Inactivation of fungi associated with barley grain by gaseous ozone

The use of gaseous ozone as a fungicide to preserve stored barley was studied. The effects of the following operating parameters on the fungicidal efficacy of ozone were examined: 1) the applied ozone dose, 2) ozonation time, 3) water activity of barley, and 4) temperature of barley. The effect of ozonation on germination of barley was also investigated. The experimental results showed that ozone was very effective in inactivation of fungi associated with the barley regardless of whether the fungi were in the forms of spores or mycelia. However, the mycelia were less resistant to ozone. With 5 minutes of ozonation, 96% of inactivation were achieved for spores as well as for mixtures of spores and small amount of mycelia by applying 0.16 and 0.10 mg of ozone/(g barley) x min, respectively. In addition, for sealed storage silos, inactivation of fungi continued when the ozone-containing gas was held inside the silos following a continuous ozone supply. The experimental results also revealed that increases in water activity and temperature of barley enhanced the fungicidal efficacy of ozone. Results of this study also indicated that the inactivation processes could be controlled by simply monitoring the exit ozone from the reactor instead of performing the time-consuming microbial examination. This finding would make the application of ozone in the preservation of cereal grains easier, simpler, and more practically applicable. The experimental results demonstrated that although ozonation above certain strength may reduce barley germination, inactivation of fungi was achieved with ozonation strengths far below the critical point.     

A novel sigma coordinate system to simulate abrupt changes of underwater terrain in a hydrodynamic model: application to Lake Mead,USA

The sigma (SIG) coordinate system in ocean circulation simulation models results inevitably in horizontal pressure gradient error. This problem also emerges in models of deep lakes or reservoirs with the same characteristics of underwater terrain mutation. SIG coordinates reflect vertical relative stratification but cannot be used to calculate horizontal pressure gradient force in places with drastic topographic changes; this results in vertical water temperature and circulation errors. In deep lakes or reservoirs, differences in water density caused by the temperature difference between upper and lower water bodies is the primary cause of thermal stratification phenomena. Lake Mead was used as a case study on steep topography based on Environmental Fluid Dynamics Code (EFDC) model in this study. SIG coordinates result in close agreement between the calibrated temperature time series at the top and middle water layers, but disparity in the bottom water layer. The error emerges in the horizontal pressure gradient error due to the SIG coordinate transformation. Neither increasing the vertical resolution nor adjusting the horizontal viscosity coefficient resolve this error. We test the sigma-zed (SGZ) coordinate which combines Z coordinate and SIG coordinate as a replacement for the SIG coordinate to find that they effectively reduce the model’s runtime and simulation efficiency. The vertical temperature distribution in SGZ coordinate mode is more accurate than the distribution in SIG coordinate mode. The Navier-Stokes horizontal gradient and advection diffusion equation results under SIG coordinates are very sensitive to the pressure gradient. The replacement also enhances resolution near the thermocline, facilitates reclosing of the water bottom and the equal sigma surface, lends significant advantages in terms of vertical temperature in the simulation for local deep water with steep terrain, and shortens runtime for 0.14 h. SGZ mixed coordinates are recommended in the simulation of deep lakes or reservoirs wherein the underwater topography is large (with abundant continuous deep trenches or reefs).

     

Status of water use and potential of rainwater harvesting for replacing centralized supply system in remote mountainous areas: a case study

Environmental Science and Pollution Research - The failure of the centralized water supply system forced XY community to become more dependent on uncertain and unstable water sources. The results...     

Prenatal diagnosis of chronic granulomatous disease (CGD) in four high risk male fetuses

Prenatal diagnosis of chronic granulomatous disease (CGD) was performed in four male high risk fetuses. The male sex was previously determined by an amniotic cell karyotype. Three kinds of test were performed on fetal blood obtained by umbilical venous puncture under fetoscopy at the 20th gestational week: nitroblue tetrazolium reduction (NBT) cytochemical test with phorbol myristate acetate (PMA) as activator; luminol enhanced chemiluminescence with activation by serum opsonized zymosan (STZ) or PMA; superoxide anion (0) production by measurement of the superoxide dismutase inhibitable reduction of cytochrome c with PMA as activator. Results were compared to those obtained in six fetuses investigated for other inherited diseases. In one case, absence of granulocyte defects was confirmed at birth. In three other cases, the tests showed deficient metabolic oxidative granulocytes. The pregnancy was terminated and the CGD diagnosis was confirmed on the products of abortion. The use of three different techniques performed on whole blood for CGD prenatal diagnosis is recommended instead of a single isolated test to ensure a higher confidence in the diagnosis.     

Human factors and tidal influences on water quality of an urban river in Can Tho, a major city of the Mekong Delta, Vietnam

In this study, we focused on water quality in an urban canal and the Mekong River in the city of Can Tho, a central municipality of the Mekong Delta region, southern Vietnam. Water temperature, pH, electrical conductivity, BOD₅, COD_Cr, Na⁺, Cl^?, NH₄ ⁺?N, SO₄ ^2??S, NO₃ ^??N, and NO₂ ^??N for both canal and river, and tide level of the urban canal, were monitored once per month from May 2010 to April 2012. The urban canal is subject to severe anthropogenic contamination, owing to poor sewage treatment. In general, water quality in the canal exhibited strong tidal variation, poorer at lower tides and better at higher tides. Some anomalies were observed, with degraded water quality under some high-tide conditions. These were associated with flow from the upstream residential area. Therefore, it was concluded that water quality in the urban canal changed with a balance between dilution effects and extent of contaminant supply, both driven by tidal fluctuations in the Mekong River.     

PBDEs and PCBs in sediments of the Thi Nai Lagoon (Central Vietnam) and soils from its mainland

Concentration and distribution of PCBs, PCB 11, and PBDEs in both surficial sediment and soil samples, taken from a zone subject to recent accelerated development, were investigated to assess the environmental quality and understand both natural and anthropogenic processes that influence contaminant behaviors. Values of PCB and PBDE are in the lower range of those reported in literature, typical of low impacted coastal zones. This could be due to efficient processes of resuspension and removal. Contaminants in the lagoon showed higher concentrations in sediments from sites close to the city and the outfalls of the industrial area, while soils showed maximum values in the northern samples. In addition, congener patterns and statistical analyses suggest the presence of effective degradation processes, especially for PBDEs, with the exception of the most concentrated samples that may indicate a direct input. PCB 11 is a significant component (up to 18%) in most lagoon sediments. Its presence is strongly associated with fine particles, thus the distribution seems to be driven mainly by the system hydrodynamic and does not trace the sources. Due to evaporation, only flooded agricultural soils show a similar relative abundance of this congener.     

Metabolic uncoupler, 3,3′,4′,5-tetrachlorosalicylanilide addition for sludge reduction and fouling control in a gravity-driven membrane bioreactor

• Effects of metabolic uncoupler TCS on the performances of GDMBR were evaluated. • Sludge EPS reduced and transformed into dissolved SMP when TCS was added. • Appropriate TCS increased the permeability and reduced cake layer fouling. • High dosage aggravated fouling due to compact cake layer with low bio-activity. The gravity-driven membrane bioreactor (MBR)system is promising for decentralized sewage treatment because of its low energy consumption and maintenance requirements. However, the growing sludge not only increases membrane fouling, but also augments operational complexities (sludge discharge). We added the metabolic uncoupler 3,3′,4′,5-tetrachlorosalicylanilide (TCS) to the system to deal with the mentioned issues. Based on the results, TCS addition effectively decreased sludge ATP and sludge yield (reduced by 50%). Extracellular polymeric substances (EPS; proteins and polysaccharides) decreased with the addition of TCS and were transformed into dissolved soluble microbial products (SMPs) in the bulk solution, leading to the break of sludge flocs into small fragments. Permeability was increased by more than two times, reaching 60–70 L/m²/h bar when 10–30 mg/L TCS were added, because of the reduced suspended sludge and the formation of a thin cake layer with low EPS levels. Resistance analyses confirmed that appropriate dosages of TCS primarily decreased the cake layer and hydraulically reversible resistances. Permeability decreased at high dosage (50 mg/L) due to the release of excess sludge fragments and SMP into the supernatant, with a thin but more compact fouling layer with low bioactivity developing on the membrane surface, causing higher cake layer and pore blocking resistances. Our study provides a fundamental understanding of how a metabolic uncoupler affects the sludge and bio-fouling layers at different dosages, with practical relevance for in situ sludge reduction and membrane fouling alleviation in MBR systems.     

Effective adsorbent for arsenic removal: core/shell structural nano zero-valent iron/manganese oxide

Recently, nano zero-valent iron (nZVI) has emerged as an effective adsorbent for the removal of arsenic from aqueous solutions. However, its use in various applications has suffered from reactivity loss resulting in a decreased efficiency. Thus, the aim of this study was to develop an effective arsenic adsorbent as a core/shell structural nZVI/manganese oxide (or nZVI/Mn oxide) to minimize the reactivity loss of the nZVI. As the major result, the arsenic adsorption capacities of the nZVI/Mn oxide for As(V) and As(III) were approximately two and three times higher than that of the nZVI, respectively. In addition, the As(V) removal efficiency of the nZVI/Mn oxide was maintained through 4 cycles of regeneration whereas that of the nZVI was decreased significantly. The enhanced reactivity and reusability of the nZVI/Mn oxide can be successfully explained by the synergistic interaction of the nZVI core and manganese oxide shell, in which the manganese oxides participate in oxidation reactions with corroded Fe²⁺ and subsequently retard the release of aqueous iron providing additional surface sites for arsenic adsorption. In summary, this study reports the successful fabrication of a core/shell nZVI/Mn oxide as an effective adsorbent for the removal of arsenic from aqueous solutions.     

化肥驱动正渗透工艺处理生活污水的研究进展

采用化肥驱动正渗透（fertilizer driven forward osmosis, FDFO）工艺处理生活污水,不仅有效降低受纳环境风险或减少水体污染,同时经稀释后的化肥汲取液可直接用于周边农田灌溉,实现了生活污水处理与农田灌溉水肥一体化协同效应,具有良好的应用前景。目前,FDFO处理生活污水处于实验室小试和部分现场中试验证阶段,规模化应用的关键核心在于高效正渗透膜的开发、膜装置设计的改进、膜表面水力学参数的优化及膜污染缓解技术水平的提升。文章综述了近10年FDFO工艺在处理生活污水中的应用,重点阐述了FDFO工艺的膜装置类型与工艺流程、评价指标及其影响因素等3方面,并展望了未来FDFO工艺规模化处理生活污水面临的挑战,以期推动FDFO工艺在处理污水领域的应用。