环境群体性事件的成因分析——基于对十起典型环境群体性事件的研究

通过对近5年来10起典型的环境群体性事件进行分析,旨在发现不同阶段引发环境群体性事件的原因,从而预防和解决环境群体性事件的发生,为人们营造一个和谐稳定的生活和工作环境。     

程海湖夏冬季浮游植物群落结构与富营养化状况研究

为了解程海湖浮游植物群落特征及其富营养化现状,对程海湖的水体理化指标和浮游植物群落结构进行了系统调查,分析了夏、冬季节程海湖水质状况、浮游植物群落结构特征及其与环境因子之间的关系,并运用综合营养状态指数法和藻类生物学法评价了程海湖的营养状态.结果表明,调研期间程海湖氮、磷浓度较高,水体中总磷(TP)浓度为0.03～0.19 mg·L~(-1),总氮(TN)为0.38～3.08 mg·L~(-1),综合营养状态指数(TLI)在49.3～54.4之间波动,已经达到轻度富营养水平;藻密度变化范围为1.54×10~6～1.65×10~7个·L~(-1),已超过常规湖泊的水华暴发阈值范围;浮游植物以蓝藻、绿藻为主,Shannon-Wiener多样性指数大多数为1～3,Pielou均匀度指数为0.18～0.72,部分时间段藻类多样性偏低,呈现出典型的蓝藻门为优势的富营养化状态,亟需对其进行生态保护与管理.     

Removal characteristics of microplastics by Fe-based coagulants during drinking water treatment

Microplastics have caused great concern worldwide recently due to their ubiquitous presence within the marine environment. Up to now, most attention has been paid to their sources, distributions, measurement methods, and especially their eco-toxicological effects. With microplastics being increasingly detected in freshwater, it is urgently necessary to evaluate their behaviors during coagulation and ultrafiltration (UF) processes. Herein, the removal behavior of polyethylene (PE), which is easily suspended in water and is the main component of microplastics, was investigated with commonly used Fe-based salts. Results showed that although higher removal efficiency was induced for smaller PE particles, low PE removal efficiency (below 15%) was observed using the traditional coagulation process, and was little influenced by water characteristics. In comparison to solution pH, PAM addition played a more important role in increasing the removal efficiency, especially anionic PAM at high dosage (with efficiency up to 90.9%). The main reason was ascribed to the dense floc formation and high adsorption ability because of the positively charged Fe-based flocs under neutral conditions. For ultrafiltration, although PE particles could be completely rejected, slight membrane fouling was caused owing to their large particle size. The membrane flux decreased after coagulation; however, the membrane fouling was less severe than that induced by flocs alone due to the heterogeneous nature of the cake layer caused by PE, even at high dosages of Fe-based salts. Based on the behavior exhibited during coagulation and ultrafiltration, we believe these findings will have potential application in drinking water treatment.     

锰氧化菌Pseudomonas sp. QJX-1对氧四环素的去除作用与机制

氧四环素（Oxytetracycline,OTC）的大量使用可能导致环境中抗性基因的生成和传播.锰氧化菌及其催化产生的生物锰氧化物（Biogenic manganese oxides,BMO）在自然界中广泛存在,但对其去除OTC的过程与机制仍不明确.因此,本研究探讨了锰氧化菌Pseudomonas sp. QJX-1对微量（5 μg·L^-1）OTC的去除作用与机制.结果表明,微量的OTC可以促进QJX-1的生长及其对Mn²⁺的氧化.QJX-1及其催化生成的BMO对OTC的去除效果较好,在第168 h时对OTC的去除率达到99%.转录组结果表明,OTC会导致细菌的pstA、pstB、pstC、urtA和urtD等ABC转运蛋白编码基因表达上调,说明OTC可能是通过ABC转运蛋白泵出QJX-1体内进而让BMO更有效地接触OTC,从而达到OTC被吸附、氧化去除的目的.RT-qPCR结果表明,微量的OTC促进了细菌多铜氧化酶基因cumA的表达,提高了BMO的生成速率,增强了对OTC的去除效果.     

磁性氮掺杂碳材料活化过硫酸盐降解酸性橙7

采用一步水热碳化法制备出微米级磁性氮掺杂碳材料（Magnetic N-doped Carbonaceous Materials,MNC）作为过硫酸盐（Persulfate,PDS）活化剂,以生成的活性氧化物质降解偶氮类染料酸性橙7（Acid Orange 7,AO7）.同时,利用扫描电镜（SEM）、比表面积与孔径测定仪（BET）、振动样品磁强计（VSM）等对MNC进行表征,考察了MNC投加量、PDS浓度、初始p H值和无机阴离子对活化PDS降解AO7的影响,并采用紫外-可见光谱分析、淬灭实验和电子顺磁性共振（Electron Paramagnetic Resonance,EPR）初步探讨了AO7的降解机理.结果表明,MNC呈微米级球状,表面富含含氧基团和氨基等活性点位;饱和磁化强度为12.7 emu·g^-1,能在外加磁场条件下实现固液分离.AO7去除率随MNC投加量、PDS浓度的增加而增加,但初始p H对AO7降解的影响呈相反规律,随p H升高而降低.3种无机阴离子对AO7降解抑制程度大小顺序为HCO₃^->SO     

玉龙雪山积雪中粉尘微粒的沉积特征

通过分析在玉龙雪山冰川区采集的雪坑样品和部分表层雪样品,对冰川积雪中的大气粉尘沉积特征进行了深入研究.玉龙雪山积雪中粒径介于0.57相似文献   

老化微塑料对水体中重金属铜和锌的吸附行为研究

微塑料（Microplastics,MPs）在水环境中可以作为重金属载体,对金属离子的迁移和毒性效应产生较大影响.本文开展了紫外光老化后的聚丙烯（Polypropylene,PP）和聚乙烯（Polyethylene,PE）对两种重金属离子Cu²⁺和Zn²⁺在单一和二元复合体系中的吸附行为研究.通过拟一级和拟二级动力学模型研究发现,微塑料对重金属离子的吸附过程更符合拟二级动力学过程,利用Langmuir模型和Freundlich模型对吸附等温线结果进行拟合,结果表明,在单一体系中,相同老化条件下的PP相比PE对金属离子的平衡吸附量更高,且对Cu²⁺的吸附量均大于对Zn²⁺;在二元复合体系中,由于竞争吸附作用,MPs对重金属离子的吸附量小于在单一体系中的吸附量,且MPs对重金属离子的吸附过程更符合Freundlich模型,即吸附主要以多层吸附为主.吸附热力学研究表明,老化PP和PE微塑料对Cu²⁺和Zn²⁺的吸附行为属于自发吸热过程.微塑料PP和PE吸附前后对莱茵衣藻的毒性试验结果表明,微塑料存在均对藻类的生长有抑制作用,但吸附重金属后的微塑料对藻的生长抑制率有所降低.通过藻的酶活性（包括超氧化歧化酶（SOD）,丙二醛（MDA）和过氧化氢酶（CAT））的测定结果表明,微塑料对藻造成一定的氧化损伤,而吸附重金属后的微塑料的毒性作用下降.本论文可以为环境中微塑料存在下复合污染物的竞争吸附行为和联合生态效应研究提供理论依据.     

Rapid control of black and odorous substances from heavily-polluted sediment by oxidation: Efficiency and effects

Oxidants were proposed to rapidly control black and odorous substances in sediments. NaClO and KMnO₄ had excellent efficiency to remove black and odorous substances. NaClO dramatically accelerated the release of organics, NH₄⁺-N, P, and heavy-metals. Moderate oxidation had a limited effect on microbial communities. NaClO of 0.2 mmol/g was viewed to be the optimum option. The control of black and odorous substances in sediments is of crucial importance to improve the urban ecological landscape and to restore water environments accordingly. In this study, chemical oxidation by the oxidants NaClO, H₂O₂, and KMnO₄ was proposed to achieve rapid control of black and odorous substances in heavily-polluted sediments. Results indicate that NaClO and KMnO₄ are effective at removing Fe(II) and acid volatile sulfides. The removal efficiencies of Fe(II) and AVS were determined to be 45.2%, 94.1%, and 93.7%, 89.5% after 24-h exposure to NaClO and KMnO₄ at 0.2 mmol/g, respectively. Additionally, rapid oxidation might accelerate the release of pollutants from sediment. The release of organic matters and phosphorus with the maximum ratios of 22.1% and 51.2% was observed upon NaClO oxidation at 0.4 mmol/g. Moreover, the introduction of oxidants contributed to changes in the microbial community composition in sediment. After oxidation by NaClO and KMnO₄ at 0.4 mmol/g, the Shannon index decreased from 6.72 to 5.19 and 4.95, whereas the OTU numbers decreased from 2904 to 1677 and 1553, respectively. Comparatively, H₂O₂ showed a lower effect on the removal of black and odorous substances, pollutant release, and changes in sediment microorganisms. This study illustrates the effects of oxidant addition on the characteristics of heavily polluted sediments and shows that chemical oxidants may be an option to achieve rapid control of black and odorous substances prior to remediation of water environments.     

Preparation of organically functionalized silica gel as adsorbent for copper ion adsorption

A novel adsorbent (AMPS-silica) was synthesized by bounding AMPS (2-acrylamido-2-methylpropanesulfonic acid) onto silica surface, which functioned with -methacryloxypropyltrimethoxysilane reagent. The adsorbent was characterized by nitrogen adsorption/ desorption measurement, thermogravimetric analysis (TGA) and potentiometric titration analysis. The TGA result indicated that the surface modification reactions introduced some organic functional groups onto the surface of silica. The surface area of AMPSsilica was 389.7 m2/g. The adsorbent was examined for copper ion removal in series of batch adsorption experiments. Results showed that the adsorption of Cu2+ onto AMPS-silica was pH dependent, and the adsorption capacity increased with increasing pH from 2 to 6. The adsorption kinetics showed that Cu2+ adsorption was fast and the data fitted well with a pseudo second- order kinetic model. The adsorption of Cu2+ onto AMPS-silica obeyed both Freundlich and Langmuir isotherms, with r2 = 0.993 and r2 = 0.984, respectively. The maximum Cu2+ adsorption capacity was 19.9 mg/g. The involved mechanism might be the adsorption through metal binding with organic functional groups such as carboxyl, amino and sulfonic groups. Cu2+ loaded on AMPS-silica could be desorbed in HNO3 solution, and the adsorption properties remain stable after three adsorption-desorption cycles.