these are because of local tropospheric photochemical production.     

Photocatalytic oxidation of monuron in the suspension of WO3 under the irradiation of UV-visible light

A comprehensive study of the degradation of monuron, one of the phenylurea herbicides, was conducted by UV-Vis/WO₃ process. It was found that hydroxyl radicals played a major role in the decay of monuron while other radicals (e.g. superoxide) and hole might also contribute to the decomposition of monuron. The oxidation path likely plays a major role in the generation of hydroxyl radicals. The effects of initial pH level, initial concentration of monuron, and inorganic oxidants on the performance of UV-Vis/WO₃ process were also investigated and optimized. Comparison between monuron decay pathways by UV-Vis/WO₃ and UV/TiO₂ was conducted. The decay mechanisms, including N-terminus demethylation, dechlorination and direct hydroxylation on benzene ring, were observed to be involved in the oxidation of monuron in these two processes. Sixteen intermediates were identified during the photodegradation of monuron and degradation pathways were proposed accordingly.     

中性红在柚子皮上的吸附机制研究

采用柚子皮作为生物吸附材料吸附去除中性红。研究了中性红的初始浓度、吸附时间及反应温度对吸附效果的影响。结果表明,当中性红溶液从100 mg/L升高到250 mg/L时,反应95 min后,柚子皮对中性红的吸附量从16.80 mg/g增加到40.00mg/g。中性红在柚子皮上的吸附在60 min内基本上可以达到平衡,且柚子皮对中性红的吸附过程为放热过程;二级吸附动力学方程能更好地描述中性红在柚子皮上的吸附行为;中性红在柚子皮孔隙中的扩散不是唯一的吸附速率控制步骤,这个吸附过程可能受多个步骤共同控制;柚子皮对中性红的吸附是自发吸附,Langmuir、Freundlich和Temkin吸附等温式能很好地拟合柚子皮对中性红的吸附过程,拟合相关系数分别达到了0.991 8、0.993 4、0.989 0。     

Relationship between Urban and Rural Sulfate Levels

Abstract

The topic of global warming as a result of increased atmospheric CO₂ concentration is arguably the most important environmental issue that the world faces today. It is a global problem that will need to be solved on a global level. The link between anthropogenic emissions of CO₂ with increased atmospheric CO₂ levels and, in turn, with increased global temperatures has been well established and accepted by the world. International organizations such as the United Nations Framework Convention on Climate Change (UNFCCC) and the Intergovernmental Panel on Climate Change (IPCC) have been formed to address this issue. Three options are being explored to stabilize atmospheric levels of greenhouse gases (GHGs) and global temperatures without severely and negatively impacting standard of living: (1) increasing energy efficiency, (2) switching to less carbon-intensive sources of energy, and (3) carbon sequestration. To be successful, all three options must be used in concert. The third option is the subject of this review. Specifically, this review will cover the capture and geologic sequestration of CO₂ generated from large point sources, namely fossil-fuel-fired power gasification plants. Sequestration of CO₂ in geological formations is necessary to meet the President’s Global Climate Change Initiative target of an 18% reduction in GHG intensity by 2012. Further, the best strategy to stabilize the atmospheric concentration of CO₂ results from a multifaceted approach where sequestration of CO₂ into geological formations is combined with increased efficiency in electric power generation and utilization, increased conservation, increased use of lower carbonintensity fuels, and increased use of nuclear energy and renewables.

This review covers the separation and capture of CO₂ from both flue gas and fuel gas using wet scrubbing technologies, dry regenerable sorbents, membranes, cryogenics, pressure and temperature swing adsorption, and other advanced concepts. Existing commercial CO₂ capture facilities at electric power-generating stations based on the use of monoethanolamine are described, as is the Rectisol process used by Dakota Gasification to separate and capture CO₂ from a coal gasifier.

Two technologies for storage of the captured CO₂ are reviewed—sequestration in deep unmineable coalbeds with concomitant recovery of CH4 and sequestration in deep saline aquifers. Key issues for both of these techniques include estimating the potential storage capacity, the storage integrity, and the physical and chemical processes that are initiated by injecting CO₂ underground. Recent studies using computer modeling as well as laboratory and field experimentation are presented here. In addition, several projects have been initiated in which CO₂ is injected into a deep coal seam or saline aquifer. The current status of several such projects is discussed. Included is a commercial-scale project in which a million tons of CO₂ are injected annually into an aquifer under the North Sea in Norway. The review makes the case that this can all be accomplished safely with off-the-shelf technologies. However, substantial research and development must be performed to reduce the cost, decrease the risks, and increase the safety of sequestration technologies.

This review also includes discussion of possible problems related to deep injection of CO₂ . There are safety concerns that need to be addressed because of the possibilities of leakage to the surface and induced seismic activity. These issues are presented along with a case study of a similar incident in the past. It is clear that monitoring and verification of storage will be a crucial part of all geological sequestration practices so that such problems may be avoided. Available techniques include direct measurement of CO₂ and CH4 surface soil fluxes, the use of chemical tracers, and underground 4-D seismic monitoring.

Ten new hypotheses were formulated to describe what happens when CO₂ is pumped into a coal seam. These hypotheses provide significant insight into the fundamental chemical, physical, and thermodynamic phenomena that occur during coal seam sequestration of CO₂ .     

Evaluation of Selected Gaseous Halocarbons for Use in source Test Performance Audits

A repository of 38 gaseous organic compounds in compressed gas cylinders has been established by EPA. This repository was established to provide standards for source test performance audits, that is, quantitative quality assurance tests. Among these compounds are ten halogenated organic species, which are the focus of this paper.

Stability studies of all ten compounds have been performed to determine the feasibility of using them as performance audit standards. Results indicate that all of the halocarbons tested are adequately stable to be used as reliable audit standards.

Subsequent to completion of stability studies, four of the ten halocarbons were used in source test performance audits. Results are available at this time for two of the four compounds; the results show agreement within 10% of the concentrations previously established by Research Triangle Institute.     

Quantification and analysis of airborne bacterial characteristics in a nursing care institution

Indoor air quality has become a critical issue because people spend most of their time in the indoor environment. The factors that influence indoor air quality are very important to environmental sanitation and air quality improvement. This study focuses on monitoring air quality, colony counts, and bacteria species of the indoor air of a nursing care institution. The regular colony counts in two different wards range from 55 to 600 cfu m(-3) Regression analysis results indicate that the bacterial colony counts have close correlation with relative humidity or carbon dioxide (CO2) but not with carbon monoxide (CO) or ozone (O3). Real-time PCR was used to quantify the bacterial pathogens of nosocomial infection, including Acinetobacter baumannii, Citrobacter freundii, Escherichia coli, Klebsiella pneumoniae, and methicillin-sensitive Staphylococcus aureus. The most abundant bacteria species in the air of the nursing care institution is E. coli.     

羟基磷灰石的制备及其对水中氟离子的吸附

本研究利用红外光谱(FTIR)、扫描电镜(SEM)和X射线粉末衍射(XRD)观察了共沉淀法合成羟基磷灰石(HAP)的形貌及其晶型结构,并探讨了Ca/P摩尔比、反应时间及反应温度等因素对羟基磷灰石吸附水中氟离子性能的影响。结果表明,n(Ca/P)=1.5/1、反应时间1 h、反应温度40℃、陈化时间48 h、煅烧温度200℃、煅烧时间2 h时,HAP除氟效果最佳,吸附效率和吸附容量分别达到68.8%和6.88 mg/g。实验数据Langmuir等温模式拟合效果优于Freundlich模式,热力学参数计算可知,HAP对氟离子的吸附是自发(ΔG00),吸热(ΔH00),熵增(ΔS00)的过程。HAP对氟离子的吸附符合拟二级反应动力学过程。     

A statistic comparison of multi-element analysis of low atmospheric fine particles (PM2.5) using different spectroscopy techniques

Over the past few decades, the metal elements(MEs) in atmospheric particles have aroused great attention. Some well-established techniques have been used to measure particlebound MEs. However, each method has its own advantages and disadvantages in terms of complexity, accuracy, and specific elements of interest. In this study, the performances of inductively coupled plasma–optical emission spectrometry(ICP-OES) and total reflection X-ray fluorescence spectroscopy(TXRF) were evaluated for qualit...